We propose an implementation of a quantum router for microwave photons in a superconducting qubit architecture consisting of a transmon qubit, SQUIDs and a nonlinear capacitor. We model and analyze the dynamics of operation of the quantum switch using quantum Langevin equations in a scattering approach and compute the photon reflection and transmission probabilities. For parameters corresponding to up-to-date experimental devices we predict successful operation of the router with probabilities above 94%.
We propose an implementation of a quantum router for microwave photons in a superconducting qubit architecture consisting of a transmon qubit, SQUIDs and a nonlinear capacitor. We model and analyze the dynamics of operation of the quantum switch using quantum Langevin equations in a scattering approach and compute the photon reflection and transmission probabilities. For parameters corresponding to up-to-date experimental devices we predict successful operation of the router with probabilities above 94%.
The realization of a quantum network composed of quantum nodes which process quantum fields and quantum channels to transfer quantum information has recently been proposed. In recent years, fundamental experiments produced by superconducting circuits suggest that they are promising candidates for realization of a quantum network. Superconducting circuit QED can act as quantum nodes, which can be linked by quantum channels, to transfer flying microwave photons (quantum information) from site to site on chip with high fidelity. Therefore, controlling the propagating microwave photons on chip is an essential step towards realization of a quantum network.In this thesis, we demonstrate a specific quantum node, namely the single photon router. The active element of the router is a single three-level artificial atom, a superconducting transmon type qubit, strongly coupled to a superconducting 1D transmission line. Strong coupling between the artificial atom and propagating microwave photons, revealed in high degree scattering of the resonance waves, has been observed. By exploiting the phenomenon of electromagnetically induced transparency (EIT), we can route a single photon signal from an input port to either of two output ports with an on-off ratio of approximately 90%. The switching time of the router is shown to be a few nanoseconds, consistent with theoretical expectations and the device parameters. Besides the router, we also observed some fundamental phenomenon of single atom, such as strong nonlinearity, anomalous dispersion and the Mollow Triplet.This thesis describes the motivation, theoretical background, design, implementation and the measurement results.
We address recent advances in quantum optics with propagating microwaves\nin superconducting circuits. This research field exploits on the fact that the coupling between a superconducting artificial atom and propagating microwave photons in a one-dimensional (1D) open transmission line can be made strong enough to observe quantum effects, without using any cavity to confine the microwave photons.\nWe embed an artificial atom, a superconducting transmon qubit, in a 1D open\ntransmission line and investigate the scattering properties of coherent microwaves. When an input coherent state, with an average photon number much less than 1, is on resonance with the artificial atom, we observe extinction of up to 99% in the forward propagating field. We observe the strong nonlinearity of the artificial atom and under strong driving we observe the Mollow triplet. We also study the statistics of the reflected and transmitted beams, which are predicted to be nonclassical states. In particular, we demonstrate photon antibunching in the reflected beam by measuring the second-order correlation function. By applying a second control tone, we observe the Autler-Townes splitting and a giant cross-Kerr effect.\nFurthermore, we demonstrate fast operation of a single-photon router using\nthe Autler-Townes splitting. This device provides important steps towards the realization of a quantum network. This thesis describes the motivation, theoretical background, design, implementation and measurement results.
We have embedded an artificial atom, a superconducting transmon qubit, in an open transmission line and investigated the strong scattering of incident microwave photons (∼6 GHz). When an input coherent state, with an average photon number N≪1 is on resonance with the artificial atom, we observe extinction of up to 99.6% in the forward propagating field. We use two-tone spectroscopy to study scattering from excited states and we observe electromagnetically induced transparency (EIT). We then use EIT to make a single-photon router, where we can control to what output port an incoming signal is delivered. The maximum on-off ratio is around 99% with a rise and fall time on the order of nanoseconds, consistent with theoretical expectations. The router can easily be extended to have multiple output ports and it can be viewed as a rudimentary quantum node, an important step towards building quantum information networks.
For several decades, scientists have been aware of significant benefits allowing quantum information processing technologies to surpass their classical counterparts. Recent technological development allows these benefits to be tested experimentally and in some cases also implemented in practical devices. So far the majority of experimental quantum networks was limited to peer-to-peer communications between two parties. Practical implementation of quantum communications networks, however, needs to address the problem of scalability to serve large numbers of users. Similarly to classical computer networks, their quantum counterparts would require routing protocols to direct the signal from its source to destination. Devices implementing these routing protocols are called quantum routers and have recently been subject of an intense research. In this paper, we report on experimental implementation of a linear-optical quantum router. Our device allows single-photon polarization-encoded qubits to be routed coherently into two spatial output modes depending on the state of two identical control qubits. The polarization qubit state of the routed photon is maintained during the routing operation. The success probability of our scheme can be increased up to 25% making it the most efficient linear-optical quantum router developed to this date.
A classical switch or router determines which of several inputs to the device passes through the output. In analogy, a quantum switch that coherently links the input to a superposition of several outputs plays an important role in quantum information processing, especially when operating at the fundamental limit where a single photon can be controlled. The controllable path superposition of propagating photonic qubits enabled by the quantum switch provides the basis for numerous quantum applications, including entanglement generation and distribution, enhanced quantum communication, and quantum random access memory. In this work, we realize such a quantum switch for microwave single photons with superconducting quantum circuits. We use a superconducting qubit to coherently switch the output path of single microwave photons and confirm quantum entanglement between the control qubit and the photons' propagation path. We further showcase the generation of quantum entanglement between a time-bin-encoded propagating photonic qubit and a superconducting qubit with the quantum switch, thus providing a versatile approach to generate reconfigurable multinode entanglement in one step. As such, our work provides a prime building block for microwave quantum networks and modular superconducting quantum computing.
We report the first experimental realization of a scalable basic cell for quantum routing, enabling coherent control and exchange of microwave photons between two spatially separated superconducting waveguides coupled via a single transmon qubit. The cell was characterized at 10 mK with an average input signal of approximately 1 photon at approximately 6 GHz, and with the qubit biased to its optimal point to minimize sensitivity to external magnetic fluctuations. By combining steady-state and time-domain measurements, we reconstructed the key parameters of the system, including qubit relaxation and dephasing, waveguide-qubit couplings, and cross-waveguide photon transfer efficiency. The observed performance is consistent with a non-Hermitian Hamiltonian formalism and demonstrates clear limits set by flux bias, temperature, and photon number, in agreement with flux- and temperature-induced dephasing models. Crucially, the cell operates reliably at the single-photon level, and in the high-photon regime we directly observe photon dressing induced by the qubit. These results establish a versatile platform for studying open quantum system phenomena and pave the way for scalable implementations of quantum routing and network nodes.