© 2026 Aqora Quantum S.A.S.

Terms Privacy Legal Notice

arXiv:2610.04063

Energy-filtered readout preserves gap-enhanced sensing in interacting quantum dots

Shirwan Abdullah

quant-phcond-mat.mes-hallSubmitted Oct 2, 2026• Announced Oct 6, 2026• 0 citations

Abstract

A small excitation gap makes a quantum dot a sensitive probe of a weak electric field, but the charge detector that reads the probe can also excite it. We ask how much of this gap enhancement survives continuous readout, for two interacting electrons tuned through a confinement-driven crossover in a gate-defined quantum dot, using a weak-coupling, stationary two-level model. The answer depends on the energy structure of the detector, not only on its noise. A quantum point contact measures more strongly at higher bias, but once the bias energy exceeds the gap it also excites the probe. When this back-action dominates the probe's own relaxation, the optimised mean-current information rate grows only as the inverse of the gap. A sensor quantum dot with a narrow level instead reaches full measurement strength at a bias below the gap, where, for a non-interacting detector and to second order in the coupling, it cannot excite the probe at zero temperature. This energy-filtered readout keeps the inverse-square gap dependence of the quantum Fisher information, down to a gap set by the detector's level width and the electron temperature. Through such a detector the interacting pair gives about three times the information rate of a single electron with the same gap and detector, compared with 1.6-1.7 in the quantum Fisher information, for both contact and Coulomb-type interactions. These different gap dependences, and the different optimal biases of the two detectors, can be tested by bias and gate sweeps on suitably tuned charge-sensed double dots.

Comments: 17 pages, 5 figures

Related papers

Spin-split excitation gap and spin entanglement of a pair of interacting electrons in a quantum dot

Godfrey A. Gumbs, Danhong Huang, M. D. Blumenthal +3 more

We calculate the energy eigenvalues, the spin-split excitation gap (energy separation between the spin-triplet excited state and the spin-singlet ground state) and the concurrence for two interacting electrons captured in a quantum dot (QD) formed by a gigahertz electron pump which is modeled by harmonic confining potentials. We find from our calculations a peak in the QD size dependence of the energy level for the spin-singlet ground state, indicating the effect due to Coulomb blockade. In addition, we observe a local minimum in the QD size dependence of the spin-split excitation gap for a relatively narrow quasi-one-dimensional (1D) channel formed from an etched wire, but a strong positive peak for the spin-split excitation gap in its QD size dependence with a relatively wide 1D channel. From the existence of a robust spin-split excitation gap against both thermal fluctuation due to finite (low) temperatures and the nonadiabatic effect due to fast barrier variations, we predict a spin-entangled electron pair inside the QD with a weak coupling to external leads. An interference-type experiment which employs a gate-controlled electron pump and a beam splitter is proposed to verify this prediction. For the electron pump, a sinusoidal radio-frequency signal is applied to the entrance gate of a two-gated system over a narrow channel etched in a GaAs/AlGaAs heterostructure, where the measured current within the channel shows plateaus at Nef with N = 1, 2,... being the number of captured electrons in a QD and f the frequency of the sinusoidal signal.

Semiconductor Science and Technology•Oct 6, 2009•7 citations

Telegraph Noise in Coupled Quantum Dot Circuits Induced by a Quantum Point Contact

D. Taubert, Michel Pioro-Ladrière, D. Schröer +3 more

Charge detection utilizing a highly biased quantum point contact has become the most effective probe for studying few electron quantum dot circuits. Measurements on double and triple quantum dot circuits is performed to clarify a back action role of charge sensing on the confined electrons. The quantum point contact triggers inelastic transitions, which occur quite generally. Under specific device and measurement conditions these transitions manifest themselves as bounded regimes of telegraph noise within a stability diagram. A nonequilibrium transition from artificial atomic to molecular behavior is identified. Consequences for quantum information applications are discussed.

arXiv:0801.4002•Physical Review Letters•May 2, 2008•46 citations

Backaction dephasing by a quantum dot detector

Toshihiro Kubo, 康弘都倉

We derive an analytical expression for the backaction dephasing rate, which characterizes the disturbance induced by coupling with an environment containing a quantum dot detector (QDD). In this paper, we show in an explicit form that the charge noise induces backaction dephasing. In equilibrium, this backaction dephasing induced by the charge noise can be explained as a relaxation by an inelastic electron-electron scattering in Fermi-liquid theory. Unlike the quantum point contact, the backaction dephasing rate increases or decreases with the bias at low bias and finite-temperature condition. This behavior depends on the QDD energy level with respect to the Fermi energy and the asymmetry of the QDD coupling to the reservoirs. In the high bias voltage regime, the dephasing rate becomes insensitive to the bias because of the saturation of the charge noise.

arXiv:1210.3089•Physical Review B•Oct 4, 2013•2 citations

Fermion-parity qubit in a proximitized double quantum dot

Max Geier, Rubén Seoane Souto, Jens Schulenborg +3 more

Bound states in quantum dots coupled to superconductors can be in a coherent superposition of states with different electron number but with the same fermion parity. Electrostatic gating can tune this superposition to a sweet spot, where the quantum dot has the same mean electric charge independent of its electron-number parity. Here, we propose to encode quantum information in the local fermion parity of two tunnel-coupled quantum dots embedded in a Josephson junction. At the sweet spot, the qubit states have zero charge dipole moment. This protects the qubit from dephasing due to charge noise acting on the potential of each dot, as well as fluctuations of the (weak) interdot tunneling. At weak interdot tunneling, relaxation is suppressed because of disjoint qubit states. However, for strong interdot tunneling the system is protected against noise affecting each quantum dot separately (energy-level noise, dot-superconductor tunneling fluctuations, and hyperfine interactions). Finally, we describe initialization and readout as well as single-qubit and two-qubit gates by pulsing gate voltages. Published by the American Physical Society 2024

arXiv:2307.05678•Physical Review Research•Jun 17, 2024•20 citations

Error detection in a tunable-barrier electron pump

S. P. Giblin, Patrick See, J. D. Fletcher +5 more

We measure the average number of electrons loaded into an electrostatically-defined quantum dot (QD) operated as a tunable-barrier electron pump, using a point-contact (PC) charge sensor 1 micron away from the QD. The measurement of the electron number probes the QD loading dynamics even in the limit of slow gate voltage rise-times, when the pumped current is too small to measure. Using simulations we show that, with optimised QD-PC coupling, the experiment can make single-shot measurements of the number of electrons in the QD with sufficiently high fidelity to test the error rate of the electron pump with metrological precision.

arXiv:1809.10249•Sep 26, 2018•0 citations

Dispersive Readout of a Few-Electron Double Quantum Dot with Fast rf Gate Sensors

James Colless, Alice Mahoney, J. M. Hornibrook +4 more

We report the dispersive charge-state readout of a double quantum dot in the few-electron regime using the in situ gate electrodes as sensitive detectors. We benchmark this gate sensing technique against the well established quantum point contact charge detector and find comparable performance with a bandwidth of $\ensuremath{\sim}10\text{ }\text{ }\mathrm{MHz}$ and an equivalent charge sensitivity of $\ensuremath{\sim}6.3\ifmmode\times\else\texttimes\fi{}{10}^{\ensuremath{-}3}\text{ }\text{ }e/\sqrt{\mathrm{Hz}}$. Dispersive gate sensing alleviates the burden of separate charge detectors for quantum dot systems and promises to enable readout of qubits in scaled-up arrays.

arXiv:1210.4645•Physical Review Letters•Jan 25, 2013•211 citations

A small excitation gap makes a quantum dot a sensitive probe of a weak electric field, but the charge detector that reads the probe can also excite it. We ask how much of this gap enhancement survives continuous readout, for two interacting electrons tuned through a confinement-driven crossover in a gate-defined quantum dot, using a weak-coupling, stationary two-level model. The answer depends on the energy structure of the detector, not only on its noise. A quantum point contact measures more strongly at higher bias, but once the bias energy exceeds the gap it also excites the probe. When this back-action dominates the probe's own relaxation, the optimised mean-current information rate grows only as the inverse of the gap. A sensor quantum dot with a narrow level instead reaches full measurement strength at a bias below the gap, where, for a non-interacting detector and to second order in the coupling, it cannot excite the probe at zero temperature. This energy-filtered readout keeps the inverse-square gap dependence of the quantum Fisher information, down to a gap set by the detector's level width and the electron temperature. Through such a detector the interacting pair gives about three times the information rate of a single electron with the same gap and detector, compared with 1.6-1.7 in the quantum Fisher information, for both contact and Coulomb-type interactions. These different gap dependences, and the different optimal biases of the two detectors, can be tested by bias and gate sweeps on suitably tuned charge-sensed double dots.

We calculate the energy eigenvalues, the spin-split excitation gap (energy separation between the spin-triplet excited state and the spin-singlet ground state) and the concurrence for two interacting electrons captured in a quantum dot (QD) formed by a gigahertz electron pump which is modeled by harmonic confining potentials. We find from our calculations a peak in the QD size dependence of the energy level for the spin-singlet ground state, indicating the effect due to Coulomb blockade. In addition, we observe a local minimum in the QD size dependence of the spin-split excitation gap for a relatively narrow quasi-one-dimensional (1D) channel formed from an etched wire, but a strong positive peak for the spin-split excitation gap in its QD size dependence with a relatively wide 1D channel. From the existence of a robust spin-split excitation gap against both thermal fluctuation due to finite (low) temperatures and the nonadiabatic effect due to fast barrier variations, we predict a spin-entangled electron pair inside the QD with a weak coupling to external leads. An interference-type experiment which employs a gate-controlled electron pump and a beam splitter is proposed to verify this prediction. For the electron pump, a sinusoidal radio-frequency signal is applied to the entrance gate of a two-gated system over a narrow channel etched in a GaAs/AlGaAs heterostructure, where the measured current within the channel shows plateaus at Nef with N = 1, 2,... being the number of captured electrons in a QD and f the frequency of the sinusoidal signal.

Charge detection utilizing a highly biased quantum point contact has become the most effective probe for studying few electron quantum dot circuits. Measurements on double and triple quantum dot circuits is performed to clarify a back action role of charge sensing on the confined electrons. The quantum point contact triggers inelastic transitions, which occur quite generally. Under specific device and measurement conditions these transitions manifest themselves as bounded regimes of telegraph noise within a stability diagram. A nonequilibrium transition from artificial atomic to molecular behavior is identified. Consequences for quantum information applications are discussed.

We derive an analytical expression for the backaction dephasing rate, which characterizes the disturbance induced by coupling with an environment containing a quantum dot detector (QDD). In this paper, we show in an explicit form that the charge noise induces backaction dephasing. In equilibrium, this backaction dephasing induced by the charge noise can be explained as a relaxation by an inelastic electron-electron scattering in Fermi-liquid theory. Unlike the quantum point contact, the backaction dephasing rate increases or decreases with the bias at low bias and finite-temperature condition. This behavior depends on the QDD energy level with respect to the Fermi energy and the asymmetry of the QDD coupling to the reservoirs. In the high bias voltage regime, the dephasing rate becomes insensitive to the bias because of the saturation of the charge noise.

Bound states in quantum dots coupled to superconductors can be in a coherent superposition of states with different electron number but with the same fermion parity. Electrostatic gating can tune this superposition to a sweet spot, where the quantum dot has the same mean electric charge independent of its electron-number parity. Here, we propose to encode quantum information in the local fermion parity of two tunnel-coupled quantum dots embedded in a Josephson junction. At the sweet spot, the qubit states have zero charge dipole moment. This protects the qubit from dephasing due to charge noise acting on the potential of each dot, as well as fluctuations of the (weak) interdot tunneling. At weak interdot tunneling, relaxation is suppressed because of disjoint qubit states. However, for strong interdot tunneling the system is protected against noise affecting each quantum dot separately (energy-level noise, dot-superconductor tunneling fluctuations, and hyperfine interactions). Finally, we describe initialization and readout as well as single-qubit and two-qubit gates by pulsing gate voltages. Published by the American Physical Society 2024

We measure the average number of electrons loaded into an electrostatically-defined quantum dot (QD) operated as a tunable-barrier electron pump, using a point-contact (PC) charge sensor 1 micron away from the QD. The measurement of the electron number probes the QD loading dynamics even in the limit of slow gate voltage rise-times, when the pumped current is too small to measure. Using simulations we show that, with optimised QD-PC coupling, the experiment can make single-shot measurements of the number of electrons in the QD with sufficiently high fidelity to test the error rate of the electron pump with metrological precision.

We report the dispersive charge-state readout of a double quantum dot in the few-electron regime using the in situ gate electrodes as sensitive detectors. We benchmark this gate sensing technique against the well established quantum point contact charge detector and find comparable performance with a bandwidth of $\ensuremath{\sim}10\text{ }\text{ }\mathrm{MHz}$ and an equivalent charge sensitivity of $\ensuremath{\sim}6.3\ifmmode\times\else\texttimes\fi{}{10}^{\ensuremath{-}3}\text{ }\text{ }e/\sqrt{\mathrm{Hz}}$. Dispersive gate sensing alleviates the burden of separate charge detectors for quantum dot systems and promises to enable readout of qubits in scaled-up arrays.