Adaptive measurements have recently been shown to significantly improve the performance of quantum state and process tomography. Adaptive tomography is especially useful in complicated experiments with low outcome generation rate, since it allows one to extract maximal information from a limited amount of data. However, the existing methods either cannot be simply applied to high-dimensional systems or are prohibitively computationally expensive. Here we propose and experimentally implement a tomographic protocol specially designed for the reconstruction of high-dimensional quantum states. The protocol shows qualitative improvement in infidelity scaling with the number of measurements and is fast enough to allow for complete state tomography of states with dimensionality up to 36.
Adaptive measurements have recently been shown to significantly improve the performance of quantum state and process tomography. Adaptive tomography is especially useful in complicated experiments with low outcome generation rate, since it allows one to extract maximal information from a limited amount of data. However, the existing methods either cannot be simply applied to high-dimensional systems or are prohibitively computationally expensive. Here we propose and experimentally implement a tomographic protocol specially designed for the reconstruction of high-dimensional quantum states. The protocol shows qualitative improvement in infidelity scaling with the number of measurements and is fast enough to allow for complete state tomography of states with dimensionality up to 36.
We discuss an experimental realization of an adaptive quantum state tomography protocol. The method we suggested and tested takes advantage of a Bayesian approach to statistical inference and is naturally tailored for adaptive strategies. For pure states we observe close to 1/N scaling of infidelity with overall number of registered events N, while best non-adaptive protocols allow for 1 N scaling only. This is the theoretical limit for any tomographic protocol, and further improvement may only affect pre-factors in this power law. Also we consider particular strategies of the state reconstruction based on adequate and inadequate models and compare their scaling. Experiments have been performed for polarization qubits and ququarts, but the approach is readily adapted to any dimension. Our method does not take into account systematic errors caused, for example, by inaccuracies in retardant plates rotation. However for the reached values of infidelities of on the order of 10 – 10 we did not observe any deviations from expected behavior and were not able to identify the influence of systematic errors.
Adaptive tomography has been widely investigated with the aim of achieving faster state tomography processing of quantum systems. Infidelity of the nearly pure states in a quantum information process generally scales as O(1/N), which requires a large number of statistical ensembles in comparison to the infidelity scaling of O(1/N) for mixed states. One previous report optimized the measurement basis in a photonic qubit system, whose state tomography uses projective measurements, to obtain an infidelity scaling of O(1/N). However, this dramatic improvement cannot be applied to indistinct measurement systems in which two quantum states cannot be distinguished with perfect measurement fidelity. We introduce in this work an optimal measurement basis to achieve fast adaptive quantum state tomography and a minimum magnitude of infidelity in an indistinct measurement system. We expect that the adaptive quantum state tomography protocol can lead to a reduction in the number of required measurements of approximately 33.74% via analytical expectation without changing the O(1/N) scaling. Experimentally, we find a 15.06% measurement number reduction in a superconducting circuit system.
We introduce a fast and accurate heuristic for adaptive tomography that addresses many of the limitations of prior methods.Previous approaches were either too computationally intensive or tailored to handle special cases such as single qubits or pure states.By contrast, our approach combines the efficiency of online optimization with generally applicable and well-motivated data-processing techniques.We numerically demonstrate these advantages in several scenarios including mixed states, higher-dimensional systems, and restricted measurements.Quantum information processing (QIP) promises advantages in a wide range of different contexts, including machine learning [2-4], chemistry simulation [5][6][7], and number theory [8,9].As such, the experimental effort to build useful QIP devices has exploded in recent years.In the course of this effort, quantum tomography is a valuable tool for diagnosing and debugging small quantum devices, and has subsequently seen a variety of different advances.In particular, Bayesian approaches to tomography which are especially well suited to utilizing prior information and adapting to changing experimental conditions have developed significantly in recent years [10-13], presenting a useful experimental tool [14][15][16].In this paper we demonstrate the efficiency and accuracy of an adaptive tomography protocol that we call PAQT: practical adaptive quantum tomography.PAQT intelligently selects new measurements based on the outcomes of previous ones [10,[17][18][19][20][21].Adaptivity has been experimentally demonstrated [14,15,[22][23][24][25], but is not currently standard practice.Though adaptivity increases accuracy, the computational costs incurred outweigh that of simply repeating standard measurements many times.The PAQT approach employs a simple heuristic that can be efficiently computed between measurements, even with embedded hardware [26][27][28][29].The algorithm we propose is therefore compatible with modern experimental design and avoids an important limitation of previous approaches.We base our algorithm off of self-guided quantum tomography (SGQT), which treats adaptive tomography as a direct optimization problem rather than a new optimization problem between each measurement [30].Though this affords an efficient and easy to implement adaptive heuristic, SGQT is not without its limitations.It requires assuming that the target state is pure, and it does not return rich region estimates for a state.What PAQT achieves is to effectively combine SGQT with conventional and easily-implemented tomographic estimators, such as the Bayesian particle filter or least-squares fit (LSF) estimators.Under this approach, an experimentalist can collect data using SGQT (even if its assumptions are not met), and then post-process this data using particle filtering or LSF.The benefit of PAQT is two-fold.(1) From the point of view of traditional tomography, it gives an adaptive tomography protocol requiring only modest computational resources, as the bulk of the computational cost is offloaded to post-processing.(2) From the point of view of simulation-based optimization tomography (such as SGQT), it effectively augments the output with region estimation providing a statistically robust quantification of uncertainty.Thus, while we do not explicitly demonstrate that the improved scaling of Ferrie [30] remains in the more general case considered here, PAQT does provide a practical and efficient procedure for performing adaptive quantum tomography with rigorous statistical principles.
Abstract Adaptive techniques have great potential for wide application in enhancing the precision of quantum parameter estimation. We present an adaptive quantum state tomography protocol for finite dimensional quantum systems and experimentally implement the adaptive tomography protocol on two-qubit systems. In this adaptive quantum state tomography protocol, an adaptive measurement strategy and a recursive linear regression estimation algorithm are performed. Numerical results show that our adaptive quantum state tomography protocol can outperform tomography protocols using mutually unbiased bases and the two-stage mutually unbiased bases adaptive strategy, even with the simplest product measurements. When nonlocal measurements are available, our adaptive quantum state tomography can beat the Gill–Massar bound for a wide range of quantum states with a modest number of copies. We use only the simplest product measurements to implement two-qubit tomography experiments. In the experiments, we use error-compensation techniques to tackle systematic error due to misalignments and imperfection of wave plates, and achieve about a 100-fold reduction of the systematic error. The experimental results demonstrate that the improvement of adaptive quantum state tomography over nonadaptive tomography is significant for states with a high level of purity. Our results also show that this adaptive tomography method is particularly effective for the reconstruction of maximally entangled states, which are important resources in quantum information.
Adaptive tomography has been widely investigated to obtain faster state tomography process for quantum computation. Infidelity [1 − F(ρ,σ)] on nearly pure states in quantum information process scales generally as O(1/N), which requires a large number of statistical ensembles in comparison to the infidelity scaling on mixed states of O(1/N). Recently, optimization of a measurement basis in a photonic qubit system, whose state tomography uses projective measurements, reported improved infidelity scaled as O(1/N). However, this dramatic improvement cannot be applied to a weak-value based measurement system, which can be attributed to the fact that one cannot distinguish two quantum states with perfect measurement reliability. We introduce new optimal measurement basis to achieve a fast adaptive quantum state tomography and minimum magnitude of infidelity in this weak measurement system. This novel protocol allows us to accomplish approximately 80% error reduction without changing the scaling of O(1/N) in numerical simulations and realize approximately 90% error reduction in superconducting circuit QED experiments.
Adaptive tomography has been widely investigated to achieve faster state tomography processing of quantum systems. Infidelity of the nearly pure states in a quantum information process generally scales as O(1/sqrt(N) ), which requires a large number of statistical ensembles in comparison to the infidelity scaling of O(1/N) for mixed states. One previous report optimized the measurement basis in a photonic qubit system, whose state tomography uses projective measurements, to obtain an infidelity scaling of O(1/N). However, this dramatic improvement cannot be applied to weak-value-based measurement systems in which two quantum states cannot be distinguished with perfect measurement fidelity. We introduce in this work a new optimal measurement basis to achieve fast adaptive quantum state tomography and a minimum magnitude of infidelity in a weak measurement system. We expect that the adaptive quantum state tomography protocol can lead to a reduction in the number of required measurements of approximately 33.74% via simulation without changing the O(1/sqrt(N)) scaling. Experimentally, we find a 14.81% measurement number reduction in a superconducting circuit system.