Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:1411.2437 · Physical Review Letters

Individual Quantum Probes for Optimal Thermometry

Luis Alfonso Correa, Mohammad Mehboudi, Gerardo Adesso, Anna Sanpera

Published Jun 5, 2015• 305 citations
arXivHTMLPDF

Abstract

The unknown temperature of a sample can be estimated with minimal disturbance by putting it in thermal contact with an individual quantum probe. If the interaction time is sufficiently long so that the probe thermalizes, the temperature can be read-out directly from its steady state. Here we prove that the optimal quantum probe, acting as a thermometer with maximal thermal sensitivity, is an effective two-level atom with a maximally degenerate excited state. When the total interaction time is insufficient to produce full thermalization, we optimize the estimation protocol by breaking it down into sequential stages of probe preparation, thermal contact, and measurement. We observe that frequently interrogated probes initialized in the ground state achieve the best performance. For both fully and partly thermalized thermometers, the sensitivity grows significantly with the number of levels, though optimization over their energy spectrum remains always crucial.

DOI
10.1103/physrevlett.114.220405

Related papers

Simulating and Optimising Quantum Thermometry Using Single Photons

W. K. Tham, Hugo Ferretti, Arun Vellat Sadashivan +1 more

A classical thermometer typically works by exchanging energy with the system being measured until it comes to equilibrium, at which point the readout is related to the final energy state of the thermometer. A recent paper noted that with a quantum thermometer consisting of a single spin/qubit, temperature discrimination is better achieved at finite times rather than once equilibration is essentially complete. Furthermore, preparing a qubit thermometer in a state with quantum coherence instead of an incoherent one improves its sensitivity to temperature differences. Implementing a recent proposal for efficiently emulating an arbitrary quantum channel, we use the quantum polarisation state of individual photons as models of "single-qubit thermometers" which evolve for a certain time in contact with a thermal bath. We investigate the optimal thermometer states for temperature discrimination, and the optimal interaction times, confirming that there is a broad regime where quantum coherence provides a significant improvement. We also discuss the more practical question of thermometers composed of a finite number of spins/qubits (greater than one), and characterize the performance of an adaptive protocol for making optimal use of all the qubits.

arXiv:1609.01589•Scientific Reports•Dec 15, 2016•29 citations

Probe thermometry with continuous measurements

Julia Boeyens, Björn Annby-Andersson, Pharnam Bakhshinezhad +5 more

Abstract Temperature estimation plays a vital role across natural sciences. A standard approach is provided by probe thermometry, where a probe is brought into contact with the sample and examined after a certain amount of time has passed. In situations where, for example, preparation of the probe is non-trivial or total measurement time of the experiment is the main resource that must be optimized, continuously monitoring the probe may be preferred. Here, we consider a minimal model, where the probe is provided by a two-level system coupled to a thermal reservoir. Monitoring thermally activated transitions enables real-time estimation of temperature with increasing accuracy over time. Within this framework we comprehensively investigate thermometry in both bosonic and fermionic environments employing a Bayesian approach. Furthermore, we explore adaptive strategies and find a significant improvement on the precision. Additionally, we examine the impact of noise and find that adaptive strategies may suffer more than non-adaptive ones for short observation times. While our main focus is on thermometry, our results are easily extended to the estimation of other environmental parameters, such as chemical potentials and transition rates.

arXiv:2307.13407•New Journal of Physics•Nov 21, 2023•11 citations

Low-temperature quantum thermometry boosted by coherence generation

Asghar Ullah, M. Tahir Naseem, Özgür Esat Müstecaplıoğlu

The precise measurement of low temperatures is significant for both the fundamental understanding of physical processes and technological applications. In this work, we present a method for low-temperature measurement that improves thermal range and sensitivity by generating quantum coherence in a thermometer probe. Typically, in temperature measurements, the probes thermalize with the sample being measured. However, we use a two-level quantum system, or qubit, as our probe and prevent direct probe access to the sample by introducing a set of ancilla qubits as an interface. We describe the open system dynamics of the probe using a global master equation and demonstrate that while the ancilla-probe system thermalizes with the sample, the probe per se evolves into a nonthermal steady state due to nonlocal dissipation channels. The populations and coherences of this steady state depend on the sample temperature, allowing for precise and wide-range low-temperature estimation. We characterize the thermometric performance of the method using quantum Fisher information and show that the quantum Fisher information can exhibit multiple and higher peaks at different low temperatures with increasing quantum coherence and the number of ancilla qubits. Our analysis reveals that the proposed approach, using a nonthermal qubit thermometer probe with temperature-dependent quantum coherence generated by a multiple qubit interface between a thermal sample and the probe qubit, can enhance the sensitivity of temperature estimation and broaden the measurable low-temperature range.

arXiv:2211.05461•Physical Review Research•Nov 27, 2023•40 citations

Optimal Quantum Metrology for Probing the Unruh Effect with Uniformly Accelerated Two-Level Atoms

Yao Jin

We develop a quantum metrological framework for optimizing the probing of the Unruh effect using uniformly accelerated two-level atomic probes. The acceleration-dependent factor generated during the atom--field interaction is encoded in the atomic state and can be estimated through repeated quantum measurements. For a fixed total probe time, which characterizes the available measurement resource, we optimize the interrogation time of individual probes, the initial atomic state, and the corresponding measurement basis to minimize the estimation uncertainty. We show that the achievable precision is governed by the Fisher information accumulated per unit probe time. Under a fixed total probe time, shorter evolution times of individual probes allow for more sequential measurements, leading to a significant improvement in the estimation precision. The optimal initial state and measurement basis depend on both the acceleration factor and the probe evolution time. In particular, the excited state provides superior sensitivity in the weak-acceleration regime, whereas the ground state becomes advantageous for sufficiently large acceleration and long interaction times. Furthermore, we determine the minimum total probe time required to resolve the acceleration-dependent signal associated with the Unruh effect and demonstrate that this requirement can be substantially reduced by employing atomic systems with larger transition dipole moments. Our results establish an optimized quantum metrological strategy for probing acceleration-induced quantum effects and provide a systematic approach toward the experimental investigation of the Unruh effect.

quant-pharXiv:2607.16701•Jul 21, 2026•0 citations

Enhancement of low-temperature thermometry by strong coupling

Luis Alfonso Correa, Martí Perarnau-Llobet, Karen V. Hovhannisyan +3 more

We consider the problem of estimating the temperature $T$ of a very cold equilibrium sample. The temperature estimates are drawn from measurements performed on a quantum Brownian probe strongly coupled to it. We model this scenario by resorting to the canonical Caldeira-Leggett Hamiltonian and find analytically the exact stationary state of the probe for arbitrary coupling strength. In general, the probe does not reach thermal equilibrium with the sample, due to their nonperturbative interaction. We argue that this is advantageous for low-temperature thermometry, as we show in our model that (i) the thermometric precision at low $T$ can be significantly enhanced by strengthening the probe-sampling coupling, (ii) the variance of a suitable quadrature of our Brownian thermometer can yield temperature estimates with nearly minimal statistical uncertainty, and (iii) the spectral density of the probe-sample coupling may be engineered to further improve thermometric performance. These observations may find applications in practical nanoscale thermometry at low temperatures---a regime which is particularly relevant to quantum technologies.

arXiv:1611.10123•Physical Review A•Dec 4, 2017•108 citations

Thermometric machine for ultraprecise thermometry of low temperatures

Ivan Henao, Karen V. Hovhannisyan, Raam Uzdin

Thermal equilibrium states are exponentially hard to distinguish at very low temperatures, making equilibrium quantum thermometry in this regime a formidable task. We present a thermometric scheme that circumvents this limitation, by using a two-level probe that does not thermalize with the sample whose temperature is measured. This is made possible thanks to a suitable interaction that couples the probe to the sample and to an auxiliary thermal bath known to be at a higher temperature. Provided a reasonable upper bound on the temperature of the sample, the resulting 'thermometric machine' drives the probe towards a steady state whose signal-to-noise ratio can achieve values as high as $\mathcal{O}(1/T)$. We also characterize the transient state of the probe and numerically illustrate an extreme reduction in the number of measurements to attain a given precision, as compared to optimal measurements on a thermalized probe.

arXiv:2108.10469•Aug 24, 2021•3 citations
The unknown temperature of a sample can be estimated with minimal disturbance by putting it in thermal contact with an individual quantum probe. If the interaction time is sufficiently long so that the probe thermalizes, the temperature can be read-out directly from its steady state. Here we prove that the optimal quantum probe, acting as a thermometer with maximal thermal sensitivity, is an effective two-level atom with a maximally degenerate excited state. When the total interaction time is insufficient to produce full thermalization, we optimize the estimation protocol by breaking it down into sequential stages of probe preparation, thermal contact, and measurement. We observe that frequently interrogated probes initialized in the ground state achieve the best performance. For both fully and partly thermalized thermometers, the sensitivity grows significantly with the number of levels, though optimization over their energy spectrum remains always crucial.
A classical thermometer typically works by exchanging energy with the system being measured until it comes to equilibrium, at which point the readout is related to the final energy state of the thermometer. A recent paper noted that with a quantum thermometer consisting of a single spin/qubit, temperature discrimination is better achieved at finite times rather than once equilibration is essentially complete. Furthermore, preparing a qubit thermometer in a state with quantum coherence instead of an incoherent one improves its sensitivity to temperature differences. Implementing a recent proposal for efficiently emulating an arbitrary quantum channel, we use the quantum polarisation state of individual photons as models of "single-qubit thermometers" which evolve for a certain time in contact with a thermal bath. We investigate the optimal thermometer states for temperature discrimination, and the optimal interaction times, confirming that there is a broad regime where quantum coherence provides a significant improvement. We also discuss the more practical question of thermometers composed of a finite number of spins/qubits (greater than one), and characterize the performance of an adaptive protocol for making optimal use of all the qubits.
Abstract Temperature estimation plays a vital role across natural sciences. A standard approach is provided by probe thermometry, where a probe is brought into contact with the sample and examined after a certain amount of time has passed. In situations where, for example, preparation of the probe is non-trivial or total measurement time of the experiment is the main resource that must be optimized, continuously monitoring the probe may be preferred. Here, we consider a minimal model, where the probe is provided by a two-level system coupled to a thermal reservoir. Monitoring thermally activated transitions enables real-time estimation of temperature with increasing accuracy over time. Within this framework we comprehensively investigate thermometry in both bosonic and fermionic environments employing a Bayesian approach. Furthermore, we explore adaptive strategies and find a significant improvement on the precision. Additionally, we examine the impact of noise and find that adaptive strategies may suffer more than non-adaptive ones for short observation times. While our main focus is on thermometry, our results are easily extended to the estimation of other environmental parameters, such as chemical potentials and transition rates.
The precise measurement of low temperatures is significant for both the fundamental understanding of physical processes and technological applications. In this work, we present a method for low-temperature measurement that improves thermal range and sensitivity by generating quantum coherence in a thermometer probe. Typically, in temperature measurements, the probes thermalize with the sample being measured. However, we use a two-level quantum system, or qubit, as our probe and prevent direct probe access to the sample by introducing a set of ancilla qubits as an interface. We describe the open system dynamics of the probe using a global master equation and demonstrate that while the ancilla-probe system thermalizes with the sample, the probe per se evolves into a nonthermal steady state due to nonlocal dissipation channels. The populations and coherences of this steady state depend on the sample temperature, allowing for precise and wide-range low-temperature estimation. We characterize the thermometric performance of the method using quantum Fisher information and show that the quantum Fisher information can exhibit multiple and higher peaks at different low temperatures with increasing quantum coherence and the number of ancilla qubits. Our analysis reveals that the proposed approach, using a nonthermal qubit thermometer probe with temperature-dependent quantum coherence generated by a multiple qubit interface between a thermal sample and the probe qubit, can enhance the sensitivity of temperature estimation and broaden the measurable low-temperature range.
We develop a quantum metrological framework for optimizing the probing of the Unruh effect using uniformly accelerated two-level atomic probes. The acceleration-dependent factor generated during the atom--field interaction is encoded in the atomic state and can be estimated through repeated quantum measurements. For a fixed total probe time, which characterizes the available measurement resource, we optimize the interrogation time of individual probes, the initial atomic state, and the corresponding measurement basis to minimize the estimation uncertainty. We show that the achievable precision is governed by the Fisher information accumulated per unit probe time. Under a fixed total probe time, shorter evolution times of individual probes allow for more sequential measurements, leading to a significant improvement in the estimation precision. The optimal initial state and measurement basis depend on both the acceleration factor and the probe evolution time. In particular, the excited state provides superior sensitivity in the weak-acceleration regime, whereas the ground state becomes advantageous for sufficiently large acceleration and long interaction times. Furthermore, we determine the minimum total probe time required to resolve the acceleration-dependent signal associated with the Unruh effect and demonstrate that this requirement can be substantially reduced by employing atomic systems with larger transition dipole moments. Our results establish an optimized quantum metrological strategy for probing acceleration-induced quantum effects and provide a systematic approach toward the experimental investigation of the Unruh effect.
We consider the problem of estimating the temperature TTT of a very cold equilibrium sample. The temperature estimates are drawn from measurements performed on a quantum Brownian probe strongly coupled to it. We model this scenario by resorting to the canonical Caldeira-Leggett Hamiltonian and find analytically the exact stationary state of the probe for arbitrary coupling strength. In general, the probe does not reach thermal equilibrium with the sample, due to their nonperturbative interaction. We argue that this is advantageous for low-temperature thermometry, as we show in our model that (i) the thermometric precision at low TTT can be significantly enhanced by strengthening the probe-sampling coupling, (ii) the variance of a suitable quadrature of our Brownian thermometer can yield temperature estimates with nearly minimal statistical uncertainty, and (iii) the spectral density of the probe-sample coupling may be engineered to further improve thermometric performance. These observations may find applications in practical nanoscale thermometry at low temperatures---a regime which is particularly relevant to quantum technologies.
Thermal equilibrium states are exponentially hard to distinguish at very low temperatures, making equilibrium quantum thermometry in this regime a formidable task. We present a thermometric scheme that circumvents this limitation, by using a two-level probe that does not thermalize with the sample whose temperature is measured. This is made possible thanks to a suitable interaction that couples the probe to the sample and to an auxiliary thermal bath known to be at a higher temperature. Provided a reasonable upper bound on the temperature of the sample, the resulting 'thermometric machine' drives the probe towards a steady state whose signal-to-noise ratio can achieve values as high as O(1/T)\mathcal{O}(1/T)O(1/T). We also characterize the transient state of the probe and numerically illustrate an extreme reduction in the number of measurements to attain a given precision, as compared to optimal measurements on a thermalized probe.