Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:1712.03840 · Journal of Statistical Mechanics Theory and Experiment

Calculating eigenvalues of many-body systems from partition functions

Chi-Chun Zhou, Wu-Sheng Dai

Published Aug 1, 2018• 10 citations
arXivHTMLPDF

Abstract

Abstract A method for calculating the eigenvalue of a many-body system without solving the eigenfunction is suggested. In many cases, we only need the knowledge of eigenvalues rather than eigenfunctions, so we need a method solving only the eigenvalue, leaving alone the eigenfunction. In this paper, the method is established based on statistical mechanics. In statistical mechanics, calculating thermodynamic quantities needs only the knowledge of eigenvalues and then the information of eigenvalues is embodied in thermodynamic quantities. The method suggested in the present paper is indeed a method for extracting the eigenvalue from thermodynamic quantities. As applications, we calculate the eigenvalues for some many-body systems. Especially, the method is used to calculate the quantum exchange energies in quantum many-body systems. Using this method, we also calculate the influence of the topological effect on eigenvalues. Moreover, a complete result of the relation between the counting function and the heat kernel is given in the appendix.

DOI
10.1088/1742-5468/aad6bb

Related papers

Many-body formalism for fermions: The partition function

D. K. Watson

The partition function, a fundamental tenet in statistical thermodynamics, contains in principle all thermodynamic information about a system. It encapsulates both microscopic information through the quantum energy levels and statistical information from the partitioning of the particles among the available energy levels. For identical particles, this statistical accounting is complicated by the symmetry requirements of the allowed quantum states. In particular, for Fermi systems, the enforcement of the Pauli principle is typically a numerically demanding task, responsible for much of the cost of the calculations. The interplay of these three elements---the structure of the many-body spectrum, the statistical partitioning of the $N$ particles among the available levels, and the enforcement of the Pauli principle---drives the behavior of mesoscopic and macroscopic Fermi systems. In this paper, we develop an approach for the determination of the partition function, a numerically difficult task, for systems of strongly interacting identical fermions and apply it to a model system of harmonically confined, harmonically interacting fermions. This approach uses a recently introduced many-body method that is an extension of the symmetry-invariant perturbation method (SPT) originally developed for bosons. It uses group theory and graphical techniques to avoid the heavy computational demands of conventional many-body methods which typically scale exponentially with the number of particles. The SPT application of the Pauli principle is trivial to implement since it is done ``on paper'' by imposing restrictions on the normal-mode quantum numbers at first order in the perturbation. The method is applied through first order and represents an extension of the SPT method to excited states. Our method of determining the partition function and various thermodynamic quantities is accurate and efficient and has the potential to yield interesting insight into the role played by the Pauli principle and the influence of large degeneracies on the emergence of the thermodynamic behavior of large-$N$ systems.

Physical Review A•Sep 1, 2017•7 citations

A Method in Quantum Statistical Mechanics, I: General Theory

Hiroshi Ichimura

A formal expansion method for the grand partition function of the system of interacting particles is developed, in which the number representation and the ordered exponential method are used. The resulting formula will be useful in calculating quantum effects-statistical and dynamical- in the thermodynamical property of various systems. Applications to the special problems will be given in later papers.

Progress of Theoretical Physics•Apr 1, 1954•6 citations

Calculating the many-body density of states on a digital quantum computer

Alessandro Summer, Cecilia Chiaracane, Mark T. Mitchison +1 more

Quantum statistical mechanics allows us to extract thermodynamic information from a microscopic description of a many-body system. A key step is the calculation of the density of states, from which the partition function and all finite-temperature equilibrium thermodynamic quantities can be calculated. In this work, we devise and implement a quantum algorithm to perform an estimation of the density of states on a digital quantum computer which is inspired by the kernel polynomial method. Classically, the kernel polynomial method allows us to sample spectral functions via a Chebyshev polynomial expansion. Our algorithm computes moments of the expansion on quantum hardware using a combination of random-state preparation for stochastic trace evaluation and a controlled unitary operator. We use our algorithm to estimate the density of states of a nonintegrable Hamiltonian on the Quantinuum H1-1 trapped ion chip for a controlled register of 18 qubits. This not only represents a state-of-the-art calculation of thermal properties of a many-body system on quantum hardware, but also exploits the controlled unitary evolution of a many-qubit register on an unprecedented scale. Published by the American Physical Society 2024

arXiv:2303.13476•Physical Review Research•Jan 26, 2024•17 citations

Lower bounds for quantum energy levels through statistical mechanics methods

Luigi Nitti, M. Pellicoro, M. Villani

A perturbative variational method for the calculation of lower bounds to energy eigenvalues is given for a wide class of quantum mechanical systems. The method makes use of the quantum statistical partition function and exploits the inequalities satisfied by the generalized Padè approximants. The mathematical and physical content of our approach is illustrated through a standard model.

Journal of Mathematical Physics•Apr 1, 1980•5 citations

Path-integral approaches to the statistical mechanics of quantum systems: Variational methods for influence functionals

Kurt Allinger

A powerful numerical procedure is developed for calculating temperature-dependent quantities, such as partition functions for quantum systems coupled to thermal or other baths. A variational procedure is worked out to construct model Hamiltonians starting from the general results of the previous paper for influence functionals. Explicit, though intricate, formulas for all relevant quantities are presented. The methods developed are applied to a generalized model for a boson-bath interaction.

Physical Review A•Jan 1, 1989•3 citations

Statistical Theory of Many-Electron Systems. Discrete Bases of Representation

Sidney Golden

The density matrix for a many-electron system has been examined. A formalism has been arrived at which facilitates its evaluation in terms of a basis corresponding to a discrete spectrum of eigenvalues. This allows a representation to be employed associated with a suitably chosen approximation to the Hamiltonian. Thereby, reasonably accurate estimates of the properties of many-electron systems may be anticipated for low orders of approximation.In developing the formalism, attention was focused upon a means for approximating the quantity $\mathrm{exp}(z\mathrm{H})$, where H is the many-particle Hamiltonian and $z$ is a complex number. It was found possible to represent this quantity exactly as an infinite product of exponential factors, each of which depends upon a portion of the Hamiltonian alone. The relation of this result to statistical mechanical applications is indicated. An approximation procedure is described in terms of which various finite products of exponential factors approach the desired quantity in the limit of indefinitely increasing numbers of factors; this limit is approached in a manner that permits any given approximation to contain all the terms of the previous approximation.The first order of approximation was employed to approximate the many-particle density matrix. The resulting theory was applied to the helium-like systems: He, ${\mathrm{Li}}^{+}$, ${\mathrm{Be}}^{++}$. The energies of the ground $^{1}S$ state of helium and the three lowest states of ${\mathrm{Li}}^{+}$ and ${\mathrm{Be}}^{++}$ were calculated. The agreement with experimental term values is reasonably satisfactory, the discrepancy between calculations and experiments not exceeding one percent. The triplet-singlet splitting for ${\mathrm{Li}}^{+}$ was in the order observed; the magnitude calculated was about one-half that observed.The relation between the present theory and the Thomas-Fermi theory is discussed. It is pointed out that the former is the analog of the latter when the density matrix is expressed in other than eigenfunctions of momentum. The quasi-classical character of the approximation is discussed.

Physical Review•Sep 1, 1957•39 citations
Abstract A method for calculating the eigenvalue of a many-body system without solving the eigenfunction is suggested. In many cases, we only need the knowledge of eigenvalues rather than eigenfunctions, so we need a method solving only the eigenvalue, leaving alone the eigenfunction. In this paper, the method is established based on statistical mechanics. In statistical mechanics, calculating thermodynamic quantities needs only the knowledge of eigenvalues and then the information of eigenvalues is embodied in thermodynamic quantities. The method suggested in the present paper is indeed a method for extracting the eigenvalue from thermodynamic quantities. As applications, we calculate the eigenvalues for some many-body systems. Especially, the method is used to calculate the quantum exchange energies in quantum many-body systems. Using this method, we also calculate the influence of the topological effect on eigenvalues. Moreover, a complete result of the relation between the counting function and the heat kernel is given in the appendix.
The partition function, a fundamental tenet in statistical thermodynamics, contains in principle all thermodynamic information about a system. It encapsulates both microscopic information through the quantum energy levels and statistical information from the partitioning of the particles among the available energy levels. For identical particles, this statistical accounting is complicated by the symmetry requirements of the allowed quantum states. In particular, for Fermi systems, the enforcement of the Pauli principle is typically a numerically demanding task, responsible for much of the cost of the calculations. The interplay of these three elements---the structure of the many-body spectrum, the statistical partitioning of the NNN particles among the available levels, and the enforcement of the Pauli principle---drives the behavior of mesoscopic and macroscopic Fermi systems. In this paper, we develop an approach for the determination of the partition function, a numerically difficult task, for systems of strongly interacting identical fermions and apply it to a model system of harmonically confined, harmonically interacting fermions. This approach uses a recently introduced many-body method that is an extension of the symmetry-invariant perturbation method (SPT) originally developed for bosons. It uses group theory and graphical techniques to avoid the heavy computational demands of conventional many-body methods which typically scale exponentially with the number of particles. The SPT application of the Pauli principle is trivial to implement since it is done ``on paper'' by imposing restrictions on the normal-mode quantum numbers at first order in the perturbation. The method is applied through first order and represents an extension of the SPT method to excited states. Our method of determining the partition function and various thermodynamic quantities is accurate and efficient and has the potential to yield interesting insight into the role played by the Pauli principle and the influence of large degeneracies on the emergence of the thermodynamic behavior of large-NNN systems.
Quantum statistical mechanics allows us to extract thermodynamic information from a microscopic description of a many-body system. A key step is the calculation of the density of states, from which the partition function and all finite-temperature equilibrium thermodynamic quantities can be calculated. In this work, we devise and implement a quantum algorithm to perform an estimation of the density of states on a digital quantum computer which is inspired by the kernel polynomial method. Classically, the kernel polynomial method allows us to sample spectral functions via a Chebyshev polynomial expansion. Our algorithm computes moments of the expansion on quantum hardware using a combination of random-state preparation for stochastic trace evaluation and a controlled unitary operator. We use our algorithm to estimate the density of states of a nonintegrable Hamiltonian on the Quantinuum H1-1 trapped ion chip for a controlled register of 18 qubits. This not only represents a state-of-the-art calculation of thermal properties of a many-body system on quantum hardware, but also exploits the controlled unitary evolution of a many-qubit register on an unprecedented scale. Published by the American Physical Society 2024
The density matrix for a many-electron system has been examined. A formalism has been arrived at which facilitates its evaluation in terms of a basis corresponding to a discrete spectrum of eigenvalues. This allows a representation to be employed associated with a suitably chosen approximation to the Hamiltonian. Thereby, reasonably accurate estimates of the properties of many-electron systems may be anticipated for low orders of approximation.In developing the formalism, attention was focused upon a means for approximating the quantity exp(zH)\mathrm{exp}(z\mathrm{H})exp(zH), where H is the many-particle Hamiltonian and zzz is a complex number. It was found possible to represent this quantity exactly as an infinite product of exponential factors, each of which depends upon a portion of the Hamiltonian alone. The relation of this result to statistical mechanical applications is indicated. An approximation procedure is described in terms of which various finite products of exponential factors approach the desired quantity in the limit of indefinitely increasing numbers of factors; this limit is approached in a manner that permits any given approximation to contain all the terms of the previous approximation.The first order of approximation was employed to approximate the many-particle density matrix. The resulting theory was applied to the helium-like systems: He, Li+{\mathrm{Li}}^{+}Li+, Be++{\mathrm{Be}}^{++}Be++. The energies of the ground 1S^{1}S1S state of helium and the three lowest states of Li+{\mathrm{Li}}^{+}Li+ and Be++{\mathrm{Be}}^{++}Be++ were calculated. The agreement with experimental term values is reasonably satisfactory, the discrepancy between calculations and experiments not exceeding one percent. The triplet-singlet splitting for Li+{\mathrm{Li}}^{+}Li+ was in the order observed; the magnitude calculated was about one-half that observed.The relation between the present theory and the Thomas-Fermi theory is discussed. It is pointed out that the former is the analog of the latter when the density matrix is expressed in other than eigenfunctions of momentum. The quasi-classical character of the approximation is discussed.