Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:1605.09536

Strengthen Weak Measurement with Conjugated Destructive Interference

Zi-Huai Zhang, Geng Chen, Xiao-Ye Xu, Jian‐Shun Tang, Wenhao Zhang, Yong‐Jian Han, Chuan‐Feng Li, Guang-Can Guo

Published May 31, 2016• 0 citations
arXivHTMLPDF

Abstract

Standard weak measurement (SWM) has been proved to be a useful ingredient for measuring small longitudinal phase shifts. [Phys. Rev. Lett. 111, 033604 (2013)]. In this letter, we show that with specfic pre-coupling and postselection, destructive interference can be observed for the two conjugated variables, i.e. time and frequency, of the meter state. Using a broad band source, this conjugated destructive interference (CDI) can be observed in a regime approximately 1 attosecond, while the related spectral shift reaches hundreds of THz. This extreme sensitivity can be used to detect tiny longitudinal phase perturbation. Combined with a frequency-domain analysis, conjugated destructive interference weak measurement (CDIWM) is proved to outperform SWM by two orders of magnitude.

DOI
10.48550/arxiv.1605.09536

Related papers

Ultrasensitive biased weak measurement for longitudinal phase estimation

Zi-Huai Zhang, Geng Chen, Xiao-Ye Xu +5 more

Standard weak measurement (SWM) has been proved to be a useful ingredient for measuring small longitudinal phase change (LPC) [X. Y. Xu, Y. Kedem, K. Sun, L. Vaidman, C. F. Li, and Guang-Can Guo, Phys. Rev. Lett. 111, 033604 (2013)]. In these SWM proposals, the working regime is selected where the relative phase between orthogonal components is zero, and the LPC can be detected by measuring the shift of the meter state, i.e., the time and frequency domain, which are conjugated observables. Here, we show that an extra bias phase can significantly improve the sensitivity of measuring LPC. This bias phase can be introduced by a precoupling process. Together with a special postselection, a destructive interference can be observed in both the time and frequency domain. Using a broadband source, this conjugated destructive interference occurs in a regime less than 1 as, while the related spectral shift reaches hundreds of THz, resulting in sensitivity outperforming SWM by two orders of magnitude.

Physical Review A•Nov 22, 2016•41 citations

Measuring Small Longitudinal Phase Shifts: Weak Measurements or Standard Interferometry?

Nicolas Brunner, Christoph Simon

Recently, weak measurements were used to measure small effects that are transverse to the propagation direction of a light beam. Here we address the question of whether weak measurements are also useful for measuring small longitudinal phase shifts. We show that standard interferometry greatly outperforms weak measurements in a scenario involving a purely real weak value. However, we also present an interferometric scheme based on a purely imaginary weak value, combined with a frequency-domain analysis, which may have the potential to outperform standard interferometry by several orders of magnitude.

arXiv:0911.5139•Physical Review Letters•Jul 2, 2010•397 citations

Weak Values Technique for Precision Measurements of Doppler Shifts

Gerardo I. Viza, Julián Martínez-Rincón, Gregory A. Howland +4 more

In a recent letter, Brunner and Simon propose an interferometric scheme using imaginary weak values with a frequency-domain analysis to outperform standard interferometry in longitudinal phase shifts [N. Brunner and C. Simon, Phys. Rev. Lett {\bf105} (2010)]. Here we demonstrate an interferometric scheme combined with a time-domain analysis to measure longitudinal velocities. The technique employs the near-destructive interference of non-Fourier limited pulses, one Doppler shifted due to a moving mirror, in a Michelson interferometer. We achieve a velocity measurement of 400 fm/s and show our estimator to be efficient by reaching its Cramer-Rao bound.

•Mar 29, 2013•0 citations

Weak-values technique for velocity measurements

Gerardo I. Viza, Julián Martínez-Rincón, Gregory A. Howland +4 more

In a recent Letter, Brunner and Simon proposed an interferometric scheme using imaginary weak values with a frequency-domain analysis to outperform standard interferometry in longitudinal phase shifts [Phys. Rev. Lett105, 010405 (2010)]. Here we demonstrate an interferometric scheme combined with a time-domain analysis to measure longitudinal velocities. The technique employs the near-destructive interference of non-Fourier limited pulses, one Doppler shifted due to a moving mirror in a Michelson interferometer. We achieve a velocity measurement of 400 fm/s and show our estimator to be efficient by reaching its Cramér-Rao bound.

arXiv:1304.0029•Optics Letters•Aug 2, 2013•162 citations

Ultrasensitive phase estimation with white light

Chuan‐Feng Li, Xiao-Ye Xu, Jian‐Shun Tang +2 more

An improvement of the scheme by Brunner and Simon [Phys. Rev. Lett. 105, 010405 (2010)] is proposed in order to show that quantum weak measurements can provide a method to detect ultrasmall longitudinal phase shifts, even with white light. By performing an analysis in the frequency domain, we find that the amplification effect will work as long as the spectrum is large enough, irrespective of the behavior in the time domain. As such, the previous scheme can be notably simplified for experimental implementations.

arXiv:1102.4902•Physical Review A•Apr 19, 2011•61 citations

Precision estimation of time delay based on weak measurement with real weak value

Weining Liu, Yisen Wang, Hailu Luo

In the standard weak measurement, the imaginary part of the weak value is usually constructed with a specific pre- or postselection state to cause a large shift of the frequency-domain pointer. In this paper we demonstrate that the purely real weak value can also shift the frequency-domain pointer when using a broad-spectrum light source. The reason for the deflection of the frequency-domain pointer in this scheme is that the postselection probability of different frequency is different, which causes the rearrangement of the amplitudes of the spectrum. The weak measurement with real weak value can be used for the estimation of time delay, and it is found that it can reach the same high resolution as the standard weak measurement in some sensitive regions.

Physical Review A•Nov 13, 2023•4 citations
Standard weak measurement (SWM) has been proved to be a useful ingredient for measuring small longitudinal phase shifts. [Phys. Rev. Lett. 111, 033604 (2013)]. In this letter, we show that with specfic pre-coupling and postselection, destructive interference can be observed for the two conjugated variables, i.e. time and frequency, of the meter state. Using a broad band source, this conjugated destructive interference (CDI) can be observed in a regime approximately 1 attosecond, while the related spectral shift reaches hundreds of THz. This extreme sensitivity can be used to detect tiny longitudinal phase perturbation. Combined with a frequency-domain analysis, conjugated destructive interference weak measurement (CDIWM) is proved to outperform SWM by two orders of magnitude.
Standard weak measurement (SWM) has been proved to be a useful ingredient for measuring small longitudinal phase change (LPC) [X. Y. Xu, Y. Kedem, K. Sun, L. Vaidman, C. F. Li, and Guang-Can Guo, Phys. Rev. Lett. 111, 033604 (2013)]. In these SWM proposals, the working regime is selected where the relative phase between orthogonal components is zero, and the LPC can be detected by measuring the shift of the meter state, i.e., the time and frequency domain, which are conjugated observables. Here, we show that an extra bias phase can significantly improve the sensitivity of measuring LPC. This bias phase can be introduced by a precoupling process. Together with a special postselection, a destructive interference can be observed in both the time and frequency domain. Using a broadband source, this conjugated destructive interference occurs in a regime less than 1 as, while the related spectral shift reaches hundreds of THz, resulting in sensitivity outperforming SWM by two orders of magnitude.
Recently, weak measurements were used to measure small effects that are transverse to the propagation direction of a light beam. Here we address the question of whether weak measurements are also useful for measuring small longitudinal phase shifts. We show that standard interferometry greatly outperforms weak measurements in a scenario involving a purely real weak value. However, we also present an interferometric scheme based on a purely imaginary weak value, combined with a frequency-domain analysis, which may have the potential to outperform standard interferometry by several orders of magnitude.
In a recent letter, Brunner and Simon propose an interferometric scheme using imaginary weak values with a frequency-domain analysis to outperform standard interferometry in longitudinal phase shifts [N. Brunner and C. Simon, Phys. Rev. Lett {\bf105} (2010)]. Here we demonstrate an interferometric scheme combined with a time-domain analysis to measure longitudinal velocities. The technique employs the near-destructive interference of non-Fourier limited pulses, one Doppler shifted due to a moving mirror, in a Michelson interferometer. We achieve a velocity measurement of 400 fm/s and show our estimator to be efficient by reaching its Cramer-Rao bound.
In a recent Letter, Brunner and Simon proposed an interferometric scheme using imaginary weak values with a frequency-domain analysis to outperform standard interferometry in longitudinal phase shifts [Phys. Rev. Lett105, 010405 (2010)]. Here we demonstrate an interferometric scheme combined with a time-domain analysis to measure longitudinal velocities. The technique employs the near-destructive interference of non-Fourier limited pulses, one Doppler shifted due to a moving mirror in a Michelson interferometer. We achieve a velocity measurement of 400 fm/s and show our estimator to be efficient by reaching its Cramér-Rao bound.
An improvement of the scheme by Brunner and Simon [Phys. Rev. Lett. 105, 010405 (2010)] is proposed in order to show that quantum weak measurements can provide a method to detect ultrasmall longitudinal phase shifts, even with white light. By performing an analysis in the frequency domain, we find that the amplification effect will work as long as the spectrum is large enough, irrespective of the behavior in the time domain. As such, the previous scheme can be notably simplified for experimental implementations.
In the standard weak measurement, the imaginary part of the weak value is usually constructed with a specific pre- or postselection state to cause a large shift of the frequency-domain pointer. In this paper we demonstrate that the purely real weak value can also shift the frequency-domain pointer when using a broad-spectrum light source. The reason for the deflection of the frequency-domain pointer in this scheme is that the postselection probability of different frequency is different, which causes the rearrangement of the amplitudes of the spectrum. The weak measurement with real weak value can be used for the estimation of time delay, and it is found that it can reach the same high resolution as the standard weak measurement in some sensitive regions.