Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Springer eBooks

Receiver A2−A 210 to 280 GHz SIS receiver for the James Clerk Maxwell Telescope

Steven R. Davies, C. T. Cunningham, Leslie T. Little, David N. Matheson

Published Jan 4, 2007• 0 citations
Publisher
DOI
10.1007/bfb0102187

Related papers

A 100-GHz-band heterodyne sis receiver for the trao telescope

Seog‐Tae Han, Changhoon Lee, Hyo-Ryoung Kim +1 more

International Journal of Infrared and Millimeter Waves•Jan 1, 1996•7 citations

Fabrication Process SIS Junctions for 40 GHz SIS Receiver

Akira Sakamoto, Takehiro Noguchi

•Jan 1, 1996•0 citations

Development of 230 GHz finline SIS mixers for next-generation large array receivers and HARP instrument upgrade

Kuan‐Yu Liu, Boon-Kok Tan, Ming-Jye Wang +28 more

In pursuit of advancing large array receiver capabilities and enhancing the 16-element Heterodyne Array Receiver Program (HARP) instrument on the James Clerk Maxwell Telescope (JCMT), we have successfully fabricated 230 GHz finline superconductor-insulator-superconductor (SIS) mixers. These mixers are critical for assessing the potential and prospective for the HARP instrument’s upgrade. Unlike the existing HARP’s mixer, we replace the probe antenna with an end-fire unilateral finline as the waveguide to planar circuit transition. This mixer design is expected to operate from about 160–260 GHz (approximately 47% bandwidth), and the mixer chips’ current-voltage (I-V) curves have been characterized, showing promising results with a quality factor (Rsg/Rn) exceeding 9.3. Evaluation of the double-sideband (DSB) receiver noise temperature (Trx) is currently underway. Once successfully characterised, our immediate aim is to scale the mixer to operate at HARP’s frequency range near 345 GHz to achieve similar broad RF bandwidth performance. Ongoing simulations are currently being conducted for the design of the 345 GHz finline mixer. This work marks a crucial step toward enhancing HARP receiver performance with better sensitivity and wider Intermediate Frequency (IF) bandwidth, enabling higher-frequency observations, and expanding the scientific potential of the JCMT and its collaborative partners.

Millimeter, Submillimeter, and Far-Infrared Detectors and Instrumentation for Astronomy XI•Jun 14, 2024•0 citations

205 GHz SIS Receiver Development

William R. McGrath, C. N. Byrom, B. N. Ellison +4 more

Astrophysics and space science library•Jan 1, 1990•1 citation

145 GHz receiver with SIS mixer

W. Hilberath, Bernd Vowinkel

Kleinheubacher Berichte•Jan 1, 1986•0 citations

SIS mixers study on Heterodyne Array Receiver Program (HARP) at JCMT

Kuan‐Yu Liu, Ming-Jye Wang, Edward Tong +20 more

We have fabricated new superconductor-insulator-superconductor (SIS) mixers chips for the 16-element Heterodyne Array Receiver Program (HARP) instrument on the James Clerk Maxwell Telescope (JCMT). The original spare mixer chips were limited and not performed as well as the used ones in HARP. The ability to manufacture new mixer chips would therefore be important for the repair and upgrade of HARP. Our immediate goal is to replace the current nonfunctional mixers in HARP with new chips. We modified the designs of waveguide probe and the matching circuit of the SIS mixer chip. The newly designed chips were fabricated with a quality factor (Rsg/Rn) over 10. The double-sideband (DSB) receiver noise temperature (Trx) is lower than 80K at frequencies between 325 GHz and 375 GHz, which is comparable to the best of the original devices. Three of the sixteen mixers have been replaced and they work very well.

Millimeter, Submillimeter, and Far-Infrared Detectors and Instrumentation for Astronomy XI•Dec 12, 2020•1 citation
In pursuit of advancing large array receiver capabilities and enhancing the 16-element Heterodyne Array Receiver Program (HARP) instrument on the James Clerk Maxwell Telescope (JCMT), we have successfully fabricated 230 GHz finline superconductor-insulator-superconductor (SIS) mixers. These mixers are critical for assessing the potential and prospective for the HARP instrument’s upgrade. Unlike the existing HARP’s mixer, we replace the probe antenna with an end-fire unilateral finline as the waveguide to planar circuit transition. This mixer design is expected to operate from about 160–260 GHz (approximately 47% bandwidth), and the mixer chips’ current-voltage (I-V) curves have been characterized, showing promising results with a quality factor (Rsg/Rn) exceeding 9.3. Evaluation of the double-sideband (DSB) receiver noise temperature (Trx) is currently underway. Once successfully characterised, our immediate aim is to scale the mixer to operate at HARP’s frequency range near 345 GHz to achieve similar broad RF bandwidth performance. Ongoing simulations are currently being conducted for the design of the 345 GHz finline mixer. This work marks a crucial step toward enhancing HARP receiver performance with better sensitivity and wider Intermediate Frequency (IF) bandwidth, enabling higher-frequency observations, and expanding the scientific potential of the JCMT and its collaborative partners.
We have fabricated new superconductor-insulator-superconductor (SIS) mixers chips for the 16-element Heterodyne Array Receiver Program (HARP) instrument on the James Clerk Maxwell Telescope (JCMT). The original spare mixer chips were limited and not performed as well as the used ones in HARP. The ability to manufacture new mixer chips would therefore be important for the repair and upgrade of HARP. Our immediate goal is to replace the current nonfunctional mixers in HARP with new chips. We modified the designs of waveguide probe and the matching circuit of the SIS mixer chip. The newly designed chips were fabricated with a quality factor (Rsg/Rn) over 10. The double-sideband (DSB) receiver noise temperature (Trx) is lower than 80K at frequencies between 325 GHz and 375 GHz, which is comparable to the best of the original devices. Three of the sixteen mixers have been replaced and they work very well.