The nitrogen-vacancy (NV) centre in diamond is a unique optical defect that is used in many applications today and methods to enhance its fluorescence brightness are highly sought after. We observed experimentally an enhancement of the NV quantum yield by up to 7% in bulk diamond caused by an external magnetic field relative to the field-free case. This observation is rationalised phenomenologically in terms of a magnetic field dependence of the NV excited state triplet-to-singlet transition rate. The theoretical model is in good qualitative agreement with the experimental results at low excitation intensities. Our results significantly contribute to our fundamental understanding of the photophysical properties of the NV defect in diamond.
The nitrogen-vacancy (NV) centre in diamond is a unique optical defect that is used in many applications today and methods to enhance its fluorescence brightness are highly sought after. We observed experimentally an enhancement of the NV quantum yield by up to 7% in bulk diamond caused by an external magnetic field relative to the field-free case. This observation is rationalised phenomenologically in terms of a magnetic field dependence of the NV excited state triplet-to-singlet transition rate. The theoretical model is in good qualitative agreement with the experimental results at low excitation intensities. Our results significantly contribute to our fundamental understanding of the photophysical properties of the NV defect in diamond.
The fluorescence of the nitrogen-vacancy (NV) centre in artificial diamond has been widely studied for applications such as quantum communication protocols, quantum computation, fluorescence-based biolabelling, and optical sensing. Optical sensing by itself encompasses a wide range of possible applications: from magnetic and electric field sensing to temperature sensing and enabling, for example, the detection of paramagnetic ions and the identification of molecules by nuclear magnetic resonance. Compared to many other systems capable of optical sensing, the NV centre works at room temperature, and its spin-dependent fluorescence emission is the key property to achieve a high sensitivity to the surrounding environment. Additionally, the NV centre emission is highly photostable, has a relatively short lifetime (~ 12ns) and spans a broad wavelength range, from the red to the near-infrared region of the electromagnetic spectrum (600 - 800nm). While the common denominator of all mentioned applications is the NV centre, the properties of the artificial diamond surrounding the NV centre have a significant impact on its sensing performance. At present, the processing of artificial diamond has not been fully optimised, and research and development towards the realisation of the `best¿ diamond sample for optical sensing is far from over. Specifically, the role of other defects in diamond and their effects on the photo-physical properties of the NV centres are not entirely understood. In this thesis, I will discuss the potential benefits of a novel processing technique to create ensembles of NV centres, and the importance that surrounding nitrogen defects has on the achievable magnetic field sensitivity. Additionally, I will show both theoretical and experimental investigations of the NV centres photo-physical processes, with focus on magnetic field sensing. I will initially explore a protocol for microwave-free magnetometry. This protocol predicts a theoretical magnetic field sensitivity <10µT/√Hz in the range 0.3 - 30mT and I will demonstrate it experimentally with a maximum sensitivity of 3.6mT/Hz. Following, I will focus on exploring techniques to increase the magnetic field sensitivity by improving the material properties of the diamond samples. I will demonstrate that the simultaneous electron irradiation and annealing improves the creation efficiency of an ensemble of NV centres by up to 117%. Finally, I will investigate how substitutional nitrogen defects in the surrounding lattice affects the charge state of the NV centre, its emission intensity, its lifetime and its magnetic field sensitivity. I will study a sample characterised by multiple regions across its volume, with nitrogen concentration changing between 10ppm and 100ppm in each region. There si an optimal region with ~ 40ppm of substitutional nitrogen which demonstrates the highest fluorescence emission, mainly from the negatively-charged NV centre, and the highest magnetic field sensitivity of 1.6 ± 0.2µT/√Hz. However, both the regions with lower and higher substitutional nitrogen concentration than the optimal region show lower emission intensity and worse magnetic field sensitivity. Following is a summary of the content in each chapter: Chapter 1 will present an introduction to the diamond material and the classification of artificial diamond samples. It will introduce the NV centre, its fluorescence properties and the process to create NV centres in diamond. The chapter will also introduce the concepts around optical magnetometry and the working principle that allows the NV centre to sense magnetic fields as well as other external quantities, such as temperature or pressure. Finally, it will include a brief overview of the defects that are found in artificial diamond or are created during the sample processing. Chapter 2 will describe the working principle of the instruments utilised in this work. I will list the details of each instrument and describe the methods used for the analysis of the data. Chapter 3 will introduce the background of modelling the fluorescence emission from NV centres. I will discuss the implementation of a computational model based on the Lindblad master equation to simulate the photo-physical dynamics of the NV centre. I will demonstrate the successful simulation of the saturation emission, fluorescence lifetime and optically detected magnetic resonance using the theoretical model. Finally, I will explore the theoretically predicted sensitivity of microwave-free magnetometry, based on the NV centre emission intensity change under an external magnetic field. Chapter 4 will demonstrate experimentally the microwave-free magnetometry technique. In relation to the study of microwave-free magnetometry, this chapter will explore an unexpected increase in emission intensity at high magnetic fields > 100mT. Combining the experimental observations and the theoretical simulation developed in the previous chapter, I will identify and discuss a phenomenological decrease in the NV centre transition rate from the triplet state to the singlet state. The chapter will conclude comparing the experimental and theoretical sensitivities associated with the microwave-free magnetometry technique. Chapter 5 will show the characterisation of a diamond sample at each step of the process to create NV centres. I will study the electron irradiation followed by separate annealing on a high-pressure high-temperature diamond sample. I will then characterise the sample employing visible and infrared absorption spectroscopy, as well as measure the fluorescence spectra and lifetime of the defects identified at each step. Chapter 6 will examine an alternative method to create NV centres in diamond. I will compare diamond samples irradiated and annealed separately with samples simultaneously irradiated and annealed (referred to as 'annealing in situ'). To compare the two processes, I will estimate the concentration of nitrogen defects and NV centres and calculate their N-to-NV conversion efficiency. Chapter 7 will discuss the effects of substitutional nitrogen on the properties of the NV centres in diamond. For this discussion, I will use a single-crystal diamond that shows the presence of 4 growth sectors. Each growth sector is characterised by a different nitrogen concentration, as I will demonstrate at the beginning of the chapter. I will focus on 4 main properties affected by the concentration of nitrogen in the different sectors: the balance between the charge states of the NV centre, the overall fluorescence intensity from each sector, the fluorescence lifetime and its relation to non-radiative processes, and the magnetic field sensitivity obtained with the optically detected magnetic resonance technique. Chapter 8 will gather the results and conclusions of the entire body of work. It will also discuss future avenues of research in the topic of diamond processing and characterisations, to improve the existing optical sensing applications.
Nitrogen–vacancy (NV) colour centres in diamond are attractive fluorescence emitters owing to their unprecedented photostability and superior applicability to spin manipulation and sub-diffraction far-field optical microscopy. However, some applications are limited by the co-occurrence of dark state population and optical excitation. In this paper, we use fluorescence microscopy and correlation spectroscopy on single negatively charged NV centres in type IIa bulk diamond to unravel the population kinetics of a >100 s long-lived dark state. The bright–dark state interconversion rates show a quadratic dependence on the applied laser intensity, which implies that higher excited states are involved. Depopulation of the dark state becomes less effective at wavelengths above 532 nm, resulting in a complete fluorescence switch-off at wavelengths >600 nm. This switch is reversible by the addition of shorter wavelengths. This behaviour can be explained by a model consisting of three dark and three bright states of different excitation levels, with the most efficient interconversion via the respective higher excited states. This model accounts for the nonlinear dark state and photoswitching kinetics, as well as for the decrease of the NV's fluorescence lifetime with excitation intensity and the strong dependence of fluorescence emission on excitation intensity. Unfortunately, our data do not give enough insight to allow us to assign the different states to specific electronic states known from the literature. Nevertheless, our observations allowed us to improve the recording of fluorescence images of single NV centres with sub-diffraction spatial resolution but they also have important implications for studying their spin states.
The nitrogen-vacancy (N-V⁻) colour centre in diamond has potential applications in quantum information processing and single photon generation. It is currently the only known defect in a solid detected at a single site level that has a non-zero spin in the electronic ground state. For the proposed applications it is desirable to have a good understanding of the electronic structure and photodynamics of the centre, however this is currently not the case. Various models have been proposed to explain the fluorescence characteristics observed in single site experiments. The challenge has been to also account for the properties of the centre well-known from observations of the fluorescence from large ensembles of N-V⁻ in diamond. Firstly, that a non-Boltzmann population distribution between the. ground state spin levels is induced by optical excitation. Secondly, that the fluorescence intensity exhibits a strong dependence on the spin orientation. The models proposed to date either cannot account for these properties, or do so only by invoking optical processes that are arbitrary or, in some cases, not physical. In this thesis an alternative model is presented. The derivation of the model, from group theoretical considerations, does not form part of this thesis. This thesis is concerned primarily with a series of independent measurements to determine the transition rates which govern the photodynamics of the centre. When these transition rates are known, there will be no free parameters in the model and the N-V⁻ emission can be simulated for an arbitrary optical field by solving the classical rate equations. To conclude the first part of this thesis, a two-pulse optical excitation is considered and the results of experiment are compared to the predictions of the model. The latter part of t his thesis is concerned with optically detecting single N-V⁻ centres. A confocal microscope system, to enable single site detection, was developed as part of this work. The photon statistics from a single N-V⁻ centre is compared to the statistics predicted by the model. The implications for the modelling of individual N-V⁻ photon statistics are discussed.
Nitrogen-Vacancy (NV) centres in diamond have been shown to possess a quantised energy structure that allows for a number of macroscopic parameters to be measured with a high level of sensitivity. The process of sensing magnetic fields can be achieved through the behaviour of the NV centre’s electron spin triplet states using the separation of field-dependent and independent states, inferred by applying a microwave frequency to drive transitions. Observation of the states is achieved through optical pumping and stimulated emission, where the intensity of the fluorescent emission and frequency of the applied microwaves relates to the magnitude of the magnetic field the NV centre experiences. The optical method of sensing can be facilitated using optical fibres in which NV diamond particles are embedded between the core and outer fibre layers, leading to a robust platform for further practical applications with strong resistance to external interference.
We investigate the magnetic field dependent photophysics of individual nitrogen-vacancy (NV) color centers in diamond under cryogenic conditions. At distinct magnetic fields, we observe significant reductions in the NV photoluminescence rate, which indicate a marked decrease in the optical readout efficiency of the NV's ground state spin. We assign these dips to excited state level anticrossings, which occur at magnetic fields that strongly depend on the effective, local strain environment of the NV center. Our results offer new insights into the structure of the NVs' excited states and a new tool for their effective characterization. Using this tool, we observe strong indications for strain-dependent variations of the NV's orbital g factor, obtain new insights into NV charge state dynamics, and draw important conclusions regarding the applicability of NV centers for low-temperature quantum sensing.
Abstract The nitrogen-vacancy colour centre in diamond is emerging as one of the most important solid-state quantum systems. It has applications to fields including high-precision sensing, quantum computing, single photon communication, metrology, nanoscale magnetic imaging and biosensing. For all of these applications, a high quantum yield of emitted photons is desirable. However, diamond samples engineered to have high densities of nitrogen-vacancy centres show levels of brightness varying significantly within single batches, or even within the same sample. Here we show that nearby nitrogen impurities quench emission of nitrogen-vacancy centres via non-radiative transitions, resulting in a reduced fluorescence quantum yield. We monitored the emission properties of nitrogen-vacancy centre ensembles from synthetic diamond samples with different concentrations of nitrogen impurities. All samples were irradiated with high energy electrons to create high densities of nitrogen-vacancy centres relative to the concentration of nitrogen impurities. While at low nitrogen densities of 1.81 ppm we measured a lifetime of 13.9 ns, we observed a strong reduction in lifetime with increasing nitrogen density. We measure a lifetime as low as 4.4 ns at a nitrogen density of 380 ppm. The change in lifetime matches a reduction in relative fluorescence quantum yield from 77.4% to 32% with an increase in nitrogen density from 88 ppm to 380 ppm, respectively. These results will inform the conditions required to optimise the properties of diamond crystals devices based on the fluorescence of nitrogen-vacancy centres. Furthermore, this work provides insights into the origin of inhomogeneities observed in high-density nitrogen-vacancy ensembles within diamonds and nanodiamonds.