We theoretically investigate the problem of finding optimal characteristics of photon pairs, produced in the spontaneous parametric down-conversion (SPDC) process, for fiber-based quantum communication protocols. By using the accessible setup parameters, the pump pulse duration and the extended phase-matching function width, we minimize the temporal width of SPDC photons within the general scenario. This allows one to perform more effectively the temporal filtering procedure, which aims at reducing the noise acquired by the measurement devices. Moreover, we compare the obtained results with the achievable parameter values for SPDC sources based on [Formula: see text]-Barium Borate crystal. We also investigate the influence of non-zero detection timing jitter. Finally, we apply our optimization strategy to a simple quantum key distribution scheme to show that the full optimization of an SPDC source can potentially extend the maximal security distance by several tens of kilometres, which is around 30% more as compared to previous approaches.
We theoretically investigate the problem of finding optimal characteristics of photon pairs, produced in the spontaneous parametric down-conversion (SPDC) process, for fiber-based quantum communication protocols. By using the accessible setup parameters, the pump pulse duration and the extended phase-matching function width, we minimize the temporal width of SPDC photons within the general scenario. This allows one to perform more effectively the temporal filtering procedure, which aims at reducing the noise acquired by the measurement devices. Moreover, we compare the obtained results with the achievable parameter values for SPDC sources based on [Formula: see text]-Barium Borate crystal. We also investigate the influence of non-zero detection timing jitter. Finally, we apply our optimization strategy to a simple quantum key distribution scheme to show that the full optimization of an SPDC source can potentially extend the maximal security distance by several tens of kilometres, which is around 30% more as compared to previous approaches.
Single-photon sources are crucial components for the implementation of quantum communication protocols. However, photons emitted by some of the most popular types of realistic sources are spectrally broadband. Due to this drawback, the signal emitted from such sources is typically affected by the effect of temporal broadening during its propagation through telecommunication fibers which exhibit chromatic dispersion. Such problem can be observed e.g. when using sources based on the process of spontaneous parametric down-conversion (SPDC). In the case of long-distance quantum communication temporal broadening can significantly limit the efficiency of temporal filtering. It is a popular method, which relies on the reduction of the duration time of the detection window, used for decreasing the number of registered errors. In this work we analyzed the impact of the type of spectral correlation within a pair of photons produced by the SPDC source on the temporal width of those photons during their propagation in dispersive media. We found out that in some situations this width can be decreased by changing the typical negative spectral correlation into positive one or by reducing its strength. This idea can be used to increase the efficiency of the temporal filtering method. Therefore, it can be applied in various implementations of quantum communication protocols. As an example of the application we subsequently analyzed the security of a quantum key distribution (QKD) scheme based on single photons. The investigation was performed for the configuration with the source of photons located in the middle between the legitimate participants of a QKD protocol (called typically Alice and Bob). We demonstrated that when the information about the emission time of the photons produced by the SPDC source is not distributed to Alice and Bob, the maximal security distance can be considerably extended by using positively correlated photons, while in the opposite case strongly (no matter positively or negatively) correlated photons are optimal. We also found out that the results of our calculation may be very sensitive to the spectral widths of the photons produced by the SPDC source. In addition, we concluded that in realistic situation Alice and Bob would have to optimize their source over both the spectral widths of the generated photons and the type of spectral correlation in order to maximally extend the security distance. The results of our work are, in particular, important for the QKD systems utilizing commercial telecom fibers populated by strong classical signals. In those systems temporal filtering method can be used to reduce not only the dark counts registered by the detection system, but also the channel noise originating from the process of Raman scattering, which is the main factor limiting their performance.
Single-photon sources are crucial components for the implementation of quantum communication protocols. However, photons emitted by some of the most popular types of realistic sources are spectrally broadband. Due to this drawback, the signal emitted from such sources is typically affected by the effect of temporal broadening during its propagation through telecommunication fibers which exhibit chromatic dispersion. Such problem can be observed e.g. when using sources based on the process of spontaneous parametric down-conversion (SPDC). In the case of long-distance quantum communication temporal broadening can significantly limit the efficiency of temporal filtering. It is a popular method, which is based on the reduction of the duration time of the detection window, used for decreasing the number of registered errors. In this work we analyzed the impact of the type of spectral correlation within a pair of photons produced by the SPDC source on the temporal width of those photons during their propagation in dispersive media. We found out that in some situations the width can be decreased by changing the typical negative spectral correlation into positive one or by reducing its strength. This idea can be used to increase the efficiency of the temporal filtering method. Therefore it can be applied in various implementations of quantum communication protocols. As an example of the application we subsequently analyzed the security of a quantum key distribution (QKD) scheme based on single photons. It was realized in the configuration with the source of photons located in the middle between the legitimate participants of a QKD protocol (called typically Alice and Bob). We demonstrated that when the information about the emission time of the photons produced by the SPDC source is not distributed to Alice and Bob, the maximal security distance can be considerably extended by using positively correlated photons, while in the opposite case strongly (no matter positively or negatively) correlated photons are optimal. We also found out that the results of our calculation may be very sensitive to the spectral widths of the photons produced by the SPDC source. In addition, we concluded that in realistic situation Alice and Bob would have to optimize their source over both the spectral widths of the generated photons and the type of spectral correlation in order to maximally extend the security distance. The results of our work are, in particular, important for the QKD systems utilizing commercial telecom fibers populated by strong classical signals. In those systems temporal filtering method can be used to reduce not only the dark counts registered by the detection system, but also the channel noise originating from the process of Raman scattering, which is the main factor limiting their performance.
Sources of photon pairs based on the spontaneous parametric down-conversion process are commonly used for long-distance quantum communication and quantum information processing. The key feature for improving the range of transmission is engineering their spectral properties. Our analysis shows the way for full control of spectral correlation within a fiber-coupled photon pair. The result of extensive numerical simulations allows us to specify the settings for the generation of pairs featuring positive-energy correlation, which can potentially improve the signal-to-noise ratio in practical implementation of quantum communication protocols. We analytically and numerically analyze the characteristics of a source based on a $\ensuremath{\beta}$-barium borate crystal cut for type-II phase matching at the degenerated frequencies $755\phantom{\rule{4pt}{0ex}}\mathrm{nm} \ensuremath{\rightarrow}1550\phantom{\rule{4pt}{0ex}}\mathrm{nm}+1550\phantom{\rule{4pt}{0ex}}\mathrm{nm}$. The presented framework is general and can be applied to other crystals.
Both correlated-mode coupling efficiency and photon pair flux (brightness) of spontaneous parametric down-conversion (SPDC) coupled into single-mode fibers are key parameters for various quantum information science applications. We present an experimental investigation on the optimization of the correlated-mode coupling efficiency and the brightness of frequency-degenerated SPDC photon pairs into single-mode optical fibers. Using photon pairs generated from a type-I phase-matched bulk $\ensuremath{\beta}$-barium borate crystal pumped by a continuous-wave laser, we carefully evaluated both the correlated-mode coupling efficiency and the brightness of SPDC light coupled to a single-mode optical fiber, while continuously changing the focusing of the pump and collection modes, experimenting with Rayleigh lengths from 3 to 280 (for the pump) and 0.2 to 20 (for the collection) times the crystal length. The measured data suggest that the correlated-mode coupling efficiency can be close to unity for any pump focus, however, the optimal Rayleigh length of the collection mode depends on the pump focus parameter, and the brightness can be increased by tightening the pump focus, provided that the Rayleigh length of the collection mode is precisely adjusted. A maximal correlated-mode coupling efficiency of $99.0\ifmmode\pm\else\textpm\fi{}1.3%$ was experimentally achieved. These results will be useful for photonic quantum science and technology using SPDC sources with high heralding efficiencies.
Entangled photon pairs play a crucial role in emerging quantum technologies, acting as tamper-proof padlocks in secure quantum communication, ultra-precise probes in quantum metrology and high-fidelity information carriers in photonic quantum computing. Amongst the many technological possibilities for generating photon pairs, sources based on spontaneous parametric down-conversion (SPDC) in second-order nonlinear crystals are still the workhorse tool in quantum optics laboratories, and more recently even in long-distance quantum communication with satellites. SPDC is a widely used method to create entangled photon pairs. The number of photon pairs that can be detected in a particular choice of collection modes, typically being optical single-mode fibers, depends critically on the spatial characteristics of the multi-mode SPDC emission as well as the particular beam waist of the collection modes. While several studies have already addressed the issue of optimal fiber coupling of SPDC photons in theory and experiment, the results of these studies arrive at different conclusions. Here, we present the results of a comprehensive experimental study on the optimal collection of photon pairs into single-mode optical fibers. Our approach is based on quasi-phase-matched type II SPDC from a periodically poled KTiOPO4 (ppKTP) crystal. We discuss the influence of pump and collection focal parameters on the spectral brightness and heralding efficiency, as well as practical issues of alignment tolerances into an optical single mode fiber. Further, Using two-photon interference (Hong-Ou-Mandel interference), we assess the spectral bandwidth of the photon pairs for variable crystal lengths. The results are in good agreement with our theoretical model, thus providing the recipe of building ultra bright and stable entangled photon sources.
There are several problems that must be solved in order to increase the distance of quantum communication protocols based on photons as an information carriers. One of them is the dispersion, whose effects can be minimized by engineering spectral properties of transmitted photons. In particular, it is expected that positively correlated photon pairs can be very useful. We present the full characterization of a source of single photon pairs at a telecom wavelength based on type II spontaneous parametric down conversion (SPDC) process in a beta-barium borate (BBO) crystal. In the type II process, a pump photon, which is polarized extraordinarily, splits in a nonlinear medium into signal and idler photons, which are polarized perpendicularly to each other. In order for the process to be efficient a phase matching condition must be fulfilled. These conditions originate from momentum and energy conservation rules and put severe restrictions on source parameters. Seemingly, these conditions force the photon pair to be negatively correlated in their spectral domain. However, it is possible to achieve positive correlation for pulsed pumping. The experimentally available degrees of freedom of a source are the width of the pumping beam, the collected modes’ widths, the length of the nonlinear crystal and the duration of the pumping pulse. In our numerical model we use the following figures of merit: the pair production rate, the efficiency of photon coupling into a single mode fiber, the spectral correlation of the coupled photon pair. The last one is defined as the Pearson correlation parameter for a joint spectral distribution. The aim here is to find the largest positive spectral correlation and the highest coupling efficiency. By resorting to the numerical model Ref. [1] we showed in Ref. [2], that by careful adjustment of the pump’s and the collected modes’ characteristics, one can optimize any of the source's parameters. Our numerical outcomes conform to the experimental results presented in Refs [3,4]. Here we investigate typical, experimentally available source parameters: the widths of the pump beam and collected modes ranging from 20μm to 500m, the crystal length ranging from 1mm to 7.5mm while the pulse duration is set to 50fs, 100fs or 150fs. We achieve the correlation coefficient value as high as approximately 0.8, or – for different values of parameters – coupling efficiency equal to 0.76.