Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Journal of Systems Engineering and Electronics

Design of good QC-LDPC codes without small girth in the p-plane

Lingjun Kong, Yang Xiao

Published Apr 1, 2011• 4 citations
Publisher

Abstract

A construction method based on the p-plane to design high-girth quasi-cyclic low-density parity-check (QC-LDPC) codes is proposed. Firstly the good points in every line of the p-plane can be ascertained through filtering the bad points, because the designed parity-check matrixes using these points have the short cycles in Tanner graph of codes. Then one of the best points from the residual good points of every line in the p-plane will be found, respectively. The optimal point is also singled out according to the bit error rate (BER) performance of the QC-LDPC codes at last. Explicit necessary and sufficient conditions for the QC-LDPC codes to have no short cycles are presented which are in favor of removing the bad points in the p-plane. Since preventing the short cycles also prevents the small stopping sets, the proposed construction method also leads to QC-LDPC codes with a higher stopping distance.

DOI
10.3969/j.issn.1004-4132.2011.02.001

Related papers

Construction of Quasi-Cyclic LDPC Codes Without Small Stopping Sets and Small Cycles

Yang Xiao

The existing design of quasi-cyclic low-density parity-check(short for QC-LDPC) codes has not considered the problems of small stopping sets and small cycles together,while their existences will lead to the BER performance of QC-LDPC codes to be much poorer than that of the randomly constructed LDPC codes even decoding failure.To solve the problem,some theorems of the QC-LDPC codes without small stopping sets and small cycles were proposed which provide a theoretical basis for the construction of parity-check matrix by analysis method;meanwhile,good QC-LDPC codes without small stopping sets and small cycles were designed.Since preventing the small stopping sets and small cycles also prevents a low minimum distance,our construction method also leads to QC-LDPC codes with a higher minimum distance.The simulation results show that the QC-LDPC codes can effectively avoid specified stopping sets and small cycles and achieve good coding and decoding property due to the proposed constructions.

Journal of Beijing Jiaotong University•Jan 1, 2010•0 citations

Construction of good quasi-cyclic LDPC codes based on the row vectors of generator matrix

Lingjun Kong, Yang Xiao

The existing construction of Quasi-Cyclic low-density parity-check (short for QC-LDPC) codes has not considered the problems of small stopping sets and small girth and small minimum code weight together, while their existences will lead to the BER performance of QC-LDPC codes to be much poorer than that of randomly constructed LDPC codes even decoding failure. To solve the problem, some theorems of the QC-LDPC codes without small stopping sets and small girth were proposed first. Then good QC-LDPC codes without small stopping sets and small girth were designed based on the row vectors of generator matrix. The small minimum code weight also can be prevented due to the new algorithm based on the row vectors of generator matrix, which is the new way to choose the shifted factors to construct the good QC-LDPC codes for the given prime. The effectiveness and the practicability of the algorithm are demonstrated by the simulation results. It is significant for us to analyze and optimize the design of LDPC codes.

IET International Conference on Wireless, Mobile and Multimedia Networks (ICWMMN)•Jan 1, 2008•1 citation

Quasi-Cyclic Low-Density Parity-Check Codes Based on Progressive Cycle Growth Algorithm

Yuanhua Liu, Meiling Zhang, Niu Xin-Liang

Short cycles in the Tanner graph of a given LDPC code has negative effect on the performance of iterative decoding. To improve the performance, we presented an approach for constructing Quasi-Cyclic Low-Density Parity-Check (QC-LDPC) codes whose associated Tanner graph has large girth and a small amount of short cycles. Each column block of the parity check matrix was designed by adding circulant permutation sub-matrices one after another, provided the current parity check matrix has minimal number of short cycles. The condition for the proposed QC-LDPC codes to have girth at least 6 was also analyzed. Regular and irregular QC-LDPC codes with various lengths and rates can be constructed. Simulations show that the proposed QC-LDPC codes have less short cycles and better performance than existing progressive edge growth based QC-LDPC codes.

International Conference on Instrumentation and Measurement, Computer, Communication and Control (IMCCC)•Jul 1, 2016•1 citation

Design of good quasi-cyclic LDPC codes

Xu Dan

The existing design of quasi-cyclic(QC) low-density parity-check(LDPC) codes has not considered the problems of short length girths and the rows' dependency.The first problem leads to the BER performance of QC LDPC codes to be much poorer than that of randomly constructed LDPC codes,while the second problem leads to the difficulty of construction of generator matrices from parity-check matrices.To solve the first problem,the constraint conditions for designing the QC LDPC codes are proposed,and the dimension and shift factors of the circulant matrices of the given sparse parity-check matrix are adjusted according to the test results of both girth 4 and girth 6.To solve the second problem,an approach of irregular QC LDPC codes is proposed.The proposed approach is to replace some sub-matrices by zero matrices and identity matrices at special positions in the given sparse parity-check matrix so as to get a nonsingular square matrix for the construction of the generator matrix.Though adopting bidiagonal submatrices in parity-check matrix can solve the rows' dependency problem,many code words with low weights will occur,which leads to the BER performance can not be better by increasing code lengths.Examples are provided for the proposed design of QC LDPC codes,and computer simulation results show that the proposed QC LDPC codes achieve good BER performance.

Systems engineering and electronics•Jan 1, 2009•1 citation

The Design of Structured Low-Density Parity-Check Codes With Large Girth

Jing Long

This paper,based on algebra and graph,proposes a method for constructing structured low-density parity-check(LDPC) codes.In this method,the authors design a connected graph with three kinds of special path to ensure that the Tanner graph of the parity check matrix mapped from the connected graph is without short cycles.The construction method results in two classes of(3,k)-regular quasi-cyclic LDPC codes with girth 8 and 12 respectively.Furthermore,by extending this construction method,two classes of LDPC codes with column weight 2,whose girths are respectively 16 and 24,can be obtained.The simulation studies show that these codes can achieve better performance than randomly constructed regular LDPC codes over AWGN channels with iterative decoding.At the BER of 10-5,the new proposed(3,6)-regular(4356,2205) QC-LDPC code performs 1.48dB from the Shannon limit.Moreover,it outperforms the random regular LDPC code of comparable parameters by 0.1dB.For the new proposed structured LDPC codes with column weight 2,they can achieve about 2dB coding gains with respect to the random regular LDPC codes with similar block lengths and code rates.

Chinese Journal of Computers•Jan 1, 2007•1 citation

Construction of quasi-cyclic low-density parity-check codes using Hamming codewords

Haijing Zhong, Shancheng Zhao, Li Chen +1 more

In this paper, we propose a new approach to construct quasi-cyclic low-density parity-check (QC-LDPC) codes using Hamming codewords of weight three, namely the HM-QC-LDPC codes. Thanks to the distance property of Hamming codes, length four cycles are avoided from the Tanner graph of the constructed codes, resulting in codes of girth six. This approach can be further extended to construct QC-LDPC codes of girth eight. Our numerical results show that the proposal has a better cycle profile than the progressive-edge-growth (PEG) constructed codes, and consequently prevails in performance. Moreover, the constructed QC-LDPC code prevails the LDPC code of the IEEE802.22 standard by 0.2 dB at the bit error rate (BER) of 10-8when the codeword length is within hundreds of bits, making it a promising candidate for scenarios where strict decoding latency is imposed.

International Conference on Wireless Communications and Signal Processing (WCSP)•Oct 1, 2016•1 citation
A construction method based on the p-plane to design high-girth quasi-cyclic low-density parity-check (QC-LDPC) codes is proposed. Firstly the good points in every line of the p-plane can be ascertained through filtering the bad points, because the designed parity-check matrixes using these points have the short cycles in Tanner graph of codes. Then one of the best points from the residual good points of every line in the p-plane will be found, respectively. The optimal point is also singled out according to the bit error rate (BER) performance of the QC-LDPC codes at last. Explicit necessary and sufficient conditions for the QC-LDPC codes to have no short cycles are presented which are in favor of removing the bad points in the p-plane. Since preventing the short cycles also prevents the small stopping sets, the proposed construction method also leads to QC-LDPC codes with a higher stopping distance.
The existing design of quasi-cyclic low-density parity-check(short for QC-LDPC) codes has not considered the problems of small stopping sets and small cycles together,while their existences will lead to the BER performance of QC-LDPC codes to be much poorer than that of the randomly constructed LDPC codes even decoding failure.To solve the problem,some theorems of the QC-LDPC codes without small stopping sets and small cycles were proposed which provide a theoretical basis for the construction of parity-check matrix by analysis method;meanwhile,good QC-LDPC codes without small stopping sets and small cycles were designed.Since preventing the small stopping sets and small cycles also prevents a low minimum distance,our construction method also leads to QC-LDPC codes with a higher minimum distance.The simulation results show that the QC-LDPC codes can effectively avoid specified stopping sets and small cycles and achieve good coding and decoding property due to the proposed constructions.
The existing construction of Quasi-Cyclic low-density parity-check (short for QC-LDPC) codes has not considered the problems of small stopping sets and small girth and small minimum code weight together, while their existences will lead to the BER performance of QC-LDPC codes to be much poorer than that of randomly constructed LDPC codes even decoding failure. To solve the problem, some theorems of the QC-LDPC codes without small stopping sets and small girth were proposed first. Then good QC-LDPC codes without small stopping sets and small girth were designed based on the row vectors of generator matrix. The small minimum code weight also can be prevented due to the new algorithm based on the row vectors of generator matrix, which is the new way to choose the shifted factors to construct the good QC-LDPC codes for the given prime. The effectiveness and the practicability of the algorithm are demonstrated by the simulation results. It is significant for us to analyze and optimize the design of LDPC codes.
Short cycles in the Tanner graph of a given LDPC code has negative effect on the performance of iterative decoding. To improve the performance, we presented an approach for constructing Quasi-Cyclic Low-Density Parity-Check (QC-LDPC) codes whose associated Tanner graph has large girth and a small amount of short cycles. Each column block of the parity check matrix was designed by adding circulant permutation sub-matrices one after another, provided the current parity check matrix has minimal number of short cycles. The condition for the proposed QC-LDPC codes to have girth at least 6 was also analyzed. Regular and irregular QC-LDPC codes with various lengths and rates can be constructed. Simulations show that the proposed QC-LDPC codes have less short cycles and better performance than existing progressive edge growth based QC-LDPC codes.
The existing design of quasi-cyclic(QC) low-density parity-check(LDPC) codes has not considered the problems of short length girths and the rows' dependency.The first problem leads to the BER performance of QC LDPC codes to be much poorer than that of randomly constructed LDPC codes,while the second problem leads to the difficulty of construction of generator matrices from parity-check matrices.To solve the first problem,the constraint conditions for designing the QC LDPC codes are proposed,and the dimension and shift factors of the circulant matrices of the given sparse parity-check matrix are adjusted according to the test results of both girth 4 and girth 6.To solve the second problem,an approach of irregular QC LDPC codes is proposed.The proposed approach is to replace some sub-matrices by zero matrices and identity matrices at special positions in the given sparse parity-check matrix so as to get a nonsingular square matrix for the construction of the generator matrix.Though adopting bidiagonal submatrices in parity-check matrix can solve the rows' dependency problem,many code words with low weights will occur,which leads to the BER performance can not be better by increasing code lengths.Examples are provided for the proposed design of QC LDPC codes,and computer simulation results show that the proposed QC LDPC codes achieve good BER performance.
This paper,based on algebra and graph,proposes a method for constructing structured low-density parity-check(LDPC) codes.In this method,the authors design a connected graph with three kinds of special path to ensure that the Tanner graph of the parity check matrix mapped from the connected graph is without short cycles.The construction method results in two classes of(3,k)-regular quasi-cyclic LDPC codes with girth 8 and 12 respectively.Furthermore,by extending this construction method,two classes of LDPC codes with column weight 2,whose girths are respectively 16 and 24,can be obtained.The simulation studies show that these codes can achieve better performance than randomly constructed regular LDPC codes over AWGN channels with iterative decoding.At the BER of 10-5,the new proposed(3,6)-regular(4356,2205) QC-LDPC code performs 1.48dB from the Shannon limit.Moreover,it outperforms the random regular LDPC code of comparable parameters by 0.1dB.For the new proposed structured LDPC codes with column weight 2,they can achieve about 2dB coding gains with respect to the random regular LDPC codes with similar block lengths and code rates.
In this paper, we propose a new approach to construct quasi-cyclic low-density parity-check (QC-LDPC) codes using Hamming codewords of weight three, namely the HM-QC-LDPC codes. Thanks to the distance property of Hamming codes, length four cycles are avoided from the Tanner graph of the constructed codes, resulting in codes of girth six. This approach can be further extended to construct QC-LDPC codes of girth eight. Our numerical results show that the proposal has a better cycle profile than the progressive-edge-growth (PEG) constructed codes, and consequently prevails in performance. Moreover, the constructed QC-LDPC code prevails the LDPC code of the IEEE802.22 standard by 0.2 dB at the bit error rate (BER) of 10-8when the codeword length is within hundreds of bits, making it a promising candidate for scenarios where strict decoding latency is imposed.