Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:2008.03504 · Optics Express

Reduction of laser intensity noise over 1 MHz band for single atom trapping

Yu Wang, Kenneth Wang, Eliot F. Fenton, Yen-Wei Lin, Kang-Kuen Ni, Jonathan D. Hood

Published Sep 25, 2020• 28 citations
arXivHTMLPDF

Abstract

We reduce the intensity noise of laser light by using an electro-optic modulator and acousto-optic modulator in series. The electro-optic modulator reduces noise at high frequency (10 kHz to 1 MHz), while the acousto-optic modulator sets the average power of the light and reduces noise at low frequency (up to 10 kHz). The light is then used to trap single sodium atoms in an optical tweezer, where the lifetime of the atoms is limited by parametric heating due to laser noise at twice the trapping frequency. With our noise eater, the noise is reduced by up to 15 dB at these frequencies and the lifetime of the atom in the optical tweezer is increased by an order of magnitude to around 6 seconds. Our technique is general and acts directly on the laser beam, expanding laser options for sensitive optical trapping applications.

DOI
10.1364/oe.405002

Related papers

Influence of Laser Intensity Fluctuation on Single-Cesium Atom Trapping Lifetime in a 1064-nm Microscopic Optical Tweezer

Rui Sun, Xin Wang, Kong Zhang +2 more

An optical tweezer composed of a strongly focused single-spatial-mode Gaussian beam of a red-detuned 1064-nm laser can confine a single-cesium (Cs) atom at the strongest point of the light intensity. We can use this for coherent manipulation of single-quantum bits and single-photon sources. The trapping lifetime of the atoms in the optical tweezers is very short due to the impact of the background atoms, the parametric heating of the optical tweezer and the residual thermal motion of the atoms. In this paper, we analyzed the influence of the background pressure, the trap frequency of optical tweezers and the laser intensity fluctuation of optical tweezers on the atomic trapping lifetime. Combined with the external feedback loop based on an acousto-optical modulator (AOM), the intensity fluctuation of the 1064-nm laser in the time domain was suppressed from ±3.360% to ±0.064%, and the suppression bandwidth in the frequency domain reached approximately 33 kHz. The trapping lifetime of a single-Cs atom in the microscopic optical tweezers was extended from 4.04 s to 6.34 s.

arXiv:2003.08415•Applied Sciences•Jan 16, 2020•5 citations

Laser Intensity Noise Suppression for Preparing Audio-Frequency Squeezed Vacuum State of Light

Lele Bai, Xin Wen, Yulin Yang +2 more

Laser intensity noise suppression has essential effects on preparation and characterization of the audio-frequency squeezed vacuum state of light based on a sub-threshold optical parametric oscillator (OPO). We have implemented two feedback loops by using relevant acousto-optical modulators (AOM) to stabilize the intensity of 795-nm near infrared (NIR) fundamental laser and 397.5-nm ultraviolet (UV) laser generated by cavity-enhanced frequency doubling. Typical peak-to-peak laser intensity fluctuation with a bandwidth of ~10 kHz in a half hour has been improved from ±7.45% to ±0.06% for 795-nm NIR laser beam, and from ±9.04% to ±0.05% for 397.5-nm UV laser beam, respectively. The squeezing level of the squeezed vacuum state at 795 nm prepared by the sub-threshold OPO with a PPKTP crystal has been improved from −3.3 to −4.0 dB around 3~9 kHz of analysis frequency range.

arXiv:2003.05090•Applied Sciences•Feb 20, 2020•5 citations

Acousto-optic modulator based frequency stabilized diode laser system for atom trapping

Peter D. McDowall, Mikkel F. Andersen

We report on an inexpensive commercial laser diode stabilized to the D(2)-line in rubidium using a simple scheme. The linewidth was reduced to 1.3 MHz without an external cavity, making it suitable for laser cooling and trapping. The system is very robust and the laser frequency can be changed rapidly (within 51 micros) while the laser remains in lock. The frequency of the locked laser drifts less than 850 kHz peak-to-peak over 25 h. We demonstrate laser cooling and trapping using our system.

Review of Scientific Instruments•May 1, 2009•7 citations

Sub-megahertz laser stabilization by harnessing orthogonality between the acousto-optic modulator dither and atomic spectroscopy

Phatwarach Siriworakoonchai, Parinya Udommai, Nuttanan Tanasanchai +1 more

A sub-MHz frequency stability of the laser is crucial in the quantum-atom experiment where precise atomic transition is required for control and manipulation of atom like in the atom quantum computing. In this work, we have built the frequency stabilization system for the lasers used in our cold Rubidium atom experiment in the magneto-optical trap (MOT) and the optical tweezers. We utilized a Rubidium vapour glass cell as a frequency reference, which provides atomically absolute reference point with low complexity setup. By mean of the absorption of the laser beam by the Rubidium vapour, the Doppler-free saturated absorption (DFSA) experiment was setup to produce the D2 line spectra. The acousto-optic modulator (AOM) was used to sinusoidally dither the laser frequency and consequently the resonance peaks in the spectra. Detailing in this work, the AOM sinusoidal dithering and the dithered DFSA signal had orthogonality and were processed together to produce the error signal used to stabilize the laser frequency to the resonant peak. This frequency stabilization system achieved the frequency standard deviation below 0.75 MHz over 200 minutes period. The system also allowed for stabilized frequency tunability over a range of 55-60 MHz about the target resonance peak. This performance is significant for stabilizing the lasers in the MOT experiment and related quantum-atom research.

Results in Optics•Oct 28, 2025•3 citations

A phase-modulated laser system of ultra-low phase noise for compact atom interferometers

Ki-Se Lee, Jaewan Kim, Sang-Bum Lee +2 more

A compact and robust laser system is essential for mobile atom interferometers. Phase modulation can provide the two necessary phase-coherent frequencies without sophisticated phase-locking between two different lasers. However, the additional laser frequencies generated can perturb the atom interferometer. In this article, we report on a novel method to produce a single high-power laser beam composed of two phase-coherent sidebands without the perturbing carrier mode. Light from a diode laser is phase-modulated by using a fiber-coupled electro-optic modulator driven at 3.4 GHz and passes through a Fabry-Perot cavity with a 6.8 GHz free spectral range. The cavity filters the carrier mode to leave the two first-order sidebands for the two-photon Raman transition between the two hyperfine ground states of 87 Rb. The laser beam is then fed to a single tapered amplifier, and the two sidebands are both amplified without mode competition. The phase noise is lower than that of a state-of-the-art optically phase-locked external-cavity diode laser (−135 dBrad 2 /Hz at 10 kHz) at frequencies above 10 Hz. This technique can be used in all-fiber-based laser systems for future mobile atom interferometers.

Journal of the Korean Physical Society•Jul 1, 2015•13 citations

Noise reduction and hyperfine level coherence in spontaneous noise spectroscopy of atomic vapor

Takahisa Mitsui, Kenichiro Aoki

We developed a system for measurements of power spectra of transmitted light intensity fluctuations, in which the extraneous noise, including shot noise, is reduced. In essence, we just apply light, measure the power of the transmitted light, and derive its power spectrum. We use this to observe the spontaneous noise spectra of photon atom interactions. Applying light with frequency modulation, we can also observe the spontaneous noise reflecting the coherence between the hyperfine levels in the excited state. There are two main novel components in the measurement system, the noise reduction scheme and the stabilization of the laser system. The noise reduction mechanism can be used to reduce the shot noise contribution to arbitrarily low levels through averaging, in principle. This is combined with differential detection to keep unwanted noise at low levels. The laser system is stabilized to obtain spectral width below 1 kHz without high frequency (≳10 MHz) noise. These methods are described systematically and the performance of the measurement system is examined through experimental results.

arXiv:1309.3097•Journal of the Optical Society of America B•Jan 2, 2014•7 citations
We reduce the intensity noise of laser light by using an electro-optic modulator and acousto-optic modulator in series. The electro-optic modulator reduces noise at high frequency (10 kHz to 1 MHz), while the acousto-optic modulator sets the average power of the light and reduces noise at low frequency (up to 10 kHz). The light is then used to trap single sodium atoms in an optical tweezer, where the lifetime of the atoms is limited by parametric heating due to laser noise at twice the trapping frequency. With our noise eater, the noise is reduced by up to 15 dB at these frequencies and the lifetime of the atom in the optical tweezer is increased by an order of magnitude to around 6 seconds. Our technique is general and acts directly on the laser beam, expanding laser options for sensitive optical trapping applications.
An optical tweezer composed of a strongly focused single-spatial-mode Gaussian beam of a red-detuned 1064-nm laser can confine a single-cesium (Cs) atom at the strongest point of the light intensity. We can use this for coherent manipulation of single-quantum bits and single-photon sources. The trapping lifetime of the atoms in the optical tweezers is very short due to the impact of the background atoms, the parametric heating of the optical tweezer and the residual thermal motion of the atoms. In this paper, we analyzed the influence of the background pressure, the trap frequency of optical tweezers and the laser intensity fluctuation of optical tweezers on the atomic trapping lifetime. Combined with the external feedback loop based on an acousto-optical modulator (AOM), the intensity fluctuation of the 1064-nm laser in the time domain was suppressed from ±3.360% to ±0.064%, and the suppression bandwidth in the frequency domain reached approximately 33 kHz. The trapping lifetime of a single-Cs atom in the microscopic optical tweezers was extended from 4.04 s to 6.34 s.
Laser intensity noise suppression has essential effects on preparation and characterization of the audio-frequency squeezed vacuum state of light based on a sub-threshold optical parametric oscillator (OPO). We have implemented two feedback loops by using relevant acousto-optical modulators (AOM) to stabilize the intensity of 795-nm near infrared (NIR) fundamental laser and 397.5-nm ultraviolet (UV) laser generated by cavity-enhanced frequency doubling. Typical peak-to-peak laser intensity fluctuation with a bandwidth of ~10 kHz in a half hour has been improved from ±7.45% to ±0.06% for 795-nm NIR laser beam, and from ±9.04% to ±0.05% for 397.5-nm UV laser beam, respectively. The squeezing level of the squeezed vacuum state at 795 nm prepared by the sub-threshold OPO with a PPKTP crystal has been improved from −3.3 to −4.0 dB around 3~9 kHz of analysis frequency range.
A sub-MHz frequency stability of the laser is crucial in the quantum-atom experiment where precise atomic transition is required for control and manipulation of atom like in the atom quantum computing. In this work, we have built the frequency stabilization system for the lasers used in our cold Rubidium atom experiment in the magneto-optical trap (MOT) and the optical tweezers. We utilized a Rubidium vapour glass cell as a frequency reference, which provides atomically absolute reference point with low complexity setup. By mean of the absorption of the laser beam by the Rubidium vapour, the Doppler-free saturated absorption (DFSA) experiment was setup to produce the D2 line spectra. The acousto-optic modulator (AOM) was used to sinusoidally dither the laser frequency and consequently the resonance peaks in the spectra. Detailing in this work, the AOM sinusoidal dithering and the dithered DFSA signal had orthogonality and were processed together to produce the error signal used to stabilize the laser frequency to the resonant peak. This frequency stabilization system achieved the frequency standard deviation below 0.75 MHz over 200 minutes period. The system also allowed for stabilized frequency tunability over a range of 55-60 MHz about the target resonance peak. This performance is significant for stabilizing the lasers in the MOT experiment and related quantum-atom research.
A compact and robust laser system is essential for mobile atom interferometers. Phase modulation can provide the two necessary phase-coherent frequencies without sophisticated phase-locking between two different lasers. However, the additional laser frequencies generated can perturb the atom interferometer. In this article, we report on a novel method to produce a single high-power laser beam composed of two phase-coherent sidebands without the perturbing carrier mode. Light from a diode laser is phase-modulated by using a fiber-coupled electro-optic modulator driven at 3.4 GHz and passes through a Fabry-Perot cavity with a 6.8 GHz free spectral range. The cavity filters the carrier mode to leave the two first-order sidebands for the two-photon Raman transition between the two hyperfine ground states of 87 Rb. The laser beam is then fed to a single tapered amplifier, and the two sidebands are both amplified without mode competition. The phase noise is lower than that of a state-of-the-art optically phase-locked external-cavity diode laser (−135 dBrad 2 /Hz at 10 kHz) at frequencies above 10 Hz. This technique can be used in all-fiber-based laser systems for future mobile atom interferometers.
We developed a system for measurements of power spectra of transmitted light intensity fluctuations, in which the extraneous noise, including shot noise, is reduced. In essence, we just apply light, measure the power of the transmitted light, and derive its power spectrum. We use this to observe the spontaneous noise spectra of photon atom interactions. Applying light with frequency modulation, we can also observe the spontaneous noise reflecting the coherence between the hyperfine levels in the excited state. There are two main novel components in the measurement system, the noise reduction scheme and the stabilization of the laser system. The noise reduction mechanism can be used to reduce the shot noise contribution to arbitrarily low levels through averaging, in principle. This is combined with differential detection to keep unwanted noise at low levels. The laser system is stabilized to obtain spectral width below 1 kHz without high frequency (≳10 MHz) noise. These methods are described systematically and the performance of the measurement system is examined through experimental results.