Up to now, the measurement of radio-frequency (RF) electric field achieved using the electromagnetically-induced transparency (EIT) of Rydberg atoms has proved to be of high-sensitivity and shows a potential to produce a promising atomic RF receiver at resonance between two chosen Rydberg states. In this paper, we study the extension of the feasibility of digital communication via this quantum-based antenna over a continuously tunable RF-carrier at off-resonance. Our experiment shows that the digital communication at a rate of 500 kbps can be performed reliably within a tunable bandwidth of 200 MHz near a 10.22 GHz carrier. Outside of this range, the bit error rate (BER) increases, rising to, for example, 15% at an RF-detuning of ±150 MHz. In the measurement, the time-varying RF field is retrieved by detecting the optical power of the probe laser at the center frequency of RF-induced symmetric or asymmetric Autler-Townes splitting in EIT. Prior to the digital test, we studied the RF-reception quality as a function of various parameters including the RF detuning and found that a choice of linear gain response to the RF-amplitude can suppress the signal distortion. The modulating signal can be decoded at speeds up to 500 kHz in the tunable bandwidth. Our test consolidates the physical basis for reliable communication and spectral sensing over a wider broadband RF-carrier, which paves a way for the concurrent multi-channel communications founded on the same pair of Rydberg states.
Up to now, the measurement of radio-frequency (RF) electric field achieved using the electromagnetically-induced transparency (EIT) of Rydberg atoms has proved to be of high-sensitivity and shows a potential to produce a promising atomic RF receiver at resonance between two chosen Rydberg states. In this paper, we study the extension of the feasibility of digital communication via this quantum-based antenna over a continuously tunable RF-carrier at off-resonance. Our experiment shows that the digital communication at a rate of 500 kbps can be performed reliably within a tunable bandwidth of 200 MHz near a 10.22 GHz carrier. Outside of this range, the bit error rate (BER) increases, rising to, for example, 15% at an RF-detuning of ±150 MHz. In the measurement, the time-varying RF field is retrieved by detecting the optical power of the probe laser at the center frequency of RF-induced symmetric or asymmetric Autler-Townes splitting in EIT. Prior to the digital test, we studied the RF-reception quality as a function of various parameters including the RF detuning and found that a choice of linear gain response to the RF-amplitude can suppress the signal distortion. The modulating signal can be decoded at speeds up to 500 kHz in the tunable bandwidth. Our test consolidates the physical basis for reliable communication and spectral sensing over a wider broadband RF-carrier, which paves a way for the concurrent multi-channel communications founded on the same pair of Rydberg states.
The highly-excited Rydberg states are with a unique property of radio-frequency (RF) resonance, and Rydberg atoms at room temperature are promising for developing a broadband RF electric field sensor and relevant metrology standards. In this paper, the working mechanism of an atomic amplitude-modulation(AM) radio receiver is investigated in detail, and various factors affecting the communication quality are discussed. The modulation RF signal can be directly retrieved by measuring the transmission of a probe laser at resonance of rubidium D2 transition using a fast photo-diode detector, without any conventional demodulation process. Various communication experiments are tested at a 10.22 GHz carrier, and a modulation bandwidth of 1 MHz and an acceptable data transfer rate of about 1 Mbps have been achieved using current detection techniques. Owing to a potential high sensitivity and ultra-broadband capability of free-space RF field sensing, the quantum receiver has great significance compared with conventional electronics-based receivers, including but not limited to a weak signal, long-distance, and broadband communication in free space or via a fiber link.
We demonstrate an atom-based amplitude-modulation (AM) receiver for digital communication with a weak continuous frequency carrier using a Rydberg AC Stark effect in a vapor cell and achieve the operating carrier frequency continuously from 0.1 GHz to 5 GHz at a single Rydberg state. A strong local oscillator (LO) field E LO acts as a gain to shift the Rydberg level to a high sensitivity region, and a weak carrier field E Carr keeps the same frequency with the LO field. The digital baseband signals are encoded onto the E Carr using the amplitude modulation technique with the different modulation frequency. The response of Rydberg atom to the baseband signal is probed via a Rydberg electromagnetically induced transparency (EIT). The measured instantaneous bandwidth of the system is about 230 kHz. To demonstrate the performance of our system for an actual communication, we consider a color image as an example, the received image displays that the bit error rate (BER) is less than 5% when the maximum data transfer rate is about 238 kbps. Meanwhile, our system shows the weak carrier field of E Carr ≥ 13.52 μ V/cm can be used for the practical communication with BER less than 5%. Our works break the limitation that EIT-AT based atomic receivers only operate at the near resonant frequencies of the Rydberg transitions, making this emerging of quantum technology close to the practical application with high sensitivity and broad bandwidth.
Rydberg atom based sensors allow for SI traceable measurements and show promise for applications in the field of communication and radar technologies. In this article, we investigate the bandwidth and sensitivity of a Rydberg atom-based sensor in a rubidium vapor cell using Rydberg electromagnetically induced transparency (EIT) spectroscopy. We employ a radio-frequency (RF) heterodyne measurement technique in combination with an optical homodyne setup to extend the achievable range between sensitivity and bandwidth in a Rydberg sensor. While the bandwidth of Rydberg sensors are limited by the transit time of atoms and the Rabi frequency of the coupling field, achieving higher bandwidth through smaller beam sizes is thought to compromise sensitivity due to reduced EIT signal strength. Using optical homodyne detection, we demonstrate that sensitivity is preserved while achieving a response bandwidth of 8 MHz. In addition, using the Rydberg sensor, we receive digital communication signals and present error vector magnitude (EVM) measurements as a function of varying symbol rates and bandwidth of the Rydberg sensor. Furthermore, the sensor's performance is compared with a conventional RF mixer. We establish that the bandwidth of a Rydberg sensor when receiving a pure tone is not the same as the bandwidth of the sensor when receiving a modulated signal. This difference results from the spreading of symbols in the frequency domain, leading to a reduction of the signal to noise ratio (SNR) and an accumulation of noise over the total span of the modulated signal.
Rydberg atoms have been extensively utilized in microwave measurement with high sensitivity, which has great potential in the field of communication. In this study, we discuss the digital communication based on a Rydberg atomic receiver under simultaneously coupling by resonant and near detuning microwaves. In addition, we verify the feasibility of the Rydberg atom-based frequency division multiplexing (FDM) in microwave communication. We demonstrate the principle and performance of the atom-based FDM receiver by applying amplitude modulation (AM) and frequency modulation (FM), respectively. To demonstrate the actual communication performance at different data transfer rates, we consider monochromatic images as an example. The experimental results show that the maximum acceptable data transfer rate of both AM and FM is about 200 kbps, whereas their maximum bit error rates (BER) is less than 5%. When compared with the traditional electronic receiver, this atomic receiver, which is compatible with FDM, has numerous advantages, such as small size, low power consumption, and high sensitivity. Furthermore, this receiver has a strong ability of anti-electromagnetic interference, and the signals transmitted do not interfere with each other in different channels.
We demonstrate a continuously tunable electric field measurement based on the far off-resonant AC stark effect in a Rydberg atomic vapor cell. In this configuration, a strong far off-resonant field, denoted as a local oscillator (LO) field, acts as a gain to shift the Rydberg level to a high sensitivity region. An incident weak signal field with a few hundreds of kHz difference from the LO field is mixed with the LO field in the Rydberg system to generate an intermediate frequency signal, which is read out by Rydberg electromagnetically induced transparency (Rydberg-EIT) spectroscopy. Not like resonant EIT-Autler–Townes spectra, we realize the electric field measurement of the signal frequency from 2 to 5 GHz using a single Rydberg state. The detectable field strength is down to 2.25 μV/cm with sensitivity of the electrometry 712 nV cm−1 Hz−1/2, and a linear dynamic range is over 65 dB. The detectable field strength is comparable with a resonant microwave-dressed Rydberg heterodyne receiver using the same system, which is 0.96 μV/cm with sensitivity of 304 nV cm–1 Hz−1/2. We also show the system has an inherent polarization selectivity feature. Our method can provide high sensitivity of electric field measurement and be extended to arbitrary frequency measurements.
Rydberg atoms, with one highly excited, nearly ionized electron, have extreme sensitivity to electric fields, including microwave fields ranging from 100 MHz to over 1 THz. Here, we show that room-temperature Rydberg atoms can be used as sensitive, high bandwidth, microwave communication antennas. We demonstrate near photon-shot-noise limited readout of data encoded in amplitude-modulated 17 GHz microwaves, using an electromagnetically induced-transparency (EIT) probing scheme. We measure a photon-shot-noise limited channel capacity of up to 8.2 Mbit s−1 and implement an 8-state phase-shift-keying digital communication protocol. The bandwidth of the EIT probing scheme is found to be limited by the available coupling laser power and the natural linewidth of the rubidium D2 transition. We discuss how atomic communication receivers offer several opportunities to surpass the capabilities of classical antennas.