arXiv:1510.08428 · Physical Review X

Imaging Photon Lattice States by Scanning Defect Microscopy

Devin Underwood, Will Shanks, Andy C. Y. Li, Lamia Ateshian, Jens Koch, Andrew Houck

Published Jun 30, 2016• 21 citations

Abstract

Microwave photons inside lattices of coupled resonators and superconducting qubits can exhibit surprising matterlike behavior.Realizing such open-system quantum simulators presents an experimental challenge and requires new tools and measurement techniques.Here, we introduce scanning defect microscopy as one such tool and illustrate its use in mapping the normal-mode structure of microwave photons inside a 49-site kagome lattice of coplanar waveguide resonators.Scanning is accomplished by moving a probe equipped with a sapphire tip across the lattice.This locally perturbs resonator frequencies and induces shifts of the lattice resonance frequencies, which we determine by measuring the transmission spectrum.From the magnitude of mode shifts, we can reconstruct photon field amplitudes at each lattice site and thus create spatial images of the photon-lattice normal modes.

DOI: 10.1103/physrevx.6.021044

Related papers

A Bird’s Eye View of Circuit Photons

Sebastian Schmidt

PhysicsJun 30, 20160 citations

Microwave cavity lattices for quantum simulation with photons

Devin Underwood

Historically our understanding of the microscopic world has been impeded by limitations in systems that behave classically. Even today, understanding simple problems in quantum mechanics remains a difficult task both computationally and experimentally. As a means of overcoming these classical limitations, the idea of using a controllable quantum system to simulate a less controllable quantum system has been proposed. This concept is known as quantum simulation and is the origin of the ideas behind quantum computing. In this thesis, experiments have been conducted that address the feasibility of using devices with a circuit quantum electrodynamics (cQED) architecture as a quantum simulator. In a cQED device, a superconducting qubit is capacitively coupled to a superconducting resonator resulting in coherent quantum behavior of the qubit when it interacts with photons inside the resonator. It has been shown theoretically that by forming a lattice of cQED elements, different quantum phases of photons will exist for dierent system parameters. In order to realize such a quantum simulator, the necessary experimental foundation must rst be developed. Here experimental eorts were focused on addressing two primary issues: 1) designing and fabricating low disorder lattices that are readily available to incorporate superconducting qubits, and 2) developing new measurement tools and techniques that can be used to characterize large lattices, and probe the predicted quantum phases within the lattice. Three experiments addressing these issues were performed. In the rst experiment a Kagome lattice of transmission line resonators was designed and fabricated, and a comprehensive study on the effects of random disorder in the lattice demonstrated that disorder was dependent on the resonator geometry. Subsequently a cryogenic 3-axis scanning stage was developed and the operation of the scanning stage was demonstrated in the final two experiments. The rst scanning experiment was conducted on a 49 site Kagome lattice, where a sapphire defect was used to locally perturb each lattice site. This perturbative scanning probe microscopy provided a means to measure the distribution of photon modes throughout the entire lattice. The second scanning experiment was performed on a single transmission line resonator where a transmon qubit was fabricated on a separate substrate, mounted to the tip of the scanning stage and coupled to the resonator. Here the coupling strength of the qubit to the resonator was mapped out demonstrating strong coupling over a wide scanning range, thus indicating the potential for a scanning qubit to be used as a local quantum probe.

Jan 1, 20150 citations

Hyperbolic lattices in circuit quantum electrodynamics

Alicia J. Kollár, Mattias Fitzpatrick, Andrew Houck

Abstract After two decades of development, cavity quantum electrodynamics with superconducting circuits has emerged as a rich platform for quantum computation and simulation. Lattices of coplanar waveguide resonators constitute artificial materials for microwave photons, in which interactions between photons can be incorporateded either through the use of nonlinear resonator materials or through coupling between qubits and resonators. Here we make use of the previously overlooked property that these lattice sites are deformable and permit tight-binding lattices that are unattainable even in solid-state systems. We show that networks of coplanar waveguide resonators can create a class of materials that constitute lattices in an effective hyperbolic space with constant negative curvature. We present numerical simulations of hyperbolic analogues of the kagome lattice that show unusual densities of states in which a macroscopic number of degenerate eigenstates comprise a spectrally isolated flat band. We present a proof-of-principle experimental realization of one such lattice. This paper represents a step towards on-chip quantum simulation of materials science and interacting particles in curved space.

Jan 1, 2019251 citations

Propagation of microwave photons along a synthetic dimension

Nathan Lee, Marek Pechal, E. Alex Wollack +3 more

The evenly spaced modes of an electromagnetic resonator are coupled to each other by appropriate time modulation, leading to dynamics analogous to those of particles hopping between different sites of a lattice. This substitution of a real spatial dimension of a lattice with a ``synthetic'' dimension in frequency space greatly reduces the hardware complexity of an analog quantum simulator. Complex control and readout of a highly multimoded structure can thus be accomplished with very few physical control lines. We demonstrate this concept with microwave photons in a superconducting transmission line resonator by modulating the system parameters at frequencies near the resonator's free spectral range and observing propagation of photon wave packets in time domain. The linear propagation dynamics are equivalent to a tight-binding model, which we probe by measuring scattering parameters between frequency sites. We extract an approximate tight-binding dispersion relation for the synthetic lattice and initialize photon wave packets with well-defined quasimomenta and group velocities. As an example application of this platform in simulating a physical system, we demonstrate Bloch oscillations associated with a particle in a periodic potential and subject to a constant external field. The simulated field strongly affects the photon dynamics despite photons having zero charge. Our observation of photon dynamics along a synthetic frequency dimension generalizes immediately to topological photonics and single-photon power levels, and expands the range of physical systems addressable by quantum simulation.

arXiv:1908.10329Physical Review AMay 4, 202022 citations

A near-field scanning microwave microscope based on a superconducting resonator for low power measurements

Sebastian E. de Graaf, Andrey V. Danilov, A. A. Adamyan +1 more

We report on the design and performance of a cryogenic (300 mK) near-field scanning microwave microscope. It uses a microwave resonator as the near-field sensor, operating at a frequency of 6 GHz and microwave probing amplitudes down to 100 μV, approaching low enough photon population (N ∼ 1000) of the resonator such that coherent quantum manipulation becomes feasible. The resonator is made out of a miniaturized distributed fractal superconducting circuit that is integrated with the probing tip, micromachined to be compact enough such that it can be mounted directly on a quartz tuning-fork, and used for parallel operation as an atomic force microscope (AFM). The resonator is magnetically coupled to a transmission line for readout, and to achieve enhanced sensitivity we employ a Pound-Drever-Hall measurement scheme to lock to the resonance frequency. We achieve a well localized near-field around the tip such that the microwave resolution is comparable to the AFM resolution, and a capacitive sensitivity down to 6.4 × 10(-20) F/Hz, limited by mechanical noise. We believe that the results presented here are a significant step towards probing quantum systems at the nanoscale using near-field scanning microwave microscopy.

arXiv:1404.0534Review of Scientific InstrumentsFeb 1, 201333 citations

Coherent interaction with two-level fluctuators using near field scanning microwave microscopy

Sebastian E. de Graaf, Andrey V. Danilov, Sergey Kubatkin

Near field Scanning Microwave Microscopy (NSMM) is a scanning probe technique that non-invasively can obtain material properties on the nano-scale at microwave frequencies. While focus has been on developing room-temperature systems it was recently shown that this technique can potentially reach the quantum regime, opening up for applications in materials science and device characterization in solid state quantum information processing. In this paper we theoretically investigate this new regime of NSMM. Specifically we show that interaction between a resonant NSMM probe and certain types of two-level systems become possible when the NSMM probe operates in the (sub-) single photon regime, and we expect a high signal-to-noise ratio if operated under the right conditions. This would allow to detect single atomic material defects with energy splittings in the GHz range with nano-scale resolution, provided that individual defects in the material under study are well enough separated. We estimate that this condition is fulfilled for materials with loss tangents below tan δ ∼ 10(-3) which holds for materials used in today's quantum circuits and devices where typically tan δ < 10(-5). We also propose several extensions to a resonant NSMM that could improve sensitivity and functionality also for microscopes operating in a high power regime.

Scientific ReportsNov 24, 201510 citations