Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:1509.01227

Quantum Phase Imaging using Spatial Entanglement

Chien-Hung Lu, Matthew C. Reichert, Sun, Xiaohang, Jason W. Fleischer

Published Sep 3, 2015• 1 citation
arXivHTMLPDF

Abstract

Entangled photons have the remarkable ability to be more sensitive to signal and less sensitive to noise than classical light. Joint photons can sample an object collectively, resulting in faster phase accumulation and higher spatial resolution, while common components of noise can be subtracted. Even more, they can accomplish this while physically separate, due to the nonlocal properties of quantum mechanics. Indeed, nearly all quantum optics experiments rely on this separation, using individual point detectors that are scanned to measure coincidence counts and correlations. Scanning, however, is tedious, time consuming, and ill-suited for imaging. Moreover, the separation of beam paths adds complexity to the system while reducing the number of photons available for sampling, and the multiplicity of detectors does not scale well for greater numbers of photons and higher orders of entanglement. We bypass all of these problems here by directly imaging collinear photon pairs with an electron-multiplying CCD camera. We show explicitly the benefits of quantum nonlocality by engineering the spatial entanglement of the illuminating photons and introduce a new method of correlation measurement by converting time-domain coincidence counting into spatial-domain detection of selected pixels. We show that classical transport-of-intensity methods are applicable in the quantum domain and experimentally demonstrate nearly optimal (Heisenberg-limited) phase measurement for the given quantum illumination. The methods show the power of direct imaging and hold much potential for more general types of quantum information processing and control.

DOI
10.48550/arxiv.1509.01227

Related papers

Quantum imaging and spatial entanglement characterization with an EMCCD camera

Matthew C. Reichert, Hugo Defienne, Xiaohang Sun +1 more

We utilize a single-photon sensitive electron multiplying CCD camera as a massively parallel coincidence counting apparatus to study spatial entanglement of photon pairs. This allows rapid measurement of transverse spatial entanglement in a fraction of the time required with traditional point-scanning techniques. We apply this technique to quantum experiments on entangled photon pairs: characterization of the evolution of entanglement upon propagation, and measurement of one- and two-photon portions of the state transmitted through non-unitary (lossy) objects, and quantum phase imaging.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•May 8, 2017•0 citations

Imaging high-dimensional spatial entanglement with a camera

M. Edgar, D. S. Tasca, Frauke Izdebski +6 more

The light produced by parametric down-conversion shows strong spatial entanglement that leads to violations of EPR criteria for separability. Historically, such studies have been performed by scanning a single-element, single-photon detector across a detection plane. Here we show that modern electron-multiplying charge-coupled device cameras can measure correlations in both position and momentum across a multi-pixel field of view. This capability allows us to observe entanglement of around 2,500 spatial states and demonstrate Einstein–Podolsky–Rosen type correlations by more than two orders of magnitude. More generally, our work shows that cameras can lead to important new capabilities in quantum optics and quantum information science. Measuring the entanglement between down-converted photons is central to many quantum optical experiments, and is normally performed by scanning detectors stepwise across a plane. Edgaret al. use a CCD camera to measure the entire entangled light field, finding strong correlations in position and momentum.

arXiv:1204.1293•Nature Communications•Aug 7, 2012•279 citations

Quantum imaging with a photon counting camera

Osian Wolley, Thomas Gregory, Sebastian M. J. Beer +2 more

Classical light sources emit a randomly-timed stream of individual photons, the spatial distribution of which can be detected with a camera to form an image. Quantum light sources, based on parametric down conversion, emit photons as correlated photon-pairs. The spatial correlations between the photons enables imaging systems where the preferential selection of photon-pairs allows for enhancements in the noise performance over what is possible using classical light sources. However, until now the technical challenge of measuring, and correlating both photons has led to system complexity. Here we show that a camera capable of resolving the number of individual photons in each pixel of the detector array can be used to record an image formed from these photon-pair events and hence achieve a greater contrast than possible using a classical light source. We achieve an enhancement in the ratio of two-photon events compared to one-photon events using spatially correlated SPDC light compared to uncorrelated illumination by a LED. These results indicate the potential advantages of using photon counting cameras in quantum imaging schemes and these advantages will further increase as the technology is developed. Operating in photon sparse regimes such systems have potential applications in low-light microscopy and covert imaging.

Scientific Reports•May 18, 2022•47 citations

Biphoton transmission through non-unitary objects

Matthew Reichert, Hugo Defienne, Xiaohang Sun +1 more

Abstract Losses should be accounted for in a complete description of quantum imaging systems, and yet they are often treated as undesirable and largely neglected. In conventional quantum imaging, images are built up by coincidence detection of spatially entangled photon pairs (biphotons) transmitted through an object. However, as real objects are non-unitary (absorptive), part of the transmitted state contains only a single photon, which is overlooked in traditional coincidence measurements. The single-photon part has a drastically different spatial distribution than the two-photon part. It contains information about both the object, and, remarkably, the spatial entanglement properties of the incident biphotons. Here, we image the one- and two-photon parts of the transmitted state using an electron multiplying CCD array, treating it both as a traditional camera and as a massively parallel coincidence counting apparatus, and demonstrate agreement with theoretical predictions of non-unitary quantum optics. This work may prove useful for photon-number imaging and may lead to techniques for entanglement characterization that do not require coincidence measurements.

arXiv:1611.10237•Journal of Optics•Mar 16, 2017•13 citations

Real-time entangled photon-pair imaging towards field deployment

Robin Camphausen, Álvaro Cuevas, Alexander Demuth +8 more

Quantum technology promises improvements in imaging, computing, and communication, for example using the resource of entanglement between photons with spatial correlations. Detecting spatial correlations, or coincidences, between entangled photons scalably, efficiently, and affordably is therefore an essential capability. However, this task is non-trivial for existing camera technologies, which require low illumination intensities or low detection duty cycles to count coincidences at high signal-to-noise ratios, resulting in long acquisition time, or use expensive custom electronic components. Here, we present an entanglement imaging system based around a novel Single-Photon Avalanche Diode (SPAD) array camera, optimized for sparse illumination with correlated photon pairs. The system is capable of maintaining a duty cycle close to 100%, while simultaneously detecting spatially resolved coincidences with high SNR, enabling the acquisition of real-time entanglement videos at a ~Hz frame rate. We use our system to demonstrate real-time monitoring of entanglement interference visibility, optical system point spread function, as well as real-time widefield entanglement-enhanced phase imaging. Our results show that SPAD array cameras represent a natural choice for scalable entanglement detection and imaging applications.

•Nov 30, 2023•1 citation

Image-Plane Detection of Spatially Entangled Photon Pairs with a CMOS Camera

David McFadden, Rainer Heintzmann

Spatially entangled photon pairs (biphotons) generated by spontaneous parametric down-conversion offer unique opportunities for quantum imaging, but image-plane biphoton correlations are difficult to observe with camera-based detectors. Previous camera-based biphoton imaging experiments have relied on photon-counting detection, which necessitates operation deep in the photon-sparse regime and requires extremely low dark rates. Here, we demonstrate the detection of spatial biphoton joint probability distributions in both the image plane and the pupil plane (also termed "near-field plane" and "far-field plane" respectively) using a conventional scientific CMOS camera operated in linear mode. We work at mesoscopic intensity levels, corresponding to a photon flux approximately four orders of magnitude higher than typical photon-counting approaches. From the measured image- and pupil plane correlations, we observe position and momentum correlations consistent with an EPR-type entanglement witness. A tailored correlation analysis suited for image plane imaging suppresses detector artifacts and intensity fluctuations, enabling acquisition with significantly fewer frames. Our results demonstrate that spatially entangled-light imaging can be performed efficiently with standard imaging hardware, extending quantum imaging techniques beyond the photon-counting regime.

quant-pharXiv:2512.24878•Jan 1, 2026•0 citations
Entangled photons have the remarkable ability to be more sensitive to signal and less sensitive to noise than classical light. Joint photons can sample an object collectively, resulting in faster phase accumulation and higher spatial resolution, while common components of noise can be subtracted. Even more, they can accomplish this while physically separate, due to the nonlocal properties of quantum mechanics. Indeed, nearly all quantum optics experiments rely on this separation, using individual point detectors that are scanned to measure coincidence counts and correlations. Scanning, however, is tedious, time consuming, and ill-suited for imaging. Moreover, the separation of beam paths adds complexity to the system while reducing the number of photons available for sampling, and the multiplicity of detectors does not scale well for greater numbers of photons and higher orders of entanglement. We bypass all of these problems here by directly imaging collinear photon pairs with an electron-multiplying CCD camera. We show explicitly the benefits of quantum nonlocality by engineering the spatial entanglement of the illuminating photons and introduce a new method of correlation measurement by converting time-domain coincidence counting into spatial-domain detection of selected pixels. We show that classical transport-of-intensity methods are applicable in the quantum domain and experimentally demonstrate nearly optimal (Heisenberg-limited) phase measurement for the given quantum illumination. The methods show the power of direct imaging and hold much potential for more general types of quantum information processing and control.
We utilize a single-photon sensitive electron multiplying CCD camera as a massively parallel coincidence counting apparatus to study spatial entanglement of photon pairs. This allows rapid measurement of transverse spatial entanglement in a fraction of the time required with traditional point-scanning techniques. We apply this technique to quantum experiments on entangled photon pairs: characterization of the evolution of entanglement upon propagation, and measurement of one- and two-photon portions of the state transmitted through non-unitary (lossy) objects, and quantum phase imaging.
The light produced by parametric down-conversion shows strong spatial entanglement that leads to violations of EPR criteria for separability. Historically, such studies have been performed by scanning a single-element, single-photon detector across a detection plane. Here we show that modern electron-multiplying charge-coupled device cameras can measure correlations in both position and momentum across a multi-pixel field of view. This capability allows us to observe entanglement of around 2,500 spatial states and demonstrate Einstein–Podolsky–Rosen type correlations by more than two orders of magnitude. More generally, our work shows that cameras can lead to important new capabilities in quantum optics and quantum information science. Measuring the entanglement between down-converted photons is central to many quantum optical experiments, and is normally performed by scanning detectors stepwise across a plane. Edgaret al. use a CCD camera to measure the entire entangled light field, finding strong correlations in position and momentum.
Classical light sources emit a randomly-timed stream of individual photons, the spatial distribution of which can be detected with a camera to form an image. Quantum light sources, based on parametric down conversion, emit photons as correlated photon-pairs. The spatial correlations between the photons enables imaging systems where the preferential selection of photon-pairs allows for enhancements in the noise performance over what is possible using classical light sources. However, until now the technical challenge of measuring, and correlating both photons has led to system complexity. Here we show that a camera capable of resolving the number of individual photons in each pixel of the detector array can be used to record an image formed from these photon-pair events and hence achieve a greater contrast than possible using a classical light source. We achieve an enhancement in the ratio of two-photon events compared to one-photon events using spatially correlated SPDC light compared to uncorrelated illumination by a LED. These results indicate the potential advantages of using photon counting cameras in quantum imaging schemes and these advantages will further increase as the technology is developed. Operating in photon sparse regimes such systems have potential applications in low-light microscopy and covert imaging.
Abstract Losses should be accounted for in a complete description of quantum imaging systems, and yet they are often treated as undesirable and largely neglected. In conventional quantum imaging, images are built up by coincidence detection of spatially entangled photon pairs (biphotons) transmitted through an object. However, as real objects are non-unitary (absorptive), part of the transmitted state contains only a single photon, which is overlooked in traditional coincidence measurements. The single-photon part has a drastically different spatial distribution than the two-photon part. It contains information about both the object, and, remarkably, the spatial entanglement properties of the incident biphotons. Here, we image the one- and two-photon parts of the transmitted state using an electron multiplying CCD array, treating it both as a traditional camera and as a massively parallel coincidence counting apparatus, and demonstrate agreement with theoretical predictions of non-unitary quantum optics. This work may prove useful for photon-number imaging and may lead to techniques for entanglement characterization that do not require coincidence measurements.
Quantum technology promises improvements in imaging, computing, and communication, for example using the resource of entanglement between photons with spatial correlations. Detecting spatial correlations, or coincidences, between entangled photons scalably, efficiently, and affordably is therefore an essential capability. However, this task is non-trivial for existing camera technologies, which require low illumination intensities or low detection duty cycles to count coincidences at high signal-to-noise ratios, resulting in long acquisition time, or use expensive custom electronic components. Here, we present an entanglement imaging system based around a novel Single-Photon Avalanche Diode (SPAD) array camera, optimized for sparse illumination with correlated photon pairs. The system is capable of maintaining a duty cycle close to 100%, while simultaneously detecting spatially resolved coincidences with high SNR, enabling the acquisition of real-time entanglement videos at a ~Hz frame rate. We use our system to demonstrate real-time monitoring of entanglement interference visibility, optical system point spread function, as well as real-time widefield entanglement-enhanced phase imaging. Our results show that SPAD array cameras represent a natural choice for scalable entanglement detection and imaging applications.
Spatially entangled photon pairs (biphotons) generated by spontaneous parametric down-conversion offer unique opportunities for quantum imaging, but image-plane biphoton correlations are difficult to observe with camera-based detectors. Previous camera-based biphoton imaging experiments have relied on photon-counting detection, which necessitates operation deep in the photon-sparse regime and requires extremely low dark rates. Here, we demonstrate the detection of spatial biphoton joint probability distributions in both the image plane and the pupil plane (also termed "near-field plane" and "far-field plane" respectively) using a conventional scientific CMOS camera operated in linear mode. We work at mesoscopic intensity levels, corresponding to a photon flux approximately four orders of magnitude higher than typical photon-counting approaches. From the measured image- and pupil plane correlations, we observe position and momentum correlations consistent with an EPR-type entanglement witness. A tailored correlation analysis suited for image plane imaging suppresses detector artifacts and intensity fluctuations, enabling acquisition with significantly fewer frames. Our results demonstrate that spatially entangled-light imaging can be performed efficiently with standard imaging hardware, extending quantum imaging techniques beyond the photon-counting regime.