Integrated photonic circuits offer great promise for quantum technologies. However, due to the rapid propagation of light, many envisioned applications require efficient on-chip quantum memories with a programmable delay, compact footprint, and high fidelity. Implementing this based on standard semiconductor processing technology is an outstanding challenge. Here, we realize such memories using erbium-doped silicon waveguides, fabricated as part of a multi-wafer project by a nanophotonic foundry. We demonstrate light storage with a 44.2(9)MHz bandwidth and a programmable delay exceeding 1μs in a device with a footprint of only 1.5×10−2mm2, outperforming on-chip delay lines by many orders of magnitude. The phase of the read-out light field is preserved with a visibility of 91.3(30)%. The efficiency of 1.89(28)×10−8 can be improved in future devices through resonator enhancement and higher dopant concentrations. With this, the demonstrated approach will pave the way towards applications in photonic quantum computing based on scalable silicon processing technology.
Heterogeneous integration provides a promising route to combine semiconductor quantum dot devices and superconducting microwave circuits, while allowing each component to be fabricated using an optimized process flow. Here, we demonstrate a flip-chip integrated platform for dispersive readout of silicon metal-oxide semiconductor (SiMOS) quantum dot devices. A SiMOS double quantum dot chip is bonded to a superconducting aluminum resonator chip using indium bump interconnects to enable microwave coupling to the quantum dot gate. We show that the developed flip-chip process is compatible with cryogenic operation of both the SiMOS device and the superconducting resonator, and demonstrate resonator-based detection of charge transitions in the quantum dot system. The readout signal-to-noise ratio follows a dependence of t with the integration time, reaching SNR = 1 at an integration time of approximately 0.3 ms. These results establish flip-chip bonding as a viable integration approach for SiMOS quantum dot devices operating at both dc and microwave frequencies, with potential applications for resonator-based techniques such as spin-photon coupling.
Silicon spin qubits are a leading candidate for large-scale quantum computing owing to their compatibility with semiconductor manufacturing. However, scaling to useful fault-tolerant processors will likely generate thermal loads that exceed the cooling power available at millikelvin temperatures. Raising the operating temperature eases cooling requirements but reduces gate fidelity, increasing the overhead of quantum error correction. Identifying the operating temperature that minimizes total power consumption is therefore a key challenge for commercially viable quantum computers. Here, we use gate set tomography to benchmark two-qubit silicon chips fabricated in both industrial and academic environments over a range of temperatures. Elevated temperatures substantially shorten coherence times and increase gate and state-preparation-and-measurement infidelities. Based on these measurements, we develop a general power model for silicon quantum computers that combines cryogenic cooling requirements with error-correction overheads. We show that a finite optimal operating temperature exists and is strongly influenced by a crossover temperature near 1 K in current devices, above which gate fidelity degrades rapidly. These results connect device-level fidelity limitations to system-level power requirements, providing design guidelines for large-scale silicon quantum computers.