We describe a superconducting qubit derived from operating a properly designed fluxonium circuit in a zero magnetic field. The qubit has a frequency of about 4 GHz and an energy relaxation quality factor Q ≈ 0.7 × 10 7 , even though the dielectric loss quality factor of the circuit components is in the low- 10 5 range. The Ramsey coherence time exceeds 100 μ s , and the average fidelity of Clifford gates is benchmarked to F > 0.999 . These figures are expected to improve with optimized fabrication and measurement procedures. Our work establishes a ready-to-use “partially protected” superconducting qubit functioning in the frequency range of conventional transmons. Published by the American Physical Society 2024
We describe a superconducting qubit derived from operating a properly designed fluxonium circuit in a zero magnetic field. The qubit has a frequency of about 4 GHz and an energy relaxation quality factor Q ≈ 0.7 × 10 7 , even though the dielectric loss quality factor of the circuit components is in the low- 10 5 range. The Ramsey coherence time exceeds 100 μ s , and the average fidelity of Clifford gates is benchmarked to F > 0.999 . These figures are expected to improve with optimized fabrication and measurement procedures. Our work establishes a ready-to-use “partially protected” superconducting qubit functioning in the frequency range of conventional transmons. Published by the American Physical Society 2024
Fluxonium superconducting qubits have demonstrated long coherence times and high single- and two-qubit gate fidelities, making them a favorable building block for superconducting quantum processors. We investigate the dominant limitations to fluxonium qubit energy relaxation time T1 using a set of eight planar, aluminum-on-silicon qubits. We find that a circuit-based model for capacitive dielectric loss best captures the frequency dependence of T1, which we analyze within both a two-level and a six-level energy relaxation model. We convert the measured T1 into an effective capacitive quality factor QCeff to compare qubits on equal footing, accounting for independently estimated contributions from 1/f flux noise and radiative loss to the control and readout circuitry. We apply this methodology to compare qubits from two fabrication processes: a baseline process and one that applies a fluorine-based wet treatment prior to Josephson junction deposition. We resolve a small improvement of (13.8 ± 8.4)% in the process mean QCeff, indicating that the fluorine treatment may have reduced loss from the metal-substrate interface, but did not address the primary source of loss in these fluxonium qubits.
Improving control over physical qubits is a crucial component of quantum computing research. Here we report a superconducting fluxonium qubit with uncorrected coherence time T_{2}^{*}=1.48±0.13 ms, exceeding the state of the art for transmons by an order of magnitude. The average gate fidelity was benchmarked at 0.99991(1). Notably, even in the millisecond range, the coherence time is limited by material absorption and could be further improved with a more rigorous fabrication. Our demonstration may be useful for suppressing errors in the next generation quantum processors.
Owing to their strong dipole moment and long coherence times, superconducting qubits have demonstrated remarkable success in hybrid quantum circuits. However, most qubit architectures are limited to the GHz frequency range, severely constraining the class of systems they can interact with. The fluxonium qubit, on the other hand, can be biased to very low frequency while being manipulated and read out with standard microwave techniques. Here, we design and operate a heavy fluxonium with an unprecedentedly low transition frequency of 1.8 MHz. We demonstrate resolved sideband cooling of the “hot” qubit transition with a final ground state population of 97.7%, corresponding to an effective temperature of 23 μ K . We further demonstrate coherent manipulation with coherence times T 1 = 34 μ s , T 2 * = 39 μ s , and single-shot readout of the qubit state. Importantly, by directly addressing the qubit transition with a capacitively coupled waveguide, we showcase its high sensitivity to a radio-frequency field. Through cyclic qubit preparation and interrogation, we transform this low-frequency fluxonium qubit into a frequency-resolved charge sensor. This method results in a charge sensitivity of 33 μ e / Hz , or an energy sensitivity (in joules per hertz) of 2.8 ℏ . This method rivals state-of-the-art transport-based devices, while maintaining inherent insensitivity to dc-charge noise. The high charge sensitivity combined with large capacitive shunt unlocks new avenues for exploring quantum phenomena in the 1–10 MHz range, such as the strong-coupling regime with a resonant macroscopic mechanical resonator. Published by the American Physical Society 2024
This thesis reports recent achievements toward scalable quantum computing with fluxonium, a superconducting artificial atom with rich energy spectrum and selection rules similar to those found in natural atoms. We show how such spectral properties can be harnessed to protect the qubit from energy relaxation and dephasing. At half-integer flux quantum bias, we show that fluxonium’s |0〉→ |1〉qubit transition has high coherence by design, with T1, T2≈500 μs in one device, the highest reported in superconducting circuits so far. Yet, the qubit exhibits the same level of addressability found in more conventional superconducting qubits (Tgate<50 ns). In addition, a controlled-Z gate can be implemented by sending a short2π-pulse at a frequency near the |1〉→|2〉transition of the target qubit. Preliminary results suggest that this gate can be used to entangle two fluxonium qubits with high fidelity. We also discuss experimental techniques employed to characterize the qubits, and present a perspective on future fluxonium-based quantum technologies.
We report superconducting fluxonium qubits with coherence times largely limited by energy relaxation and reproducibly satisfying T 2 > 100 μs (T 2 > 400 μs in one device).Moreover, given the state-of-the-art values of the surface loss tangent and the 1=f flux-noise amplitude, the coherence time can be further improved beyond 1 ms.Our results violate a common viewpoint that the number of Josephson junctions in a superconducting circuit-over 10 2 here-must be minimized for best qubit coherence.We outline how the unique to fluxonium combination of long coherence time and large anharmonicity can benefit both gate-based and adiabatic quantum computing.
Encoding quantum information in quantum states with disjoint wave-function support and noise-insensitive energies is the key behind the idea of qubit protection. While fully protected qubits are expected to offer exponential protection against both energy relaxation and pure dephasing, simpler circuits may grant partial protection with currently achievable parameters. Here, we study a fluxonium circuit in which the wave functions are engineered to minimize their overlap while benefiting from a first-order-insensitive flux sweet spot. Taking advantage of a large superinductance ( L ∼ 1 μ H ), our circuit incorporates a resonant tunneling mechanism at zero external flux that couples states with the same fluxon parity, thus enabling bifluxon tunneling. The states | 0 ⟩ and | 1 ⟩ are encoded in wave functions with parities 0 and 1, respectively, ensuring a minimal form of protection against relaxation. Two-tone spectroscopy reveals the energy-level structure of the circuit and the presence of 4 π quantum-phase slips between different potential wells corresponding to m = ± 1 fluxons, which can be precisely described by a simple fluxonium Hamiltonian or by an effective bifluxon Hamiltonian. Despite suboptimal fabrication, the measured relaxation ( T 1 = 177 ± 3 μ s ) and dephasing ( T 2 E = 75 ± 5 μ s ) times not only demonstrate the relevance of our approach but also open an alternative direction toward quantum computing using partially protected fluxonium qubits. Published by the American Physical Society 2024