Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Quantum Tomography with Phase Space Measurements

Jussi Schultz

Published Aug 17, 2012• 0 citations
OpenAlex

Abstract

This thesis addresses the use of covariant phase space observables in quantum tomography. Necessary and sufficient conditions for the informational completeness of covariant phase space observables are proved, and some state reconstruction formulae are derived. Different measurement schemes for measuring phase space observables are considered. Special emphasis is given to the quantum optical eight-port homodyne detection scheme and, in particular, on the effect of non-unit detector efficiencies on the measured observable. It is shown that the informational completeness of the observable does not depend on the efficiencies. As a related problem, the possibility of reconstructing the position and momentum distributions from the marginal statistics of a phase space observable is considered. It is shown that informational completeness for the phase space observable is neither necessary nor sufficient for this procedure. Two methods for determining the distributions from the marginal statistics are presented. Finally, two alternative methods for determining the state are considered. Some of their shortcomings when compared to the phase space method are discussed.

Related papers

Homodyne Tomography and the Reconstruction of Quantum States of Light

Giacomo Mauro D’Ariano, Lorenzo Maccone, Massimiliano Federico Sacchi

Quantum tomography is a procedure to determine the quantum state of a physical system, or equivalently, to estimate the expectation value of any operator. It consists in appropriately averaging the outcomes of the measurement results of different observables, obtained on identical copies of the same system. Alternatively, it consists in maximizing an appropriate likelihood function defined on the same data. The procedure can be also used to completely characterize an unknown apparatus. Here we focus on the electromagnetic field, where the tomographic observables are obtained from homodyne detection.

arXiv:quant-ph/0507078•IMPERIAL COLLEGE PRESS eBooks•Feb 1, 2007•8 citations

Moment Operators of Observables in Quantum Mechanics, with Applications to Quantization and Homodyne Detection

Jukka Kiukas

The questions studied in this thesis are centered around the moment operators of a quantum observable, the latter being represented by a normalized positive operator measure. The moment operators of an observable are physically relevant, in the sense that these operators give, as averages, the moments of the outcome statistics for the measurement of the observable. The main questions under consideration in this work arise from the fact that, unlike a projection valued observable of the von Neumann formulation, a general positive operator measure cannot be characterized by its first moment operator. The possibility of characterizing certain observables by also involving higher moment operators is investigated and utilized in three different cases: a characterization of projection valued measures among all the observables is given, a quantization scheme for unbounded classical variables using translation covariant phase space operator measures is presented, and, finally, a mathematically rigorous description is obtained for the measurements of rotated quadratures and phase space observables via the high amplitude limit in the balanced homodyne and eight-port homodyne detectors, respectively. In addition, the structure of the covariant phase space operator measures, which is essential for the above quantization, is analyzed in detail in the context of a (not necessarily unimodular) locally compact group as the phase space.

•Jan 19, 2008•1 citation

Realistic eight-port homodyne detection and covariant phase space observables

PEKKA J. LAHTI, Juha-Pekka Pellonpää, Jussi Schultz

We consider the quantum optical eight-port homodyne detection scheme in the case that each of the associated photon detectors is assigned with a different quantum efficiency. We give a mathematically rigorous and strictly quantum mechanical proof of the fact that the measured observable (positive operator measure) in the high-amplitude limit is a smearing of the covariant phase space observable related to the ideal measurement, that is, the measurement performed with fully efficient detectors. The result is proved for an arbitary parameter field. Furthermore, we investigate some properties of the measured observable. In particular, we show that detector inefficiencies do not affect the observable's ability to distinguish between different states.

arXiv:1004.5006•Journal of Modern Optics•Jul 20, 2010•9 citations

Tasks and premises in quantum state determination

Claudio Carmeli, Teiko Heinosaari, Jussi Schultz +1 more

The purpose of quantum tomography is to determine an unknown quantum state from measurement outcome statistics. There are two obvious ways to generalize this setting. First, our task need not be the determination of any possible input state but only some input states, for instance pure states. Second, we may have some prior information, or premise, which guarantees that the input state belongs to some subset of states, for instance the set of states with rank less than half of the dimension of the Hilbert space. We investigate state determination under these two supplemental features, concentrating on the cases where the task and the premise are statements about the rank of the unknown state. We characterize the structure of quantum observables (positive operator valued measures) that are capable of fulfilling these type of determination tasks. After the general treatment we focus on the class of covariant phase space observables, thus providing physically relevant examples of observables both capable and incapable of performing these tasks. In this context, the effect of noise is discussed.

arXiv:1308.5502•Journal of Physics A Mathematical and Theoretical•Feb 3, 2014•24 citations

Statistical analysis of sampling methods in quantum tomography

T. Kiesel

In quantum physics, all measured observables are subject to statistical uncertainties, which arise from the quantum nature as well as the experimental technique. We consider the statistical uncertainty of the so-called sampling method, in which one estimates the expectation value of a given observable by empirical means of suitable pattern functions. We show that if the observable can be written as a function of a single directly measurable operator, the variance of the estimate from the sampling method equals to the quantum-mechanical one. In this sense, we say that the estimate is on the quantum-mechanical level of uncertainty. In contrast, if the observable depends on noncommuting operators (e.g., different quadratures), the quantum-mechanical level of uncertainty is not achieved. The impact of the results on quantum tomography is discussed, and different approaches to quantum tomographic measurements are compared. It is shown explicitly for the estimation of quasiprobabilities of a quantum state, that balanced homodyne tomography does not operate on the quantum-mechanical level of uncertainty, while the unbalanced homodyne detection does.

arXiv:1201.5612•Physical Review A•May 17, 2012•8 citations

Data pattern tomography: reconstruction with an unknown apparatus

Dmitri S. Mogilevtsev, Alexandr Ignatenko, А. С. Малоштан +3 more

We propose a scheme for the reconstruction of the quantum state without a priori knowledge about the measurement setup. Using the data pattern approach, we develop an iterative procedure for obtaining information about the measurement which is sufficient for an estimation of a particular signal state. The method is illustrated with the examples of reconstruction with on/off detection and quantum homodyne tomography.

New Journal of Physics•Feb 27, 2013•34 citations
This thesis addresses the use of covariant phase space observables in quantum tomography. Necessary and sufficient conditions for the informational completeness of covariant phase space observables are proved, and some state reconstruction formulae are derived. Different measurement schemes for measuring phase space observables are considered. Special emphasis is given to the quantum optical eight-port homodyne detection scheme and, in particular, on the effect of non-unit detector efficiencies on the measured observable. It is shown that the informational completeness of the observable does not depend on the efficiencies. As a related problem, the possibility of reconstructing the position and momentum distributions from the marginal statistics of a phase space observable is considered. It is shown that informational completeness for the phase space observable is neither necessary nor sufficient for this procedure. Two methods for determining the distributions from the marginal statistics are presented. Finally, two alternative methods for determining the state are considered. Some of their shortcomings when compared to the phase space method are discussed.
Quantum tomography is a procedure to determine the quantum state of a physical system, or equivalently, to estimate the expectation value of any operator. It consists in appropriately averaging the outcomes of the measurement results of different observables, obtained on identical copies of the same system. Alternatively, it consists in maximizing an appropriate likelihood function defined on the same data. The procedure can be also used to completely characterize an unknown apparatus. Here we focus on the electromagnetic field, where the tomographic observables are obtained from homodyne detection.
The questions studied in this thesis are centered around the moment operators of a quantum observable, the latter being represented by a normalized positive operator measure. The moment operators of an observable are physically relevant, in the sense that these operators give, as averages, the moments of the outcome statistics for the measurement of the observable. The main questions under consideration in this work arise from the fact that, unlike a projection valued observable of the von Neumann formulation, a general positive operator measure cannot be characterized by its first moment operator. The possibility of characterizing certain observables by also involving higher moment operators is investigated and utilized in three different cases: a characterization of projection valued measures among all the observables is given, a quantization scheme for unbounded classical variables using translation covariant phase space operator measures is presented, and, finally, a mathematically rigorous description is obtained for the measurements of rotated quadratures and phase space observables via the high amplitude limit in the balanced homodyne and eight-port homodyne detectors, respectively. In addition, the structure of the covariant phase space operator measures, which is essential for the above quantization, is analyzed in detail in the context of a (not necessarily unimodular) locally compact group as the phase space.
We consider the quantum optical eight-port homodyne detection scheme in the case that each of the associated photon detectors is assigned with a different quantum efficiency. We give a mathematically rigorous and strictly quantum mechanical proof of the fact that the measured observable (positive operator measure) in the high-amplitude limit is a smearing of the covariant phase space observable related to the ideal measurement, that is, the measurement performed with fully efficient detectors. The result is proved for an arbitary parameter field. Furthermore, we investigate some properties of the measured observable. In particular, we show that detector inefficiencies do not affect the observable's ability to distinguish between different states.
The purpose of quantum tomography is to determine an unknown quantum state from measurement outcome statistics. There are two obvious ways to generalize this setting. First, our task need not be the determination of any possible input state but only some input states, for instance pure states. Second, we may have some prior information, or premise, which guarantees that the input state belongs to some subset of states, for instance the set of states with rank less than half of the dimension of the Hilbert space. We investigate state determination under these two supplemental features, concentrating on the cases where the task and the premise are statements about the rank of the unknown state. We characterize the structure of quantum observables (positive operator valued measures) that are capable of fulfilling these type of determination tasks. After the general treatment we focus on the class of covariant phase space observables, thus providing physically relevant examples of observables both capable and incapable of performing these tasks. In this context, the effect of noise is discussed.
In quantum physics, all measured observables are subject to statistical uncertainties, which arise from the quantum nature as well as the experimental technique. We consider the statistical uncertainty of the so-called sampling method, in which one estimates the expectation value of a given observable by empirical means of suitable pattern functions. We show that if the observable can be written as a function of a single directly measurable operator, the variance of the estimate from the sampling method equals to the quantum-mechanical one. In this sense, we say that the estimate is on the quantum-mechanical level of uncertainty. In contrast, if the observable depends on noncommuting operators (e.g., different quadratures), the quantum-mechanical level of uncertainty is not achieved. The impact of the results on quantum tomography is discussed, and different approaches to quantum tomographic measurements are compared. It is shown explicitly for the estimation of quasiprobabilities of a quantum state, that balanced homodyne tomography does not operate on the quantum-mechanical level of uncertainty, while the unbalanced homodyne detection does.