The ability to directly detect gravitational waves will open a completely new branch of astronomy to view the Universe, one that is inaccessible to electromagnetic-based astronomy. First generation ground-based interferometric gravitational-wave detectors have achieved strain sensitivities of order one part in ten to the twenty-one, at 100 Hz detection frequency. A new generation of detectors are under construction, designed to improve on the sensitivity of the first-generation detectors by a factor of 10. The quantum nature of light will broadly limit the sensitivity of these new instruments. This quantum noise will originate from the quantum vacuum fluctuations that enter the unused port of the interferometer. One of the most promising options for reducing the quantum noise impact and further increasing the sensitivity is applying quantum squeezed vacuum states. These squeezed states have lower noise in one quadrature than the vacuum state. By replacing the quantum vacuum fluctuations entering the interferometer with squeezed vacuum states, the quantum noise impact is reduced. This thesis firstly details the development of a squeezed light source that produces squeezed states applicable for enhancing interferometric gravitational-wave detectors. A doubly-resonant, travelling-wave bow-tie cavity squeezed light source is presented. For the first time, greater than 10 dB of quantum noise suppression across the gravitational-wave detection band is directly observed, and 11.6 dB of quantum noise suppression is observed above 200 Hz. This squeezing cavity design also has benefits with intrinsic isolation to backscattered light. Experiments that quantify this isolation are reported. The properties affecting squeezing magnitude and low-frequency squeezing measurement are discussed. In addition, a modified squeezing-ellipse-phase control technique for squeezed vacuum states is presented. This thesis secondly presents results from the LIGO Squeezed Light Injection Experiment, undertaken to test squeezed light injection into a 4 km interferometric gravitational-wave detector. The results of the experiment show the first measurement of squeezing-enhancement in a 4 km gravitational-wave detector, with 2.15 dB measured above 250 Hz. This represents the best sensitivity to gravitational waves yet achieved at these frequencies by any single gravitational-wave detector to date. An unknown area was whether the addition of a squeezer would introduce noise couplings that degrade the crucial low frequency sensitivity. The results demonstrate that injected squeezed states are compatible with low frequency gravitational-wave measurement. The characterisation of squeezing-injection optical losses and fluctuations of the squeezing angle are also reported. The knowledge and processes gained, from both the squeezed light source development work and the LIGO Squeezed Light Injection Experiment, will inform the design, planning and implementation of squeezed states in future gravitational-wave detectors.
We study the photon counting noise in optical interferometers used for gravitational wave detection. In order to reduce quantum noise a squeezed vacuum state is injected into the usually unused input port. Here, we specifically investigate the so-called “dark port case,” when the beam splitter is oriented close to 90° to the incoming laser beam, such that nearly all photons go to one output port of the interferometer, and only a small fraction of photons is seen in the other port (“dark port”). For this case it had been suggested that signal amplification is possible without concurrent noise amplification [R. Barak and Y. Ben-Aryeh, J. Opt. Soc. Am. B 25 , 361 (2008)]. We show that by injection of a squeezed vacuum state into the second input port, counting noise is reduced for large values of the squeezing factor, however the signal is not amplified. Signal strength only depends on the intensity of the laser beam.
Quantum noise limits high-precision sensing, such as in gravitational wave detectors. Caves first proposed beating this shot-noise limit by injecting squeezed vacuum at the dark port of an interferometer. Frequency-dependent squeezing through a filter cavity now delivers broadband quantum noise reductions of up to 5.2 dB at Hanford and 6.1 dB at Livingston in the LIGO detectors' fourth observing run. Building on these advances, this thesis develops techniques for interferometric sensing under realistic loss and phase noise, spanning Gaussian state preparation, optomechanical readout and feedback control, and non-Gaussian state preparation. In Parts I and II, we work in the two-photon formalism, where states are Gaussian and dynamics are linear. In Part I, we present a waveguide squeezer as an alternative to the traditional bulk cavity-based source; it is single-pass, broadband, and compact, and its modularity opens a path to non-Gaussian state generation. We report the detection of squeezed light from waveguide sources at 1064 nm in the sub-MHz regime, and we phase-stabilize the squeezed vacuum with quantum noise locking. We also analyze the loss and phase-noise tolerance of Gaussian states. In Part II, we design a tabletop phase-sensitive optomechanical amplifier and analyze its performance in terms of cavity stability, control system, and noise budget. We then implement the locking scheme, including Pound-Drever-Hall locking of the cavity, and characterize the noise budget at the initial stage. We also propose using optomechanics for coherent feedback control, which could evade back-action and broaden the detection bandwidth of future gravitational wave detectors. In Part III, we turn to non-Gaussian states. Phase noise does not preserve Gaussianity, so the best input state under combined loss and phase noise need not be Gaussian. We numerically optimize the input state for displacement sensing over the
(η,σϕ) landscape, integrating the Lindblad master equation in a truncated Fock basis and computing the quantum Fisher information. Within the Gaussian sub-family, the optimizer returns a displaced squeezed state once phase noise is appreciable, rather than pure squeezed vacuum. Without the Gaussian restriction, the optimized states sort roughly into four classes (Fock-like, cubic-phase-like, discrete-rotational, and squeezed), each dominant in a different region of the parameter space. In the experimentally relevant region of 1% loss and 100 mrad phase noise, cat states outperform squeezed vacuum even with balanced homodyne readout, an improvement implementable in the near term. We also show that the non-Gaussian advantage persists at higher photon budgets, well above
Nˉ=5. Together, these results show how state preparation, readout, and feedback choices trade off against realistic loss and phase noise, and identify the regimes where non-Gaussian states perform better.
Squeezing-assisted interferometers achieve sub-shot-noise sensitivity to phase shifts, but losses can strongly degrade their performance. Here we present the first experimental demonstration of detection-loss tolerance for this class of interferometers employing degenerate optical parametric amplification at one output port. For
50% detection efficiency, the phase sensitivity of any interferometer with coherent and squeezed vacuum inputs would not overcome the shot-noise limit, but in our case the output amplification gives
6 dB sub-shot-noise sensitivity. We further demonstrate that robustness increases with higher gain of the output amplifier: sub-shot-noise sensitivity is achieved for detection efficiency as low as
13%. We believe that overcoming detection inefficiency will become crucial to take full advantage of quantum metrology, for example in gravitational-wave detection, quantum sensing and imaging.
The current generation of gravitational wave laser interferometer detectors operate at the sensitivity limit imposed by quantum uncertainty of photon amplitude and phase quadratures. Heisenberg's principle dictates that the product of amplitude and phase uncertainty must be above a certain value, but apart from that we can still manipulate either quadrature to achieve quantum noise reduction, since the effect of amplitude and phase uncertainty is frequency dependent in gravitational wave detectors. This is the crux of the frequency dependent squeezing technique, which reduces quantum amplitude uncertainty at low frequency and quantum phase uncertainty at high frequency, where these respective quadratures each dominate. Thus, we can reduce quantum noise across the entire detection band. However, this technique is extremely sensitive to optical losses at all parts of the squeezing generation chain, and so far only a low degree of broadband squeezing has been observed. This proceeding outlines the current status of squeezing research at the former TAMA300 gravitational wave detector at the National Astronomical Observatory of Japan, where we aim to improve the level of achievable broadband squeezing. An update is also given regarding design and noise of squeezed injection for the underground gravitational wave detector KAGRA located in Gifu, Japan.
Squeezed states of light are a valuable resource for reducing quantum noise in precision measurements. Injection of squeezed vacuum states has emerged as an important technique for reducing quantum shot noise, which is a fundamental limitation to the sensitivity of interferometric gravitational wave detectors. Realizing the most benefit from squeezed-state injection requires lowering optical losses and also minimizing squeezed quadrature fluctuations—or phase noise—to ensure that the large noise in the anti-squeezed quadrature does not contaminate the measurement quadrature. Here, we present an audio band squeezed vacuum source with 1.3+0.7−0.5 mrad of phase noise. This is a nearly tenfold improvement over previously reported measurements, improving prospects for squeezing enhancements in current and future gravitational wave detectors.