Optomechanics is currently believed to provide a promising route towards the achievement of genuine quantum effects at the large, massive-system scale. By using a recently proposed figure of merit that is well suited to address continuous-variable systems, in this paper we question such expectation. We quantify the degree of macroscopicity of the state of a vibrating mechanical mode (embodied by an end-cavity cantilever or a membrane placed within an optical cavity) achieved through its radiation-pressure coupling to a quantized field of light. By showing that quite demanding conditions should be met in order to be able to claim for genuine macroscopic quantum superpositions, our investigation poses substantial doubts on the suitability of current experimental configurations in optomechanics.
Optomechanics is currently believed to provide a promising route towards the achievement of genuine quantum effects at the large, massive-system scale. By using a recently proposed figure of merit that is well suited to address continuous-variable systems, in this paper we question such expectation. We quantify the degree of macroscopicity of the state of a vibrating mechanical mode (embodied by an end-cavity cantilever or a membrane placed within an optical cavity) achieved through its radiation-pressure coupling to a quantized field of light. By showing that quite demanding conditions should be met in order to be able to claim for genuine macroscopic quantum superpositions, our investigation poses substantial doubts on the suitability of current experimental configurations in optomechanics.
Optomechanics is currently believed to provide a promising route towards the achievement of genuine quantum effects at the large, massive-system scale. By using a recently proposed figure of merit that is well suited to address continuous-variable systems, in this paper we analyze the requirements needed for the state of a mechanical mode (embodied by an end-cavity cantilever or a membrane placed within an optical cavity) to be qualified as macroscopic. We show that according to the phase-space-based criterion that we have chosen for our quantitative analysis, the state achieved through strong single-photon radiation-pressure coupling to a quantized field of light and conditioned by measurements operated on the latter might be interpreted as macroscopically quantum. In general, though, genuine macroscopic quantum superpositions appear to be possible only under quite demanding experimental conditions.
The investigation of macroscopic quantum phenomena is a current active area of research that offers significant promise to advance the forefronts of both fundamental and applied quantum science. Utilising the exquisite precision and control of quantum optics provides a powerful toolset for generating such quantum states where the types and 'size' of the states that can be generated are set by the experimental parameter regime available and the resourcefulness of the protocol applied. In this work we present a new multistep scheme to 'grow' macroscopic superposition states of motion of a mechanical oscillator via cavity quantum optomechanics. The scheme consists of a series of optical pulses interacting with a mechanical mode via radiation-pressure followed by photon-counting measurements. The multistep nature of our protocol allows macroscopic superposition states to be prepared with a relaxed requirement for the single-photon optomechanical coupling strength. To illustrate the experimental feasibility of our proposal, we quantify how initial mechanical thermal occupation and mechanical decoherence affects the non-classicality and macroscopicity of the states generated and show that our scheme is resilient to optical loss. The advantages of this protocol provide a promising path to grow non-classical mechanical quantum states to a macroscopic scale under realistic experimental conditions.
The search for experimental demonstrations of the quantum behavior of macroscopic mechanical resonators is a fastly growing field of investigation and recent results suggest that the generation of quantum states of resonators with a mass at the microgram scale is within reach. In this chapter we give an overview of two important topics within this research field: cooling to the motional ground state, and the generation of entanglement involving mechanical, optical and atomic degrees of freedom. We focus on optomechanical systems where the resonator is coupled to one or more driven cavity modes by the radiation pressure interaction. We show that robust stationary entanglement between the mechanical resonator and the output fields of the cavity can be generated, and that this entanglement can be transferred to atomic ensembles placed within the cavity. These results show that optomechanical devices are interesting candidates for the realization of quantum memories and interfaces for continuous variable quantum communication networks.
A multipartite quantum system is entangled when its state cannot be factorized into a product of states or a mixture of such products. Quantum information schemes that exploit this purely quantum mechanical feature have been devised initially for systems with two discrete quantum levels (i.e., qubits), and afterward, extended to continuous-variable (CV) systems characterized by observables with continuous spectra, such as the position and momentum of a particle, or the quadratures of an electromagnetic field. Optomechanical systems, such as a driven optical cavity with vibrating end-mirrors or a classical coherent field scattering sidebands off a freely suspended mirror, hold a promise of being candidates for CV quantum information processing applications. As in most other proposals, light is the information carrier; the difference lies in the choice of a micromirror as a quantum storage device. Desired quantum states can be encoded in acoustic modes. The optomechanical coupling, owing to which quantum state transfer between radiation and mirror is possible, is realized via the radiation pressure effect, which consists in momentum transfer between field and mirror during the scattering process. The use of the vibrational modes of a micromirror as a quantum state encoder system is somehow unexpected because this is a macroscopic ensemble of atoms expected to behave rather classically. However, there are proposals that show that, in principle, the vibrational occupation number of even such a large collection of atoms in a solid can be reduced close to zero, which signifies a clear transition from the classical to the quantum regime. Remarkable progress has been made to experimentally cool the resonator by a few orders of magnitude to quite low occupation numbers. However, in order to approach the quantum limit, one needs to integrate small, light, and flexible micromechanical elements into high-finesse cavities (which are typically much more rigid and massive), which is technically challenging. Furthermore, the mechanical quality factor has to be quite high, but present microfabrication techniques yield a mechanical quality factor scaling down for smaller and smaller microresonators. This chapter starts with developing a general framework for treating the dynamics of a driven optical cavity with a vibrating end-mirror system in which two cooling techniques have been recently demonstrated: (i) cold-damping quantum feedback, where the oscillator position is measured through a phase-sensitive detection of the cavity output and the resulting photocurrent is used for a real-time correction of the dynamics, and (ii) backaction or self-cooling, in which the off-resonant operation of the cavity results in a retarded back action on the mechanical system, and hence, in a “self”-modification of its dynamics. The two situations are illustrated in Fig. 24.1. Analytical results for the final phonon number are obtained for both schemes and their applicability within today's state-of-the-art laboratory setups is analyzed.
Cavity optomechanics has become an established and equally promising branch in quantum optics. Thanks to the interaction between matter and electromagnetic radiation, it has proved to be an optimal platform for a range of scopes, from weak force sensing to the study of non-classicality of mechanical motion. Besides, the capability to isolate genuine quantum features of the interaction represents a test ground to address many important questions regarding decoherence, quantum-to-classical transitions and the interface between quantum mechanics and gravity. The first part of the research embedded in this thesis is addressed towards the clear identification and characterisation of quantum features in optomechanics. The main model we will refer to is a deformable Fabry-P\'erot cavity where one of the two mirrors moves under the radiation pressure of light. After having properly assessed the quantum peculiarities of the system, and also having revised some intakes from past literature, we will focus on the study of mechanical non-linearities, as they have been proved to be a key resource to bring out and enhance quantum properties. These investigations provide the basis to eventually propose a method to deterministically prepare and measure macroscopic quantum superposition states of the movable mirror. Such massive quantum states play a key role to inspect the foundations of physics, e.g. to test the collapse of the wave function and phenomenological models of quantum gravity, as well as to develop new enhanced quantum technologies.
In this thesis, I studied two different approaches which are promising for creating macroscopic quantum superpositions. The first approach, which is the main focus of this thesis, is based on optomechanical systems. The basic challenge to realize quantum effects in optomechanical systems, is considered to be the weak optomechanical coupling rate compared to the decoherence rates of the system caused by the cavity and mechanical damping. To enhance the optomechanical coupling it has been suggested to pump the cavity with coherent laser light \cite{Vitali07}. By this method the strong coupling regime in which the optomechanical coupling rate exceeds all decoherence rates has been demonstrated very recently \cite{Verhagen12,Groblacher09}. It is also known that the optomechanical systems may exhibit nonlinear behaviours such as bistability. After introducing the basic ideas of optomechanical systems in chapter 1, in chapter 2 we studied the connection between optomechanical entanglement and bistability. In chapter 3, we studied the drawback of using a laser to enhance the interaction. We studied the effect of the laser phase noise, as an additional decoherence channel, on the optomechanical entanglement. We have shown that the system is very sensitive to this new source of decoherence and the sensitivity is maximum in the bistable threshold. We discussed that our results are independent of how we model the laser phase noise. In chapter 4, we studied single photon optomechanics. In this regime, we proposed a new scheme to enhance the optomechanical coupling based on post selection. Our scheme is potentially promising to create a superposition of the massive oscillator in different motional states. We also discussed the potential application of our scheme to test some decoherence models. The second approach that we consider in this thesis is based on amplifying single photons with high gain to create micro-macro superpositions . In chapter 5, we discussed the De Martini scheme. We then present our scheme for creating optical micro-macro superposition and discussed its experimental realization under realistic conditions when losses are taken into account.