Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:1311.5472 · Physical Review Letters

Reversing Quantum Trajectories with Analog Feedback

G. de Lange, Diego Ristè, M. J. Tiggelman, Christopher Eichler, Lars Tornberg, Göran Johansson, Andreas J. Wallraff, Raymond N. Schouten, L. DiCarlo

Published Feb 24, 2014• 88 citations
arXivHTMLPDF

Abstract

We demonstrate the active suppression of transmon qubit dephasing induced by dispersive measurement, using parametric amplification and analog feedback.By real-time processing of the homodyne record, the feedback controller reverts the stochastic quantum phase kick imparted by the measurement on the qubit.The feedback operation matches a model of quantum trajectories with a measurement efficiency η ≈ 0.5, consistent with the result obtained by postselection.We overcome the bandwidth limitations of the amplification chain by numerically optimizing the signal processing in the feedback loop and provide a theoretical model explaining the optimization result.

DOI
10.1103/physrevlett.112.080501

Related papers

Dispersive qubit measurement using an on-chip parametric amplifer

B. A. Levitan

We investigate the quantum measurement physics of a system in which a phase-sensitive parametric amplifier is used to directly measure a qubit to which it is coupled dispersively. By analytic calculation of the signal-to-noise ratio, we show that the amplification properties of the paramp can be exploited to achieve on-chip gain of the qubit readout signal, mitigating the damage done to the measurement rate by circulator added noise and losses in between the readout cavity and any following amplification chain. With a different choice of drive phase, we show that when added noise is not a concern, the squeezing properties of the paramp can be used to enhance the measurement rate relative to a standard dispersive readout by reducing the readout noise without corresponding reduction of qubit signal. We then proceed to calculate the back-action dephasing of the qubit by way of a phase-space technique, and find analytic results valid in the long-time limit while numerically handling the finite-time case. We show how in both operating modes, in the long-time limit, the back-action dephasing of the qubit can be made as small as is allowed by quantum mechanics by using using sufficiently many photons in the measurement, i.e.\@ by using a sufficiently strong coherent measurement drive. Crucially, we find that in the presence of experimentally realistic amounts of added noise, the on-chip gain afforded by such a device can be used to come significantly closer to the quantum limit than is possible with a standard dispersive measurement setup, allowing for efficiencies of ~ 75% under conditions that would yield efficiencies <~ 1 % when applying the usual scheme.

•Jan 1, 2016•0 citations

Effects of time delay in no-knowledge quantum feedback control

Jirawat Saiphet, Areeya Chantasri, Sujin Suwanna

Abstract The no-knowledge quantum feedback, introduced in Phys. Rev. Lett., 113, 020407 (2014), is a measurement-based feedback protocol for decoherence suppression in a quantum system coupled to noisy environment. By continuously measuring the environmental noise, without directly gathering any information about the system, the decoherence effect can be suppressed by feeding back quantum controls proportional to the measured signal. In the original work, the feedback control was assumed instantaneous, leading to perfect cancellation of noise backaction on the quantum system. However, the instantaneous feedback is difficult to achieve in practice, and close-loop feedback protocols are always associated with finite delayed time. Therefore, in this work, we consider the effects of the delay between the time at which the measurement signal is acquired and the time that such signal is fed back to the system. We investigate the problem with an example of a two-level system (qubit) coupled to a Markovian reservoir, via a Hermitian coupling operator, where a homodyne detection is used to measure the environmental noise. We numerically simulate quantum stochastic trajectories of the qubit and analyse their averaged dynamics. We find that the feedback control with time delay can either enhance or reduce the decoherence effects, depending on whether the delayed time is in-phase or out-of-phase with the unitary dynamics of the qubit system.

Journal of Physics Conference Series•Nov 1, 2019•3 citations

Quantum feedback and adaptive measurements

Hideo Mabuchi, John K. Au, J. K. Chin +2 more

Summary form only given. Although real-time feedback of measured signals is an essential component of sensing and control in classical settings, models for quantum feedback that are rigorous yet useful have only become possible since the advent of measurement-based quantum trajectory theory. The quantum feedback scenario introduces new concerns of coherence and measurement backaction, but recent work has shown that these can be treated properly in a formal integration of quantum trajectory theory with standard state-space formulations of filtering and control theory. Pioneering studies by H. M. Wiseman have shown that such models can be used to design and to analyze realistic schemes for adaptive homodyne measurement and for feedback control of atomic motion. Much of the ongoing research in our group focuses on the experimental implementation of such schemes. For a broad range of quantum feedback scenarios, certain recurring technical issues arise out of the need to perform complex, high-bandwidth processing of measured signals. We are developing a "rapid-prototyping" approach to refining signal processing and feedback algorithms via quantum trajectory simulation on a PC, followed by translation of the algorithms into hardware Description language (HDL).

Quantum Electronics and Laser Science Conference•Nov 13, 2002•0 citations

Using Spontaneous Emission of a Qubit as a Resource for Feedback Control

Philippe Campagne-Ibarcq, S. Jézouin, Nathanaël Cottet +6 more

Persistent control of a transmon qubit is performed by a feedback protocol based on continuous heterodyne measurement of its fluorescence. By driving the qubit and cavity with microwave signals whose amplitudes depend linearly on the instantaneous values of the quadratures of the measured fluorescence field, we show that it is possible to stabilize permanently the qubit in any targeted state. Using a Josephson mixer as a phase-preserving amplifier, it was possible to reach a total measurement efficiency η=35%, leading to a maximum of 59% of excitation and 44% of coherence for the stabilized states. The experiment demonstrates multiple-input multiple-output analog Markovian feedback in the quantum regime.

arXiv:1602.05479•Physical Review Letters•Aug 1, 2016•48 citations

Efficient quantum filtering for quantum feedback control

Pierre Rouchon, Jason F. Ralph

We discuss an efficient numerical scheme for the recursive filtering of diffusive quantum stochastic master equations. We show that the resultant quantum trajectory is robust and may be used for feedback based on inefficient measurements. The proposed numerical scheme is amenable to approximation, which can be used to further reduce the computational burden associated with calculating quantum trajectories and may allow real-time quantum filtering. We provide a two-qubit example where feedback control of entanglement may be within the scope of current experimental systems.

arXiv:1410.5345•Physical Review A•Jan 28, 2015•85 citations

Broadband sensitivity improvement via coherent quantum feedback with PT-symmetry

Xiang Li, Maxim Goryachev, Yiqiu Ma +4 more

A conventional resonant detector is often subject to a trade-off between bandwidth and peak sensitivity. Anomalous dispersion has been shown to improve the bandwidth-sensitivity limit by signal amplification, but its unstable issue in operation needs additional feedback control. Here we propose a stable quantum amplifier enabled by two-mode non-degenerate parametric amplification. As the amplifier operates at threshold, one mode of the amplifier forms a parity-time(PT)-symmetric system with the mode of the original detector, while the other mode of the amplifier collects signal and gets extracted by a readout. Viewed more broadly in the context of coherent quantum control theory, we are attaching a controller that consists of a time reversal of the plant, which, by canceling the inertia of the plant, helps drive up the closed-loop signal gain. Examples of microwave cavity axion detectors and laser-interferometric gravitational-wave detectors will be discussed for this technique.

arXiv:2012.00836•Optical and Quantum Sensing and Precision Metrology•Mar 4, 2021•22 citations
We demonstrate the active suppression of transmon qubit dephasing induced by dispersive measurement, using parametric amplification and analog feedback.By real-time processing of the homodyne record, the feedback controller reverts the stochastic quantum phase kick imparted by the measurement on the qubit.The feedback operation matches a model of quantum trajectories with a measurement efficiency η ≈ 0.5, consistent with the result obtained by postselection.We overcome the bandwidth limitations of the amplification chain by numerically optimizing the signal processing in the feedback loop and provide a theoretical model explaining the optimization result.
We investigate the quantum measurement physics of a system in which a phase-sensitive parametric amplifier is used to directly measure a qubit to which it is coupled dispersively. By analytic calculation of the signal-to-noise ratio, we show that the amplification properties of the paramp can be exploited to achieve on-chip gain of the qubit readout signal, mitigating the damage done to the measurement rate by circulator added noise and losses in between the readout cavity and any following amplification chain. With a different choice of drive phase, we show that when added noise is not a concern, the squeezing properties of the paramp can be used to enhance the measurement rate relative to a standard dispersive readout by reducing the readout noise without corresponding reduction of qubit signal. We then proceed to calculate the back-action dephasing of the qubit by way of a phase-space technique, and find analytic results valid in the long-time limit while numerically handling the finite-time case. We show how in both operating modes, in the long-time limit, the back-action dephasing of the qubit can be made as small as is allowed by quantum mechanics by using using sufficiently many photons in the measurement, i.e.\@ by using a sufficiently strong coherent measurement drive. Crucially, we find that in the presence of experimentally realistic amounts of added noise, the on-chip gain afforded by such a device can be used to come significantly closer to the quantum limit than is possible with a standard dispersive measurement setup, allowing for efficiencies of ~ 75% under conditions that would yield efficiencies <~ 1 % when applying the usual scheme.
Abstract The no-knowledge quantum feedback, introduced in Phys. Rev. Lett., 113, 020407 (2014), is a measurement-based feedback protocol for decoherence suppression in a quantum system coupled to noisy environment. By continuously measuring the environmental noise, without directly gathering any information about the system, the decoherence effect can be suppressed by feeding back quantum controls proportional to the measured signal. In the original work, the feedback control was assumed instantaneous, leading to perfect cancellation of noise backaction on the quantum system. However, the instantaneous feedback is difficult to achieve in practice, and close-loop feedback protocols are always associated with finite delayed time. Therefore, in this work, we consider the effects of the delay between the time at which the measurement signal is acquired and the time that such signal is fed back to the system. We investigate the problem with an example of a two-level system (qubit) coupled to a Markovian reservoir, via a Hermitian coupling operator, where a homodyne detection is used to measure the environmental noise. We numerically simulate quantum stochastic trajectories of the qubit and analyse their averaged dynamics. We find that the feedback control with time delay can either enhance or reduce the decoherence effects, depending on whether the delayed time is in-phase or out-of-phase with the unitary dynamics of the qubit system.
Summary form only given. Although real-time feedback of measured signals is an essential component of sensing and control in classical settings, models for quantum feedback that are rigorous yet useful have only become possible since the advent of measurement-based quantum trajectory theory. The quantum feedback scenario introduces new concerns of coherence and measurement backaction, but recent work has shown that these can be treated properly in a formal integration of quantum trajectory theory with standard state-space formulations of filtering and control theory. Pioneering studies by H. M. Wiseman have shown that such models can be used to design and to analyze realistic schemes for adaptive homodyne measurement and for feedback control of atomic motion. Much of the ongoing research in our group focuses on the experimental implementation of such schemes. For a broad range of quantum feedback scenarios, certain recurring technical issues arise out of the need to perform complex, high-bandwidth processing of measured signals. We are developing a "rapid-prototyping" approach to refining signal processing and feedback algorithms via quantum trajectory simulation on a PC, followed by translation of the algorithms into hardware Description language (HDL).
Persistent control of a transmon qubit is performed by a feedback protocol based on continuous heterodyne measurement of its fluorescence. By driving the qubit and cavity with microwave signals whose amplitudes depend linearly on the instantaneous values of the quadratures of the measured fluorescence field, we show that it is possible to stabilize permanently the qubit in any targeted state. Using a Josephson mixer as a phase-preserving amplifier, it was possible to reach a total measurement efficiency η=35%, leading to a maximum of 59% of excitation and 44% of coherence for the stabilized states. The experiment demonstrates multiple-input multiple-output analog Markovian feedback in the quantum regime.
We discuss an efficient numerical scheme for the recursive filtering of diffusive quantum stochastic master equations. We show that the resultant quantum trajectory is robust and may be used for feedback based on inefficient measurements. The proposed numerical scheme is amenable to approximation, which can be used to further reduce the computational burden associated with calculating quantum trajectories and may allow real-time quantum filtering. We provide a two-qubit example where feedback control of entanglement may be within the scope of current experimental systems.
A conventional resonant detector is often subject to a trade-off between bandwidth and peak sensitivity. Anomalous dispersion has been shown to improve the bandwidth-sensitivity limit by signal amplification, but its unstable issue in operation needs additional feedback control. Here we propose a stable quantum amplifier enabled by two-mode non-degenerate parametric amplification. As the amplifier operates at threshold, one mode of the amplifier forms a parity-time(PT)-symmetric system with the mode of the original detector, while the other mode of the amplifier collects signal and gets extracted by a readout. Viewed more broadly in the context of coherent quantum control theory, we are attaching a controller that consists of a time reversal of the plant, which, by canceling the inertia of the plant, helps drive up the closed-loop signal gain. Examples of microwave cavity axion detectors and laser-interferometric gravitational-wave detectors will be discussed for this technique.