The evenly spaced modes of an electromagnetic resonator are coupled to each other by appropriate time modulation, leading to dynamics analogous to those of particles hopping between different sites of a lattice. This substitution of a real spatial dimension of a lattice with a ``synthetic'' dimension in frequency space greatly reduces the hardware complexity of an analog quantum simulator. Complex control and readout of a highly multimoded structure can thus be accomplished with very few physical control lines. We demonstrate this concept with microwave photons in a superconducting transmission line resonator by modulating the system parameters at frequencies near the resonator's free spectral range and observing propagation of photon wave packets in time domain. The linear propagation dynamics are equivalent to a tight-binding model, which we probe by measuring scattering parameters between frequency sites. We extract an approximate tight-binding dispersion relation for the synthetic lattice and initialize photon wave packets with well-defined quasimomenta and group velocities. As an example application of this platform in simulating a physical system, we demonstrate Bloch oscillations associated with a particle in a periodic potential and subject to a constant external field. The simulated field strongly affects the photon dynamics despite photons having zero charge. Our observation of photon dynamics along a synthetic frequency dimension generalizes immediately to topological photonics and single-photon power levels, and expands the range of physical systems addressable by quantum simulation.
In the circuit quantum electrodynamics architecture, both the resonance frequency and the coupling of superconducting qubits to microwave field modes can be controlled via external electric and magnetic fields to explore qubit-photon dynamics in a wide parameter range. Here, we experimentally demonstrate and analyze a scheme for tuning the coupling between a transmon qubit and a microwave resonator using a single coherent drive tone. We treat the transmon as a three-level system, with the qubit subspace defined by the ground and the second excited states. If the drive frequency matches the difference between the resonator and the qubit frequencies, a Jaynes-Cummings-type interaction is induced, which is tunable in both amplitude and phase. We show that coupling strengths of about 10 MHz can be achieved in our setup, limited only by the anharmonicity of the transmon qubit. This scheme has been successfully used to generate microwave photons with a controlled temporal shape [M. Pechal et al., Phys. Rev. X 4, 041010 (2014)] and can be directly implemented with superconducting quantum devices featuring larger anharmonicity for higher coupling strengths.
Artificially engineered atoms, built using superconducting electrical circuits, have had a broad impact on the field of quantum information and quantum computing. Based on the Josephson effect, superconducting qubits have provided a robust platform for engineering light-matter interactions at the single-photon level. The ability to precisely control and manipulate single photons using superconducting qubits and cavities, a field now popularly known as circuit quantum electrodynamics (circuit QED), has enabled new and novel regimes in quantum physics, which previously remained inaccessible. For instance, the coupling between individual photons and artificial atoms have been shown to reach the ultrastrong and deep-strong regimes, a feat which is difficult to achieve with natural atoms. The superconducting circuit platform is now a promising contender for building large-scale quantum processors, attracting large investments from academic, industry and government players. \n \nThis thesis uses superconducting circuits to engineer photon interactions in two separate studies. The first is aimed at studying the physics of ``giant" artificial-atoms. The second study explores the route towards building a quantum heat engine using two parametrically-coupled, superconducting microwave cavities. We review the theoretical ideas and concepts which motivate our work, along with discussions of the design methodology, simulations, fabrication, measurement setup and the experimental findings. \n \nIn the first study, we explore a giant artificial atom, formed from a transmon qubit, which is coupled to propagating microwaves at multiple points along an open transmission line. The multipoint coupling nature of the transmon allows its radiated field to interfere with itself leading to some striking ``giant" atom effects. For instance, we observe strong frequency dependent couplings of the transmon's transition levels to its electromagnetic environment, a feature which is not observed with ordinary artificial atoms. We measure large on/off ratios, as high as
380, for the coupling rate of the
ket0−ket1 transition. Furthermore, we show that we can enhance or suppress the coupling rate of the
ket1−ket2 transition relative to the
ket0−ket1 transition, by more than a factor of
200. The relative modulation of the coupling rates was exploited to engineer a metastable state in the giant transmon and demonstrate electromagnetically-induced transparency (EIT), a typical signature of a lambda system. Our results show that we can transform the ladder structure of an ordinary transmon into a more interesting lambda system using a giant transmon, thereby paving the way for exploring new possibilities to study three-level physics in a waveguide-QED setting. \n \nExtending giant atom physics to multiple giant atoms, we then explore a device with two giant artificial atoms connected in a braided configuration to a transmission line. The braided topology of the qubits, offers an interesting regime where the qubits can interact with each other in a decoherence-free environment, where the interaction is mediated by virtual photons in the transmission line. We probe the resonant behavior of the qubits at two different frequency bias points, where we observe qualitatively different scattering behavior. Furthermore, when probing for the Autler-Townes Splitting (ATS), multiple resonances are observed for both resonant and off-resonant cases instead of the familiar doublet in the ATS spectroscopy. This comes as a surprise as the frequency-level spacings in both qubits are nominally identical. We believe these features could be an indication of a novel resonant interaction between the qubits facilitated by the braided topology. An effort to understand this theoretically is underway. \n \nFor our second study, we explore a system with two parametrically-coupled superconducting resonators, which implements an optomechanical-like interaction in an all-electrical network. The nonlinear nature of this interaction is mediated by a superconducting quantum interference device (SQUID), where the current in one resonator couples to the photon number in the other resonator. We propose to use this system to build a ``photonic piston" engine in the quantum regime. We motivate the feasibility of the proposal by reviewing key theoretical results which demonstrate an Otto-cycle by appropriately driving the system with noise. Our experimental findings demonstrate the crucial nonlinear coupling that is required for the engine to work. We also show that we can increase the coupling strength between the resonators depending on the chosen flux operating point.
Quantum optics in superconducting circuits, known as circuit QED, studies the interaction of photons at microwave frequencies with artificial atoms made of Josephson junctions. Although quite young, remarkable progress has been made in this field over the past decade, especially given the interest in building a quantum computer using superconducting circuits. In this thesis based on the appended papers, we look at generation, engineering and detection of microwave photons using superconducting circuits. We do this by taking advantage of the strong coupling, on-chip tunability and huge nonlinearity available in superconducting circuits. First, we present the strong photon-photon interaction measured experimentally, as shown in the giant cross-Kerr effect. In this work, conditional phase shift of about 20 degrees per photon was measured between two coherent fields at single photon level. Given this strong interaction, we propose and analyze a cascaded setup based on the cross-Kerr effect to detect itinerant microwave photons, a long outstanding problem with only recent experimental realizations. We show that a nondestructive detection of microwave photons is possible with few cascaded transmons. The on-chip tunability of Superconducting Quantum Interference Device (SQUID) is exploited to create a tunable superconducting resonator in the next presented experimental work. Finally, we show that by placing the atom at the end of a transmission line, microwave photons can be generated efficiently and on-demand. We also present a setup that can generate the photons in arbitrary wave packets.
Quantum walks on photonic platforms represent a physics-rich framework for quantum measurements, simulations and universal computing. Dynamic reconfigurability of photonic circuitry is key to controlling the walk and retrieving its full operation potential. Universal quantum processing schemes based on time-bin encoding in gated fibre loops have been proposed but not demonstrated yet, mainly due to gate inefficiencies. Here we present a scalable quantum processor based on the discrete-time quantum walk of time-bin-entangled photon pairs on synthetic temporal photonic lattices implemented on a coupled fibre-loop system. We utilize this scheme to path-optimize quantum state operations, including the generation of two- and four-level time-bin entanglement and the respective two-photon interference. The design of the programmable temporal photonic lattice enabled us to control the dynamic of the walk, leading to an increase in the coincidence counts and quantum interference measurements without recurring to post-selection. Our results show how temporal synthetic dimensions can pave the way towards efficient quantum information processing, including quantum phase estimation, Boson sampling and the realization of topological phases of matter for high-dimensional quantum systems in a cost-effective, scalable and robust fibre-based setup.
Synthesizing many-body quantum systems with various ranges of interactions facilitates the study of quantum chaotic dynamics. Such extended interaction range can be enabled by using nonlocal degrees of freedom such as photonic modes in an otherwise locally connected structure. Here, we present a superconducting quantum simulator in which qubits are connected through an extensible photonic-bandgap metamaterial, thus realizing a one-dimensional Bose-Hubbard model with tunable hopping range and on-site interaction. Using individual site control and readout, we characterize the statistics of measurement outcomes from many-body quench dynamics, which enables in situ Hamiltonian learning. Further, the outcome statistics reveal the effect of increased hopping range, showing the predicted crossover from integrability to ergodicity. Our work enables the study of emergent randomness from chaotic many-body evolution and, more broadly, expands the accessible Hamiltonians for quantum simulation using superconducting circuits.