Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:1706.00004

Superconducting Single-Photon Detectors with Enhanced High-Effciency Bandwidth

Stephan Krapick, Marina Hesselberg, Varun Boehm Verma, Igor Vayshenker, Sae Woo Nam, Richard P. Mirin

Published May 31, 2017• 1 citation
arXivHTMLPDF

Abstract

We present an alternative approach to the fabrication of highly efficient superconducting nanowire single-photon detectors (SNSPDs) based on tungsten silicide. Using well-established technologies for the deposition of dielectric mirrors and anti-reflection coatings in conjunction with an embedded WSi bilayer photon absorber structure, we fabricated a bandwidth-enhanced detector. It exhibits system detection efficiencies (SDE) higher than $\left(87.1\pm1.3\right)\,\%$ in the range from $1450\,\mathrm{nm}$ to $1640\,\mathrm{nm}$, with a maximum of $\left(92.9\pm1.1\right)\,\%$ at $1515\,\mathrm{nm}$. Our measurements indicate SDE enhancements of up to $\left(18.4\pm1.7\right)\,\%$ over a single-absorber WSi SNSPD. The latter has been optimized for 1550 nm for comparison and exhibits maximum SDE of $\left(93.5\pm1.2\right)\,\%$ at 1555 nm. We emphasize that our technological approach has been tested with, but is not limited to, the wavelengths and absorber material presented here. It could be adapted flexibly for multi-color detector systems from the ultraviolet to the mid-infrared wavelength range. This bears the potential for significant improvements in many current quantum optical experiments and applications as well as for detector commercialization.

DOI
10.48550/arxiv.1706.00004

Related papers

Tungsten Germanide Superconducting Nanowire Single-Photon Detectors with Saturated Internal Detection Efficiency at Wavelengths up to 29 μm

Benedikt Hampel, Daniel Kuznesof, Andrew S. Mueller +13 more

Superconducting nanowire single-photon detectors (SNSPDs) are among the most sensitive single-photon detectors available and have the potential to transform fields ranging from infrared astrophysics to molecular spectroscopy. However, extending their performance into the mid-infrared spectral region - crucial for applications such as exoplanet transit spectroscopy and vibrational fingerprinting of molecules - has remained a major challenge, primarily due to material limitations and scalability constraints. Here, we report on the development of SNSPDs based on tungsten germanide, a novel material system that combines high mid-infrared sensitivity with compatibility for large-scale fabrication. Our detectors exhibit saturated internal detection efficiency at wavelengths up to 29 μm, while using 2.7x thicker films (8 nm vs 3 nm) and up to 4.5x wider nanowires (360 nm vs 80 nm) compared to mid-infrared-optimized SNSPDs fabricated from tungsten silicide. This advance will enable scalable, high-performance single-photon detection in a spectral region that was previously inaccessible, opening new frontiers in remote sensing, thermal imaging, environmental monitoring, molecular physics, and astronomy.

physics.ins-detCross-listedarXiv:2511.20868•Nov 27, 2025

Detecting single infrared photons toward optimal system detection efficiency

Peng Hu, Hao Li, Lixing You +7 more

Superconducting nanowire single-photon detector (SNSPD) with near-unity system efficiency is a key enabling, but still elusive, technology for numerous quantum fundamental theory verifications and quantum information applications. The key challenge is to have both a near-unity photon-response probability and absorption efficiency simultaneously for the meandered nanowire with a finite filling ratio, which is more crucial for NbN than other superconducting materials (e.g., WSi) with lower transition temperatures. Here, we overcome the above challenge and produce NbN SNSPDs with a record system efficiency by replacing a single-layer nanowire with twin-layer nanowires on a dielectric mirror. The detector at 0.8 K shows a maximal system detection efficiency (SDE) of 98% at 1590 nm and a system efficiency of over 95% in the wavelength range of 1530-1630 nm. Moreover, the detector at 2.1 K demonstrates a maximal SDE of 95% at 1550 nm using a compacted two-stage cryocooler. This type of detector also shows the robustness against various parameters, such as the geometrical size of the nanowire and the spectral bandwidth, enabling a high yield of 73% (36%) with an SDE of >80% (90%) at 2.1 K for 45 detectors fabricated in the same run. These SNSPDs made of twin-layer nanowires are of important practical significance for batch production.

arXiv:2009.14690•Optics Express•Nov 12, 2020•155 citations

Bandwidth-enhanced Superconducting Nanowire Single Photon Detectors for Telecom Wavelengths

Stephan Krapick, Marina Hesselberg, Varun Boehm Verma +2 more

We present a single-photon detector providing system detection efficiencies of at least (86.7 ± 0.9) % from 1450 nm to 1640 nm. It comprises bilayer superconducting WSi nanowires in conjunction with all-dielectric structures for optical impedance matching.

Conference on Lasers and Electro-Optics•Jan 1, 2017•1 citation

Superconducting Nanowire Single Photon Detectors with High System Detection Efficiency at Telecom Wavelengths

Francesco Marsili, Varun Boehm Verma, Jeff A. Stern +9 more

We report on a fiber-coupled eight-channel single-photon-detection system employing superconducting nanowire single-photon detectors (SNSPDs) based on amorphous tungsten silicide (WSi) with system detection efficiency ranging from 81 to 89 % at 1550 nm wavelength.

•Jan 1, 2013•1 citation

Mid-Infrared Single-Photon Detection with Tungsten Silicide Superconducting Nanowires

Francesco Marsili, Varun Boehm Verma, Martin J. Stevens +7 more

We developed superconducting nanowire single-photon detectors (SNSPDs) based on tungsten silicide (WSi), that show saturated internal detection efficiency from 2.1 to 5.5 mum wavelength.

•Jan 1, 2013•11 citations

Superconducting nanowire single-photon detectors based on amorphous tungsten germanide

Shi‐Jie Yang, Ying Chen, Limin Sun +13 more

In this Letter, we characterized superconducting nanowire single-photon detectors (SNSPDs) based on amorphous tungsten germanide (W0.8Ge0.2) superconducting films, which exhibit superconducting properties comparable to those of amorphous WSi. The nanowire width ranges from 60 to 90 nm, with a fixed filling factor of 30%. All fabricated devices exhibit saturated intrinsic detection efficiency for infrared photons with wavelengths up to 2 μm, indicating that WGe is a promising candidate for SNSPDs designed for mid- and far-infrared photon detection. The timing jitter of these detectors, measured with a room-temperature amplifier, ranges from 127 to 234.5 ps. Further improvements can be achieved through device geometry optimization or the implementation of cryogenic amplifiers.

Applied Physics Letters•Apr 21, 2025•4 citations
We present an alternative approach to the fabrication of highly efficient superconducting nanowire single-photon detectors (SNSPDs) based on tungsten silicide. Using well-established technologies for the deposition of dielectric mirrors and anti-reflection coatings in conjunction with an embedded WSi bilayer photon absorber structure, we fabricated a bandwidth-enhanced detector. It exhibits system detection efficiencies (SDE) higher than (87.1±1.3) %\left(87.1\pm1.3\right)\,\%(87.1±1.3)% in the range from 1450 nm1450\,\mathrm{nm}1450nm to 1640 nm1640\,\mathrm{nm}1640nm, with a maximum of (92.9±1.1) %\left(92.9\pm1.1\right)\,\%(92.9±1.1)% at 1515 nm1515\,\mathrm{nm}1515nm. Our measurements indicate SDE enhancements of up to (18.4±1.7) %\left(18.4\pm1.7\right)\,\%(18.4±1.7)% over a single-absorber WSi SNSPD. The latter has been optimized for 1550 nm for comparison and exhibits maximum SDE of (93.5±1.2) %\left(93.5\pm1.2\right)\,\%(93.5±1.2)% at 1555 nm. We emphasize that our technological approach has been tested with, but is not limited to, the wavelengths and absorber material presented here. It could be adapted flexibly for multi-color detector systems from the ultraviolet to the mid-infrared wavelength range. This bears the potential for significant improvements in many current quantum optical experiments and applications as well as for detector commercialization.
Superconducting nanowire single-photon detectors (SNSPDs) are among the most sensitive single-photon detectors available and have the potential to transform fields ranging from infrared astrophysics to molecular spectroscopy. However, extending their performance into the mid-infrared spectral region - crucial for applications such as exoplanet transit spectroscopy and vibrational fingerprinting of molecules - has remained a major challenge, primarily due to material limitations and scalability constraints. Here, we report on the development of SNSPDs based on tungsten germanide, a novel material system that combines high mid-infrared sensitivity with compatibility for large-scale fabrication. Our detectors exhibit saturated internal detection efficiency at wavelengths up to 29 μm, while using 2.7x thicker films (8 nm vs 3 nm) and up to 4.5x wider nanowires (360 nm vs 80 nm) compared to mid-infrared-optimized SNSPDs fabricated from tungsten silicide. This advance will enable scalable, high-performance single-photon detection in a spectral region that was previously inaccessible, opening new frontiers in remote sensing, thermal imaging, environmental monitoring, molecular physics, and astronomy.
Superconducting nanowire single-photon detector (SNSPD) with near-unity system efficiency is a key enabling, but still elusive, technology for numerous quantum fundamental theory verifications and quantum information applications. The key challenge is to have both a near-unity photon-response probability and absorption efficiency simultaneously for the meandered nanowire with a finite filling ratio, which is more crucial for NbN than other superconducting materials (e.g., WSi) with lower transition temperatures. Here, we overcome the above challenge and produce NbN SNSPDs with a record system efficiency by replacing a single-layer nanowire with twin-layer nanowires on a dielectric mirror. The detector at 0.8 K shows a maximal system detection efficiency (SDE) of 98% at 1590 nm and a system efficiency of over 95% in the wavelength range of 1530-1630 nm. Moreover, the detector at 2.1 K demonstrates a maximal SDE of 95% at 1550 nm using a compacted two-stage cryocooler. This type of detector also shows the robustness against various parameters, such as the geometrical size of the nanowire and the spectral bandwidth, enabling a high yield of 73% (36%) with an SDE of >80% (90%) at 2.1 K for 45 detectors fabricated in the same run. These SNSPDs made of twin-layer nanowires are of important practical significance for batch production.
In this Letter, we characterized superconducting nanowire single-photon detectors (SNSPDs) based on amorphous tungsten germanide (W0.8Ge0.2) superconducting films, which exhibit superconducting properties comparable to those of amorphous WSi. The nanowire width ranges from 60 to 90 nm, with a fixed filling factor of 30%. All fabricated devices exhibit saturated intrinsic detection efficiency for infrared photons with wavelengths up to 2 μm, indicating that WGe is a promising candidate for SNSPDs designed for mid- and far-infrared photon detection. The timing jitter of these detectors, measured with a room-temperature amplifier, ranges from 127 to 234.5 ps. Further improvements can be achieved through device geometry optimization or the implementation of cryogenic amplifiers.