Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:0911.5322 · Physical Review A

Tunable joint measurements in the dispersive regime of cavity QED

Kevin Lalumière, Jay Gambetta, Alexandre Blais

Published Apr 1, 2010• 74 citations
arXivHTMLPDF

Abstract

Joint measurements of multiple qubits open new possibilities for quantum information processing. Here we present an approach based on homodyne detection to realize such measurements in the dispersive regime of cavity or circuit QED. By changing details of the measurement, the readout can be tuned from extracting only single-qubit to extracting only multiqubit properties. We obtain a reduced stochastic master equation describing this measurement and its effect on the qubits. As an example, we present results showing parity measurements of two qubits. In this situation, measurement of an initially unentangled state can yield, with near unit probability, a state of significant concurrence.

DOI
10.1103/physreva.81.040301

Related papers

Multi-qubit joint measurements in circuit QED: stochastic master equation analysis

Ben Criger, Alessandro Ciani, David Peter Divincenzo

We derive a family of stochastic master equations describing homodyne measurement of multi-qubit diagonal observables in circuit quantum electrodynamics. In the regime where qubit decay can be neglected, our approach replaces the polaron-like transformation of previous work, which required a lengthy calculation for the physically interesting case of three qubits and two resonator modes. The technique introduced here makes this calculation straightforward and manifestly correct. Using this technique, we are able to show that registers larger than one qubit evolve under a non-Markovian master equation. We perform numerical simulations of the three-qubit, two-mode case from previous work, obtaining an average post-measurement state fidelity of ∼ 94%, limited by measurement-induced decoherence and dephasing.

arXiv:1510.03211•EPJ Quantum Technology•Apr 4, 2016•9 citations

High-fidelity feedback-assisted parity measurement in circuit QED

Lars Tornberg, Göran Johansson

We analyze a two-qubit parity measurement based on dispersive readout in circuit quantum electrodynamics. The back action on the qubits has two qualitatively different contributions. One is an unavoidable dephasing in one of the parity subspaces, arising during the transient time of switching on the measurement. The other part is a stochastic rotation of the phase in the same subspace, which persists during the whole measurement. The latter can be determined from the full measurement record using the method of state estimation. Our main result is that the outcome of this phase determination process is independent of the initial state in the state estimation procedure. The procedure can thus be used in a measurement situation where the initial state is unknown. We discuss how this feedback method can be used to achieve a high-fidelity parity measurement for moderate values of the cavity-qubit coupling strength. Finally, we discuss the robustness of the feedback procedure toward errors in the measurement record.

arXiv:1003.5488•Physical Review A•Jul 26, 2010•41 citations

Dispersive regime of circuit QED: Photon-dependent qubit dephasing and relaxation rates

Maxime Boissonneault, Jay Gambetta, Alexandre Blais

Superconducting electrical circuits can be used to study the physics of cavity quantum electrodynamics (QED) in new regimes, therefore realizing circuit QED. For quantum-information processing and quantum optics, an interesting regime of circuit QED is the dispersive regime, where the detuning between the qubit transition frequency and the resonator frequency is much larger than the interaction strength. In this paper, we investigate how nonlinear corrections to the dispersive regime affect the measurement process. We find that in the presence of pure qubit dephasing, photon population of the resonator used for the measurement of the qubit act as an effective heat bath, inducing incoherent relaxation and excitation of the qubit. Measurement thus induces both dephasing and mixing of the qubit, something that can reduce the quantum nondemolition aspect of the readout. Using quantum trajectory theory, we show that this heat bath can induce quantum jumps in the qubit state. Nonlinear effects can also reduce the achievable signal-to-noise ratio of a homodyne measurement of the voltage.

arXiv:0810.1336•Physical Review A•Jan 23, 2009•301 citations

Joint observables induced by indirect measurements in cavity QED

Kalle Raikisto, Kimmo Luoma

A fundamental feature of quantum mechanics is that there are observable pairs that cannot be measured jointly, such as observables corresponding to position and momentum or spin direction measurements. However, unsharp versions of non-jointly measurable observables may become jointly measurable. In this study, we investigate the joint measurability of time-continuous observables emerging from indirect time-continuous measurements. In particular, we study a paradigmatic situation where a qubit is interacting with a mode of light in a cavity, and the light escaping the cavity is continuously monitored. We find that the properties of the observables can be tuned by changing the type of the monitoring scheme or by tuning the initial state of the cavity. In particular, we demonstrate that heterodyne measurements are a joint measurement of a noisy homodyne measurement of a pair of canonical quadratures. Moreover, we investigate the purity of the induced qubit observables as a function of the noise.

Frontiers in Quantum Science and Technology•Oct 17, 2025•0 citations

Undoing measurement-induced dephasing in circuit QED

Anton Frisk Kockum, Lars Tornberg, Göran Johansson

We analyze the backaction of homodyne detection and photodetection on superconducting qubits in circuit quantum electrodynamics. Although both measurement schemes give rise to backaction in the form of stochastic phase rotations, which leads to dephasing, we show that this can be perfectly undone provided that the measurement signal is fully accounted for. This result improves on an earlier one [Phys. Rev. A 82, 012329 (2010)], showing that the method suggested can be made to realize a perfect two-qubit parity measurement. We propose a benchmarking experiment on a single qubit to demonstrate the method using homodyne detection. By analyzing the limited measurement efficiency of the detector and bandwidth of the amplifier, we show that the parameter values necessary to see the effect are within the limits of existing technology.

arXiv:1202.2386•Physical Review A•May 24, 2012•29 citations

Proposal for generating and detecting multi-qubit GHZ states in circuit QED

Lev S. Bishop, L Tornberg, D Price +8 more

We propose methods for the preparation and entanglement detection of multi-qubit Greenberger–Horne–Zeilinger (GHZ) states in circuit quantum electrodynamics. Using quantum trajectory simulations appropriate for the situation of a weak continuous measurement, we show that the joint dispersive readout of several qubits can be utilized for the probabilistic production of high-fidelity GHZ states. When employing a nonlinear filter on the recorded homodyne signal, the selected states are found to exhibit values of the Bell–Mermin operator exceeding 2 under realistic conditions. We discuss the potential of the dispersive readout to demonstrate a violation of the Mermin bound, and present a measurement scheme avoiding the necessity for full detector tomography.

arXiv:0902.0324•New Journal of Physics•Jul 23, 2009•66 citations
Joint measurements of multiple qubits open new possibilities for quantum information processing. Here we present an approach based on homodyne detection to realize such measurements in the dispersive regime of cavity or circuit QED. By changing details of the measurement, the readout can be tuned from extracting only single-qubit to extracting only multiqubit properties. We obtain a reduced stochastic master equation describing this measurement and its effect on the qubits. As an example, we present results showing parity measurements of two qubits. In this situation, measurement of an initially unentangled state can yield, with near unit probability, a state of significant concurrence.
We derive a family of stochastic master equations describing homodyne measurement of multi-qubit diagonal observables in circuit quantum electrodynamics. In the regime where qubit decay can be neglected, our approach replaces the polaron-like transformation of previous work, which required a lengthy calculation for the physically interesting case of three qubits and two resonator modes. The technique introduced here makes this calculation straightforward and manifestly correct. Using this technique, we are able to show that registers larger than one qubit evolve under a non-Markovian master equation. We perform numerical simulations of the three-qubit, two-mode case from previous work, obtaining an average post-measurement state fidelity of ∼ 94%, limited by measurement-induced decoherence and dephasing.
We analyze a two-qubit parity measurement based on dispersive readout in circuit quantum electrodynamics. The back action on the qubits has two qualitatively different contributions. One is an unavoidable dephasing in one of the parity subspaces, arising during the transient time of switching on the measurement. The other part is a stochastic rotation of the phase in the same subspace, which persists during the whole measurement. The latter can be determined from the full measurement record using the method of state estimation. Our main result is that the outcome of this phase determination process is independent of the initial state in the state estimation procedure. The procedure can thus be used in a measurement situation where the initial state is unknown. We discuss how this feedback method can be used to achieve a high-fidelity parity measurement for moderate values of the cavity-qubit coupling strength. Finally, we discuss the robustness of the feedback procedure toward errors in the measurement record.
Superconducting electrical circuits can be used to study the physics of cavity quantum electrodynamics (QED) in new regimes, therefore realizing circuit QED. For quantum-information processing and quantum optics, an interesting regime of circuit QED is the dispersive regime, where the detuning between the qubit transition frequency and the resonator frequency is much larger than the interaction strength. In this paper, we investigate how nonlinear corrections to the dispersive regime affect the measurement process. We find that in the presence of pure qubit dephasing, photon population of the resonator used for the measurement of the qubit act as an effective heat bath, inducing incoherent relaxation and excitation of the qubit. Measurement thus induces both dephasing and mixing of the qubit, something that can reduce the quantum nondemolition aspect of the readout. Using quantum trajectory theory, we show that this heat bath can induce quantum jumps in the qubit state. Nonlinear effects can also reduce the achievable signal-to-noise ratio of a homodyne measurement of the voltage.
A fundamental feature of quantum mechanics is that there are observable pairs that cannot be measured jointly, such as observables corresponding to position and momentum or spin direction measurements. However, unsharp versions of non-jointly measurable observables may become jointly measurable. In this study, we investigate the joint measurability of time-continuous observables emerging from indirect time-continuous measurements. In particular, we study a paradigmatic situation where a qubit is interacting with a mode of light in a cavity, and the light escaping the cavity is continuously monitored. We find that the properties of the observables can be tuned by changing the type of the monitoring scheme or by tuning the initial state of the cavity. In particular, we demonstrate that heterodyne measurements are a joint measurement of a noisy homodyne measurement of a pair of canonical quadratures. Moreover, we investigate the purity of the induced qubit observables as a function of the noise.
We analyze the backaction of homodyne detection and photodetection on superconducting qubits in circuit quantum electrodynamics. Although both measurement schemes give rise to backaction in the form of stochastic phase rotations, which leads to dephasing, we show that this can be perfectly undone provided that the measurement signal is fully accounted for. This result improves on an earlier one [Phys. Rev. A 82, 012329 (2010)], showing that the method suggested can be made to realize a perfect two-qubit parity measurement. We propose a benchmarking experiment on a single qubit to demonstrate the method using homodyne detection. By analyzing the limited measurement efficiency of the detector and bandwidth of the amplifier, we show that the parameter values necessary to see the effect are within the limits of existing technology.
We propose methods for the preparation and entanglement detection of multi-qubit Greenberger–Horne–Zeilinger (GHZ) states in circuit quantum electrodynamics. Using quantum trajectory simulations appropriate for the situation of a weak continuous measurement, we show that the joint dispersive readout of several qubits can be utilized for the probabilistic production of high-fidelity GHZ states. When employing a nonlinear filter on the recorded homodyne signal, the selected states are found to exhibit values of the Bell–Mermin operator exceeding 2 under realistic conditions. We discuss the potential of the dispersive readout to demonstrate a violation of the Mermin bound, and present a measurement scheme avoiding the necessity for full detector tomography.