The decoy-state method is widely used in practical quantum key distribution systems to replace ideal single photon sources with realistic light sources by varying intensities. Instead of active modulation, the passive decoy-state method employs built-in decoy states in a parametric down-conversion photon source, which can decrease the side channel information leakage in decoy state preparation and hence increase the security. By employing low dark count up-conversion single photon detectors, we have experimentally demonstrated the passive decoy-state method over a 50-km-long optical fiber and have obtained a key rate of about 100 bit/s. Our result suggests that the passive decoy-state source is a practical candidate for future quantum communication implementation.
The decoy-state method is widely used in practical quantum key distribution systems to replace ideal single photon sources with realistic light sources by varying intensities. Instead of active modulation, the passive decoy-state method employs built-in decoy states in a parametric down-conversion photon source, which can decrease the side channel information leakage in decoy state preparation and hence increase the security. By employing low dark count up-conversion single photon detectors, we have experimentally demonstrated the passive decoy-state method over a 50-km-long optical fiber and have obtained a key rate of about 100 bit/s. Our result suggests that the passive decoy-state source is a practical candidate for future quantum communication implementation.
Decoy states have been proven to be a very useful method for significantly enhancing the performance of quantum key distribution systems with practical light sources. Although active modulation of the intensity of the laser pulses is an effective way of preparing decoy states in principle, in practice passive preparation might be desirable in some scenarios. Typical passive schemes involve parametric down-conversion. More recently, it has been shown that phase-randomized weak coherent pulses (WCP) can also be used for the same purpose [M. Curty et al., Opt. Lett. 34, 3238 (2009).] This proposal requires only linear optics together with a simple threshold photon detector, which shows the practical feasibility of the method. Most importantly, the resulting secret key rate is comparable to the one delivered by an active decoy-state setup with an infinite number of decoy settings. In this article we extend these results, now showing specifically the analysis for other practical scenarios with different light sources and photodetectors. In particular, we consider sources emitting thermal states, phase-randomized WCP, and strong coherent light in combination with several types of photodetectors, like, for instance, threshold photon detectors, photon number resolving detectors, and classical photodetectors. Our analysis includes as well the effect that detection inefficiencies and noise in the form of dark counts shown by current threshold detectors might have on the final secret key rate. Moreover, we provide estimations on the effects that statistical fluctuations due to a finite data size can have in practical implementations.
The decoy-state method could effectively enhance the performance of quantum key distribution (QKD) with a practical phase randomized weak coherent source. Although active modulation of the source intensity is effective and has been implemented in many experiments, passive preparation of decoy states is also an important addition to the family of decoy-state QKD protocols. In this paper, following the theory of Curty et al. [Phys. Rev. A 81, 022310 (2010)], we experimentally demonstrate the phase-encoding passive-decoy-state QKD with only linear optical setups and threshold single-photon detectors. In our experiment, two homemade independent pulsed lasers, with visibility of Hong-Ou-Mandel interference $0.53(\ifmmode\pm\else\textpm\fi{}0.003)$, have been implemented and used to passively generate the different decoy states. Finally, a secret key rate of $1.5\ifmmode\times\else\texttimes\fi{}{10}^{\ensuremath{-}5}$/pulse is obtained with 10-km commercial fiber between Alice and Bob.
We present a new scheme for realizing passive decoy-state quantum key distribution with the SARG04 protocol. It is based on parametric down-conversion sources, and we do not need to modulate the pumping light into different intensities. By applying local-mode-splitting detections on Alice’s side, legitimate users can obtain four different kinds of counting events on Bob’s side, due to intrinsic correlations between photon pairs from parametric down-conversion processes. In the new scheme, we do not need to modulate signal pulses into different intensities and can, thus, avoid introducing any intensity modulating uncertainty. As a result, quite precise estimations of single- or multi-photon-pulse contributions can be obtained, enabling better performance of the key generation rate and transmission distance compared with other existing SARG04 protocols, e.g., the four-intensity decoy-state method using either parametric down-conversion sources or weak coherent sources. Besides, through comparisons, we also find that the proposed new passive decoy-state SARG04 protocol can also show some superiority over the conventional three-intensity decoy-state BB84 protocol at long transmission distances under certain experimental conditions.
To date, only active-decoy-state methods have been adopted in current measurement-device-independent (MDI) quantum key distribution (QKD) protocols, causing security loopholes when modulating multiple light intensities with practical devices. To solve this problem, the passive-decoy-state method will be a good choice. Until today practical passive-decoy-state MDI QKD is still missing. In this paper, based on a recently discussed structure of heralded single-photon sources, we propose a passive-decoy-state MDI QKD protocol. In present work, one does not need to modulate light sources into different intensities, but utilizes the built-in local detection events to passively generate different decoy states. Furthermore, through carrying out an appropriate mathematical method, we are able to give very precise estimations for single-photon-pair contributions. As a result, our protocol can exhibit distinct advantages compared with state-of-the-art MDI QKD schemes even when the finite-key-size effect is taken into account. Therefore, our protocol seems a promising candidate to enhance both the security and performance of MDI QKD in practical implementation.
Signal state preparation in quantum key distribution schemes can be realized using either an active or a passive source. Passive sources might be valuable in some scenarios; for instance, in those experimental setups operating at high transmission rates, since no externally driven element is required. Typical passive transmitters involve parametric down-conversion. More recently, it has been shown that phase-randomized coherent pulses also allow passive generation of decoy states and Bennett–Brassard 1984 (BB84) polarization signals, though the combination of both setups in a single passive source is cumbersome. In this paper, we present a complete passive transmitter that prepares decoy-state BB84 signals using coherent light. Our method employs sum-frequency generation together with linear optical components and classical photodetectors. In the asymptotic limit of an infinite long experiment, the resulting secret key rate (per pulse) is comparable to the one delivered by an active decoy-state BB84 setup with an infinite number of decoy settings.