Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:1403.7141 · Journal of the Optical Society of America B

Saturation of atomic transitions using subwavelength diameter tapered optical fibers in rubidium vapor

Daniel E. Jones, J. D. Franson, T. B. Pittman

Published Jul 31, 2014• 20 citations
arXivHTMLPDF

Abstract

We experimentally investigate ultralow-power saturation of the rubidium D2 transitions using a tapered optical fiber (TOF) suspended in a warm Rb vapor. A direct comparison of power-dependent absorption measurements for the TOF system with those obtained in a standard free-space vapor cell system highlights the differences in saturation behavior for the two systems. The effects of hyperfine pumping in the TOF system are found to be minimized due to the short atomic transit times through the highly confined evanescent optical mode guided by the TOF. The TOF system data are well-fit by a relatively simple empirical absorption model that indicates nanoWatt-level saturation powers.

DOI
10.1364/josab.31.001997

Related papers

Experiments using sub-wavelength diameter tapered optical fibers in Rubidium vapor

Meimei Lai

In this work, we describe experimental research on a relatively new nonlinear optics system comprised of a sub-wavelength diameter Tapered Optical Fiber (TOF) suspended in atomic Rubidium (Rb) vapor. The compression of the evanescent optical mode propagating along the TOF enables a dramatic increase in the nonlinear interactions between the fields and the surrounding Rb atoms, thereby allowing the observation of a variety of nonlinear optical effects with very low-power fields. Specifically, we report on the observation of saturated absorption with nW power levels and, more significantly, the observation of two-photon absorption using power-levels corresponding to only 10's to 100's of photons interacting with the Rb atoms at a given time. One significant drawback to this TOF in Rb system is that at the relatively high atomic densities needed for many of these experiments, Rb atoms accumulating on the TOF surface can cause a significant loss of overall transmission through the fiber. Here we report direct measurements of the time-scale associated with this transmission degradation for various Rb density conditions. We find that transmission is affected almost immediately after the introduction of Rb vapor into the system, and declines rapidly as the density is increased. More significantly, we show how a heating element designed to raise the TOF temperature can be used to reduce this transmission loss and dramatically extend the effective TOF transmission lifetime. Our results indicate that it is possible to achieve relatively high TOF transmission, even in the presence of the relatively high Rb vapor densities that would be needed for many low-power nonlinear optics applications. This study represents a significant step in moving the basic TOF in Rb system from a laboratory setting towards a practical ultra-low-power nonlinear optics device.

•Jan 1, 2013•0 citations

Absorption saturation measurement using the tapered optical nanofiber in a hot cesium vapor

Zixuan Song Zixuan Song, Xingyu Yue Xingyu Yue, Yu Luo Yu Luo +2 more

We report the observation of ultralow-power absorption saturation in a tapered optical fiber (TOF) mounted in a hot cesium (Cs) vapor in a vacuum chamber. The small optical mode area of TOF produces a great influence on optical properties, allowing optical interactions with nanowatt-level power. The comparison of transmission characteristics for the TOF system and free-space vapor is investigated at different input power and atomic density. The unique performance of the Cs-TOF system makes it a promising candidate in resonant nonlinear optical applications with ultralow power.

Chinese Optics Letters•Jan 1, 2019•6 citations

Ultralow-light level saturation spectroscopy and EIT using a tapered fiber in a hot vapor cell

S. M. Spillane, G. S. Pati, M. S. Shahriar +2 more

We present an experimental approach to study low light level absorption in a tapered optical fiber embedded in a rubidium atomic vapor medium. Our initial measurements demonstrates the potential of the system to realize extremely low light level quantum interference effects in the ultra small mode volume of the thin fiber, which is promising for many practical integrated device applications. The measurement shows saturated probe absorption using a low optical power of only ten nanowatt. Efforts are underway to use the fiber in a cloud of trapped rubidium atoms, which will circumvent the transit time limit for demonstrating a low photon optical switch via quantum interference.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Feb 8, 2007•0 citations

Ultralow-power nonlinear optics using tapered optical fibers in metastable xenon

T. B. Pittman, Daniel E. Jones, J. D. Franson

We demonstrate nanowatt-level saturated absorption using a subwavelength diameter tapered optical fiber (TOF) suspended in a gas of metastable xenon atoms. This ultralow-power nonlinearity is enabled by a small optical mode area propagating over a relatively long distance through the Xe gas. The use of inert noble gases in these kinds of TOF experiments may offer practical advantages over the use of reactive alkali-metal vapors, such as rubidium.

arXiv:1308.5655•Physical Review A•Nov 6, 2013•23 citations

Optical Nonlinearities Using Tapered Optical Fibers in Rubidium Vapor

Daniel E. Jones, J. D. Franson, T. B. Pittman

Sub-wavelength diameter tapered optical fibers suspended in rubidium vapor can allow ultralow-power nonlinearities that may have applications in photonic quantum information processing. Here we experimentally investigate saturation of the relevant atomic transitions with ultralow-power fields.

•Jan 1, 2014•0 citations

Transmission degradation and preservation for tapered optical fibers in rubidium vapor

Meimei Lai, J. D. Franson, T. B. Pittman

The use of subwavelength diameter tapered optical fibers (TOFs) in warm rubidium vapor has recently been identified as a promising system for realizing ultralow-power nonlinear optical effects. However, at the relatively high atomic densities needed for many of these experiments, rubidium atoms accumulating on the TOF surface can cause a significant loss of overall transmission through the fiber. Here we report direct measurements of the time scale associated with this transmission degradation for various rubidium density conditions. Transmission is affected almost immediately after the introduction of rubidium vapor into the system, and declines rapidly as the density is increased. More significantly, we show how a heating element designed to raise the TOF temperature can be used to reduce this transmission loss and dramatically extend the effective TOF transmission lifetime.

arXiv:1212.5189•Applied Optics•Apr 11, 2013•24 citations
We experimentally investigate ultralow-power saturation of the rubidium D2 transitions using a tapered optical fiber (TOF) suspended in a warm Rb vapor. A direct comparison of power-dependent absorption measurements for the TOF system with those obtained in a standard free-space vapor cell system highlights the differences in saturation behavior for the two systems. The effects of hyperfine pumping in the TOF system are found to be minimized due to the short atomic transit times through the highly confined evanescent optical mode guided by the TOF. The TOF system data are well-fit by a relatively simple empirical absorption model that indicates nanoWatt-level saturation powers.
In this work, we describe experimental research on a relatively new nonlinear optics system comprised of a sub-wavelength diameter Tapered Optical Fiber (TOF) suspended in atomic Rubidium (Rb) vapor. The compression of the evanescent optical mode propagating along the TOF enables a dramatic increase in the nonlinear interactions between the fields and the surrounding Rb atoms, thereby allowing the observation of a variety of nonlinear optical effects with very low-power fields. Specifically, we report on the observation of saturated absorption with nW power levels and, more significantly, the observation of two-photon absorption using power-levels corresponding to only 10's to 100's of photons interacting with the Rb atoms at a given time. One significant drawback to this TOF in Rb system is that at the relatively high atomic densities needed for many of these experiments, Rb atoms accumulating on the TOF surface can cause a significant loss of overall transmission through the fiber. Here we report direct measurements of the time-scale associated with this transmission degradation for various Rb density conditions. We find that transmission is affected almost immediately after the introduction of Rb vapor into the system, and declines rapidly as the density is increased. More significantly, we show how a heating element designed to raise the TOF temperature can be used to reduce this transmission loss and dramatically extend the effective TOF transmission lifetime. Our results indicate that it is possible to achieve relatively high TOF transmission, even in the presence of the relatively high Rb vapor densities that would be needed for many low-power nonlinear optics applications. This study represents a significant step in moving the basic TOF in Rb system from a laboratory setting towards a practical ultra-low-power nonlinear optics device.
We report the observation of ultralow-power absorption saturation in a tapered optical fiber (TOF) mounted in a hot cesium (Cs) vapor in a vacuum chamber. The small optical mode area of TOF produces a great influence on optical properties, allowing optical interactions with nanowatt-level power. The comparison of transmission characteristics for the TOF system and free-space vapor is investigated at different input power and atomic density. The unique performance of the Cs-TOF system makes it a promising candidate in resonant nonlinear optical applications with ultralow power.
We present an experimental approach to study low light level absorption in a tapered optical fiber embedded in a rubidium atomic vapor medium. Our initial measurements demonstrates the potential of the system to realize extremely low light level quantum interference effects in the ultra small mode volume of the thin fiber, which is promising for many practical integrated device applications. The measurement shows saturated probe absorption using a low optical power of only ten nanowatt. Efforts are underway to use the fiber in a cloud of trapped rubidium atoms, which will circumvent the transit time limit for demonstrating a low photon optical switch via quantum interference.
The use of subwavelength diameter tapered optical fibers (TOFs) in warm rubidium vapor has recently been identified as a promising system for realizing ultralow-power nonlinear optical effects. However, at the relatively high atomic densities needed for many of these experiments, rubidium atoms accumulating on the TOF surface can cause a significant loss of overall transmission through the fiber. Here we report direct measurements of the time scale associated with this transmission degradation for various rubidium density conditions. Transmission is affected almost immediately after the introduction of rubidium vapor into the system, and declines rapidly as the density is increased. More significantly, we show how a heating element designed to raise the TOF temperature can be used to reduce this transmission loss and dramatically extend the effective TOF transmission lifetime.