The presence of dark matter (DM) stands as one of the most compelling indications of new physics in particle physics. Typically, the detection of wavelike DM involves quantum sensors, such as qubits or cavities. The phase of the sensors is usually discarded as the value of the phase itself is not physically meaningful. However, the difference of the phase between the sensors contains the information of the velocity and direction of the DM wind. We propose a measurement protocol to extract this information from the sensors using quantum states. Our method does not require specific experimental setups and can be applied to any type of DM detector as long as the data from the detectors can be taken quantum mechanically. We also show that our method does not spoil the sensitivity of the DM detectors and is superior to the classical method based on the correlations of the DM signals between the detectors.
The presence of dark matter (DM) stands as one of the most compelling indications of new physics in particle physics. Typically, the detection of wavelike DM involves quantum sensors, such as qubits or cavities. The phase of the sensors is usually discarded as the value of the phase itself is not physically meaningful. However, the difference of the phase between the sensors contains the information of the velocity and direction of the DM wind. We propose a measurement protocol to extract this information from the sensors using quantum states. Our method does not require specific experimental setups and can be applied to any type of DM detector as long as the data from the detectors can be taken quantum mechanically. We also show that our method does not spoil the sensitivity of the DM detectors and is superior to the classical method based on the correlations of the DM signals between the detectors.
We propose a novel method to significantly enhance the signal rate in qubit-based dark matter detection experiments with the help of quantum interference. Various quantum sensors possess ideal properties for detecting wavelike dark matter, and qubits, commonly employed in quantum computers, are excellent candidates for dark matter detectors. We demonstrate that, by designing an appropriate quantum circuit to manipulate the qubits, the signal rate scales proportionally to n_{q}^{2}, with n_{q} being the number of sensor qubits, rather than linearly with n_{q}. Consequently, in the dark matter detection with a substantial number of sensor qubits, a significant increase in the signal rate can be expected. We provide a specific example of a quantum circuit that achieves this enhancement by coherently combining the phase evolution in each individual qubit due to its interaction with dark matter. We also demonstrate that the circuit is fault tolerant to dephasing noises, a critical quantum noise source in quantum computers. The enhancement mechanism proposed here is applicable to various modalities for quantum computers, provided that the quantum operations relevant to enhancing the dark matter signal can be applied to these devices.
We present a halo-independent framework for sub-GeV dark matter (DM) direct detection using quantum sensors with sub-eV energy thresholds. Such detectors enable access to low DM velocities and may be sensitive to departures from the Standard Halo Model that are challenging to probe with conventional direct DM detection experiments. The method expresses the DM scattering event rate in terms of a detector and particle model-dependent response function, and a universal halo function common to all experiments to be determined from data. This allows the local DM velocity distribution to be constrained. As representative implementations, we consider TES (Al) and MKID (TiN)-like sensors and show that their differing material responses probe complementary regimes of the DM velocity distribution. Applying the framework to mock data derived from several benchmark local halo models, we demonstrate how the assumed halo function could be reconstructed. This framework demonstrates the potential of quantum sensors as a new avenue for mapping the local DM velocity distribution.
We propose a quantum error correction-like noise mitigation protocol for enhancing the sensitivity of wave-like dark matter searches with quantum sensors. Our protocol uses multiple sensors to mitigate the noise affecting each sensor individually, allowing for the suppression of excitation noise that is parallel to the dark matter signal. We demonstrate that our protocol can improve the sensitivity to dark matter signals by a factor of N, where N is the number of sensors used, for small N. Furthermore, for sufficiently large N, we find that our protocol achieves the same performance as the standard quantum limit by the ideal measurement, which non-entangled sensors with parallel noise cannot reach due to the unknown phase of the dark matter field. Our work can be widely applied to various types of signals with unknown phases, and has the potential to enhance the sensitivity of quantum sensors such as arrays of resonant cavities.
Although various pieces of indirect evidence about the nature of dark matter have been collected, its direct detection has eluded experimental searches despite extensive effort. If the mass of dark matter is below 1 MeV, it is essentially imperceptible to conventional detection methods because negligible energy is transferred to nuclei during collisions. Here I propose directly detecting dark matter through the quantum decoherence it causes rather than its classical effects, such as recoil or ionization. I show that quantum spatial superpositions are sensitive to low-mass dark matter that is inaccessible to classical techniques. This provides new independent motivation for matter interferometry with large masses, especially on spaceborne platforms. The apparent dark matter wind we experience as the Sun travels through the Milky Way ensures interferometers and related devices are directional detectors, and so are able to provide unmistakable evidence that decoherence has Galactic origins.
One of the areas of research of the Superconducting Quantum Systems and Materials (SQMS) center is the application of quantum sensing to fundamental physics searches, demonstrating that quantum sensors can greatly improve the sensitivity of experiments searching for Beyond the Standard Model (BSM) physics, or performing high-precision measurements. Theorists have developed many ideas for BSM physics that would result in interactions that can in principle be detected, but with signals small enough that they haven t been observed yet. In this field, the capability to lower the detector s thermal noise to few or dozens of mK, and to use QIS technologies such as Josephson Parametric Amplifiers and photon counters (in-situ or itinerant) enable us to reach unprecedented sensitivities and faster scan rates. Here is presented an overview of the quantum sensing efforts at SQMS [1], focusing on theoretical advancements and experimental searches for Dark Sector particles (as dark matter candidates and not), gravitational waves, and precision measurements. The experiments conducted, or under preparation, include axion dark matter (DM) [2, 3], dark photon DM searches [4,5], light-shining-through-wall experiments [6], cavity-based searches for high frequency gravitational waves [7], and measurements of the electron magnetic moment [8]. [1] Berlin, A., et al. "Searches for new particles, dark matter, and gravitational waves with SRF cavities." arXiv preprint arXiv:2203.12714 (2022). [2] Giaccone, B., et al. "Design of axion and axion dark matter searches based on ultra high Q SRF cavities." arXiv preprint arXiv:2207.11346 (2022). [3] Braggio, C., et al. "Quantum-enhanced sensing of axion dark matter with a transmon-based single microwave photon counter." arXiv preprint arXiv:2403.02321 (2024). [4] Fan, X., et al. "One-electron quantum cyclotron as a milli-eV dark-photon detector." Physical review letters 129.26 (2022): 261801. [5] Cervantes, R., et al. "Deepest sensitivity to wavelike dark photon dark matter with superconducting radio frequency cavities." Physical Review D 110.4 (2024): 043022. [6] Romanenko, A., et al. "Search for dark photons with superconducting radio frequency cavities." Physical review letters 130.26 (2023): 261801. [7] Berlin, A., et al. "Electromagnetic cavities as mechanical bars for gravitational waves." Physical Review D 108.8 (2023): 084058. [8] Fan, X., et al. "Measurement of the electron magnetic moment." Physical review letters 130.7 (2023): 071801.
We propose a direct axion dark matter (DM) search using superconducting transmon quantum bits (qubits) as quantum sensors. With an external magnetic field applied, axion DM generates an oscillating electric field, which causes the excitation of the qubit. Such an excitation can be regarded as a signal of the axion DM. We provide a theoretical consideration of the excitation process of the qubits, taking into account the effects of the shielding cavity surrounding the qubits, and estimate the signal rate for the axion DM detection. We also discuss the enhancement of the DM signal by using cavity resonance and entangled quantum sensors realized by a quantum circuit. Combining these two effects, we can reach the parameter region suggested by QCD axion models. Published by the American Physical Society 2024