Abstract We explore routing of propagating phonons in analogy with previous experiments on photons. Surface acoustic waves (SAWs) in the microwave regime are scattered by a superconducting transmon qubit. The transmon can be tuned on or off resonance with the incident SAW field using an external magnetic field or the Autler–Townes effect, and thus the reflection and transmission of the SAW field can be controlled in time. We observe 80% extinction in the transmission of the low power continuous signal and a 40 ns rise time of the router. The slow propagation speed of SAWs on solid surfaces allows for in-flight manipulations of the propagating phonons. The ability to route short, 100 ns, pulses enables new functionality, for instance to catch an acoustic phonon between two qubits and then release it in a controlled direction.
Abstract We explore routing of propagating phonons in analogy with previous experiments on photons. Surface acoustic waves (SAWs) in the microwave regime are scattered by a superconducting transmon qubit. The transmon can be tuned on or off resonance with the incident SAW field using an external magnetic field or the Autler–Townes effect, and thus the reflection and transmission of the SAW field can be controlled in time. We observe 80% extinction in the transmission of the low power continuous signal and a 40 ns rise time of the router. The slow propagation speed of SAWs on solid surfaces allows for in-flight manipulations of the propagating phonons. The ability to route short, 100 ns, pulses enables new functionality, for instance to catch an acoustic phonon between two qubits and then release it in a controlled direction.
Surface acoustic waves (SAWs) are mechanical vibrations that propagate on the surface of solids while dissipating little power, consequently enabling them to propagate freely over long distances. The speed and wavelength of SAWs are reduced a five order of magnitude compared to when light is used as a carrier at gigahertz frequencies. The unique properties of SAWs combined with the possibility to let them interact with artificial atoms, discovered and shown for the very first time in appended Paper I of this thesis, open up for exploration of new regimes of quantum physics. The appended Paper II is a book chapter providing an overview of many of the new areas of research, as well as going into depth of the method and significance of the results ofthe appended Paper I.The essential interaction between artificial atoms and SAWs was further investigated by using Autler-Townes splitting to achieve fast control of the interactions. The appended Paper IV, shows a transmitted field extinction of 80 %, and provides proof of concept for a SAW router in the quantum regime. In addition, due to the artificial atom's highly frequency dependent coupling to SAWs, electromagnetically induced transparency (EIT) could be observed in the appended Paper V. Furthermore, the EIT region was distinguished from the Autler-Townes splitting region by a threshold in the applied power. The results produce parallel findings to quantum optics, but are perhaps best described as part of a different field, quantum acoustics.Among the many possible areas of research emerging as an outcome of this work, a variety of potential quantum experiments would benefit greatly from a higher conversion efficiency between electric signals and SAWs. Due to this, focus was put on improving this conversion efficiency by studying superconducting unidirectional transducers (UDTs), making use of advances in classical SAW devices. The appended Paper III shows that 99.4~\\% of the acoustic power can be focused in a desired direction and that the conversion between electric signals and SAWs is greatly improved by using UDTs, thereby eliminating the largest source of loss of symmetric inter-digital transducers. There is, however, a trade-off between conversion efficiency and bandwidth. This finding allows tailoring of quantum experiments based on SAWs that may pave the way towards measuring quantum sound.
Photon blockade via a giant self-Kerr nonlinearity in an optical resonator induced by an N-type quantum system is one of the main routines towards photon-based quantum information processing. However, such an N-type system for phonons is lacking. We propose an effective N-type quantum system for phonons, forming from a superconducting transmon qubit and a microwave resonator. In the absence of any external driving, the quantum vacuum-qubit interaction causes the surface acoustic wave (SAW) phonon blockade. Such a vacuum-induced phonon blockade paves the way to prepare single SAW phonons from a weak coherent phononic state for SAW accessible superconducting quantum computation.
Abstract Surface acoustic waves are commonly used in classical electronics applications, and their use in quantum systems is beginning to be explored, as evidenced by recent experiments using acoustic Fabry–Pérot resonators. Here we explore their use for quantum communication, where we demonstrate a single-phonon surface acoustic wave transmission line, which links two physically separated qubit nodes. Each node comprises a microwave phonon transducer, an externally controlled superconducting variable coupler, and a superconducting qubit. Using this system, precisely shaped individual itinerant phonons are used to coherently transfer quantum information between the two physically distinct quantum nodes, enabling the high-fidelity node-to-node transfer of quantum states as well as the generation of a two-node Bell state. We further explore the dispersive interactions between an itinerant phonon emitted from one node and interacting with the superconducting qubit in the remote node. The observed interactions between the phonon and the remote qubit promise future quantum-optics-style experiments with itinerant phonons.
The past 20 years has seen rapid developments in circuit quantum electrodynamics, where superconducting qubits and resonators are used to control and study quantum light-matter interaction at a fundamental level. The development of this field is strongly influenced by quantum information science and the prospect of realizing quantum computation, but also opens up opportunities for combinations of different physical systems and research areas. Superconducting circuits in the microwave domain offer a versatile platform for interfacing with other quantum systems thanks to strong nonlinearities and zero-point fluctuations, as well as flexibility in design and fabrication. Hybrid quantum systems based on circuit quantum electrodynamics could enable novel functionalities by exploiting the strengths of the individual components.This thesis covers experiments coupling superconducting circuits to surface acoustic waves (SAWs), mechanical waves propagating along the surface of a solid. Strong coupling can be engineered using the piezoelectric properties of GaAs substrates, and our experiments exploit this to investigate phenomena in quantum field-matter interaction. A key property of surface acoustic waves is the slow propagation speed, typically five orders of magnitude slower than light in vacuum, and the associated short wavelength. This enables the giant atom regime where the artificial atom in the form of a superconducting circuit is large compared to the wavelength of interacting SAW radiation, a condition which is difficult to realize in other systems. Experiments described in this thesis use these properties to demonstrate electromagnetically induced transparency for a mechanical mode, as well as non-Markovian interactions between an artificial giant atom and the SAW field. When the SAW field is confined to a resonant cavity, the short wavelength allows multimode spectra suitable for interacting with a frequency comb. We use a multimode SAW resonator to characterize the ensemble of microscopic two-level system defects with a two-tone spectroscopy approach. Finally, we introduce a hybrid superconducting-SAW resonator with applications in quantum information processing in mind. Experiments with this device demonstrate entanglement of SAW modes, and show promising results on the way to engineer cluster states for quantum computation in continuous variables.
Phononic resonators are becoming increasingly important in quantum information science, both for applications in quantum computing, communication, and sensing as well as in experiments investigating fundamental physics. Here, we study the decoherence of phonons confined in a surface acoustic wave (SAW) resonator strongly coupled $(g/2\ensuremath{\pi}\ensuremath{\approx}9\phantom{\rule{0.16em}{0ex}}\mathrm{MHz})$ to a superconducting transmon qubit. By comparing experimental data with numerical solutions to the Markovian master equation, we report a surface phononic energy decay rate of ${\ensuremath{\kappa}}_{1}/2\ensuremath{\pi}=480\phantom{\rule{0.16em}{0ex}}\mathrm{kHz}$ and a pure dephasing rate of ${\ensuremath{\kappa}}_{\ensuremath{\phi}}/2\ensuremath{\pi}=180\phantom{\rule{0.16em}{0ex}}\mathrm{kHz}$. These rates are in good agreement with the level of decoherence we extract from qubit-assisted spectroscopic measurements of the SAW resonator. We additionally find that the timescales over which coherent driven dynamics and decoherence occur are comparable, highlighting the need to model the composite device as an open quantum system. We discuss possible sources of decoherence in SAW-based quantum acoustic devices and the application of these devices in future quantum acoustic dissipation engineering experiments. The decoherence characterization techniques we employ are broadly applicable for investigating and benchmarking the effects of loss and dephasing on mechanical resonators in the quantum regime.
Abstract The experimental investigation of quantum devices incorporating mechanical resonators has opened up new frontiers in the study of quantum mechanics at a macroscopic level. It has recently been shown that surface acoustic waves (SAWs) can be piezoelectrically coupled to superconducting qubits, and confined in high-quality Fabry–Perot cavities in the quantum regime. Here we present measurements of a device in which a superconducting qubit is coupled to a SAW cavity, realising a surface acoustic version of cavity quantum electrodynamics. We use measurements of the AC Stark shift between the two systems to determine the coupling strength, which is in agreement with a theoretical model. This quantum acoustodynamics architecture may be used to develop new quantum acoustic devices in which quantum information is stored in trapped on-chip acoustic wavepackets, and manipulated in ways that are impossible with purely electromagnetic signals, due to the 10 5 times slower mechanical waves.