We report on the realization of a superinductor, a dissipationless element whose microwave impedance greatly exceeds the resistance quantum R(Q). The design of the superinductor, implemented as a ladder of nanoscale Josephson junctions, enables tuning of the inductance and its nonlinearity by a weak magnetic field. The Rabi decay time of the superinductor-based qubit exceeds 1 μs. The high kinetic inductance and strong nonlinearity offer new types of functionality, including the development of qubits protected from both flux and charge noises, fault tolerant quantum computing, and high-impedance isolation for electrical current standards based on Bloch oscillations.
We report on the realization of a superinductor, a dissipationless element whose microwave impedance greatly exceeds the resistance quantum R(Q). The design of the superinductor, implemented as a ladder of nanoscale Josephson junctions, enables tuning of the inductance and its nonlinearity by a weak magnetic field. The Rabi decay time of the superinductor-based qubit exceeds 1 μs. The high kinetic inductance and strong nonlinearity offer new types of functionality, including the development of qubits protected from both flux and charge noises, fault tolerant quantum computing, and high-impedance isolation for electrical current standards based on Bloch oscillations.
Superinductors are inductors whose microwave characteristic impedances are greater than the resistance quantum, RQ=h/(2e)2approx6.5kOmega. They can be implemented using Josephson junction chains and high kinetic inductance nanowires. In this dissertation, we explore applications of superinductors in both implementations in superconducting quantum circuits. The dissertation consists of three parts. In the first part, we discuss the fluxon-parity-protected qubit consisting of a Cooper-pair box (CPB) shunted by a superinductor made of a chain of coupled asymmetric Superconducting Quantum Interference Devices (CASQUIDs). The spectroscopic measurement of a prototype of the fluxon-parity-protected qubit was performed. We observed almost complete suppression of the single fluxon tunneling across the CPB due to the destructive Aharonov-Casher interference when the offset charge on the CPB island was set to e mod(2e). A fluxon-parity-protected qubit with a higher superinductance can potentially be used to perform fault-tolerant Clifford gates. In the second part, we studied the microwave losses in high-kinetic-inductance granular Aluminum films using superconducting coplanar-waveguide (CPW) resonators made of the films. We observed that the intrinsic losses in these resonators at low temperatures were limited by resonator coupling to the two-level systems (TLS) in the environment. The demonstrated internal quality factors are comparable with those for CPW resonators made of conventional superconductors. The characterized granular Aluminum films can be used to fabricate superinductors for a wide range of applications in quantum metrology and quantum information processing. In the third part, we discuss the one-dimensional Josephson metamaterial made of a similar structure as the superinductor used in the fluxon-parity-protected qubit. The metamaterial demonstrated strong Kerr nonlinearity with the Kerr constant tunable over a wide range from positive to negative values by the magnetic field. The metamaterial is promising for use as an active medium for quantum-limited Josephson traveling-wave parametric amplifiers.
Quantum decoherence due to charge fluctuations is still a problem in many device architectures for quantum computing or metrology, but it can be suppressed by shunting the circuit with a high microwave impedance, known as a $s\phantom{\rule{0}{0ex}}u\phantom{\rule{0}{0ex}}p\phantom{\rule{0}{0ex}}e\phantom{\rule{0}{0ex}}r\phantom{\rule{0}{0ex}}i\phantom{\rule{0}{0ex}}n\phantom{\rule{0}{0ex}}d\phantom{\rule{0}{0ex}}u\phantom{\rule{0}{0ex}}c\phantom{\rule{0}{0ex}}t\phantom{\rule{0}{0ex}}a\phantom{\rule{0}{0ex}}n\phantom{\rule{0}{0ex}}c\phantom{\rule{0}{0ex}}e$. This study uses the kinetic inductance of a nanowire of disordered superconductor to demonstrate a low-loss, small-capacitance superinductor, in a simpler approach than the traditionally used Josephson-junction arrays. Such nanowire superinductors should have an impact on engineering long-lived superconducting qubits, and quantum-coherent experiments with mesoscopic systems.
In superconducting circuits, $s\phantom{\rule{0}{0ex}}u\phantom{\rule{0}{0ex}}p\phantom{\rule{0}{0ex}}e\phantom{\rule{0}{0ex}}r\phantom{\rule{0}{0ex}}i\phantom{\rule{0}{0ex}}n\phantom{\rule{0}{0ex}}d\phantom{\rule{0}{0ex}}u\phantom{\rule{0}{0ex}}c\phantom{\rule{0}{0ex}}t\phantom{\rule{0}{0ex}}o\phantom{\rule{0}{0ex}}r\phantom{\rule{0}{0ex}}s$ are employed to suppress charge fluctuations and increase zero-point voltage, enabling features for hardware-protected qubits, metrological standards, and strongly coupled hybrid devices. Conventionally these devices are based on kinetic inductance, and can suffer from nonlinearity, additional complexity due to multiterminal structure, and the limited control and reliability of bottom-up fabrication. Making use of miniaturization and substrate engineering, the authors realize a geometrically defined, single-wavefunction superinductor---a high-performance, innovative circuit element that promises to expand the scope of quantum circuitry.
This work is concerned with two fascinating circuit quantum electrodynamics components, the Josephson junction and the geometric superinductor, and the interesting experiments that can be done by combining the two. The Josephson junction has revolutionized the field of superconducting circuits as a non-linear dissipation-less circuit element and is used in almost all superconducting qubit implementations since the 90s. On the other hand, the superinductor is a relatively new circuit element introduced as a key component of the fluxonium qubit in 2009. This is an inductor with characteristic impedance larger than the resistance quantum and self-resonance frequency in the GHz regime. The combination of these two elements can occur in two fundamental ways: in parallel and in series. When connected in parallel the two create the fluxonium qubit, a loop with large inductance and a rich energy spectrum reliant on quantum tunneling. On the other hand placing the two elements in series aids with the measurement of the IV curve of a single Josephson junction in a high impedance environment. In this limit theory predicts that the junction will behave as its dual element: the phase-slip junction. While the Josephson junction acts as a non-linear inductor the phase-slip junction has the behavior of a non-linear capacitance and can be used to measure new Josephson junction phenomena, namely Coulomb blockade of Cooper pairs and phase-locked Bloch oscillations. The latter experiment allows for a direct link between frequency and current which is an elusive connection in quantum metrology. This work introduces the geometric superinductor, a superconducting circuit element where the high inductance is due to the geometry rather than the material properties of the superconductor, realized from a highly miniaturized superconducting planar coil. These structures will be described and characterized as resonators and qubit inductors and progress towards the measurement of phase-locked Bloch oscillations will be presented.
A quantum-limited amplifier enables the amplification of weak signals while introducing minimal noise dictated by the principles of quantum mechanics. Such amplifiers serve a broad spectrum of applications in quantum computing, including fast and accurate readout of superconducting qubits and spins, as well as various uses in quantum sensing and metrology. Parametric amplification, primarily developed with use of Josephson junctions, has evolved into the leading technology for highly effective microwave measurements within quantum circuits. Despite their significant contributions, these amplifiers face fundamental limitations, such as their inability to handle high powers, their sensitivity to parasitic magnetic fields, and particularly their limitation to operate only at millikelvin temperatures. To tackle these challenges, here we experimentally develop a novel quantum-limited amplifier based on superconducting kinetic inductance and present an extensive theoretical model to describe this nonlinear coupled-mode system. Our device surpasses the conventional constraints associated with Josephson-junction amplifiers by operating at much higher temperatures up to 4.5 K. With two distinct spectral modes and tunability through bias current, this amplifier can operate selectively in both the single-mode-amplification regime and the double-mode-amplification regime near the quantum noise limit. Using a nonlinear thin film exhibiting kinetic inductance, our device attains gain exceeding 50 dB in a single-mode configuration and 32 dB in a double-mode configuration, while adding 0.82 input-referred noise quanta. Importantly, this amplifier eliminates the need for Josephson junctions, resulting in the capability to handle significantly higher powers than Josephson junction--based amplifiers. It also demonstrates resilience in the presence of magnetic fields, offers a straightforward design, and increases reliability. This positions the amplifier as a versatile solution for quantum applications and facilitates its integration into future superconducting quantum computers.
With a large portfolio of elemental quantum components, superconducting quantum circuits have contributed to dramatic advances in microwave quantum optics. Of these elements, quantum-limited parametric amplifiers have proven to be essential for low noise readout of quantum systems whose energy range is intrinsically low (tens of µeV). They are also used to generate non classical states of light that can be a resource for quantum enhanced detection. Superconducting parametric amplifiers, like quantum bits, typically utilize a Josephson junction as a source of magnetically tunable and dissipation-free nonlinearity. The magnetic control is not an industry standard for devices and starts already to be an issue in large scale circuits. In recent years, efforts have been made to introduce semiconductor weak links as electrically tunable nonlinear elements, with demonstrations of microwave resonators and quantum bits using semiconductor nanowires, a two dimensional electron gas, carbon nanotubes and graphene. However, given the challenge of balancing nonlinearity, dissipation, participation, and energy scale, parametric amplifiers have not yet been implemented with a semiconductor weak link. The work presented in this PhD thesis demonstrates the design, fabrication and performances of a parametric amplifier leveraging a graphene Josephson junction.The graphene is encapsulated in between hBN flakes in order to improve its quality. Using such high quality junctions, we demonstrate amplification with 20 dB gain which is the milestone for overcoming noise of the classical amplifiers in the rest of the amplification chain. The Josephson parametric amplifier being based on a resonant structure (around 6 GHz) suffers from the gain bandwidth product limiting the amplification to a few MegaHertz frequency range. The use of a side gate to electrically tune the graphene gives control of the Josephson junction inductance and thus the resonant frequency of the amplifier. We demonstrate a near 1 GHz tunability of the amplification frequency with the use of a side gate which is as good as the tunability offered by using a magnetic flux on a SQUID for similar amplifier designs. Moreover, graphene has shown to exhibit nonlinear loss under a strong microwave irradiation arising because of dynamics in the Andreev states. Dissipation is known to add intrinsic noise on quantum amplifiers and could be a problem for quantum limited parametric amplification. We demonstrate that despite the presence of nonlinear loss, graphene based Josephson parametric amplifiers can reach near quantum limited amplification. A two photon loss model was used to describe the behaviour of the device but we show that a more complex model is required in order to take into account the nonlinear dissipation and the non-sinusoidal current phase relation. We also studied the dynamic range and showed that the graphene based Josephson parametric amplifier can reach a 1 dB compression point of -123 dBm which is as good as single tunnel junctions based parametric amplifiers. Our results expand the toolset for electrically tunable superconducting quantum circuits and offer new opportunities for the development of quantum technologies such as quantum computing, quantum sensing and fundamental science.