In this thesis, I studied two different approaches which are promising for creating macroscopic quantum superpositions. The first approach, which is the main focus of this thesis, is based on optomechanical systems. The basic challenge to realize quantum effects in optomechanical systems, is considered to be the weak optomechanical coupling rate compared to the decoherence rates of the system caused by the cavity and mechanical damping. To enhance the optomechanical coupling it has been suggested to pump the cavity with coherent laser light \cite{Vitali07}. By this method the strong coupling regime in which the optomechanical coupling rate exceeds all decoherence rates has been demonstrated very recently \cite{Verhagen12,Groblacher09}. It is also known that the optomechanical systems may exhibit nonlinear behaviours such as bistability. After introducing the basic ideas of optomechanical systems in chapter 1, in chapter 2 we studied the connection between optomechanical entanglement and bistability. In chapter 3, we studied the drawback of using a laser to enhance the interaction. We studied the effect of the laser phase noise, as an additional decoherence channel, on the optomechanical entanglement. We have shown that the system is very sensitive to this new source of decoherence and the sensitivity is maximum in the bistable threshold. We discussed that our results are independent of how we model the laser phase noise. In chapter 4, we studied single photon optomechanics. In this regime, we proposed a new scheme to enhance the optomechanical coupling based on post selection. Our scheme is potentially promising to create a superposition of the massive oscillator in different motional states. We also discussed the potential application of our scheme to test some decoherence models. The second approach that we consider in this thesis is based on amplifying single photons with high gain to create micro-macro superpositions . In chapter 5, we discussed the De Martini scheme. We then present our scheme for creating optical micro-macro superposition and discussed its experimental realization under realistic conditions when losses are taken into account.
After a quick review of the basic theory of quantum optomechanical systems, based largely on linearized Heisenberg–Langevin equations, this chapter focuses on selected topics related to quantum measurement and quantum optomechanics. Included are: a comprehensive discussion of the quantum limit on the added noise of a continuous position detector, following the quantum linear response approach; a detailed discussion of the role of noise correlations, and how these can be achieved in an optomechanical cavity (by using squeezed input light, or by modifying the choice of measured output quadrature); and a discussion of back-action evading measurements of a mechanical quadrature, discussing how this can be achieved in a two-tone driven cavity system. The chapter ends with a quick introduction to the theory of conditional continuous quantum measurement, and a discussion on how a back-action evading measurement can be used to produce conditional mechanical squeezed states.
My Ph.D dissertation is on the fundamental effects in optomechanical systems (OMS) and their important applications. The OMS are based on the possibility of the mechanical motion produced by few photons incident on the mechanical device. This dissertation presents several applications of the OMS in the area of storage of light in long-lived phonons, single mode optomechanical Ramsey interferometry, and generation of large amount of squeezing in the output radiation. The long-lived phonons can be monitored and controlled via optical means as was experimentally demonstrated. To show this, I develop the theory of transient electromagnetically induced transparency (EIT). For further applications like state transfer, especially over very different frequency regimes, I consider double-cavity OMS, where the two cavities can correspond to different spectral domains, yet the state transfer is possible via phonons. The state transfer is based on a new effect, electromagnetically induced absorption (EIA), where one uses a second control field from the other cavity to produce an absorption peak inside the EIT window. All these involve the interference of various path ways via which a final state is reached. The following chapter shows how Fano-like interference can arise in OMS. A Fano asymmetry parameter for OMS was defined.