We present a method for producing three-dimensional Bose-Einstein condensates using only laser cooling. The phase transition to condensation is crossed with 2.5×10^{4} ^{87}Rb atoms at a temperature of T_{c}=0.6 μK after 1.4 s of cooling. Atoms are trapped in a crossed optical dipole trap and cooled using Raman cooling with far-off-resonant optical pumping light to reduce atom loss and heating. The achieved temperatures are well below the effective recoil temperature. We find that during the final cooling stage at atomic densities above 10^{14} cm^{-3}, careful tuning of trap depth and optical-pumping rate is necessary to evade heating and loss mechanisms. The method may enable the fast production of quantum degenerate gases in a variety of systems including fermions.
We present a method for producing three-dimensional Bose-Einstein condensates using only laser cooling. The phase transition to condensation is crossed with 2.5×10^{4} ^{87}Rb atoms at a temperature of T_{c}=0.6 μK after 1.4 s of cooling. Atoms are trapped in a crossed optical dipole trap and cooled using Raman cooling with far-off-resonant optical pumping light to reduce atom loss and heating. The achieved temperatures are well below the effective recoil temperature. We find that during the final cooling stage at atomic densities above 10^{14} cm^{-3}, careful tuning of trap depth and optical-pumping rate is necessary to evade heating and loss mechanisms. The method may enable the fast production of quantum degenerate gases in a variety of systems including fermions.
We report the realization of a Bose-Einstein condensate of 39K atoms without the aid of an additional atomic coolant. Our route to Bose-Einstein condensation comprises sub-Doppler laser cooling of large atomic clouds with more than 1010 atoms and evaporative cooling in an optical dipole trap where the collisional cross section can be increased using magnetic Feshbach resonances. Large condensates with almost 106 atoms can be produced in less than 15 s. Our achievements eliminate the need for sympathetic cooling with Rb atoms, which was the usual route implemented until now due to the unfavorable collisional property of 39K. Our findings simplify the experimental setup for producing Bose-Einstein condensates of 39K atoms with tunable interactions, which have a wide variety of promising applications, including atom interferometry to studies on the interplay of disorder and interactions in quantum gases.
In 1925, Einstein predicted the condensation of bosons into the ground state of the system for low (but finite) temperatures. Several phenomena, including superfluidity and superconductivity have been associated with Bose-Einstein condensation, but these systems interact strongly with their environment and pure Bose-Einstein condensation could not be established. It took 70 years, in which time the laser was discovered, and laser cooling techniques to manipulate atoms in a dilute atomic gas, before Bose-Einstein condensation in dilute atomic gases could be demonstrated in 1995. In the first condensation experiments, BECs were created in a magnetic trap. Since in a magnetic trap not all mF states of the atom can be trapped simultaneously, thereby limiting the number of experiments that can be done, other ways of trapping and generating BECs were sought and found. In 2001, the first all-optical BEC was made, where the dipole force was used to trap atoms in the crossing of two far red detuned laser beams. In an optical dipole trap not only atoms in different internal states can be trapped, but also different atomic species simultaneously. In this thesis, the formation of an all-optical Bose-Einstein condensate with rubidium atoms is presented. Conventional all-optical BECs are usually created in high power CO2 laser dipole traps, or have complicated laser cooling schemes and complex dipole trap setups. In our simple and straightforward setup, we load rubidium atoms from a magneto-optical trap into a crossed optical dipole trap created by a single frequency Yb:YAG laser with a wavelength at 1030 nm. The small wavelength allows for a small diffraction limit, and permits us to use standard optical materials, thus making the experimental setup cost effective. Other attempts to achieve Bose-Einstein condensation in a multi-mode (frequency) fiber laser at 1064 nm failed, because the atom loss was quite high. It is assumed that the multi-mode character of the fiber laser induces Raman transitions in rubidium atoms, thereby heating them. We can trap about ∼ 5E7 atoms in a single beam dipole trap out of ∼ 5E9 atoms trapped in theMOT, and ∼ 350,000 atoms can be trapped in a crossed beam dipole trap due to the smaller trap volume. 70% of the atoms in the dipole trap is optically pumped into one mF state. Quantum degeneracy is reached by evaporatively cooling the atoms in the crossed dipole trap by ramping down the laser power with three linear ramps. We can independently change the power of each beam by an AOM. This allows us to use one beam as an atom waveguide for future experiments. After evaporation, we typically have about 10,000 atoms at a temperature below the critical temperature. We have proved Bose-Einstein condensation by using the anisotropic expansion of a quantum degenerate gas trapped in an anisotropic potential. The aspect ratio of our atom cloud changed during a time of flight from 0.7 to 1.2 in 10 ms, thus proving that we have reached quantum degeneracy. We have about 5,000 condensed atoms in our optical dipole trap at a temperature less than 100 nK. The remaining atoms are thermal. Bose-Einstein condensation is obtained within 8 s, and we can repeat the experiment every 30 s. It should be mentioned that the Bose-Einstein experiment was moved from the ”Leibniz Universität Hannover” to the ”Technische Universität Darmstadt”, and had to be completely rebuilt. All-optical Bose-Einstein condensation was reached within one year after the move. Our Bose-Einstein condensation setup presents an ideal starting point for using our condensates in combination with miniaturized atom optical setups based on our novel microfabricated optical elements. With our microlenses, we can create a number of possible dipole trap configurations, such as the dipole trap array or the cylindrical microlens array. Using microlenses in miniaturized atom optical setups opens a completely new field of coherent atom optics. Also because the tight confinement of the microtraps allows us to load a 3D BEC, a 1D BEC, or a Tonks-Girardeau gas in the micropotentials depending on the density.
We report on the realization of a sodium Bose–Einstein condensate (BEC) in a combined red-detuned optical dipole trap formed by two beams crossing in a horizontal plane and a third, tightly focused dimple trap (dT) propagating vertically. We produce a BEC in three main steps: loading of the crossed dipole trap from laser-cooled atoms, an intermediate evaporative cooling stage that results in efficient loading of the auxiliary dT, and a final evaporative cooling stage in the dT. Our protocol is implemented in a compact setup and allows us to reach quantum degeneracy even with relatively modest initial atom numbers and available laser power.
We report the production of 87Rb Bose–Einstein condensate in an asymmetric crossed optical dipole trap (ACODT) without the need of an additional dimple laser. In our experiment, the ACODT is formed by two laser beams with different radii to achieve efficient capture and rapid evaporation of laser cooled atoms. Compared to the cooling procedure in a magnetic trap, the atoms are firstly laser cooled and then directly loaded into an ACODT without the pre-evaporative cooling process. In order to determine the optimal parameters for evaporation cooling, we optimize the power ratio of the two beams and the evaporation time to maximize the final atom number left in the ACODT. By loading about 6 × 105 laser cooled atoms in the ACODT, we obtain a pure Bose–Einstein condensate with about 1.4 × 104 atoms after 19 s evaporation. Additionally, we demonstrate that the fringe-type noises in optical density distributions can be reduced via principal component analysis, which correspondingly improves the reliability of temperature measurement.
Summary form only given. Recently, we have created a Bose condensate of /sup 87/Rb atoms directly in an optical trap formed by tightly focused laser beams. Following initial loading from a laser cooled gas, evaporative cooling through the BEC transition is achieved by simply lowering the depth of the optical trap. Our success is due in part to a high initial phase space density realized in the loading of our optical dipole trap and in part to the tight confinement of the atoms that permits rapid evaporative cooling to the BEC transition in 2 s.