Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:1601.00510 · Physical review. B./Physical review. B

Fermionic approach to junctions of multiple quantum wires attached to Tomonaga-Luttinger liquid leads

Zheng Shi, Ian K. Affleck

Published Jul 5, 2016• 12 citations
arXivHTMLPDF

Abstract

Junctions of multiple one-dimensional quantum wires of interacting electrons have received considerable theoretical attention as a basic constituent of quantum circuits. While results have been obtained on these models using bosonization and density-matrix renormalization-group (DMRG) methods, another powerful technique is based on direct perturbation theory in the bulk interactions combined with the renormalization group. This technique has so far only been applied to the case in which finite-length interacting wires are attached to noninteracting Fermi liquid leads. We extend this method to cover the case of infinite-length interacting leads, obtaining results on two- and three-lead junctions in good agreement with previous bosonization and DMRG results.

DOI
10.1103/physrevb.94.035106

Related papers

Transport properties of a two-lead Luttinger-liquid junction out of equilibrium: Fermionic representation

D. N. Aristov, P. Wölfle

The electrical current through an arbitrary junction connecting quantum wires of spinless interacting fermions is calculated in fermionic representation. The wires are adiabatically attached to two reservoirs at chemical potentials differing by the applied voltage bias. The relevant scale-dependent contributions in perturbation theory in the interaction up to infinite order are evaluated and summed up. The result allows one to construct renormalization group equations for the conductance as a function of voltage (or temperature, wire length). There are two fixed points at which the conductance follows a power law in terms of a scaling variable $\ensuremath{\Lambda}$, which equals the bias voltage $V$, if $V$ is the largest energy scale compared to temperature $T$ and inverse wire length ${L}^{\ensuremath{-}1}$, and interpolates between these quantities in the crossover regimes.

arXiv:1408.4914•Physical Review B•Dec 8, 2014•11 citations

Density-matrix renormalization group study of the linear conductance in quantum wires coupled to interacting leads or phonons

Jan-Moritz Bischoff, Eric Jeckelmann

In a previous paper [Bischoff and Jeckelmann, Phys. Rev. B 96, 195111 (2017)] we introduced a density-matrix renormalization group method for calculating the linear conductance of one-dimensional correlated quantum systems and demonstrated it on homogeneous spinless fermion chains with impurities. Here we present extensions of this method to inhomogeneous systems, models with phonons, and the spin conductance of electronic models. The method is applied to a spinless fermion wire-lead model, the homogeneous spinless Holstein model, and the Hubbard model. Its capabilities are demonstrated by comparison with the predictions of Luttinger liquid theory combined with Bethe ansatz solutions and other numerical methods. We find a complex behavior for quantum wires coupled to interacting leads when the sign of the interaction (repulsive/attractive) differs in the wire and leads. The renormalization of the conductance given by the Luttinger parameter in purely fermionic systems is shown to remain valid in the Luttinger liquid phase of the Holstein model with phononic degrees of freedom.

arXiv:1907.01844•Physical review. B./Physical review. B•Aug 28, 2019•4 citations

Conductance of Tomonaga-Luttinger liquid wires and junctions with resistances

Abhiram Soori, Diptiman Sen

We study the effect that resistive regions have on the conductance of a quantum wire with interacting electrons which is connected to Fermi liquid leads. Using the bosonization formalism and a Rayleigh dissipation function to model the power dissipation, we use both scattering theory and Green's function techniques to derive the DC conductance. The resistive regions are generally found to lead to incoherent transport. For a single wire, we find that the resistance adds in series to the contact resistance of h/e(2) for spinless electrons, and the total resistance is independent of the Luttinger parameter K-W of the wire. We numerically solve the bosonic equations to illustrate what happens when a charge density pulse is incident on the wire; the results depend on the parameters of the resistive and interacting regions in interesting ways. For a junction of Tomonaga-Luttinger liquid wires, we use a dissipationless current splitting matrix to model the junction. For a junction of three wires connected to Fermi liquid leads, there are two families of such matrices; we find that the conductance matrix generally depends on K-W for one family but is independent of K-W for the other family, regardless of the resistances present in the system. Copyright (c) EPLA, 2011

•Mar 1, 2011•7 citations

Conductance of Tomonaga-Luttinger liquid wires and junctions with resistances

Abhiram Soori, Diptiman Sen

We study the effect that resistive regions have on the conductance of a quantum wire with interacting electrons which is connected to Fermi liquid leads. Using the bosonization formalism and a Rayleigh dissipation function to model the power dissipation, we use both scattering theory and Green's function techniques to derive the DC conductance. The resistive regions are generally found to lead to incoherent transport. For a single wire, we find that the resistance adds in series to the contact resistance of h / e 2 for spinless electrons, and the total resistance is independent of the Luttinger parameter K W of the wire. We numerically solve the bosonic equations to illustrate what happens when a charge density pulse is incident on the wire; the results depend on the parameters of the resistive and interacting regions in interesting ways. For a junction of Tomonaga-Luttinger liquid wires, we use a dissipationless current splitting matrix to model the junction. For a junction of three wires connected to Fermi liquid leads, there are two families of such matrices; we find that the conductance matrix generally depends on K W for one family but is independent of K W for the other family, regardless of the resistances present in the system.

arXiv:1011.5058•Europhysics Letters (EPL)•Mar 1, 2011•13 citations

Tunneling density of states in a Y junction of Tomonaga-Luttinger liquid wires: A density matrix renormalization group study

Monalisa Singh Roy, Manoranjan Kumar, Sourin Das

It is well known that the pristine bulk of an interacting one-dimensional system in Tomonaga-Luttinger liquid (TLL) phase shows power law suppression of quasiparticle tunneling amplitude for all values of TLL parameter $g$, in the zero-energy limit. We perform a density matrix renormalization group (DMRG) study of a fully symmetric Y junction of TLL wires and observe an anomalous enhancement of the tunneling density of states (TDOS) in the vicinity of the junction for both (a) interacting bosons case and (b) interacting fermions case, when $g>1$. We also observe suppression of TDOS for $g<1$ for both bosonic and fermionic cases. We find that the TDOS enhancements follow different power laws for bosonic and fermionic cases which suggests that these represent distinct fixed points, owing to statistical correlations that play an important role at the Y junction. Analysis of static conductance for the junction indicates that the fixed point for $1<g<3$ resembles the mysterious $M$ fixed point of Y junction predicted by Oshikawa, Chamon, and Affleck [J. Stat. Mech. (2006) P02008]. We also show that the TDOS enhancement spans over a length scale of $\ensuremath{\propto}{\ensuremath{\omega}}^{\ensuremath{-}1}$ from the junction, for $1<g<3$.

arXiv:1912.13040•Physical review. B./Physical review. B•Jul 17, 2020•3 citations

Junctions of multiple quantum wires with different Luttinger parameters

Chang-Yu Hou, Armin Rahmani, Adrian E. Feiguin +1 more

Within the framework of boundary conformal field theory, we evaluate the conductance of stable fixed points of junctions of two and three quantum wires with different Luttinger parameters. For two wires, the physical properties are governed by a single effective Luttinger parameter for each of the charge and spin sectors. We present numerical density-matrix-renormalization-group calculations of the conductance of a junction of two chains of interacting spinless fermions with different interaction strengths, obtained using a recently developed method [Phys. Rev. Lett. 105, 226803 (2010)]. The numerical results show very good agreement with the analytical predictions. For three spinless wires (i.e., a Y junction) we analytically determine the full phase diagram and compute all fixed-point conductances as a function of the three Luttinger parameters.

arXiv:1205.2125•Physical Review B•Aug 22, 2012•33 citations
Junctions of multiple one-dimensional quantum wires of interacting electrons have received considerable theoretical attention as a basic constituent of quantum circuits. While results have been obtained on these models using bosonization and density-matrix renormalization-group (DMRG) methods, another powerful technique is based on direct perturbation theory in the bulk interactions combined with the renormalization group. This technique has so far only been applied to the case in which finite-length interacting wires are attached to noninteracting Fermi liquid leads. We extend this method to cover the case of infinite-length interacting leads, obtaining results on two- and three-lead junctions in good agreement with previous bosonization and DMRG results.
The electrical current through an arbitrary junction connecting quantum wires of spinless interacting fermions is calculated in fermionic representation. The wires are adiabatically attached to two reservoirs at chemical potentials differing by the applied voltage bias. The relevant scale-dependent contributions in perturbation theory in the interaction up to infinite order are evaluated and summed up. The result allows one to construct renormalization group equations for the conductance as a function of voltage (or temperature, wire length). There are two fixed points at which the conductance follows a power law in terms of a scaling variable $\ensuremath{\Lambda}$, which equals the bias voltage VVV, if VVV is the largest energy scale compared to temperature TTT and inverse wire length ${L}^{\ensuremath{-}1}$, and interpolates between these quantities in the crossover regimes.
In a previous paper [Bischoff and Jeckelmann, Phys. Rev. B 96, 195111 (2017)] we introduced a density-matrix renormalization group method for calculating the linear conductance of one-dimensional correlated quantum systems and demonstrated it on homogeneous spinless fermion chains with impurities. Here we present extensions of this method to inhomogeneous systems, models with phonons, and the spin conductance of electronic models. The method is applied to a spinless fermion wire-lead model, the homogeneous spinless Holstein model, and the Hubbard model. Its capabilities are demonstrated by comparison with the predictions of Luttinger liquid theory combined with Bethe ansatz solutions and other numerical methods. We find a complex behavior for quantum wires coupled to interacting leads when the sign of the interaction (repulsive/attractive) differs in the wire and leads. The renormalization of the conductance given by the Luttinger parameter in purely fermionic systems is shown to remain valid in the Luttinger liquid phase of the Holstein model with phononic degrees of freedom.
We study the effect that resistive regions have on the conductance of a quantum wire with interacting electrons which is connected to Fermi liquid leads. Using the bosonization formalism and a Rayleigh dissipation function to model the power dissipation, we use both scattering theory and Green's function techniques to derive the DC conductance. The resistive regions are generally found to lead to incoherent transport. For a single wire, we find that the resistance adds in series to the contact resistance of h/e(2) for spinless electrons, and the total resistance is independent of the Luttinger parameter K-W of the wire. We numerically solve the bosonic equations to illustrate what happens when a charge density pulse is incident on the wire; the results depend on the parameters of the resistive and interacting regions in interesting ways. For a junction of Tomonaga-Luttinger liquid wires, we use a dissipationless current splitting matrix to model the junction. For a junction of three wires connected to Fermi liquid leads, there are two families of such matrices; we find that the conductance matrix generally depends on K-W for one family but is independent of K-W for the other family, regardless of the resistances present in the system. Copyright (c) EPLA, 2011
We study the effect that resistive regions have on the conductance of a quantum wire with interacting electrons which is connected to Fermi liquid leads. Using the bosonization formalism and a Rayleigh dissipation function to model the power dissipation, we use both scattering theory and Green's function techniques to derive the DC conductance. The resistive regions are generally found to lead to incoherent transport. For a single wire, we find that the resistance adds in series to the contact resistance of h / e 2 for spinless electrons, and the total resistance is independent of the Luttinger parameter K W of the wire. We numerically solve the bosonic equations to illustrate what happens when a charge density pulse is incident on the wire; the results depend on the parameters of the resistive and interacting regions in interesting ways. For a junction of Tomonaga-Luttinger liquid wires, we use a dissipationless current splitting matrix to model the junction. For a junction of three wires connected to Fermi liquid leads, there are two families of such matrices; we find that the conductance matrix generally depends on K W for one family but is independent of K W for the other family, regardless of the resistances present in the system.
It is well known that the pristine bulk of an interacting one-dimensional system in Tomonaga-Luttinger liquid (TLL) phase shows power law suppression of quasiparticle tunneling amplitude for all values of TLL parameter ggg, in the zero-energy limit. We perform a density matrix renormalization group (DMRG) study of a fully symmetric Y junction of TLL wires and observe an anomalous enhancement of the tunneling density of states (TDOS) in the vicinity of the junction for both (a) interacting bosons case and (b) interacting fermions case, when g>1g>1g>1. We also observe suppression of TDOS for g<1g<1g<1 for both bosonic and fermionic cases. We find that the TDOS enhancements follow different power laws for bosonic and fermionic cases which suggests that these represent distinct fixed points, owing to statistical correlations that play an important role at the Y junction. Analysis of static conductance for the junction indicates that the fixed point for 1<g<31<g<31<g<3 resembles the mysterious MMM fixed point of Y junction predicted by Oshikawa, Chamon, and Affleck [J. Stat. Mech. (2006) P02008]. We also show that the TDOS enhancement spans over a length scale of $\ensuremath{\propto}{\ensuremath{\omega}}^{\ensuremath{-}1}$ from the junction, for 1<g<31<g<31<g<3.
Within the framework of boundary conformal field theory, we evaluate the conductance of stable fixed points of junctions of two and three quantum wires with different Luttinger parameters. For two wires, the physical properties are governed by a single effective Luttinger parameter for each of the charge and spin sectors. We present numerical density-matrix-renormalization-group calculations of the conductance of a junction of two chains of interacting spinless fermions with different interaction strengths, obtained using a recently developed method [Phys. Rev. Lett. 105, 226803 (2010)]. The numerical results show very good agreement with the analytical predictions. For three spinless wires (i.e., a Y junction) we analytically determine the full phase diagram and compute all fixed-point conductances as a function of the three Luttinger parameters.