Superconducting standing$-$wave parametric amplifiers are crucial for the readout of microwave quantum devices. Despite significant improvements in recent years, the need to operate near an instability point imposes a fundamental constraint: the instantaneous bandwidth decreases with increasing amplifier gain. Here we show that it is possible to obtain parametric amplification without instability by using two simultaneous drives that activate phase-preserving gain and frequency conversion. Realized in a granular aluminum dimer with Kerr nonlinearity, our method demonstrates a sixfold bandwidth increase at 20 dB gain, surpasses the conventional gain$-$bandwidth scaling up to 25 dB, and remains near the quantum limit.
Superconducting standing−wave parametric amplifiers are crucial for the readout of microwave quantum devices. Despite significant improvements in recent years, the need to operate near an instability point imposes a fundamental constraint: the instantaneous bandwidth decreases with increasing amplifier gain. Here we show that it is possible to obtain parametric amplification without instability by using two simultaneous drives that activate phase-preserving gain and frequency conversion. Realized in a granular aluminum dimer with Kerr nonlinearity, our method demonstrates a sixfold bandwidth increase at 20 dB gain, surpasses the conventional gain−bandwidth scaling up to 25 dB, and remains near the quantum limit.
We propose a flux-pumped superconducting parametric amplifier based on symmetrically threaded superconducting quantum interference devices (SQUIDs) that achieves a Kerr-free operating point under suitable drive conditions. Eliminating the Kerr nonlinearity is advantageous for quantum-limited amplification, as it mitigates unwanted distortions in squeezing and prevents degradation of both gain and quantum efficiency in the high-gain strong drive regime. By replacing the central junction in the symmetrically threaded SQUIDs (STS) configuration with a linear inductor, we find that the Kerr-nonlinearity can be eliminated and the effective Hamiltonian reduces to that of a degenerate parametric amplifier (DPA), up to higher-order corrections in the zero-point fluctuations of the superconducting phase operator. We show that the deviations from ideal DPA behavior introduced by these higher-order terms are significantly weaker than those associated with a Kerr nonlinearity. Consequently, the STS design can be driven strongly while maintaining near-quantum-limited performance at the Kerr-free point. Our analysis predicts phase-preserving gain and efficiency approaching the quantum limit, with robust operation demonstrated up to 25 dB of gain.
Quantum-limited parametric amplifiers based on superconducting circuits are essential for the readout of microwave quantum systems. They are typically realized by exploiting the nonlinearity of Josephson junctions (JJs), which can be modulated through the application of strong pump tones. Despite the remarkable progress achieved over the past decade, JJ-based amplifiers still suffer from two major limitations that hinder their applicability in next-generation quantum technologies: sensitivity to magnetic fields beyond the millitesla range and non-negligible higher-order nonlinearities. Disordered superconductors have recently emerged as an alternative nonlinear medium capable of overcoming these limitations. Among them, granular aluminum (grAl) offers a particularly rich and versatile source of nonlinearity, well suited for the implementation of parametric devices. In this work, we leverage the intrinsic properties of grAl to develop a practical standing-wave parametric amplifier, called grAlPA, with a design resembling a superconducting Bose–Hubbard dimer. We demonstrate the magnetic-field resilience of the grAlPA, achieving near quantum-limited performance for in-plane magnetic fields up to 1 T. Furthermore, by exploiting the interplay between the intrinsically diluted higher-order nonlinearities and the low self-capacitance of grAl, we realize an amplifier exhibiting unconventional gain–bandwidth scaling up to gain levels of 25 dB. These results positions grAl as a compelling nonlinear platform for the next-generation of parametric amplifiers and open new opportunities for future quantum technologies.
Superconducting traveling-wave parametric amplifiers (TWPA) have emerged as highly versatile devices, offering broadband amplification with quantum-limited noise performance. They hold significant potential for addressing the readout bottleneck in prototype quantum computers, enabling scalability. Key challenges with this technology include achieving sufficient gain with minimal gain ripple while maintaining low noise performance. Efficient phase matching between a weak signal and a strong pump over the entire length of the TWPA is critical to overcoming these challenges. We present an experimental demonstration of the inverse Kerr phase matching technique in a TWPA, first proposed in Ref. Phys. Rev. Appl. 4, 024014. This method addresses several limitations of conventional dispersion engineering approaches of phase matching in the four-wave mixing parametric process in TWPAs. Most notably the existence of an unusable region of gain near the pump frequency which typically corresponds to the region of most optimal phase matching and maximum gain. The inverse Kerr phase matching approach, allows for greater frequency separation between the region of optimal gain and pump, \textit{in situ} tunability of the pump, minimal gain ripple, and a compact footprint which reduces losses. A TWPA employing the inverse Kerr phase matching technique experimentally demonstrated 20 dB of gain over a 3 GHz instantaneous bandwidth, with a tunable bandwidth of 8 GHz, minimal gain ripple, and near quantum-limited noise performance, with 1.5 photons of added noise.
Parametric amplification is essential for quantum measurement, enabling the amplification of weak microwave signals with minimal added noise. While Josephson-junction-based amplifiers have become standard in superconducting quantum circuits, their magnetic sensitivity, limited saturation power, and sub-kelvin operating requirements motivate the development of alternative nonlinear platforms. Here we demonstrate a two-mode kinetic-inductance parametric amplifier based on a pair of capacitively coupled Kerr-nonlinear resonators fabricated from NbTiN and NbN thin films. The distributed Kerr nonlinearity of these materials enables nondegenerate four-wave-mixing amplification with gains approaching 40 dB, gain-bandwidth products up to 6.9 MHz, and 1-dB compression powers two to three orders of magnitude higher than those of state-of-the-art Josephson amplifiers. A coupled-mode theoretical model accurately captures the pump-induced modification of the hybridized modes and quantitatively reproduces the observed signal and idler responses. The NbN device exhibits a significantly larger Kerr coefficient and superior gain-bandwidth performance, highlighting the advantages of high-kinetic-inductance materials. Our results establish coupled kinetic-inductance resonators as a robust platform for broadband, high-power, and magnetically resilient quantum-limited amplification, offering a scalable route for advanced readout in superconducting qubits, spin ensembles, quantum dots, and other microwave-quantum technologies.
One of the primary requirements for superconducting quantum information processors is high-fidelity, quantum non-demolition qubit readout. In superconducting circuits, we perform measurements with quantum-limited microwave amplifiers. These amplifiers are based on microwave cavities and powered by Josephson-junction based nonlinearities, which we drive to parametrically modulate the circuit and generate gain. However, cavity-based amplifiers generally suffer from a fixed gain-bandwidth product, a limited dynamic range, and the absence of directionality, and so they must be operated with external lossy microwave commercial components such as circulators. Many of these limitations can be circumvented by combining multiple parametric processes in a few-mode device, in particular by combining parametric drives which produce gain and those which produce gainless photon conversion. By combining balanced gain and conversion processes between a pair of modes, we have demonstrated transmission-only, phase-sensitive, gain-bandwidth-free amplification. We have also used measurements of transmon qubits with this mode of amplification to demonstrate its practical utility. More, by combining multiple instances of imbalanced gain and conversion processes among three modes, we have realized devices with non-reciprocal, transmission-only amplification, matched ports, and a large, gain-independent bandwidth. One of the biggest challenges in tuning multiple parametric processes is both inherent and dynamically-generated higher order nonlinearities in the device, which shift mode frequencies and parametric coupling strengths with pump power, preventing accurate balancing of the parametric processes. These can be controlled through engineering the Hamiltonian of the nonlinear element, in this thesis either a linearly-shunted Josephson Ring Modulator or SNAIL (Superconducting Nonlinear Asymmetric Inductive eLements), which for certain applied flux values can minimize or even change the sign of higher-order even nonlinearities. Additionally, we have explored a range of circuit parameters, allowing us to also control the relative size of odd-order nonlinearities. We have developed a series of prototypes which implement these concepts, and have achieved both high-dynamic range singly pumped amplifiers, and a promising platform for multi-parametric devices. We conclude by presenting recent progress towards implementing multiple parametric schemes that generates a practical directional amplifier, and discuss the remaining obstacles to a truly ideal parametric amplifiers.
Advancing superconducting quantum devices to higher operating frequencies broadens their functionality and enables operation at elevated temperatures, but it also requires near-quantum-limited amplifiers beyond the few-gigahertz regime. Here we present a junction-free, kinetic-inductance parametric amplifier based on thin-film niobium nitride (NbN) operating at 23 GHz in the microwave K-band, achieving a gain up to 40 dB, a 100 MHz gain-bandwidth product, a 1 dB saturation input power of -85 dBm with 23 dB gain, and added noise no greater than 1.4 quanta for phase-preserving amplification. Leveraging the large superconducting gap of NbN, this architecture can be extended to even higher frequencies, supporting applications such as high-fidelity readout of millimeter-wave superconducting qubits and axion searches over an expanded mass window.