Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:1001.0944

Single Photon Atomic Sorting: Isotope Separation with Maxwell's Demon

M. Jerkins, Isaac Chavez, Uzi Even, Mark G. Raizen

Published Jan 6, 2010• 0 citations
arXivHTMLPDF

Abstract

Isotope separation is one of the grand challenges of modern society and holds great potential for basic science, medicine, energy, and defense. We consider here a new and general approach to isotope separation. The method is based on an irreversible change of the mass-to-magnetic moment ratio of a particular isotope in an atomic beam, followed by a magnetic multipole whose gradients deflect and guide the atoms. The underlying mechanism is a reduction of the entropy of the beam by the information of a single-scattered photon for each atom that is separated. We numerically simulate isotope separation for a range of examples, including lithium, for which we describe the experimental setup we are currently constructing. Simulations of other examples demonstrate this technique's general applicability to almost the entire periodic table. We show that the efficiency of the process is only limited by the available laser power, since one photon on average enables the separation of one atom. The practical importance of the proposed method is that large-scale isotope separation should be possible, using ordinary inexpensive magnets and the existing technologies of supersonic beams and lasers.

DOI
10.48550/arxiv.1001.0944

Related papers

Efficient isotope separation by single-photon atomic sorting

M. Jerkins, Isaac Chavez, Uzi Even +1 more

We propose a general and scalable approach to isotope separation. The method is based on an irreversible change of the mass-to-magnetic moment ratio of a particular isotope in an atomic beam, followed by a magnetic multipole whose gradients deflect and guide the atoms. The underlying mechanism is a reduction of the entropy of the beam by the information of a single scattered photon for each atom that is separated. We numerically simulate isotope separation for a range of examples, which demonstrate this technique's general applicability to almost the entire periodic table. The practical importance of the proposed method is that large-scale isotope separation should be possible, using ordinary inexpensive magnets and the existing technologies of supersonic beams and lasers.

Physical Review A•Sep 15, 2010•13 citations

Separation of isotopes by laser deflection of atomic beam. I. Barium

Anthony F. Bernhardt, D. E. Duerre, J. R. Simpson +1 more

Spatial separation of isotopes of barium in an atomic beam has been demonstrated, using radiation pressure of light from a tunable dye laser which resolved the unusually narrow isotopic hyperfine structure of the Ba (I) 5535.7-Å resonance line. Observations of the deflected monoisotopic beam indicate an average of 25 photons scattered per atom in the deflected beam.

Applied Physics Letters•Nov 15, 1974•60 citations

Comprehensive Control of Atomic Motion

Mark G. Raizen

Recent work provides a general two-step solution to trapping and cooling of atoms. The first step is magnetic stopping of paramagnetic atoms with the use of a sequence of pulsed fields. The second step is single-photon cooling, which is based on a one-way barrier. This cooling method is related intimately to the historic problem of "Maxwell's Demon" and subsequent work by L. Szilard. Here, I discuss the connections between single-photon cooling and information entropy. I also outline future application of these methods to fundamental tests with hydrogen isotopes.

Science•Jun 11, 2009•82 citations

Theoretical study on isotope separation of an ytterbium atomic beam by laser deflection

Min Zhou, Xinye Xu

Isotope separation by laser deflecting an atomic beam is analyzed theoretically. Interacting with a tilted one-dimensional optical molasses, an ytterbium atomic beam is split into multi-beams with different isotopes like 172 Yb, 173 Yb, and 174 Yb. By using the numerical calculation, the dependences of the splitting angle on the molasses laser intensity and detuning are studied, and the optimal parameters for the isotope separation are also investigated. Furthermore, the isotope separation efficiency and purity are estimated. Finally a new scheme for the efficient isotope separation is proposed. These findings will give a guideline for simply obtaining pure isotopes of various elements.

Chinese Physics B•Jan 1, 2014•2 citations

A new method of isotope separation by means of laser deflection of an atomic beam

Liang Liu, Yuzhu Wang

The radiation pressure produced by two-laser fields on a two-level atom is obtained. These results show that the radiation pressure produced by two-laser fields with appropriate detunings with atom is much greater than that produced by a single-laser field. This great radiation pressure is possible to be applied to isotope separation by laser deflection of an atomic beam.

Chinese Physics Letters•Nov 1, 1986•1 citation

Laser isotope separation of barium using an inhomogeneous magnetic field

William Arie van Wijngaarden, Jin-Sun Ki

Isotopes of barium are selectively excited to a metastable state using a single ring dye laser. The excited atoms are then deflected out of an atomic beam by an inhomogeneous magnetic field. The deflection of the beam is studied using a hot wire detector and a quadrupole mass spectrometer. Measurements are presented showing that nearly all atoms of a particle isotope can be excited from the 6s{sup 2} ground still to the 6s5d state and subsequently spatially separated. This method of isotope separation requires metastable states having lifetimes greater than about 100 {mu}sec. These states can be readily excited from the ground state in atoms such as the Group II elements.

Bulletin of the American Physical Society•May 1, 1993•0 citations
Isotope separation is one of the grand challenges of modern society and holds great potential for basic science, medicine, energy, and defense. We consider here a new and general approach to isotope separation. The method is based on an irreversible change of the mass-to-magnetic moment ratio of a particular isotope in an atomic beam, followed by a magnetic multipole whose gradients deflect and guide the atoms. The underlying mechanism is a reduction of the entropy of the beam by the information of a single-scattered photon for each atom that is separated. We numerically simulate isotope separation for a range of examples, including lithium, for which we describe the experimental setup we are currently constructing. Simulations of other examples demonstrate this technique's general applicability to almost the entire periodic table. We show that the efficiency of the process is only limited by the available laser power, since one photon on average enables the separation of one atom. The practical importance of the proposed method is that large-scale isotope separation should be possible, using ordinary inexpensive magnets and the existing technologies of supersonic beams and lasers.
We propose a general and scalable approach to isotope separation. The method is based on an irreversible change of the mass-to-magnetic moment ratio of a particular isotope in an atomic beam, followed by a magnetic multipole whose gradients deflect and guide the atoms. The underlying mechanism is a reduction of the entropy of the beam by the information of a single scattered photon for each atom that is separated. We numerically simulate isotope separation for a range of examples, which demonstrate this technique's general applicability to almost the entire periodic table. The practical importance of the proposed method is that large-scale isotope separation should be possible, using ordinary inexpensive magnets and the existing technologies of supersonic beams and lasers.
Recent work provides a general two-step solution to trapping and cooling of atoms. The first step is magnetic stopping of paramagnetic atoms with the use of a sequence of pulsed fields. The second step is single-photon cooling, which is based on a one-way barrier. This cooling method is related intimately to the historic problem of "Maxwell's Demon" and subsequent work by L. Szilard. Here, I discuss the connections between single-photon cooling and information entropy. I also outline future application of these methods to fundamental tests with hydrogen isotopes.
Isotope separation by laser deflecting an atomic beam is analyzed theoretically. Interacting with a tilted one-dimensional optical molasses, an ytterbium atomic beam is split into multi-beams with different isotopes like 172 Yb, 173 Yb, and 174 Yb. By using the numerical calculation, the dependences of the splitting angle on the molasses laser intensity and detuning are studied, and the optimal parameters for the isotope separation are also investigated. Furthermore, the isotope separation efficiency and purity are estimated. Finally a new scheme for the efficient isotope separation is proposed. These findings will give a guideline for simply obtaining pure isotopes of various elements.
Isotopes of barium are selectively excited to a metastable state using a single ring dye laser. The excited atoms are then deflected out of an atomic beam by an inhomogeneous magnetic field. The deflection of the beam is studied using a hot wire detector and a quadrupole mass spectrometer. Measurements are presented showing that nearly all atoms of a particle isotope can be excited from the 6s{sup 2} ground still to the 6s5d state and subsequently spatially separated. This method of isotope separation requires metastable states having lifetimes greater than about 100 {mu}sec. These states can be readily excited from the ground state in atoms such as the Group II elements.