Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:1209.2747 · Physical Review Letters

Ultrasensitive N -Photon Interferometric Autocorrelator

Zili Zhou, G. Frucci, F. Mattioli, Alessandro Gaggero, Roberto Leoni, Saeedeh Jahanmirinejad, Thang B. Hoang, Andrea Fiore

Published Mar 28, 2013• 20 citations
arXivHTMLPDF

Abstract

We demonstrate a novel method to measure Nth-order (N=1,2,3,4) interferometric autocorrelation with high sensitivity and temporal resolution. It is based on the combination of linear absorption and nonlinear detection in a superconducting nanodetector, providing much higher efficiency than methods based on all-optical nonlinearities. Its temporal resolution is only limited by the quasiparticle energy relaxation time, which is directly measured to be in the 20 ps range for the NbN films used in this work. We present a general model of interferometric autocorrelation with these nonlinear detectors and discuss the comparison with other approaches and possible improvements.

DOI
10.1103/physrevlett.110.133605

Related papers

Multiphoton detection in superconducting nanowires: nonlinear optics in the detector

Zili Zhou, G. Frucci, F. Mattioli +5 more

A Nth-order (N=1, 2, 3, 4, 5, 6) interferometric autocorrelator based on superconducting nanodetectors is presented. It provides much higher sensitivity as compared to the conventional autocorrelators using all-optical nonlinearities and a temporal resolution of about 20 ps, which is limited by the quasi-particle energy relaxation time in the superconducting films. A semiclassical model is introduced to explain the nonlinear photodetection process. A comparison of sensitivity to conventional autocorrelators is also presented.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•May 29, 2013•2 citations

N-photon Autocorrelator with Picosecond Temporal Resolution

Zili Zhou, G. Frucci, Saeedeh Jahanmirinejad +4 more

We demonstrate an ultrafast autocorrelator with single-photon sensitivity based on superconducting nanodetectors. Its temporal resolution is only limited by the hotspot relaxation time which has been directly measured to be ~ 20 ps.

Research in Optical Sciences•Jan 1, 2012•0 citations

Picosecond N-photon autocorrelator based on superconducting nanodetectors

Zili Zhou, G. Frucci, Saeedeh Jahanmirinejad +4 more

We present a novel approach to an ultrafast N-photon autocorrelator with single-photon sensitivity based on superconducting nanodetectors. The hotspot relaxation time which determines the autocorrelator’s temporal resolution was measured to be ~20 ps.

Conference on Lasers and Electro-Optics•Jan 1, 2012•0 citations

Spectral Sensitivity and Temporal Resolution of NbN Superconducting Single-Photon Detectors

Alexander A. Verevkin, J. Zhang, Wojciech Słysz +8 more

We report our studies on spectral sensitivity and time resolution of superconducting NbN thin film single-photon detectors (SPDs). Our SPDs exhibit an everimentally measured detection efficiencies (DE) from — 0.2% at 2=1550 nm up to —3% at 2=405 nm wavelength for 10-nm film thickness devices and up to 3.5% at 2=1550 nm for 3.5-nm film thickness devices. Spectral dependences of detection efficiency (DE) at 2=0.4 —3.0 pm range are presented. With variable optical delay setup, it is shown that NbN SPD potentially can resolve optical pulses with the repetition rate up to 10 GHz at least. The observed full width at the half maximum (FWHM) of the signal pulse is about 150-180 ps, limited by read-out electronics. The jitter of NbN SPD is measured to be —35 ps at optimum biasing.

Softwaretechnik-Trends•Mar 1, 2002•0 citations

Complete experimental characterization of a superconducting multiphoton nanodetector

J. J. Renema, G. Frucci, Zili Zhou +6 more

We present a complete method to characterize multiphoton detectors with a small overall detection efficiency. We do this by separating the nonlinear action of the multiphoton detection event from linear losses in the detector. Such a characterization is a necessary step for quantum information protocols with single and multiphoton detectors and can provide quantitative information to understand the underlying physics of a given detector. This characterization is applied to a superconducting multiphoton nanodetector, consisting of an NbN nanowire with a bowtie-shaped subwavelength constriction. Depending on the bias current, this detector has regimes with single and multiphoton sensitivity. We present the first full experimental characterization of such a detector.

arXiv:1110.5442•Oct 25, 2011•0 citations

Towards linear optical detection with single photon sensitivity at telecom wavelengths

Saeedeh Jahanmirinejad, Andrea Fiore

Standard linear optical detectors have a maximum sensitivity in the few hundreds of photons range, limited by amplifier noise. On the other hand, single photon detectors, which are the most sensitive detectors, are strongly nonlinear: One or more photons result in the same output signal. Photon number resolving (PNR) detectors, which have the ability to discriminate the number of photons in a weak optical pulse, are of great importance in the field of quantum information processing and quantum cryptography. Moreover, a PNR detector with large dynamic range can cover the gap between these two detection modes. Such detectors are greatly desirable not only in quantum information science and technology, but also in any application dealing with low light levels. In this work, we propose a novel approach to photon number resolving detectors based on spatial multiplexing of nanowire superconducting single-photon detectors. In the proposed approach, N superconducting nanowires, each connected in parallel to an integrated resistor, are connected in series. Photon absorption in a nanowire switches its bias current to the parallel resistor, forming a voltage pulse across it. The sum of these voltages, proportional to the number of absorbed photons, is measured at the output. The use of a cryogenic preamplifier with high input impedance for the read-out increases the linearity, the signal to noise ratio, and the speed. With this combination, we expect to be able to count up to few tens of photons with high fidelity, excellent timing resolution, and very high sensitivity in the telecommunication wavelength range.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Apr 21, 2012•2 citations
We demonstrate a novel method to measure Nth-order (N=1,2,3,4) interferometric autocorrelation with high sensitivity and temporal resolution. It is based on the combination of linear absorption and nonlinear detection in a superconducting nanodetector, providing much higher efficiency than methods based on all-optical nonlinearities. Its temporal resolution is only limited by the quasiparticle energy relaxation time, which is directly measured to be in the 20 ps range for the NbN films used in this work. We present a general model of interferometric autocorrelation with these nonlinear detectors and discuss the comparison with other approaches and possible improvements.
A Nth-order (N=1, 2, 3, 4, 5, 6) interferometric autocorrelator based on superconducting nanodetectors is presented. It provides much higher sensitivity as compared to the conventional autocorrelators using all-optical nonlinearities and a temporal resolution of about 20 ps, which is limited by the quasi-particle energy relaxation time in the superconducting films. A semiclassical model is introduced to explain the nonlinear photodetection process. A comparison of sensitivity to conventional autocorrelators is also presented.
We report our studies on spectral sensitivity and time resolution of superconducting NbN thin film single-photon detectors (SPDs). Our SPDs exhibit an everimentally measured detection efficiencies (DE) from — 0.2% at 2=1550 nm up to —3% at 2=405 nm wavelength for 10-nm film thickness devices and up to 3.5% at 2=1550 nm for 3.5-nm film thickness devices. Spectral dependences of detection efficiency (DE) at 2=0.4 —3.0 pm range are presented. With variable optical delay setup, it is shown that NbN SPD potentially can resolve optical pulses with the repetition rate up to 10 GHz at least. The observed full width at the half maximum (FWHM) of the signal pulse is about 150-180 ps, limited by read-out electronics. The jitter of NbN SPD is measured to be —35 ps at optimum biasing.
We present a complete method to characterize multiphoton detectors with a small overall detection efficiency. We do this by separating the nonlinear action of the multiphoton detection event from linear losses in the detector. Such a characterization is a necessary step for quantum information protocols with single and multiphoton detectors and can provide quantitative information to understand the underlying physics of a given detector. This characterization is applied to a superconducting multiphoton nanodetector, consisting of an NbN nanowire with a bowtie-shaped subwavelength constriction. Depending on the bias current, this detector has regimes with single and multiphoton sensitivity. We present the first full experimental characterization of such a detector.
Standard linear optical detectors have a maximum sensitivity in the few hundreds of photons range, limited by amplifier noise. On the other hand, single photon detectors, which are the most sensitive detectors, are strongly nonlinear: One or more photons result in the same output signal. Photon number resolving (PNR) detectors, which have the ability to discriminate the number of photons in a weak optical pulse, are of great importance in the field of quantum information processing and quantum cryptography. Moreover, a PNR detector with large dynamic range can cover the gap between these two detection modes. Such detectors are greatly desirable not only in quantum information science and technology, but also in any application dealing with low light levels. In this work, we propose a novel approach to photon number resolving detectors based on spatial multiplexing of nanowire superconducting single-photon detectors. In the proposed approach, N superconducting nanowires, each connected in parallel to an integrated resistor, are connected in series. Photon absorption in a nanowire switches its bias current to the parallel resistor, forming a voltage pulse across it. The sum of these voltages, proportional to the number of absorbed photons, is measured at the output. The use of a cryogenic preamplifier with high input impedance for the read-out increases the linearity, the signal to noise ratio, and the speed. With this combination, we expect to be able to count up to few tens of photons with high fidelity, excellent timing resolution, and very high sensitivity in the telecommunication wavelength range.