Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:2108.13216

Entanglement Limits in Hybrid Spin-Mechanical Systems

Souvik Agasti, Abhishek Shukla, Miloš Nesládek

Published Aug 30, 2021• 0 citations
arXivHTMLPDF

Abstract

We investigate how to generate continuous-variable entanglement between distant optomechanical and spin systems, by transferring input two-mode squeezed vacuum state to the system. Such a setup has been proposed for backaction evading gravitational-wave measurement, squeezing the output noise below the standard quantum limit. We find that the spin cavity entanglement saturates to a particular value when no mechanics are involved even though the entanglement of the input beam increases steadily, and drops down when the mechanical oscillator interacts with the cavity. Our study also reveals that the spin optical readout rate enables the robustness of the spin-cavity entanglement with input squeezing whereas the optomechanical coupling strength disables it. The entanglement reaches its maximum when the effective resonance frequency and bandwidth of the cavity match the spin system. Determining collective quadrature fluctuations, our analysis also shows that even though the entanglement between spin and cavity, and cavity and mechanics is significantly present; it is still impossible to obtain entanglement between spin and mechanical oscillator.

DOI
10.48550/arxiv.2108.13216

Related papers

Two-mode back-action-evading measurements in cavity optomechanics

Matthew J. Woolley, Aashish A. Clerk

We study theoretically a three-mode optomechanical system where two mechanical oscillators are coupled to a single cavity mode. By using two-tone (i.e., amplitude-modulated) driving of the cavity, it is possible to couple the cavity to a single collective quadrature of the mechanical oscillators. In such a way, a back-action-evading measurement of the collective mechanical quadrature is possible. We discuss how this can allow one to measure both quadratures of a mechanical force beyond the full quantum limit, paying close attention to the role of dissipation and experimental imperfections. We also describe how this scheme allows one to generate steady-state mechanical entanglement; namely, one can conditionally prepare an entangled, two-mode squeezed mechanical state. This entanglement can be verified directly from the measurement record by applying a generalized version of Duan's inequality; we also discuss how feedback can be used to produce unconditional entanglement.

arXiv:1304.4059•Physical Review A•Jun 28, 2013•117 citations

Stationary optomechanical entanglement between a mechanical oscillator and its measurement apparatus

Corentin Gut, K. Winkler, Jason Hoelscher-Obermaier +9 more

We provide an argument to infer stationary entanglement between light and a mechanical oscillator based on continuous measurement of light only.We propose an experimentally realizable scheme involving an optomechanical cavity driven by a resonant, continuous-wave field operating in the non-sideband-resolved regime.This corresponds to the conventional configuration of an optomechanical position or force sensor.We show analytically that entanglement between the mechanical oscillator and the output field of the optomechanical cavity can be inferred from the measurement of squeezing in (generalized) Einstein-Podolski-Rosen quadratures of suitable temporal modes of the stationary light field.Squeezing can reach levels of up to 50% of noise reduction below shot noise in the limit of large quantum cooperativity.Remarkably, entanglement persists even in the opposite limit of small cooperativity.Viewing the optomechanical device as a position sensor, entanglement between mechanics and light is an instance of object-apparatus entanglement predicted by quantum measurement theory.

arXiv:1912.01635•Physical Review Research•Aug 12, 2020•40 citations

Backaction-evading measurement of entanglement in optomechanics

Francesco Massel

We propose here a fully backaction-evading scheme for the measurement of the entanglement between two nanomechanical resonators. The system, which consists of two mechanical oscillators, coupled to a single mode of an electromagnetic resonant cavity through a radiation-pressure interaction term, is driven by two pump tones and four detection tones. As previously discussed in the literature, the former induce entanglement between the two mechanical oscillators, while we show here that a specific choice of phase and amplitude of the detection tones allows for direct pairwise reconstruction of the collective quadrature fluctuations of the mechanical oscillators belonging to quantum-mechanics-free subspaces, thereby providing direct evidence of the entanglement properties of the two mechanical resonators.

arXiv:1907.09882•Physical Review A•Aug 15, 2019•7 citations

Utilizing single-mode squeezing and non-Gaussianity metrics to investigate bipartite and tripartite entanglement in three-mode ponderomotive optomechanics simulations

Kahlil Dixon, Lior Cohen, Narayan Bhusal +3 more

Quantum entanglement is a crucial resource for a wide variety of quantum technologies. However, the current state-of-art methods to generate quantum entanglement in optomechanical systems are not as efficient as all-optical methods utilizing nonlinear crystals. This article proposes a new scheme in which two single-mode squeezed light fields are injected into an optomechanical cavity. We demonstrate through our numerical simulations that the quantum entanglement can be substantially enhanced with the careful selection of squeezing strength and squeezing angle of the two quadrature squeezed light fields. Our results represent a significant improvement in output bipartite photon-photon entanglement over the previously demonstrated schemes using two coherent light fields as inputs. These simulations predict a maximum increase in Gaussian entanglement by a factor of about 6 for lossless input coupling, as well as increases in the quantum noise and non-Gaussianity of the output light. This non-Gaussianity is attributed to tripartite entanglement between the two optical fields and the optomechanical oscillator (OMO). At particular squeezing angles, the Gaussianity can be increased, thus introducing a method of optically controlling the intracavity entanglement. These mechanics can benefit various optical quantum technologies utilizing optomechanical entanglement and continuous variable quantum optics.

•Jul 15, 2021•0 citations

Single-mode input squeezing and tripartite entanglement in three-mode ponderomotive optomechanics simulations

Kahlil Dixon, Lior Cohen, Narayan Bhusal +3 more

Quantum entanglement is a crucial resource for a wide variety of quantum technologies. However, the current state-of-art methods to generate quantum entanglement in optomechanical systems are not as efficient as all-optical methods utilizing nonlinear crystals. This article proposes a new scheme in which two single-mode squeezed light fields are injected into an optomechanical cavity. We demonstrate through our numerical simulations that the quantum entanglement can be substantially enhanced with the careful selection of squeezing strength and squeezing angle of the two quadrature squeezed light fields. Our results represent a significant improvement in output bipartite photon-photon entanglement over the previously demonstrated schemes using two coherent light fields as inputs. These simulations predict a maximum increase in bipartite optical entanglement by a factor of about 6, as well as increases in the quantum noise of the output light. A perceived loss of quantum information at certain squeezing angles is attributed to tripartite entanglement between the two optical fields and the optomechanical oscillator (OMO). At particular squeezing angles, the bipartite (or tripartite) entanglement can be increased, thus introducing a method of optically controlling the intracavity entanglement. These mechanics can benefit various optical quantum technologies utilizing optomechanical entanglement and continuous variable quantum optics.

arXiv:2107.07053•Jul 15, 2021•0 citations

Generating of squeezed state and entanglement in cavity optomechanical system

Taha Yousif

We study theoretically a two-mode optomechanical system where two cavity modes are coupled to a single mechanical mode. It is shown that the whole system can yield good squeezing, which is comparable to that produced by dispersive coupling, the numerical results which we obtained showed periodic oscillations with a maximum peaks in one of the two quadrature component with a value less than 0.5. We also showed that entanglement can be achieved by calculating the variance in quadrature component of the field operators. Our results are useful in non- degenerate parametric oscillation.

Humanitarian and Natural Sciences Journal•May 1, 2023•0 citations
We investigate how to generate continuous-variable entanglement between distant optomechanical and spin systems, by transferring input two-mode squeezed vacuum state to the system. Such a setup has been proposed for backaction evading gravitational-wave measurement, squeezing the output noise below the standard quantum limit. We find that the spin cavity entanglement saturates to a particular value when no mechanics are involved even though the entanglement of the input beam increases steadily, and drops down when the mechanical oscillator interacts with the cavity. Our study also reveals that the spin optical readout rate enables the robustness of the spin-cavity entanglement with input squeezing whereas the optomechanical coupling strength disables it. The entanglement reaches its maximum when the effective resonance frequency and bandwidth of the cavity match the spin system. Determining collective quadrature fluctuations, our analysis also shows that even though the entanglement between spin and cavity, and cavity and mechanics is significantly present; it is still impossible to obtain entanglement between spin and mechanical oscillator.
We study theoretically a three-mode optomechanical system where two mechanical oscillators are coupled to a single cavity mode. By using two-tone (i.e., amplitude-modulated) driving of the cavity, it is possible to couple the cavity to a single collective quadrature of the mechanical oscillators. In such a way, a back-action-evading measurement of the collective mechanical quadrature is possible. We discuss how this can allow one to measure both quadratures of a mechanical force beyond the full quantum limit, paying close attention to the role of dissipation and experimental imperfections. We also describe how this scheme allows one to generate steady-state mechanical entanglement; namely, one can conditionally prepare an entangled, two-mode squeezed mechanical state. This entanglement can be verified directly from the measurement record by applying a generalized version of Duan's inequality; we also discuss how feedback can be used to produce unconditional entanglement.
We provide an argument to infer stationary entanglement between light and a mechanical oscillator based on continuous measurement of light only.We propose an experimentally realizable scheme involving an optomechanical cavity driven by a resonant, continuous-wave field operating in the non-sideband-resolved regime.This corresponds to the conventional configuration of an optomechanical position or force sensor.We show analytically that entanglement between the mechanical oscillator and the output field of the optomechanical cavity can be inferred from the measurement of squeezing in (generalized) Einstein-Podolski-Rosen quadratures of suitable temporal modes of the stationary light field.Squeezing can reach levels of up to 50% of noise reduction below shot noise in the limit of large quantum cooperativity.Remarkably, entanglement persists even in the opposite limit of small cooperativity.Viewing the optomechanical device as a position sensor, entanglement between mechanics and light is an instance of object-apparatus entanglement predicted by quantum measurement theory.
We propose here a fully backaction-evading scheme for the measurement of the entanglement between two nanomechanical resonators. The system, which consists of two mechanical oscillators, coupled to a single mode of an electromagnetic resonant cavity through a radiation-pressure interaction term, is driven by two pump tones and four detection tones. As previously discussed in the literature, the former induce entanglement between the two mechanical oscillators, while we show here that a specific choice of phase and amplitude of the detection tones allows for direct pairwise reconstruction of the collective quadrature fluctuations of the mechanical oscillators belonging to quantum-mechanics-free subspaces, thereby providing direct evidence of the entanglement properties of the two mechanical resonators.
Quantum entanglement is a crucial resource for a wide variety of quantum technologies. However, the current state-of-art methods to generate quantum entanglement in optomechanical systems are not as efficient as all-optical methods utilizing nonlinear crystals. This article proposes a new scheme in which two single-mode squeezed light fields are injected into an optomechanical cavity. We demonstrate through our numerical simulations that the quantum entanglement can be substantially enhanced with the careful selection of squeezing strength and squeezing angle of the two quadrature squeezed light fields. Our results represent a significant improvement in output bipartite photon-photon entanglement over the previously demonstrated schemes using two coherent light fields as inputs. These simulations predict a maximum increase in Gaussian entanglement by a factor of about 6 for lossless input coupling, as well as increases in the quantum noise and non-Gaussianity of the output light. This non-Gaussianity is attributed to tripartite entanglement between the two optical fields and the optomechanical oscillator (OMO). At particular squeezing angles, the Gaussianity can be increased, thus introducing a method of optically controlling the intracavity entanglement. These mechanics can benefit various optical quantum technologies utilizing optomechanical entanglement and continuous variable quantum optics.
Quantum entanglement is a crucial resource for a wide variety of quantum technologies. However, the current state-of-art methods to generate quantum entanglement in optomechanical systems are not as efficient as all-optical methods utilizing nonlinear crystals. This article proposes a new scheme in which two single-mode squeezed light fields are injected into an optomechanical cavity. We demonstrate through our numerical simulations that the quantum entanglement can be substantially enhanced with the careful selection of squeezing strength and squeezing angle of the two quadrature squeezed light fields. Our results represent a significant improvement in output bipartite photon-photon entanglement over the previously demonstrated schemes using two coherent light fields as inputs. These simulations predict a maximum increase in bipartite optical entanglement by a factor of about 6, as well as increases in the quantum noise of the output light. A perceived loss of quantum information at certain squeezing angles is attributed to tripartite entanglement between the two optical fields and the optomechanical oscillator (OMO). At particular squeezing angles, the bipartite (or tripartite) entanglement can be increased, thus introducing a method of optically controlling the intracavity entanglement. These mechanics can benefit various optical quantum technologies utilizing optomechanical entanglement and continuous variable quantum optics.
We study theoretically a two-mode optomechanical system where two cavity modes are coupled to a single mechanical mode. It is shown that the whole system can yield good squeezing, which is comparable to that produced by dispersive coupling, the numerical results which we obtained showed periodic oscillations with a maximum peaks in one of the two quadrature component with a value less than 0.5. We also showed that entanglement can be achieved by calculating the variance in quadrature component of the field operators. Our results are useful in non- degenerate parametric oscillation.