Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:2308.09168 · Physical Review A

Protecting backaction-evading measurements from parametric instability

E. P. Ruddy, Yue Jiang, Nicholas Frattini, K. O. Quinlan, Konrad W. Lehnert

Published Aug 27, 2024• 1 citation
arXivHTMLPDF

Abstract

Noiseless measurement of a single quadrature in systems of parametrically coupled oscillators is theoretically possible by pumping at the sum and difference frequencies of the two oscillators, realizing a backaction-evading (BAE) scheme. Although this would hold true in the simplest scenario for a system with pure three-wave mixing, implementations of this scheme are hindered by unwanted higher-order parametric processes that destabilize the system and add noise. We show analytically that detuning the two pumps from the sum and difference frequencies can stabilize the system and fully recover the BAE performance, enabling operation at otherwise inaccessible cooperativities. We also show that the acceleration demonstrated in a weak-signal-detection experiment [Jiang et al., PRX Quantum 4, 020302 (2023)] was only achievable because of this detuning technique.

DOI
10.1103/physreva.110.023731

Related papers

Repeated backaction evading measurements: demonstration of a noiseless optical bus

Juan Ariel Levenson, Kamel Bencheikh, Philippe Grangier +1 more

Summary form only given. We report here repeated back action evading (BAE) experiments that clearly demonstrate all quantum nondemolition (QND) features for repeated measurements. An important feature is that each of the two BAE setups, based on pulsed type-II parametric amplifiers, also have performances that are the best achieved so far, and therefore make this demonstration more convincing. The conditional variance of the signal at the output of the first device measurement is given.

Quantum Electronics and Laser Science Conference•Jun 7, 1996•0 citations

Backaction evading measurements for quantum nondemolition detection and quantum optical tapping

Silvania F. Pereira, Z. Y. Ou, Harry J. Kimble

Backaction evading (BAE) measurements are described for optical parametric amplification with polarization mixing. Quantum correlations between the ``signal'' and ``meter'' outputs from the BAE device lead to an observed photocurrent variance 30% (1.5 dB) below the signal shot-noise level and to an inferred variance 44% below the vacuum-state level for determination of the signal field given the meter reading. Together with its efficient information transfer, this BAE detector functions as a quantum optical tap and is suitable for implementing quantum nondemolition detection.

Physical Review Letters•Jan 10, 1994•111 citations

Backaction-evading measurement of entanglement in optomechanics

Francesco Massel

We propose here a fully backaction-evading scheme for the measurement of the entanglement between two nanomechanical resonators. The system, which consists of two mechanical oscillators, coupled to a single mode of an electromagnetic resonant cavity through a radiation-pressure interaction term, is driven by two pump tones and four detection tones. As previously discussed in the literature, the former induce entanglement between the two mechanical oscillators, while we show here that a specific choice of phase and amplitude of the detection tones allows for direct pairwise reconstruction of the collective quadrature fluctuations of the mechanical oscillators belonging to quantum-mechanics-free subspaces, thereby providing direct evidence of the entanglement properties of the two mechanical resonators.

arXiv:1907.09882•Physical Review A•Aug 15, 2019•7 citations

Optomechanical backaction-evading measurement without parametric instability

Steven Steinke, Keith Schwab, Pierre Meystre

We review a scheme for performing a backaction-evading measurement of one mechanical quadrature in an optomechanical setup. The experimental application of this scheme has been limited by parametric instabilities caused in general by a slight dependence of the mechanical frequency on the electromagnetic energy in the cavity. We find that a simple modification to the optical drive can effectively eliminate the parametric instability even at high intracavity power, allowing realistic devices to achieve sub-zero-point uncertainties in the measured quadrature.

arXiv:1304.6779•Physical Review A•Aug 21, 2013•9 citations

Soliton backaction-evading measurement using spectral filtering

Friedrich König, B. C. Buchler, T. Rechtenwald +2 more

We report on a backaction-evading (BAE) measurement of the photon number of fiber-optical solitons operating in the quantum regime. We employ a recently proposed different detection scheme based on spectral filtering of colliding optical solitons. The measurements of the BAE criteria demonstrate significant quantum state preparation and transfer of the input signal to the signal and probe outputs exiting the apparatus, displaying the quantum-nondemolition behavior of the experiment.

arXiv:quant-ph/0209020•Physical Review A•Oct 23, 2002•23 citations

Two-stage quantum nondemolition experiment

Richard E. Slusher, Arthur La Porta, Seng‐Tiong Ho +1 more

We have previously demonstrated a backaction evading (BAE) measurement apparatus based on simple optics and a parametric downconversion amplifier.1 This apparatus avoids contamination of the measured signal by the measurement process. Quantum correlations were demonstrated between the measured portion of the signal and the transmitted signal, while the mean level of the transmitted signal is equal to that of the input.

•May 21, 1990•0 citations
Noiseless measurement of a single quadrature in systems of parametrically coupled oscillators is theoretically possible by pumping at the sum and difference frequencies of the two oscillators, realizing a backaction-evading (BAE) scheme. Although this would hold true in the simplest scenario for a system with pure three-wave mixing, implementations of this scheme are hindered by unwanted higher-order parametric processes that destabilize the system and add noise. We show analytically that detuning the two pumps from the sum and difference frequencies can stabilize the system and fully recover the BAE performance, enabling operation at otherwise inaccessible cooperativities. We also show that the acceleration demonstrated in a weak-signal-detection experiment [Jiang et al., PRX Quantum 4, 020302 (2023)] was only achievable because of this detuning technique.
Backaction evading (BAE) measurements are described for optical parametric amplification with polarization mixing. Quantum correlations between the ``signal'' and ``meter'' outputs from the BAE device lead to an observed photocurrent variance 30% (1.5 dB) below the signal shot-noise level and to an inferred variance 44% below the vacuum-state level for determination of the signal field given the meter reading. Together with its efficient information transfer, this BAE detector functions as a quantum optical tap and is suitable for implementing quantum nondemolition detection.
We propose here a fully backaction-evading scheme for the measurement of the entanglement between two nanomechanical resonators. The system, which consists of two mechanical oscillators, coupled to a single mode of an electromagnetic resonant cavity through a radiation-pressure interaction term, is driven by two pump tones and four detection tones. As previously discussed in the literature, the former induce entanglement between the two mechanical oscillators, while we show here that a specific choice of phase and amplitude of the detection tones allows for direct pairwise reconstruction of the collective quadrature fluctuations of the mechanical oscillators belonging to quantum-mechanics-free subspaces, thereby providing direct evidence of the entanglement properties of the two mechanical resonators.
We review a scheme for performing a backaction-evading measurement of one mechanical quadrature in an optomechanical setup. The experimental application of this scheme has been limited by parametric instabilities caused in general by a slight dependence of the mechanical frequency on the electromagnetic energy in the cavity. We find that a simple modification to the optical drive can effectively eliminate the parametric instability even at high intracavity power, allowing realistic devices to achieve sub-zero-point uncertainties in the measured quadrature.