Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:1312.5031 · Physical Review A

5-mg suspended mirror driven by measurement-induced backaction

Nobuyuki Matsumoto, Kentaro Komori, Yuta Michimura, Gen Hayase, Y. Aso, Kimio Tsubono

Published Sep 15, 2015• 35 citations
arXivHTMLPDF

Abstract

Quantum mechanics predicts superpositions of position states even for macroscopic objects. Recently, the use of a quasifreely suspended mirror combined with a laser was proposed to prepare such states [H. M\"uller-Ebhardt et al., Phys. Rev. Lett. 100, 013601 (2008)]. One of the key milestones towards this goal is the preparation of the mechanical oscillator mainly driven by measurement-induced backaction in the quantum regime. Here we describe the observation of backaction acting on a suspended 5-mg mirror in the classical regime. Furthermore, its quantum component is estimated to be larger than the thermal fluctuating force due to internal damping of the suspension, by a factor of $1.4\ifmmode\pm\else\textpm\fi{}0.2$ at 325 Hz.

DOI
10.1103/physreva.92.033825

Related papers

Verification of conditional mechanical squeezing for a mg-scale pendulum near quantum regimes

Jordy G. Santiago-Condori, Naoki Yamamoto, Nobuyuki Matsumoto

In quantum mechanics, measurement can be used to prepare a quantum state. This principle is applicable even for macroscopic objects, which may enable us to see classical-quantum transition. Here, we demonstrate conditional mechanical squeezing of a mg-scale suspended mirror (i.e. the center-of-mass mode of a pendulum) near quantum regimes, through continuous linear position measurement and quantum state prediction. The experiment involved the pendulum interacting with photon coherent fields in a detuned optical cavity, which creates an optical spring. Futhermore, the detuned cavity allows us to perform linear position measurement by direct photo-detection of the reflected light. We experimentally verify the conditional squeezing using the theory combining prediction and retrodiction based on the causal and anti-causal filters. As a result, the standard deviation of position and momentum are respectively given by 36 times the zero-point amplitude of position $q_{\rm zpf}$ and 89 times the zero-point amplitude of momentum $p_{\rm zpf}$. The squeezing level achieved is about 5 times closer to the zero-point motion, despite that the mass of the mechanical oscillator is approximately 7 orders of magnitude greater, compared to the previous study. Thus, our demonstration is the first step towards quantum control for massive objects whose mass-scale is high enough to measure gravitational interactions. Such quantum control will pave the way to test quantum mechanics using the center-of-mass mode of massive objects.

arXiv:2008.10848•Aug 25, 2020•19 citations

Preparing mechanical squeezing of a macroscopic pendulum near quantum regimes

Nobuyuki Matsumoto, Naoki Yamamoto

We present the mechanical squeezing of a mg-scale suspended mirror (i.e. a pendulum) near quantum regimes through continuous linear position measurement. The experiment involved the pendulum interacting with photon coherent fields in a detuned optical cavity. The position uncertainty in the measured data is reduced and squeezed to $470$ times the zero-point amplitude $x_{\rm zpf}$ with a purity of about 0.0004, by means of optimal state estimation through causal Wiener filtering. The purity of the squeezed state is clearly maximized by the Wiener filter, based on precisely identified optomechanical parameters. This is the first step for measurement-based quantum control of macroscopic pendulums, e.g. generation of an entanglement state between macroscopic pendulums. Such quantum control will provide a direct insight into the quantum to classical transition and will pave the way to test semiclassical gravity and gravity sourced by macroscopic quantum oscillators.

•Aug 25, 2020•2 citations

Conditional mechanical squeezing of a macroscopic pendulum near quantum regimes

Nobuyuki Matsumoto, Naoki Yamamoto

We present the mechanical squeezing of a mg-scale suspended mirror (i.e. a pendulum) near quantum regimes through continuous linear position measurement. The experiment involved the pendulum interacting with photon coherent fields in a detuned optical cavity. The position uncertainty in the measured data is reduced and squeezed to $470$ times the zero-point amplitude $x_{\rm zpf}$ with a purity of about 0.0004, by means of optimal state estimation through causal Wiener filtering. The purity of the squeezed state is clearly maximized by the Wiener filter, based on precisely identified optomechanical parameters. This is the first step for measurement-based quantum control of macroscopic pendulums, e.g. generation of an entanglement state between macroscopic pendulums. Such quantum control will provide a direct insight into the quantum to classical transition and will pave the way to test semiclassical gravity and gravity sourced by macroscopic quantum oscillators.

•Aug 25, 2020•0 citations

Quantum phase-space analysis of the pendular cavity

M. K. Olsen, A. B. Melo, K. Dechoum +1 more

We perform a quantum-mechanical analysis of the pendular cavity, using the positive-$P$ representation, showing that the quantum state of the moving mirror, a macroscopic object, has noticeable effects on the dynamics. This system has previously been proposed as a candidate for the quantum-limited measurement of small displacements of the mirror due to radiation pressure, for the production of states with entanglement between the mirror and the field, and even for superposition states of the mirror. However, when we treat the oscillating mirror quantum mechanically, we find that it always oscillates, has no stationary steady state, and exhibits uncertainties in position and momentum which are typically larger than the mean values. This means that previous linearized fluctuation analyses which have been used to predict these highly quantum states are of limited use. We find that the achievable accuracy in measurement is far worse than the standard quantum limit due to thermal noise, which, for typical experimental parameters, is overwhelming even at $2\phantom{\rule{0.3em}{0ex}}\mathrm{mK}$

arXiv:quant-ph/0409214•Physical Review A•Oct 21, 2004•10 citations

Force metrology using quantum correlations of light due to a room-temperature mechanical oscillator

Vivishek Sudhir, Ryan Schilling, Sergey A. Fedorov +3 more

The radiation pressure interaction of light with a mechanical oscillator leads to a fundamental disturbance on the oscillator. This disturbance - measurement backaction - is due to the quantum fluctuations in the amplitude of the light. When the phase of the light is detected to infer the mechanical position, quantum fluctuations in the phase - measurement imprecision - leads to a further uncertainty in the estimate of the position. In this conventional measurement strategy, these two noise sources impose a fundamental limit on the ability to estimate the position of the mechanical object - the so-called standard quantum limit [1]. However, the two noise contributions are in general correlated. The fluctuations in the amplitude quadrature drive the mechanical oscillator, and this backaction driven motion is transduced into the phase quadrature. Correlations thus established [2] form a valuable quantum mechanical resource that can be directly employed for back-action cancellation in the measurement record via “variational measurements” [3].

Conference on Lasers and Electro-Optics Europe & European Quantum Electronics Conference (CLEO/Europe-EQEC)•Jun 1, 2017•1 citation

Towards the Standard Quantum Limit in a Table-Top Interferometer

Д. В. Мартынов, J. Smetana

We discuss the development and expected performance of a table-top experiment for measuring quantum fluctuations in a suspended-test-mass interferometer. The ultimate goal of this experiment is to perform measurements of the quantum noise-limited displacement sensitivity of the interferometer at the level of the standard quantum limit (5×10−19 m/sqrt(Hz) at 100 Hz). The case is made for an experiment that will show the feasibility of preparing a macroscopic quantum-limited system within a regular laboratory environment. This will be achieved by suspending a cryogenically cooled, high-finesse, optical cavity via a multi-stage suspension. We motivate the utility of our experiment in providing an increased understanding of the nature of quantum fluctuations in current and future gravitational wave detectors, as well as opening an avenue for research into aspects of macroscopic quantum mechanics and quantum gravity. We explain how these requirements drove our design specification. Given the extremely small displacements in question, particular attention is devoted to discussing noise mitigation, with a focus on the suppression of seismic and thermal noise.

•Apr 23, 2020•1 citation
Quantum mechanics predicts superpositions of position states even for macroscopic objects. Recently, the use of a quasifreely suspended mirror combined with a laser was proposed to prepare such states [H. M"uller-Ebhardt et al., Phys. Rev. Lett. 100, 013601 (2008)]. One of the key milestones towards this goal is the preparation of the mechanical oscillator mainly driven by measurement-induced backaction in the quantum regime. Here we describe the observation of backaction acting on a suspended 5-mg mirror in the classical regime. Furthermore, its quantum component is estimated to be larger than the thermal fluctuating force due to internal damping of the suspension, by a factor of 1.4\ifmmode±\else\textpm\fi0.21.4\ifmmode\pm\else\textpm\fi{}0.21.4\ifmmode±\else\textpm\fi0.2 at 325 Hz.
In quantum mechanics, measurement can be used to prepare a quantum state. This principle is applicable even for macroscopic objects, which may enable us to see classical-quantum transition. Here, we demonstrate conditional mechanical squeezing of a mg-scale suspended mirror (i.e. the center-of-mass mode of a pendulum) near quantum regimes, through continuous linear position measurement and quantum state prediction. The experiment involved the pendulum interacting with photon coherent fields in a detuned optical cavity, which creates an optical spring. Futhermore, the detuned cavity allows us to perform linear position measurement by direct photo-detection of the reflected light. We experimentally verify the conditional squeezing using the theory combining prediction and retrodiction based on the causal and anti-causal filters. As a result, the standard deviation of position and momentum are respectively given by 36 times the zero-point amplitude of position qzpfq_{\rm zpf}qzpf​ and 89 times the zero-point amplitude of momentum pzpfp_{\rm zpf}pzpf​. The squeezing level achieved is about 5 times closer to the zero-point motion, despite that the mass of the mechanical oscillator is approximately 7 orders of magnitude greater, compared to the previous study. Thus, our demonstration is the first step towards quantum control for massive objects whose mass-scale is high enough to measure gravitational interactions. Such quantum control will pave the way to test quantum mechanics using the center-of-mass mode of massive objects.
We present the mechanical squeezing of a mg-scale suspended mirror (i.e. a pendulum) near quantum regimes through continuous linear position measurement. The experiment involved the pendulum interacting with photon coherent fields in a detuned optical cavity. The position uncertainty in the measured data is reduced and squeezed to 470470470 times the zero-point amplitude xzpfx_{\rm zpf}xzpf​ with a purity of about 0.0004, by means of optimal state estimation through causal Wiener filtering. The purity of the squeezed state is clearly maximized by the Wiener filter, based on precisely identified optomechanical parameters. This is the first step for measurement-based quantum control of macroscopic pendulums, e.g. generation of an entanglement state between macroscopic pendulums. Such quantum control will provide a direct insight into the quantum to classical transition and will pave the way to test semiclassical gravity and gravity sourced by macroscopic quantum oscillators.
We present the mechanical squeezing of a mg-scale suspended mirror (i.e. a pendulum) near quantum regimes through continuous linear position measurement. The experiment involved the pendulum interacting with photon coherent fields in a detuned optical cavity. The position uncertainty in the measured data is reduced and squeezed to 470470470 times the zero-point amplitude xzpfx_{\rm zpf}xzpf​ with a purity of about 0.0004, by means of optimal state estimation through causal Wiener filtering. The purity of the squeezed state is clearly maximized by the Wiener filter, based on precisely identified optomechanical parameters. This is the first step for measurement-based quantum control of macroscopic pendulums, e.g. generation of an entanglement state between macroscopic pendulums. Such quantum control will provide a direct insight into the quantum to classical transition and will pave the way to test semiclassical gravity and gravity sourced by macroscopic quantum oscillators.
We perform a quantum-mechanical analysis of the pendular cavity, using the positive-PPP representation, showing that the quantum state of the moving mirror, a macroscopic object, has noticeable effects on the dynamics. This system has previously been proposed as a candidate for the quantum-limited measurement of small displacements of the mirror due to radiation pressure, for the production of states with entanglement between the mirror and the field, and even for superposition states of the mirror. However, when we treat the oscillating mirror quantum mechanically, we find that it always oscillates, has no stationary steady state, and exhibits uncertainties in position and momentum which are typically larger than the mean values. This means that previous linearized fluctuation analyses which have been used to predict these highly quantum states are of limited use. We find that the achievable accuracy in measurement is far worse than the standard quantum limit due to thermal noise, which, for typical experimental parameters, is overwhelming even at 2mK2\phantom{\rule{0.3em}{0ex}}\mathrm{mK}2mK
The radiation pressure interaction of light with a mechanical oscillator leads to a fundamental disturbance on the oscillator. This disturbance - measurement backaction - is due to the quantum fluctuations in the amplitude of the light. When the phase of the light is detected to infer the mechanical position, quantum fluctuations in the phase - measurement imprecision - leads to a further uncertainty in the estimate of the position. In this conventional measurement strategy, these two noise sources impose a fundamental limit on the ability to estimate the position of the mechanical object - the so-called standard quantum limit [1]. However, the two noise contributions are in general correlated. The fluctuations in the amplitude quadrature drive the mechanical oscillator, and this backaction driven motion is transduced into the phase quadrature. Correlations thus established [2] form a valuable quantum mechanical resource that can be directly employed for back-action cancellation in the measurement record via “variational measurements” [3].
We discuss the development and expected performance of a table-top experiment for measuring quantum fluctuations in a suspended-test-mass interferometer. The ultimate goal of this experiment is to perform measurements of the quantum noise-limited displacement sensitivity of the interferometer at the level of the standard quantum limit (5×10−19 m/sqrt(Hz) at 100 Hz). The case is made for an experiment that will show the feasibility of preparing a macroscopic quantum-limited system within a regular laboratory environment. This will be achieved by suspending a cryogenically cooled, high-finesse, optical cavity via a multi-stage suspension. We motivate the utility of our experiment in providing an increased understanding of the nature of quantum fluctuations in current and future gravitational wave detectors, as well as opening an avenue for research into aspects of macroscopic quantum mechanics and quantum gravity. We explain how these requirements drove our design specification. Given the extremely small displacements in question, particular attention is devoted to discussing noise mitigation, with a focus on the suppression of seismic and thermal noise.