The second-order photon correlation function g2(τ) is of great importance in quantum optics. g2(τ) is typically measured with the Hanbury Brown and Twiss (HBT) interferometer, which employs a pair of single-photon detectors and a dual-channel time acquisition module. Here, we demonstrate a new method to measure and extract g2(τ) with a standard single-photon avalanche photodiode (dead-time = 22 ns) and a single-channel time acquisition module. This is realized by shifting the coincidence counts of interest to a time window not affected by the dead-time and after-pulse of the detection system using a fiber-based delay line. The new scheme is verified by measuring g2(τ) from a single colloidal nanocrystal. Photon antibunching is unambiguously observed and agrees well with the result measured using the standard HBT setup. Our scheme simplifies the higher-order correlation technique and might be favored in cost-sensitive circumstances.
The second-order photon correlation function g2(τ) is of great importance in quantum optics. g2(τ) is typically measured with the Hanbury Brown and Twiss (HBT) interferometer, which employs a pair of single-photon detectors and a dual-channel time acquisition module. Here, we demonstrate a new method to measure and extract g2(τ) with a standard single-photon avalanche photodiode (dead-time = 22 ns) and a single-channel time acquisition module. This is realized by shifting the coincidence counts of interest to a time window not affected by the dead-time and after-pulse of the detection system using a fiber-based delay line. The new scheme is verified by measuring g2(τ) from a single colloidal nanocrystal. Photon antibunching is unambiguously observed and agrees well with the result measured using the standard HBT setup. Our scheme simplifies the higher-order correlation technique and might be favored in cost-sensitive circumstances.
High-order photon correlations of light fields are important for characterizing the quantum nature. Since Hanbury Brown and Twiss conducted the pioneering experiments in the 1950s, the HBT effect has inspired extensive research on high-order photon correlation in quantum optics, quantum information, and quantum imaging. The Single-photon counting module is one of the most widely used single-photon detectors. Due to its high detection efficiency and low dark counts in the visible and near-infrared region, it is reasonably chosen for basic research on quantum mechanics. Many researches have demonstrated that the maximum value of second-order photon correlation g(2)(τ) at zero delay (τ = 0) can be used to distinguish different light fields. Therefore, the HBT scheme containing two single photon detectors have been widely used in many advanced studies, such as space interference, ghost imaging, single photon detection with high efficiency, etc. However, higher-order photon correlations g(n) (n > 2) can reveal more measurable characteristics of light fields, such as information about the non-Gaussian scattering process, the skewness and kurtosis of photon number distribution, etc. When the extended HBT scheme is used to measure higher-order photon correlations, the experimental conditions including quantum efficiency and background noise greatly affect the photon correlation measurement. The influences of the counting rate and resolution time of the detection system on the measurements are also very important and cannot be ignored. Therefore, the comprehensive considering of various influence factors is necessary for accurately measuring the high-order photon correlations and also a challenge. In this paper, we present a method based on double Hanbury Brown-Twiss scheme for the accurate measuring of high-order photon correlations g(n) (n > 2). The system consists of four single photon counting modules and is used to detect and analyze the joint distribution probability of temporal photon correlation. Considering the effects of the background noise and overall efficiency, theoretically, we analyze the correlations of the third- and fourth-order photon with the incident light intensity, squeezing parameter and photon number respectively for thermal state, coherent state, squeezed vacuum state, and Fock state. Meanwhile, experimentally we study the influences of resolution time and counting rate on correlations of the coherent state and thermal state with third- and fourth-order photon. On condition that the resolution time is 210 ns and the counting rate is 80 kc/s, the correlations of third and fourth-order photon with the thermal state at zero time delay are accurately measured, and the relative statistical deviations of the measured vales from the theoretical values are 0.3% and 0.8%, respectively. In addition, the third- and fourth-order photon correlations of the thermal state at different delay times are also observed. It is demonstrated that the high-order photon correlations of light fields are measured accurately by comprehensively analyzing various influencing factors. This technique provides a promising and useful tool to investigate quantum correlated imaging and quantum coherence of light fields.
Photon anti-bunching, which is characterized by the second-order temporal coherence function g(2)(0) < g(2)(τ), has previously been measured using single-photon counting methods. We experimentally demonstrate a homodyne detection technique for measuring the second-order coherence g(2)(τ) of quantum states of light at sideband frequencies. Our scheme is based on the original Hanbury-Brown-Twiss (HBT) intensity interferometer, but instead replaces all use of photon counters with homodyne detection in each arm (see Fig. 1). The second-order coherence, g(2)(τ), is obtained from a set of quadrature amplitude measurements.
The Hanbury Brown–Twiss (HBT) interferometer, which is used to measure the correlation of two photons or two light beams, has played a crucial role in quantum optics and quantum information. We propose a generalized HBT interferometer, which is able to measure the correlation of photons or light beams up to eight in a single experimental run. With an improved time correlated single-photon counting (TCSPC) algorithm, two-, three-, and four-photon coincidence counts, and the degree of fifth-order coherence of pseudothermal light are measured with a data collection time of 60 s. The generalized HBT interferometer can be used to measure the correlation of two multi-photon detection events by simulating photon number resolving detectors with multiple single-photon detectors. The generalized HBT interferometer and improved TCSPC algorithm provide a versatile framework for studying multi-photon correlations and interference, which is helpful to understand the physics of multi-photon interference and may find applications in fluorescence lifetime imaging and other techniques using TCSPC.
We measure second- and third-order temporal coherences, g((2))(τ) and g((3))(τ1,τ2), of an optically excited single-photon source: an InGaAs quantum dot in a microcavity pedestal. Increasing the optical excitation power leads to an increase in the measured count rate, and also an increase in multi-photon emission probability. We show that standard measurements of g((2)) provide limited information about this multi-photon probability, and that more information can be gained by simultaneously measuring g((3)). Experimental results are compared with a simple theoretical model to show that the observed antibunchings are consistent with an incoherent addition of two sources: 1) an ideal single-photon source that never emits multiple photons and 2) a background cavity emission having Poissonian photon number statistics. Spectrally resolved cross-correlation measurements between quantum-dot and cavity modes show that photons from these two sources are largely uncorrelated, further supporting the model. We also analyze the Hanbury Brown-Twiss interferometer implemented with two or three "click" detectors, and explore the conditions under which it can be used to accurately measure g((2))(τ) and g((3))(τ1,τ2).
Understanding the boundary between classical and nonclassical phenomena is important for both fundamental researches in quantum optics and applications in quantum information. One of the most interesting research directions in this field is exploring nonclassical effects with classical light. In this paper, we will show that it is possible to observe antibunching with thermal light in a Hanbury Brown-Twiss interferometer by treating single-photon detectors as photon-number-resolving detectors to perform photon-number projection measurements. Both temporal and spatial antibunching is observed via the correlation of two detectors detecting one and zero photon, respectively. By comparing the measured results of thermal and laser light, it is found that the observed antibunching arises from the combined effect of photon statistics of thermal light and photon-number projection measurement.The classical and nonclassical nature of the observed antibunching is analyzed. The results are helpful to understand the connection between classical and nonclassical correlation and may find applications in multiphoton interference and quantum imaging.
Photon anti-bunching, or the tendency of photons to be detected apart from one another, is characterized by the second-order coherence function which has previously been measured using discrete-variable (DV) single-photon counting methods. The authors theoretically propose and experimentally demonstrate a continuous-variable (CV) technique for measuring the second-order coherence of quantum states of light at sideband frequencies. The scheme is based on the original Hanbury-Brown-Twiss (HBT) intensity interferometer, but instead uses optical homodyne detection in each arm, to obtain the second-order coherence from a set of quadrature amplitude correlation measurements (each of which can be independently time-averaged).