Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:2605.30296

Enhanced Loading of a Molecular Magneto-Optical Trap

Ebram Youssef, Kaiya Wilson, Jiahe Cao, Reilly Brislawn, Avani Lakkireddy, Kun Liu, Aaron Teo, Phoebe Turner, Loïc Anderegg

Published May 28, 2026• 0 citations
arXivHTMLPDF

Abstract

Molecular magneto-optical traps (MOTs) typically capture orders of magnitude fewer particles than their atomic counterparts due in part to their significantly lower capture velocities. Here, we employ a Stochastic Schrödinger Equation Monte Carlo approach to model a CaF DC MOT to understand the factors limiting capture velocity. We provide physical intuition into the mechanisms that affect capture velocity and identify important parameters and general strategies to improve it. In addition, we point out a loss mechanism intrinsic to molecular MOTs and determine parameter regimes that should be avoided experimentally. We benchmark our simulations against a CaF DC MOT and experimentally implement the improvements predicted by our model. In doing so, we demonstrate a molecular MOT with 1.5 million trapped molecules. This represents an eight-fold improvement and is an important step toward achieving quantum degeneracy with laser cooled molecules.

DOI
10.48550/arxiv.2605.30296

Related papers

Toward improved loading, cooling, and trapping of molecules in magneto-optical traps

Thomas Langin, David P. DeMille

Abstract Recent experiments have demonstrated direct cooling and trapping of diatomic and triatomic molecules in magneto-optical traps (MOTs). However, even the best molecular MOTs to date still have density 10−5 times smaller than in typical atomic MOTs. The main limiting factors are: (i) inefficiencies in slowing molecules to velocities low enough to be captured by the MOT, (ii) low MOT capture velocities, and (iii) limits on density within the MOT resulting from sub-Doppler heating (Devlin and Tarbutt 2018 Phys. Rev. A 90 063415). All of these are consequences of the need to drive ‘Type-II’ optical cycling transitions, where dark states appear in Zeeman sublevels, in order to avoid rotational branching. We present simulations demonstrating ways to mitigate each of these limitations. This should pave the way toward loading molecules into conservative traps with sufficiently high density and number to evaporatively cool them to quantum degeneracy.

arXiv:2210.14223•New Journal of Physics•Mar 10, 2023•19 citations

Characteristics of a magneto-optical trap of molecules

H. J. Williams, Stefan Truppe, Moritz Hambach +5 more

We present the properties of a magneto-optical trap (MOT) of CaF molecules. We study the process of loading the MOT from a decelerated buffer-gas-cooled beam, and how best to slow this molecular beam in order to capture the most molecules. We determine how the number of molecules, the photon scattering rate, the oscillation frequency, damping constant, temperature, cloud size and lifetime depend on the key parameters of the MOT, especially the intensity and detuning of the main cooling laser. We compare our results to analytical and numerical models, to the properties of standard atomic MOTs, and to MOTs of SrF molecules. We load up to molecules, and measure a maximum scattering rate of s −1 per molecule, a maximum oscillation frequency of 100 Hz, a maximum damping constant of 500 s −1 , and a minimum MOT rms radius of 1.5 mm. A minimum temperature of 730 μ K is obtained by ramping down the laser intensity to low values. The lifetime, typically about 100 ms, is consistent with a leak out of the cooling cycle with a branching ratio of about . The MOT has a capture velocity of about 11 m s −1 .

arXiv:1706.07848•New Journal of Physics•Sep 22, 2017•81 citations

Experimental Optimization of a Cryogenic Buffer Gas Source for Molecular Magneto-optical Traps

Kaiya Wilson, Ebram Youssef, Lo\"ıc Anderegg

Molecular magneto-optical traps (MOTs) are loaded from cryogenic buffer gas beam (CBGB) sources, which produce a large flux of cold molecules. However, only a small fraction of this flux is slowed and captured. Here, we investigate and optimize one of these CBGB sources through a combination of experiment and simulation to maximize the number of molecules loaded into a MOT of CaF molecules. We experimentally determine the range of molecule velocities from the source that are successfully slowed and captured in the MOT, and perform a systematic study of buffer gas source geometries to identify designs that maximize MOT loading. Our observations agree well with Monte Carlo simulations, which provide physical insight into the dynamics within the source and explain how source geometry influences the subset of molecules that are ultimately trapped. These results provide practical design guidelines for optimizing cryogenic buffer gas beam sources used in laser cooling experiments.

arXiv:2610.29033•Oct 21, 2026•0 citations

Laser slowing of CaF molecules to near the capture velocity of a molecular MOT

Boerge Hemmerling, Eunmi Chae, Aakash Ravi +7 more

Laser slowing of CaF molecules down to the capture velocity of a magneto-optical trap for molecules is achieved. Starting from a two-stage buffer gas beam source, we apply frequency-broadened 'white-light' slowing and observe approximately 6 x 10⁴ CaF molecules in a single pulse with velocities 10 ± 4 m s⁻¹. CaF is a candidate for collisional studies in the mK regime. This work represents a significant step towards magneto-optical trapping of CaF.

•Mar 1, 2016•86 citations

Blue-detuned molecular magneto-optical trap schemes based on Bayesian optimization

S. Xu, R. X. Li, Yong Xia +2 more

Direct laser cooling and trapping of molecules to temperature below the Doppler limit and density exceeding ${10}^{8}$ are challenging due to the sub-Doppler heating effects of a molecular magneto-optical trap (MOT). In our previous paper [S. Xu et al., Phys. Rev. Res. 4, L042036 (2022)], we presented a general approach to engineering the sub-Doppler force by tuning the AC Stark shift with the addition of a blue-detuned laser. Here, by employing the Bayesian optimization method to optical Bloch equations, we have identified multiple blue-detuned MOT schemes for the CaF molecule. From the three-dimensional Monte Carlo simulation, we obtained a MOT temperature and density of 14 $\textmu{}\mathrm{K}$ and $4.5\ifmmode\times\else\texttimes\fi{}{10}^{8} {\mathrm{cm}}^{\ensuremath{-}3}$, respectively. Our findings present a potential avenue for directly loading molecular MOTs into conservative traps, which can capitalize on the high density and low temperature of the MOTs.

arXiv:2305.16576•Physical Review A•Sep 5, 2023•4 citations

Laser slowing of CaF molecules to near the capture velocity of a molecular MOT

Boerge Hemmerling, Eunmi Chae, Aakash Ravi +7 more

Abstract Laser slowing of CaF molecules down to the capture velocity of a magneto-optical trap for molecules is achieved. Starting from a two-stage buffer gas beam source, we apply frequency-broadened ‘white-light’ slowing and observe approximately 6 × 10 4 CaF molecules in a single pulse with velocities 10 ± 4 m s −1 . CaF is a candidate for collisional studies in the mK regime. This work represents a significant step towards magneto-optical trapping of CaF.

arXiv:1603.02787•Journal of Physics B Atomic Molecular and Optical Physics•Aug 10, 2016•94 citations
Molecular magneto-optical traps (MOTs) typically capture orders of magnitude fewer particles than their atomic counterparts due in part to their significantly lower capture velocities. Here, we employ a Stochastic Schrödinger Equation Monte Carlo approach to model a CaF DC MOT to understand the factors limiting capture velocity. We provide physical intuition into the mechanisms that affect capture velocity and identify important parameters and general strategies to improve it. In addition, we point out a loss mechanism intrinsic to molecular MOTs and determine parameter regimes that should be avoided experimentally. We benchmark our simulations against a CaF DC MOT and experimentally implement the improvements predicted by our model. In doing so, we demonstrate a molecular MOT with 1.5 million trapped molecules. This represents an eight-fold improvement and is an important step toward achieving quantum degeneracy with laser cooled molecules.
Abstract Recent experiments have demonstrated direct cooling and trapping of diatomic and triatomic molecules in magneto-optical traps (MOTs). However, even the best molecular MOTs to date still have density 10−5 times smaller than in typical atomic MOTs. The main limiting factors are: (i) inefficiencies in slowing molecules to velocities low enough to be captured by the MOT, (ii) low MOT capture velocities, and (iii) limits on density within the MOT resulting from sub-Doppler heating (Devlin and Tarbutt 2018 Phys. Rev. A 90 063415). All of these are consequences of the need to drive ‘Type-II’ optical cycling transitions, where dark states appear in Zeeman sublevels, in order to avoid rotational branching. We present simulations demonstrating ways to mitigate each of these limitations. This should pave the way toward loading molecules into conservative traps with sufficiently high density and number to evaporatively cool them to quantum degeneracy.
We present the properties of a magneto-optical trap (MOT) of CaF molecules. We study the process of loading the MOT from a decelerated buffer-gas-cooled beam, and how best to slow this molecular beam in order to capture the most molecules. We determine how the number of molecules, the photon scattering rate, the oscillation frequency, damping constant, temperature, cloud size and lifetime depend on the key parameters of the MOT, especially the intensity and detuning of the main cooling laser. We compare our results to analytical and numerical models, to the properties of standard atomic MOTs, and to MOTs of SrF molecules. We load up to molecules, and measure a maximum scattering rate of s −1 per molecule, a maximum oscillation frequency of 100 Hz, a maximum damping constant of 500 s −1 , and a minimum MOT rms radius of 1.5 mm. A minimum temperature of 730 μ K is obtained by ramping down the laser intensity to low values. The lifetime, typically about 100 ms, is consistent with a leak out of the cooling cycle with a branching ratio of about . The MOT has a capture velocity of about 11 m s −1 .
Molecular magneto-optical traps (MOTs) are loaded from cryogenic buffer gas beam (CBGB) sources, which produce a large flux of cold molecules. However, only a small fraction of this flux is slowed and captured. Here, we investigate and optimize one of these CBGB sources through a combination of experiment and simulation to maximize the number of molecules loaded into a MOT of CaF molecules. We experimentally determine the range of molecule velocities from the source that are successfully slowed and captured in the MOT, and perform a systematic study of buffer gas source geometries to identify designs that maximize MOT loading. Our observations agree well with Monte Carlo simulations, which provide physical insight into the dynamics within the source and explain how source geometry influences the subset of molecules that are ultimately trapped. These results provide practical design guidelines for optimizing cryogenic buffer gas beam sources used in laser cooling experiments.
Direct laser cooling and trapping of molecules to temperature below the Doppler limit and density exceeding 108{10}^{8}108 are challenging due to the sub-Doppler heating effects of a molecular magneto-optical trap (MOT). In our previous paper [S. Xu et al., Phys. Rev. Res. 4, L042036 (2022)], we presented a general approach to engineering the sub-Doppler force by tuning the AC Stark shift with the addition of a blue-detuned laser. Here, by employing the Bayesian optimization method to optical Bloch equations, we have identified multiple blue-detuned MOT schemes for the CaF molecule. From the three-dimensional Monte Carlo simulation, we obtained a MOT temperature and density of 14 $\textmu{}\mathrm{K}$ and $4.5\ifmmode\times\else\texttimes\fi{}{10}^{8} {\mathrm{cm}}^{\ensuremath{-}3}$, respectively. Our findings present a potential avenue for directly loading molecular MOTs into conservative traps, which can capitalize on the high density and low temperature of the MOTs.