Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:2005.13292 · Physical Review Applied

Experimental Diagnostics of Entanglement Swapping by a Collective Entanglement Test

Vojtěch Trávníček, Karol Bartkiewicz, Antonín Černoch, Karel Lemr

Published Dec 24, 2020• 6 citations
arXivHTMLPDF

Abstract

This paper reports on the experimental diagnostics of an entanglement-swapping protocol by means of collective entanglement witness. Our approach is suitable to detect disturbances occurring in the preparation of quantum states, quantum-communication channels, and imperfect Bell-state projections. More specifically, we demonstrate that our method can distinguish disturbances such as depolarization, phase damping, amplitude damping, and imperfect Bell-state measurement by observing four probabilities and estimating collective entanglement witness. Since entanglement swapping is a key procedure for quantum repeaters, quantum relays, device-independent quantum communications, and entanglement-assisted error correction, this can aid in faster and practical resolutions of quality of transmission related problems as our approach requires fewer measurements than other means of diagnostics.

DOI
10.1103/physrevapplied.14.064071

Related papers

Bell nonlocality and fully entangled fraction measured in an entanglement-swapping device without quantum state tomography

Karol Bartkiewicz, Karel Lemr, Antonín Černoch +1 more

We propose and experimentally implement an efficient procedure based on entanglement swapping to determine the Bell nonlocality measure of Horodecki et al. [Phys. Lett. A 200, 340 (1995)] and the fully entangled fraction of Bennett et al. [Phys. Rev. A 54, 3824 (1996)] of an arbitrary two-qubit polarization-encoded state. The nonlocality measure corresponds to the amount of the violation of the Clauser-Horne-Shimony-Holt (CHSH) optimized over all measurement settings. By using simultaneously two copies of a given state, we measure directly only six parameters. This is an experimental determination of these quantities without quantum state tomography or continuous monitoring of all measurement bases in the usual CHSH inequality tests. We analyze how well the measured degrees of Bell nonlocality and other entanglement witnesses (including the fully entangled fraction and a nonlinear entropic witness) of an arbitrary two-qubit state can estimate its entanglement. In particular, we measure these witnesses and estimate the negativity of various two-qubit Werner states. Our approach could especially be useful for quantum communication protocols based on entanglement swapping.

arXiv:1609.09653•Physical Review A•Mar 13, 2017•39 citations

Genuine Multipartite Entanglement Detection with Imperfect Measurements: Concept and Experiment

Huan Cao, Simon Morelli, Lee A. Rozema +3 more

Standard procedures for entanglement detection assume that experimenters can exactly implement specific quantum measurements. Here, we depart from such idealizations and investigate, in both theory and experiment, the detection of genuine multipartite entanglement when measurements are subject to small imperfections. For arbitrary qubits number n, we construct multipartite entanglement witnesses where the detrimental influence of the imperfection is independent of n. In a tabletop four-partite photonic experiment, we demonstrate first how a small amount of alignment error can undermine the conclusions drawn from standard entanglement witnesses and then perform the correction analysis. Furthermore, since we consider quantum devices that are trusted but not perfectly controlled, we showcase advantages in terms of noise resilience as compared to device-independent models.

arXiv:2310.11946•Physical Review Letters•Oct 7, 2024•23 citations

Resource-Efficient Measurement-Device-Independent Entanglement Witness

E. Verbanis, Anthony Martin, Denis Rosset +3 more

Imperfections in experimental measurement schemes can lead to falsely identifying, or over estimating, entanglement in a quantum system. A recent solution to this is to define schemes that are robust to measurement imperfections-measurement-device-independent entanglement witness (MDI-EW). This approach can be adapted to witness all entangled qubit states for a wide range of physical systems and does not depend on detection efficiencies or classical communication between devices. Here we extend the theory to remove the necessity of prior knowledge about the two-qubit states to be witnessed. Moreover, we tested this model via a novel experimental implementation for MDI-EW that significantly reduces the experimental complexity. By applying it to a bipartite Werner state, we demonstrate the robustness of this approach against noise by witnessing entanglement down to an entangled state fraction close to 0.4.

arXiv:1510.01203•Physical Review Letters•May 9, 2016•43 citations

Experimental Realization of Robust Self-Testing of Bell State Measurements

Wen-Hao Zhang, Geng Chen, Xing-Xiang Peng +6 more

Bell state measurements, of which the eigenvectors are in an entangled form, are crucial resources in the construction of quantum networks. Therefore, device-independent certification of a Bell state measurement has significance in the quantum information process because it satisfies the exact demand on security. In this study, we implement a proof-of-concept experiment to certify a Bell state measurement device independently in an entanglement swapping process, namely, self-testing. Instead of preparing a tensor product of two singlets with four photons, multiplex encoding in polarization and spatial modes is utilized to produce two pairs of entangled qubits. As a result, we implement a full Bell state measurement and achieve a high degree of Bell violation on the remaining two qubits, which are required for nontrivial self-testing of a Bell state measurement. Furthermore, our results combine the correlations before and after the swapping; thus, the quality of the performed Bell state measurement can be precisely inferred.

Physical Review Letters•Mar 8, 2019•27 citations

Device-independent characterization of entanglement based on bell nonlocality

Geng Chen, Wen-Hao Zhang, Peng Yin +2 more

Quantum entanglement, has been acknowledged as a precious resource due to its inherent nonclassical correlations between subsystems. These quantum correlations have the potential for many quantum processes, including canonical ones: quantum cryptography, quantum teleportation, and dense coding. To exploit the advantages of quantum entanglement, two essential premises are required, i.e., to prepare high-quality entanglement and characterize quality level of prepared entanglement. Thus far, quantum entanglement can be produced in various quantum systems; however, it appears that this new resource is complex and difficult to characterize. The standard methods to characterize multipartite entanglement, e.g., entanglement witness, state tomography, or quantum state verification, require full knowledge of the Hilbert space dimension and precise calibration of measurement devices, which are usually difficult to acquire in experiment. The most radical way to overcome these problems is to detect entanglement solely based on the Bell-like correlations of measurement outcomes collected in the experiment, namely, device-independent characterization of entanglement. This article reviews the recently developed device-independent methods to characterize entanglement, including self-testing and device-independent certification of entanglement. These approaches can be widely applied in kinds of quantum information processing, especially for those with security demands.

Fundamental Research•Jan 1, 2021•19 citations

Implementation of a Measurement-Device-Independent Entanglement Witness

Ping Xu, Xiao Yuan, Luo-Kan Chen +5 more

Entanglement, the essential resource in quantum information processing, should be witnessed in many tasks such as quantum computing and quantum communication. The conventional entanglement witness method, relying on an idealized implementation of measurements, could wrongly conclude a separable state to be entangled due to imperfect detections. Inspired by the idea of a time-shift attack, we construct an attack on the conventional entanglement witness process and demonstrate that a separable state can be falsely identified to be entangled. To close such detection loopholes, based on a recently proposed measurement-device-independent entanglement witness method, we design and experimentally demonstrate a measurement-device-independent entanglement witness for a variety of two-qubit states. By the new scheme, we show that an entanglement witness can be realized without detection loopholes.

arXiv:1404.4205•Physical Review Letters•Apr 10, 2014•58 citations
This paper reports on the experimental diagnostics of an entanglement-swapping protocol by means of collective entanglement witness. Our approach is suitable to detect disturbances occurring in the preparation of quantum states, quantum-communication channels, and imperfect Bell-state projections. More specifically, we demonstrate that our method can distinguish disturbances such as depolarization, phase damping, amplitude damping, and imperfect Bell-state measurement by observing four probabilities and estimating collective entanglement witness. Since entanglement swapping is a key procedure for quantum repeaters, quantum relays, device-independent quantum communications, and entanglement-assisted error correction, this can aid in faster and practical resolutions of quality of transmission related problems as our approach requires fewer measurements than other means of diagnostics.
We propose and experimentally implement an efficient procedure based on entanglement swapping to determine the Bell nonlocality measure of Horodecki et al. [Phys. Lett. A 200, 340 (1995)] and the fully entangled fraction of Bennett et al. [Phys. Rev. A 54, 3824 (1996)] of an arbitrary two-qubit polarization-encoded state. The nonlocality measure corresponds to the amount of the violation of the Clauser-Horne-Shimony-Holt (CHSH) optimized over all measurement settings. By using simultaneously two copies of a given state, we measure directly only six parameters. This is an experimental determination of these quantities without quantum state tomography or continuous monitoring of all measurement bases in the usual CHSH inequality tests. We analyze how well the measured degrees of Bell nonlocality and other entanglement witnesses (including the fully entangled fraction and a nonlinear entropic witness) of an arbitrary two-qubit state can estimate its entanglement. In particular, we measure these witnesses and estimate the negativity of various two-qubit Werner states. Our approach could especially be useful for quantum communication protocols based on entanglement swapping.
Standard procedures for entanglement detection assume that experimenters can exactly implement specific quantum measurements. Here, we depart from such idealizations and investigate, in both theory and experiment, the detection of genuine multipartite entanglement when measurements are subject to small imperfections. For arbitrary qubits number n, we construct multipartite entanglement witnesses where the detrimental influence of the imperfection is independent of n. In a tabletop four-partite photonic experiment, we demonstrate first how a small amount of alignment error can undermine the conclusions drawn from standard entanglement witnesses and then perform the correction analysis. Furthermore, since we consider quantum devices that are trusted but not perfectly controlled, we showcase advantages in terms of noise resilience as compared to device-independent models.
Imperfections in experimental measurement schemes can lead to falsely identifying, or over estimating, entanglement in a quantum system. A recent solution to this is to define schemes that are robust to measurement imperfections-measurement-device-independent entanglement witness (MDI-EW). This approach can be adapted to witness all entangled qubit states for a wide range of physical systems and does not depend on detection efficiencies or classical communication between devices. Here we extend the theory to remove the necessity of prior knowledge about the two-qubit states to be witnessed. Moreover, we tested this model via a novel experimental implementation for MDI-EW that significantly reduces the experimental complexity. By applying it to a bipartite Werner state, we demonstrate the robustness of this approach against noise by witnessing entanglement down to an entangled state fraction close to 0.4.
Bell state measurements, of which the eigenvectors are in an entangled form, are crucial resources in the construction of quantum networks. Therefore, device-independent certification of a Bell state measurement has significance in the quantum information process because it satisfies the exact demand on security. In this study, we implement a proof-of-concept experiment to certify a Bell state measurement device independently in an entanglement swapping process, namely, self-testing. Instead of preparing a tensor product of two singlets with four photons, multiplex encoding in polarization and spatial modes is utilized to produce two pairs of entangled qubits. As a result, we implement a full Bell state measurement and achieve a high degree of Bell violation on the remaining two qubits, which are required for nontrivial self-testing of a Bell state measurement. Furthermore, our results combine the correlations before and after the swapping; thus, the quality of the performed Bell state measurement can be precisely inferred.
Quantum entanglement, has been acknowledged as a precious resource due to its inherent nonclassical correlations between subsystems. These quantum correlations have the potential for many quantum processes, including canonical ones: quantum cryptography, quantum teleportation, and dense coding. To exploit the advantages of quantum entanglement, two essential premises are required, i.e., to prepare high-quality entanglement and characterize quality level of prepared entanglement. Thus far, quantum entanglement can be produced in various quantum systems; however, it appears that this new resource is complex and difficult to characterize. The standard methods to characterize multipartite entanglement, e.g., entanglement witness, state tomography, or quantum state verification, require full knowledge of the Hilbert space dimension and precise calibration of measurement devices, which are usually difficult to acquire in experiment. The most radical way to overcome these problems is to detect entanglement solely based on the Bell-like correlations of measurement outcomes collected in the experiment, namely, device-independent characterization of entanglement. This article reviews the recently developed device-independent methods to characterize entanglement, including self-testing and device-independent certification of entanglement. These approaches can be widely applied in kinds of quantum information processing, especially for those with security demands.
Entanglement, the essential resource in quantum information processing, should be witnessed in many tasks such as quantum computing and quantum communication. The conventional entanglement witness method, relying on an idealized implementation of measurements, could wrongly conclude a separable state to be entangled due to imperfect detections. Inspired by the idea of a time-shift attack, we construct an attack on the conventional entanglement witness process and demonstrate that a separable state can be falsely identified to be entangled. To close such detection loopholes, based on a recently proposed measurement-device-independent entanglement witness method, we design and experimentally demonstrate a measurement-device-independent entanglement witness for a variety of two-qubit states. By the new scheme, we show that an entanglement witness can be realized without detection loopholes.