Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:1707.01491 · Physical Review Letters

Universal Stabilization of a Parametrically Coupled Qubit

Yao Lu, Srivatsan Chakram, N. Leung, Nathan Earnest, Ravi Naik, Ziwen Huang, Peter Groszkowski, Eliot Kapit, Jens Koch, David Schuster

Published Oct 13, 2017• 125 citations
arXivHTMLPDF

Abstract

We autonomously stabilize arbitrary states of a qubit through parametric modulation of the coupling between a fixed frequency qubit and resonator. The coupling modulation is achieved with a tunable coupling design, in which the qubit and the resonator are connected in parallel to a superconducting quantum interference device. This allows for quasistatic tuning of the qubit-cavity coupling strength from 12 MHz to more than 300 MHz. Additionally, the coupling can be dynamically modulated, allowing for single-photon exchange in 6 ns. Qubit coherence times exceeding 20 μs are maintained over the majority of the range of tuning, limited primarily by the Purcell effect. The parametric stabilization technique realized using the tunable coupler involves engineering the qubit bath through a combination of photon nonconserving sideband interactions realized by flux modulation, and direct qubit Rabi driving. We demonstrate that the qubit can be stabilized to arbitrary states on the Bloch sphere with a worst-case fidelity exceeding 80%.

DOI
10.1103/physrevlett.119.150502

Related papers

Universal stabilization of single-qubit states using a tunable coupler

Ziwen Huang, Yao Lu, Eliot Kapit +2 more

We theoretically analyze a scheme for fast stabilization of arbitrary qubit states with high fidelities, extending a protocol recently demonstrated experimentally [Lu et al., Phys. Rev. Lett. 119, 150502 (2017)]. That experiment utilized red and blue sideband transitions in a system composed of a fluxonium qubit, a low-$Q$ $LC$ oscillator, and a coupler enabling us to tune the interaction between them. Under parametric modulations of the coupling strength, the qubit can be steered into any desired pure or mixed single-qubit state. For realistic circuit parameters, we predict that stabilization can be achieved within $100\phantom{\rule{0.28em}{0ex}}\mathrm{ns}$. By varying the ratio between the oscillator's damping rate and the effective qubit-oscillator coupling strength, we can switch between underdamped, critically damped, and overdamped stabilization and find optimal working points. We further analyze the effect of thermal fluctuations and show that the stabilization scheme remains robust for realistic temperatures.

arXiv:1803.01079•Physical Review A•Jun 29, 2018•13 citations

Parametric-Resonance Entangling Gates with a Tunable Coupler

Eyob Alebachew Sete, Nicolas Didier, Angela Q. Chen +3 more

High-fidelity parametric gates have been demonstrated with superconducting qubits via rf flux modulation of the qubit frequency. The modulation however leads to renormalization of the bare qubit-qubit coupling, thereby reducing the gate speed. Here, we realize a parametric-resonance gate, which is activated by bringing the average frequency of the modulated qubit in resonance with a static-frequency qubit while approximately retaining the bare qubit-qubit coupling. The activation of parametric-resonance gates does not depend on the frequency of modulation, allowing us to choose the modulation frequencies and avoid frequency collisions. Moreover, we show that this approach is compatible with tunable coupler architectures, which reduce always-on residual couplings. Using these techniques, we demonstrate iswap and controlled-$Z$ gates between two qubits coupled via a tunable coupler with average process fidelities as high as $99.3\mathrm{%}$ and $97.9\mathrm{%}$, respectively. The flexibility in activating parametric-resonance gates combined with a tunable coupler architecture provides a pathway for building large-scale quantum computers.

arXiv:2104.03511•Physical Review Applied•Aug 27, 2021•91 citations

Microwave-induced amplitude- and phase-tunable qubit-resonator coupling in circuit quantum electrodynamics

Sina Zeytinoǧlu, Marek Pechal, S. Berger +3 more

In the circuit quantum electrodynamics architecture, both the resonance frequency and the coupling of superconducting qubits to microwave field modes can be controlled via external electric and magnetic fields to explore qubit-photon dynamics in a wide parameter range. Here, we experimentally demonstrate and analyze a scheme for tuning the coupling between a transmon qubit and a microwave resonator using a single coherent drive tone. We treat the transmon as a three-level system, with the qubit subspace defined by the ground and the second excited states. If the drive frequency matches the difference between the resonator and the qubit frequencies, a Jaynes-Cummings-type interaction is induced, which is tunable in both amplitude and phase. We show that coupling strengths of about 10 MHz can be achieved in our setup, limited only by the anharmonicity of the transmon qubit. This scheme has been successfully used to generate microwave photons with a controlled temporal shape [M. Pechal et al., Phys. Rev. X 4, 041010 (2014)] and can be directly implemented with superconducting quantum devices featuring larger anharmonicity for higher coupling strengths.

arXiv:1502.03692•Physical Review A•Apr 30, 2015•97 citations

Tuning and amplifying the interactions in superconducting quantum circuits with subradiant qubits

Qiming Chen, Fabian Kronowetter, Florian Fesquet +7 more

We propose a tunable coupler consisting of $N$ fixed-frequency qubits, which can tune and even amplify the effective interaction between two superconducting quantum circuits. The tuning range of the interaction is proportional to $N$, with a minimum value of zero and a maximum that can exceed the physical coupling rates between the coupler and the circuits. The effective coupling rate is determined by the collective magnetic quantum number of the qubit ensemble, which takes only discrete values and is free from collective decay and decoherence. Using single-photon $\ensuremath{\pi}$-pulses, the coupling rate can be switched between arbitrary choices of the initial and final values within the dynamic range in a single step without going through intermediate values. A cascade of the couplers for amplifying small interactions or weak signals is also discussed. These results should not only stimulate interest in exploring the collective effects in quantum information processing, but also enable development of applications in tuning and amplifying the interactions in a general cavity-QED system.

arXiv:2107.01842•Physical Review A•Jan 3, 2022•1 citation

Tunable and switchable coupling between two superconducting resonators

A. Baust, Eric A. Hoffmann, M. Haeberlein +16 more

We realize a device allowing for tunable and switchable coupling between two frequency-degenerate superconducting resonators mediated by an artificial atom. For the latter, we utilize a persistent current flux qubit. We characterize the tunable and switchable coupling in the frequency and time domains and find that the coupling between the relevant modes can be varied in a controlled way. Specifically, the coupling can be tuned by adjusting the flux through the qubit loop or by controlling the qubit population via a microwave drive. Our measurements allow us to find parameter regimes for optimal coupler performance and quantify the tunability range.

arXiv:1405.1969•Physical Review B•Jan 30, 2015•68 citations

Fast Tunable Coupler for Superconducting Qubits

Radoslaw C. Bialczak, M. Ansmann, M. Hofheinz +11 more

A major challenge in the field of quantum computing is the construction of scalable qubit coupling architectures. Here, we demonstrate a novel tunable coupling circuit that allows superconducting qubits to be coupled over long distances. We show that the interqubit coupling strength can be arbitrarily tuned over nanosecond time scales within a sequence that mimics actual use in an algorithm. The coupler has a measured on/off ratio of 1000. The design is self-contained and physically separate from the qubits, allowing the coupler to be used as a module to connect a variety of elements such as qubits, resonators, amplifiers, and readout circuitry over distances much larger than nearest-neighbor. Such design flexibility is likely to be useful for a scalable quantum computer.

arXiv:1007.2219•Physical Review Letters•Feb 9, 2011•120 citations
We autonomously stabilize arbitrary states of a qubit through parametric modulation of the coupling between a fixed frequency qubit and resonator. The coupling modulation is achieved with a tunable coupling design, in which the qubit and the resonator are connected in parallel to a superconducting quantum interference device. This allows for quasistatic tuning of the qubit-cavity coupling strength from 12 MHz to more than 300 MHz. Additionally, the coupling can be dynamically modulated, allowing for single-photon exchange in 6 ns. Qubit coherence times exceeding 20 μs are maintained over the majority of the range of tuning, limited primarily by the Purcell effect. The parametric stabilization technique realized using the tunable coupler involves engineering the qubit bath through a combination of photon nonconserving sideband interactions realized by flux modulation, and direct qubit Rabi driving. We demonstrate that the qubit can be stabilized to arbitrary states on the Bloch sphere with a worst-case fidelity exceeding 80%.
We theoretically analyze a scheme for fast stabilization of arbitrary qubit states with high fidelities, extending a protocol recently demonstrated experimentally [Lu et al., Phys. Rev. Lett. 119, 150502 (2017)]. That experiment utilized red and blue sideband transitions in a system composed of a fluxonium qubit, a low-QQQ LCLCLC oscillator, and a coupler enabling us to tune the interaction between them. Under parametric modulations of the coupling strength, the qubit can be steered into any desired pure or mixed single-qubit state. For realistic circuit parameters, we predict that stabilization can be achieved within 100ns100\phantom{\rule{0.28em}{0ex}}\mathrm{ns}100ns. By varying the ratio between the oscillator's damping rate and the effective qubit-oscillator coupling strength, we can switch between underdamped, critically damped, and overdamped stabilization and find optimal working points. We further analyze the effect of thermal fluctuations and show that the stabilization scheme remains robust for realistic temperatures.
High-fidelity parametric gates have been demonstrated with superconducting qubits via rf flux modulation of the qubit frequency. The modulation however leads to renormalization of the bare qubit-qubit coupling, thereby reducing the gate speed. Here, we realize a parametric-resonance gate, which is activated by bringing the average frequency of the modulated qubit in resonance with a static-frequency qubit while approximately retaining the bare qubit-qubit coupling. The activation of parametric-resonance gates does not depend on the frequency of modulation, allowing us to choose the modulation frequencies and avoid frequency collisions. Moreover, we show that this approach is compatible with tunable coupler architectures, which reduce always-on residual couplings. Using these techniques, we demonstrate iswap and controlled-ZZZ gates between two qubits coupled via a tunable coupler with average process fidelities as high as $99.3\mathrm{%}$ and $97.9\mathrm{%}$, respectively. The flexibility in activating parametric-resonance gates combined with a tunable coupler architecture provides a pathway for building large-scale quantum computers.
In the circuit quantum electrodynamics architecture, both the resonance frequency and the coupling of superconducting qubits to microwave field modes can be controlled via external electric and magnetic fields to explore qubit-photon dynamics in a wide parameter range. Here, we experimentally demonstrate and analyze a scheme for tuning the coupling between a transmon qubit and a microwave resonator using a single coherent drive tone. We treat the transmon as a three-level system, with the qubit subspace defined by the ground and the second excited states. If the drive frequency matches the difference between the resonator and the qubit frequencies, a Jaynes-Cummings-type interaction is induced, which is tunable in both amplitude and phase. We show that coupling strengths of about 10 MHz can be achieved in our setup, limited only by the anharmonicity of the transmon qubit. This scheme has been successfully used to generate microwave photons with a controlled temporal shape [M. Pechal et al., Phys. Rev. X 4, 041010 (2014)] and can be directly implemented with superconducting quantum devices featuring larger anharmonicity for higher coupling strengths.
We propose a tunable coupler consisting of NNN fixed-frequency qubits, which can tune and even amplify the effective interaction between two superconducting quantum circuits. The tuning range of the interaction is proportional to NNN, with a minimum value of zero and a maximum that can exceed the physical coupling rates between the coupler and the circuits. The effective coupling rate is determined by the collective magnetic quantum number of the qubit ensemble, which takes only discrete values and is free from collective decay and decoherence. Using single-photon $\ensuremath{\pi}$-pulses, the coupling rate can be switched between arbitrary choices of the initial and final values within the dynamic range in a single step without going through intermediate values. A cascade of the couplers for amplifying small interactions or weak signals is also discussed. These results should not only stimulate interest in exploring the collective effects in quantum information processing, but also enable development of applications in tuning and amplifying the interactions in a general cavity-QED system.
We realize a device allowing for tunable and switchable coupling between two frequency-degenerate superconducting resonators mediated by an artificial atom. For the latter, we utilize a persistent current flux qubit. We characterize the tunable and switchable coupling in the frequency and time domains and find that the coupling between the relevant modes can be varied in a controlled way. Specifically, the coupling can be tuned by adjusting the flux through the qubit loop or by controlling the qubit population via a microwave drive. Our measurements allow us to find parameter regimes for optimal coupler performance and quantify the tunability range.
A major challenge in the field of quantum computing is the construction of scalable qubit coupling architectures. Here, we demonstrate a novel tunable coupling circuit that allows superconducting qubits to be coupled over long distances. We show that the interqubit coupling strength can be arbitrarily tuned over nanosecond time scales within a sequence that mimics actual use in an algorithm. The coupler has a measured on/off ratio of 1000. The design is self-contained and physically separate from the qubits, allowing the coupler to be used as a module to connect a variety of elements such as qubits, resonators, amplifiers, and readout circuitry over distances much larger than nearest-neighbor. Such design flexibility is likely to be useful for a scalable quantum computer.