Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Springer series in optical sciences/SPringer series in optical sciences

Stopping Atoms with Diode Lasers

Richard N. Watts, Carl Wieman

Published Jan 1, 1985• 0 citations
Publisher
DOI
10.1007/978-3-540-39664-2_6

Related papers

Stopping Atoms with Diode Lasers (With 2 Figures)

Richard N. Watts, Carl Wieman

•Jan 1, 1985•0 citations

From Diode Laser to Atom Laser

Tilman Esslinger, Immanuel Bloch

Springer eBooks•Jan 1, 2002•0 citations

La température limite d'un jet atomique de césium ralenti par diode laser

Jean Dalibard, Christophe Salomon

The velocity distribution ofcesium atoms decelmated by a laser diode is measwed using a dye lasm with a narrow spectral width. The "stopped atoms" density is four times greatm than that ofthe free atomic beam at maximum of the Doppler distribution. The average quadratic velocity of these stopped atoms is 3 m/s, and is much lower than the width of the velocity class resonant with the lasm diode (25 m/s). The cooling observed is in good agreement with the simple theoretical mode1 presented in this Note. The possibility of using a "three-frequency" diode is also demonstrated.

•Jan 1, 1988•0 citations

Using diode lasers for atomic physics

Carl Wieman, Leo W. Hollberg

WORLD SCIENTIFIC eBooks•Jan 1, 2008•5 citations

The Diode Laser Manipulation Of Cesium Atoms (polarization, Stopping).

Richard N. Watts

The results of two experiments involving the rapid frequency modulation of diode lasers are presented. In the first experiment, a cesium beam of 10('14) atoms/sec is produced with more than 98% of the atoms in a single spin state. The beam is polarized by optically pumping it with a single diode laser whose frequency is switched between the 6s(F = 4)-6p(,3/2)(F = 5) and 6s(F = 3)-6p(,3/2)(F = 4) transitions at 100 kHz. To do this, the frequency response of a diode laser to changes in injection current was first determined and the injection current modified to force a jump of 9.2 GHz in 1.5 (mu)sec. The same laser is used to probe the atomic population distribution simultaneously. In the second experiment, two diode lasers, tuned to the 6s(F = 4)-6p(,3/2)(F = 5) and 6s(F = 3)-6p(,3/2)(F = 4) transitions, are used to cool and stop a beam of cesium atoms. The laser frequencies are swept to keep them in resonance with the slowing atoms. The same lasers are used to probe the resulting velocity distribution. More than 10('10) atoms/sec are slowed to a velocity of 0 (+OR-) 15 m/sec, corresponding to a temperature of 1(DEGREES)K. Both of these experiments demonstrate extremely simple and inexpensive ways to manipulate atomic cesium.

•Jan 1, 1986•0 citations

Cooling cesium atoms using diode lasers

Carl Wieman, R. N. Watts

We have cooled and stopped a beam of cesium atoms using frequency chirped diode lasers. In this technique, a moving atom absorbs and reemits many photons from a counter propagating laser that is frequency swept to keep it in resonance with an atomic transition. The resulting momentum transfer slows the atom. The basic approach is identical to that developed by Hall and co-workers, however, the use of diode lasers allows us to obtain the necessary frequency modulation simply by sweeping the laser injection current. We use two diode lasers tuned to each of the 6s hyperfine ground state levels to drive the 6s—6p3/2 transitions. Each laser is simultaneously swept over the Doppler profile of the 100°C thermal cesium beam to bring a substantial number to a stop. Using additional fast frequency modulation, the same lasers are used to probe the resulting velocity distribution. This technique allows us to bring ~106 atoms/cm3 to a temperature of 1 K. This method is an extremely simple and inexpensive way to produce cold atoms.

International Laser Science Conference•Jan 1, 1986•0 citations
The velocity distribution ofcesium atoms decelmated by a laser diode is measwed using a dye lasm with a narrow spectral width. The "stopped atoms" density is four times greatm than that ofthe free atomic beam at maximum of the Doppler distribution. The average quadratic velocity of these stopped atoms is 3 m/s, and is much lower than the width of the velocity class resonant with the lasm diode (25 m/s). The cooling observed is in good agreement with the simple theoretical mode1 presented in this Note. The possibility of using a "three-frequency" diode is also demonstrated.
The results of two experiments involving the rapid frequency modulation of diode lasers are presented. In the first experiment, a cesium beam of 10('14) atoms/sec is produced with more than 98% of the atoms in a single spin state. The beam is polarized by optically pumping it with a single diode laser whose frequency is switched between the 6s(F = 4)-6p(,3/2)(F = 5) and 6s(F = 3)-6p(,3/2)(F = 4) transitions at 100 kHz. To do this, the frequency response of a diode laser to changes in injection current was first determined and the injection current modified to force a jump of 9.2 GHz in 1.5 (mu)sec. The same laser is used to probe the atomic population distribution simultaneously. In the second experiment, two diode lasers, tuned to the 6s(F = 4)-6p(,3/2)(F = 5) and 6s(F = 3)-6p(,3/2)(F = 4) transitions, are used to cool and stop a beam of cesium atoms. The laser frequencies are swept to keep them in resonance with the slowing atoms. The same lasers are used to probe the resulting velocity distribution. More than 10('10) atoms/sec are slowed to a velocity of 0 (+OR-) 15 m/sec, corresponding to a temperature of 1(DEGREES)K. Both of these experiments demonstrate extremely simple and inexpensive ways to manipulate atomic cesium.
We have cooled and stopped a beam of cesium atoms using frequency chirped diode lasers. In this technique, a moving atom absorbs and reemits many photons from a counter propagating laser that is frequency swept to keep it in resonance with an atomic transition. The resulting momentum transfer slows the atom. The basic approach is identical to that developed by Hall and co-workers, however, the use of diode lasers allows us to obtain the necessary frequency modulation simply by sweeping the laser injection current. We use two diode lasers tuned to each of the 6s hyperfine ground state levels to drive the 6s—6p3/2 transitions. Each laser is simultaneously swept over the Doppler profile of the 100°C thermal cesium beam to bring a substantial number to a stop. Using additional fast frequency modulation, the same lasers are used to probe the resulting velocity distribution. This technique allows us to bring ~106 atoms/cm3 to a temperature of 1 K. This method is an extremely simple and inexpensive way to produce cold atoms.