Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:1906.02263 · Physical Review A

Experimental simultaneous readout of the real and imaginary parts of the weak value

Alireza Hariri, Davor Curic, Lambert Giner, Jeff S. Lundeen

Published Sep 24, 2019• 23 citations
arXivHTMLPDF

Abstract

The weak value, the average result of a weak measurement, has proven useful for probing quantum and classical systems. Examples include amplifying small signals, investigating quantum paradoxes, and elucidating fundamental quantum phenomena such as geometric phase. A key characteristic of the weak value is that it can be complex, in contrast to a standard expectation value. However, typically only either the real or imaginary component of the weak value is determined in a given experimental setup. Weak measurements can be used to, in a sense, simultaneously measure noncommuting observables. This principle was used in the direct measurement of the quantum wave function. However, the wave function's real and imaginary components, given by a weak value, are determined in different setups or on separate ensembles of systems, putting the procedure's directness in question. To address these issues, we introduce and experimentally demonstrate a general method to simultaneously read out both components of the weak value in a single experimental apparatus. In particular, we directly measure the polarization state of an ensemble of photons using weak measurement. With our method, each photon contributes to both the real and imaginary parts of the weak-value average. On a fundamental level, this suggests that the full complex weak value is a characteristic of each photon measured.

DOI
10.1103/physreva.100.032119

Related papers

Determination of weak values of quantum operators using only strong measurements

Eliahu Cohen, Eli Pollak

Weak values have been shown to be helpful especially when considering them as the outcomes of weak measurements. In this paper we show that, in principle, the real and imaginary parts of the weak value of any operator may be elucidated from expectation values of suitably defined density, flux, and Hermitian commutator operators. Expectation values are the outcomes of strong (projective) measurements, implying that weak values are general properties of operators in association with pre- and postselection and they need not be preferentially associated with weak measurements. They should be considered as an important measurable property which provides added information compared with the ``standard'' diagonal expectation value of an operator. As the first specific example we consider the determination of the real and imaginary parts of the weak value of the momentum operator employing projective time-of-flight experiments. Then the results are analyzed from the point of view of Bohmian mechanics. Finally, we consider recent neutron interferometry experiments used to determine the weak values of the neutron spin.

arXiv:1804.11298•Physical Review A•Oct 9, 2018•46 citations

Reconstructing the wave function through the momentum weak value

Junfan Zhu, An Wang, Xiong Liu +3 more

The wave function is the cornerstone of quantum mechanics, although it is still open to different interpretations. It has been shown that the amplitude and the phase of a wave function are manifested in the imaginary and real parts of the momentum weak value, respectively. Based on this, we develop a weak measurement scheme to reconstruct the wave function through measuring the momentum weak value. A proof-of-principle experiment is made to confirm the feasibility of our measurement scheme, in which the polarization states and the momentum of light are coupled. We believe the experimental protocol has the potential to be applied in diverse fields such as wave-front sensing, edge detection, and optical communication, and measurement of the momentum weak value may offer valuable insight to better understand quantum mechanics.

Physical Review A•Sep 27, 2021•23 citations

Weird Measurements

WJ Mullin

A weak measurement does not completely collapse the wave function into one of the components of a superposition. A subsequent projective measurement on the weakly measured wave function can result in an amplification of the result for the original weak measurement. This chapter illustrates the procedure by a measurement of the average trajectories taken by particles in the two-slit experiment, in which the local momentum of a photon is encoded into its polarization, by means of a birefringent calcite crystal. The particle trajectories show the interference pattern. A second experimental example finds the real part and the imaginary part of a particle’s complex wave function. The amplitude and phase of the wave function are expressed in terms of its real and imaginary parts.

Oxford University Press eBooks•Mar 16, 2017•0 citations

Measuring non-Hermitian operators via weak values

Arun Kumar Pati, Uttam Singh, Urbasi Sinha

In quantum theory, a physical observable is represented by a Hermitian operator as it admits real eigenvalues. This stems from the fact that any measuring apparatus that is supposed to measure a physical observable will always yield a real number. However, the reality of an eigenvalue of some operator does not mean that it is necessarily Hermitian. There are examples of non-Hermitian operators that may admit real eigenvalues under some symmetry conditions. In general, given a non-Hermitian operator, its average value in a quantum state is a complex number and there are only very limited methods available to measure it. Following standard quantum mechanics, we provide an experimentally feasible protocol to measure the expectation value of any non-Hermitian operator via weak measurements. The average of a non-Hermitian operator in a pure state is a complex multiple of the weak value of the positive-semidefinite part of the non-Hermitian operator. We also prove an uncertainty relation for any two non-Hermitian operators and show that the fidelity of a quantum state under a quantum channel can be measured using the average of the corresponding Kraus operators. The importance of our method is shown in testing the stronger uncertainty relation, verifying the Ramanujan formula, and measuring the product of noncommuting projectors.

arXiv:1406.3007•Physical Review A•Nov 25, 2015•70 citations

Theory and experiment for resource-efficient joint weak-measurement

Aldo C. Martinez-Becerril, Gabriel Bussières, Davor Curic +3 more

Incompatible observables underlie pillars of quantum physics such as contextuality and entanglement. The Heisenberg uncertainty principle is a fundamental limitation on the measurement of the product of incompatible observables, a 'joint' measurement. However, recently a method using weak measurement has experimentally demonstrated joint measurement. This method [Lundeen, J. S., and Bamber, C. Phys. Rev. Lett. 108, 070402, 2012] delivers the standard expectation value of the product of observables, even if they are incompatible. A drawback of this method is that it requires coupling each observable to a distinct degree of freedom (DOF), i.e., a disjoint Hilbert space. Typically, this 'read-out' system is an unused internal DOF of the measured particle. Unfortunately, one quickly runs out of internal DOFs, which limits the number of observables and types of measurements one can make. To address this limitation, we propose and experimentally demonstrate a technique to perform a joint weak-measurement of two incompatible observables using only one DOF as a read-out system. We apply our scheme to directly measure the density matrix of photon polarization states.

arXiv:2103.16389•Quantum•Dec 6, 2021•11 citations

Simultaneous path weak-measurements in neutron interferometry

Armin Danner, Ismaele Vincent Masiello, Andreas Dvorak +4 more

The statistical properties of the detection events constituting the interference fringes at the output of an interferometer are well-known. Nevertheless, there is still no unified view of what is happening to a quantum system inside an interferometer. Strong measurements of path operators destroy the interference effect. In weak measurements, an observable is weakly coupled to a pointer system and the resulting weak values quantify the observable by minimally disturbing the system. Previous which-way experiments with weak measurements could extract either the real or imaginary part of a single weak value with each ensemble. Here, we present the simultaneous full complex quantification of two path weak values with a single ensemble in a Mach-Zehnder neutron interferometer. Magnetic fields, oscillating with different frequencies, change the energy state in each interferometer path. The time-dependent phase between the energy states distinctly marks each path. The resulting beating intensity modulation at the interferometer output gives both path weak values. For the present experiment, the weak values' absolute value and phase directly describe the observed amplitude and phase of the intensity modulation.

Scientific Reports•Oct 29, 2024•3 citations
The weak value, the average result of a weak measurement, has proven useful for probing quantum and classical systems. Examples include amplifying small signals, investigating quantum paradoxes, and elucidating fundamental quantum phenomena such as geometric phase. A key characteristic of the weak value is that it can be complex, in contrast to a standard expectation value. However, typically only either the real or imaginary component of the weak value is determined in a given experimental setup. Weak measurements can be used to, in a sense, simultaneously measure noncommuting observables. This principle was used in the direct measurement of the quantum wave function. However, the wave function's real and imaginary components, given by a weak value, are determined in different setups or on separate ensembles of systems, putting the procedure's directness in question. To address these issues, we introduce and experimentally demonstrate a general method to simultaneously read out both components of the weak value in a single experimental apparatus. In particular, we directly measure the polarization state of an ensemble of photons using weak measurement. With our method, each photon contributes to both the real and imaginary parts of the weak-value average. On a fundamental level, this suggests that the full complex weak value is a characteristic of each photon measured.
Weak values have been shown to be helpful especially when considering them as the outcomes of weak measurements. In this paper we show that, in principle, the real and imaginary parts of the weak value of any operator may be elucidated from expectation values of suitably defined density, flux, and Hermitian commutator operators. Expectation values are the outcomes of strong (projective) measurements, implying that weak values are general properties of operators in association with pre- and postselection and they need not be preferentially associated with weak measurements. They should be considered as an important measurable property which provides added information compared with the ``standard'' diagonal expectation value of an operator. As the first specific example we consider the determination of the real and imaginary parts of the weak value of the momentum operator employing projective time-of-flight experiments. Then the results are analyzed from the point of view of Bohmian mechanics. Finally, we consider recent neutron interferometry experiments used to determine the weak values of the neutron spin.
The wave function is the cornerstone of quantum mechanics, although it is still open to different interpretations. It has been shown that the amplitude and the phase of a wave function are manifested in the imaginary and real parts of the momentum weak value, respectively. Based on this, we develop a weak measurement scheme to reconstruct the wave function through measuring the momentum weak value. A proof-of-principle experiment is made to confirm the feasibility of our measurement scheme, in which the polarization states and the momentum of light are coupled. We believe the experimental protocol has the potential to be applied in diverse fields such as wave-front sensing, edge detection, and optical communication, and measurement of the momentum weak value may offer valuable insight to better understand quantum mechanics.
A weak measurement does not completely collapse the wave function into one of the components of a superposition. A subsequent projective measurement on the weakly measured wave function can result in an amplification of the result for the original weak measurement. This chapter illustrates the procedure by a measurement of the average trajectories taken by particles in the two-slit experiment, in which the local momentum of a photon is encoded into its polarization, by means of a birefringent calcite crystal. The particle trajectories show the interference pattern. A second experimental example finds the real part and the imaginary part of a particle’s complex wave function. The amplitude and phase of the wave function are expressed in terms of its real and imaginary parts.
In quantum theory, a physical observable is represented by a Hermitian operator as it admits real eigenvalues. This stems from the fact that any measuring apparatus that is supposed to measure a physical observable will always yield a real number. However, the reality of an eigenvalue of some operator does not mean that it is necessarily Hermitian. There are examples of non-Hermitian operators that may admit real eigenvalues under some symmetry conditions. In general, given a non-Hermitian operator, its average value in a quantum state is a complex number and there are only very limited methods available to measure it. Following standard quantum mechanics, we provide an experimentally feasible protocol to measure the expectation value of any non-Hermitian operator via weak measurements. The average of a non-Hermitian operator in a pure state is a complex multiple of the weak value of the positive-semidefinite part of the non-Hermitian operator. We also prove an uncertainty relation for any two non-Hermitian operators and show that the fidelity of a quantum state under a quantum channel can be measured using the average of the corresponding Kraus operators. The importance of our method is shown in testing the stronger uncertainty relation, verifying the Ramanujan formula, and measuring the product of noncommuting projectors.
Incompatible observables underlie pillars of quantum physics such as contextuality and entanglement. The Heisenberg uncertainty principle is a fundamental limitation on the measurement of the product of incompatible observables, a 'joint' measurement. However, recently a method using weak measurement has experimentally demonstrated joint measurement. This method [Lundeen, J. S., and Bamber, C. Phys. Rev. Lett. 108, 070402, 2012] delivers the standard expectation value of the product of observables, even if they are incompatible. A drawback of this method is that it requires coupling each observable to a distinct degree of freedom (DOF), i.e., a disjoint Hilbert space. Typically, this 'read-out' system is an unused internal DOF of the measured particle. Unfortunately, one quickly runs out of internal DOFs, which limits the number of observables and types of measurements one can make. To address this limitation, we propose and experimentally demonstrate a technique to perform a joint weak-measurement of two incompatible observables using only one DOF as a read-out system. We apply our scheme to directly measure the density matrix of photon polarization states.
The statistical properties of the detection events constituting the interference fringes at the output of an interferometer are well-known. Nevertheless, there is still no unified view of what is happening to a quantum system inside an interferometer. Strong measurements of path operators destroy the interference effect. In weak measurements, an observable is weakly coupled to a pointer system and the resulting weak values quantify the observable by minimally disturbing the system. Previous which-way experiments with weak measurements could extract either the real or imaginary part of a single weak value with each ensemble. Here, we present the simultaneous full complex quantification of two path weak values with a single ensemble in a Mach-Zehnder neutron interferometer. Magnetic fields, oscillating with different frequencies, change the energy state in each interferometer path. The time-dependent phase between the energy states distinctly marks each path. The resulting beating intensity modulation at the interferometer output gives both path weak values. For the present experiment, the weak values' absolute value and phase directly describe the observed amplitude and phase of the intensity modulation.