Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:1312.2271

Probing semiconductor quantum dot state and manipulation with superconducting transmission line resonator

Zhe Guan

Published Dec 8, 2013• 0 citations
arXivHTMLPDF

Abstract

A coupled system of a superconducting transmission line resonator with a semiconductor double quantum dot is analyzed. We simulate the phase shift of the microwave signal in the resonator, which is sensitive to the quantum dot qubit state and manipulation. The measurement quality is sufficiently high and the results demonstrate a solid-state quantum processor based on this type of circuit can be envisioned.

DOI
10.48550/arxiv.1312.2271

Related papers

Measurement of Spin Singlet-Triplet Qubit in Quantum Dots Using Superconducting Resonator*

Xingyu Zhu, Tao Tu, Ao-Lin Guo +2 more

The spin qubit in quantum dots is one of the leading platforms for quantum computation. A crucial requirement for scalable quantum information processing is the high efficient measurement. Here we analyze the measurement process of a quantum-dot spin qubit coupled to a superconducting transmission line resonator. Especially, the phase shift of the resonator is sensitive to the spin states and the gate operations. The response of the resonator can be used to measure the spin qubit efficiently, which can be extend to read out the multiple spin qubits in a scalable solid-state quantum processor.

Chinese Physics Letters•Feb 1, 2020•4 citations

Dipole Coupling of a Double Quantum Dot to a Microwave Resonator

Tobias Frey, Peter Leek, Mattias Beck +4 more

We demonstrate the realization of a hybrid solid-state quantum device, in which a semiconductor double quantum dot is dipole coupled to the microwave field of a superconducting coplanar waveguide resonator. The double dot charge stability diagram extracted from measurements of the amplitude and phase of a microwave tone transmitted through the resonator is in good agreement with that obtained from transport measurements. Both the observed frequency shift and linewidth broadening of the resonator are explained considering the double dot as a charge qubit coupled with a strength of several tens of MHz to the resonator.

arXiv:1108.5378•Physical Review Letters•Jan 25, 2012•358 citations

Microwave-Resonator-Detected Excited-State Spectroscopy of a Double Quantum Dot

Ming-Bo Chen, Shun-Li Jiang, Ning Wang +6 more

As an application in circuit quantum electrodynamics coupled systems, superconducting resonators play an important role in high-sensitivity measurements in a superconducting-semiconductor hybrid architecture. Taking advantage of a high-impedance $\mathrm{Nb}\text{\ensuremath{-}}\mathrm{Ti}\text{\ensuremath{-}}\mathrm{N}$ resonator, we perform excited-state spectroscopy on a $\mathrm{Ga}\mathrm{As}$ double quantum dot (DQD) by applying voltage pulses to one gate electrode. The pulse train modulates the DQD energy detuning and gives rise to charge state transitions at zero detuning. Benefiting from the outstanding sensitivity of the resonator, we distinguish different spin-state transitions in the energy spectrum according to the Pauli exclusion principle. Furthermore, we experimentally study how the interdot tunneling rate modifies the resonator response. The experimental results are consistent with the simulated spectra based on our model.

arXiv:2102.08169•Physical Review Applied•Apr 28, 2021•11 citations

Single-electron double quantum dot dipole-coupled to a single photonic mode

J. Basset, David-Dominik Jarausch, Anna Stockklauser +6 more

We have realized a hybrid solid-state quantum device in which a single-electron semiconductor double quantum dot is dipole coupled to a superconducting microwave frequency transmission line resonator. The dipolar interaction between the two entities manifests itself via dispersive and dissipative effects observed as frequency shifts and linewidth broadenings of the photonic mode respectively. A Jaynes-Cummings Hamiltonian master equation calculation is used to model the combined system response and allows for determining both the coherence properties of the double quantum dot and its interdot tunnel coupling with high accuracy. The value and uncertainty of the tunnel coupling extracted from the microwave read-out technique are compared to a standard quantum point contact charge detection analysis. The two techniques are found to be consistent with a superior precision for the microwave experiment when tunneling rates approach the resonator eigenfrequency. Decoherence properties of the double dot are further investigated as a function of the number of electrons inside the dots. They are found to be similar in the single-electron and many-electron regimes suggesting that the density of the confinement energy spectrum plays a minor role in the decoherence rate of the system under investigation.

arXiv:1304.5141•Physical Review B•Sep 30, 2013•71 citations

Generation of Quantum-Dot Cluster States with a Superconducting Transmission Line Resonator

Zhirong Lin, Guo‐Ping Guo, Tao Tu +2 more

We propose an efficient method to generate cluster states in spatially separated double quantum dots with a superconducting transmission line resonator. When the detuning between the double-dot qubit transition frequency and the frequency of the full wave mode in the transmission line resonator satisfies some conditions, an Ising-like operator between an arbitrary two separated qubits can be achieved. Even including the main noise sources, it is shown that the high fidelity cluster states could be generated in this solid system in just one step.

arXiv:0804.3187•Physical Review Letters•Dec 1, 2008•78 citations

Quantum efficiency of a single microwave photon detector based on a semiconductor double quantum dot

Clement H. Wong, Maxim Vavilov

Motivated by recent interest in implementing circuit quantum electrodynamics with semiconducting quantum dots, we consider a double quantum dot (DQD) capacitively coupled to a superconducting resonator that is driven by the microwave field of a superconducting transmission line. We analyze the DQD current response using input-output theory and show that the resonator-coupled DQD is a sensitive microwave single photon detector. Using currently available experimental parameters of DQD-resonator coupling and dissipation, including the effects of $1/f$ charge noise and phonon noise, we determine the parameter regime for which incident photons are completely absorbed and near-unit $\ensuremath{\gtrsim}98$% efficiency can be achieved. We show that this regime can be reached by using very high quality resonators with quality factor $Q\ensuremath{\simeq}{10}^{5}$.

arXiv:1512.06939•Physical Review A•Jan 24, 2017•46 citations
A coupled system of a superconducting transmission line resonator with a semiconductor double quantum dot is analyzed. We simulate the phase shift of the microwave signal in the resonator, which is sensitive to the quantum dot qubit state and manipulation. The measurement quality is sufficiently high and the results demonstrate a solid-state quantum processor based on this type of circuit can be envisioned.
The spin qubit in quantum dots is one of the leading platforms for quantum computation. A crucial requirement for scalable quantum information processing is the high efficient measurement. Here we analyze the measurement process of a quantum-dot spin qubit coupled to a superconducting transmission line resonator. Especially, the phase shift of the resonator is sensitive to the spin states and the gate operations. The response of the resonator can be used to measure the spin qubit efficiently, which can be extend to read out the multiple spin qubits in a scalable solid-state quantum processor.
We demonstrate the realization of a hybrid solid-state quantum device, in which a semiconductor double quantum dot is dipole coupled to the microwave field of a superconducting coplanar waveguide resonator. The double dot charge stability diagram extracted from measurements of the amplitude and phase of a microwave tone transmitted through the resonator is in good agreement with that obtained from transport measurements. Both the observed frequency shift and linewidth broadening of the resonator are explained considering the double dot as a charge qubit coupled with a strength of several tens of MHz to the resonator.
As an application in circuit quantum electrodynamics coupled systems, superconducting resonators play an important role in high-sensitivity measurements in a superconducting-semiconductor hybrid architecture. Taking advantage of a high-impedance $\mathrm{Nb}\text{\ensuremath{-}}\mathrm{Ti}\text{\ensuremath{-}}\mathrm{N}$ resonator, we perform excited-state spectroscopy on a GaAs\mathrm{Ga}\mathrm{As}GaAs double quantum dot (DQD) by applying voltage pulses to one gate electrode. The pulse train modulates the DQD energy detuning and gives rise to charge state transitions at zero detuning. Benefiting from the outstanding sensitivity of the resonator, we distinguish different spin-state transitions in the energy spectrum according to the Pauli exclusion principle. Furthermore, we experimentally study how the interdot tunneling rate modifies the resonator response. The experimental results are consistent with the simulated spectra based on our model.
We have realized a hybrid solid-state quantum device in which a single-electron semiconductor double quantum dot is dipole coupled to a superconducting microwave frequency transmission line resonator. The dipolar interaction between the two entities manifests itself via dispersive and dissipative effects observed as frequency shifts and linewidth broadenings of the photonic mode respectively. A Jaynes-Cummings Hamiltonian master equation calculation is used to model the combined system response and allows for determining both the coherence properties of the double quantum dot and its interdot tunnel coupling with high accuracy. The value and uncertainty of the tunnel coupling extracted from the microwave read-out technique are compared to a standard quantum point contact charge detection analysis. The two techniques are found to be consistent with a superior precision for the microwave experiment when tunneling rates approach the resonator eigenfrequency. Decoherence properties of the double dot are further investigated as a function of the number of electrons inside the dots. They are found to be similar in the single-electron and many-electron regimes suggesting that the density of the confinement energy spectrum plays a minor role in the decoherence rate of the system under investigation.
We propose an efficient method to generate cluster states in spatially separated double quantum dots with a superconducting transmission line resonator. When the detuning between the double-dot qubit transition frequency and the frequency of the full wave mode in the transmission line resonator satisfies some conditions, an Ising-like operator between an arbitrary two separated qubits can be achieved. Even including the main noise sources, it is shown that the high fidelity cluster states could be generated in this solid system in just one step.
Motivated by recent interest in implementing circuit quantum electrodynamics with semiconducting quantum dots, we consider a double quantum dot (DQD) capacitively coupled to a superconducting resonator that is driven by the microwave field of a superconducting transmission line. We analyze the DQD current response using input-output theory and show that the resonator-coupled DQD is a sensitive microwave single photon detector. Using currently available experimental parameters of DQD-resonator coupling and dissipation, including the effects of 1/f1/f1/f charge noise and phonon noise, we determine the parameter regime for which incident photons are completely absorbed and near-unit $\ensuremath{\gtrsim}98$% efficiency can be achieved. We show that this regime can be reached by using very high quality resonators with quality factor $Q\ensuremath{\simeq}{10}^{5}$.